Having problems with your Chevrolet Chevy ?

Coil Hi I installed rebuilt 350 v-8 engine in a 1970 chevrolet 1/2 ton pickup with a 1982 el camino 0em hei distributor in july 2003. Had no problems until now. Have now done a complete tune up (Plugs, plug wires, cap, rotor, coil, even a rebuilt starter and solenoid). Since then the coil has to be replaced every week due to failure. Please Help. Sincerely, David Auldredge

Posted / edited by AnonymousUser on : 19-03-2018

Answers :

You change the coil every week when you open the distributor cap the pick up coit it has 2 wire and is connected to module pull those wire gently to see if there not broken those wire break inside the plstic if you visualy check it only youre not gonns see then pull a bit it they break that that the problem hope it help fixya our post thanks pierre
Please make shure that you have the hot wire on a switch this is the wire that goes to the side if the distributer if the wire that you have in place right now is hot al the time it will overheat the coil and burn it out ok good luck
Repair Help & Product Troubleshooting for Chevrolet Chevy

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0055 seconds