Having problems with your 1999 Daewoo Nubira ?

Clutch problem Hi there,Have replaced clutch slave and master cyclinder and i still cant shift into gear well the car is running but can get gears when car is turned off,Have bleed everything up and still have no joy getting gears,Is there a special way to bleed this clutch? I ended up putting a new clutch kit in and still no joy.Please help?

Posted / edited by AnonymousUser on : 12-03-2018

Answers :

Have someone press down on the clutch pedal while you look at the release lever. There should be movement on the lever of about a 1/2 inch. If not the problem is on the hydraulic side. If there is sufficient movement the problem is on the mechanical side (Incorrect fitment/ cracked release lever in the bellhousing/incorrect parts ie pressure plate) Pay attention to where the slave cylinder pin contacts the release lever. Severe wear can occur at this point as it is hardly ever lubricated by service centres/backyard mechanis and you could have a situation where the pin goes straight throught the contact point due to wear.
Bear in mind, (something that has puzzled me completely), a master cylinder that has been inoperative for a while, especially on older cars, needs to have its' seals replaced before working properly again. Go figure!
Repair Help & Product Troubleshooting for 1999 Daewoo Nubira

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0343 seconds