Having problems with your Chevrolet 3500 ?

1948 chevy thriftmaster bench seat adjusting

\015 1948 chevy thriftmaster bench seat adjusting rails were joined by a cable. I cannot figure out how the cable goes on to make them work. Help???\015 Posted / edited by AnonymousUser on : 26-02-2018

Answers :

Not sure because this was 20 years before I was born,but the 70's erra seats has the handle with the fork/finger locking teeth with the return spring on the drivers side and there was a tiny hole on the inside where the wire goes.On the under side of the seat attached to the steel wavey springs there were loops just like hog rings that were used to route the wire to the locking lever on the other side.If this is the type of set up you could also use the hard plastic air line.Any heavy truck parts place will have it and it comes in many sizes.Would be easy to rout your wire thru.Well hope the helps and good luck.
Repair Help & Product Troubleshooting for Chevrolet 3500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0067 seconds