Having problems with your 1997 Volkswagen Jetta ?

I have a 97 jetta and when i try and bleed my brakes i start on the passenger side bleeder valve. and when i start bleeding the brakes i have pressure and the pedal goes to the floor but when i bleed the other brake valves i still have pressure but the pedal doesn't go the the floor when iam bleeding the brakes. and also when i turn on the car i lose all of my pressure and when i shut the car off i get my pressure back.

Posted / edited by AnonymousUser on : 19-03-2018

Answers :

When bleeding you start at the rt rear to left rear to rt front to left front always checking to make sure master stays with fluid, also start by removing one bleeder at a time and make sure the hole is clean and free of dirt brake clean should flow through, do this to all 4, then have someone pump pedal 3 times and hold then open bleeder when you close bleeder tell them pump again three times, do this all around until you have a good pedal, also check for leaks after bleeding, may have bad rusted line or bad master but bleed each wheel good first.dont worry about pedal going to floor everytime, just make sure fluid flows out of all bleeders when bleeding. hope this helps.
Repair Help & Product Troubleshooting for 1997 Volkswagen Jetta

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0057 seconds