Having problems with your 1985 Ford F 250 ?

Replaced Clutch, master cylinder and slave cylinder on my 85 F250 diesel. The truck shifts ok when it is cold, once it warms up it wont shift using the clutch. you have to use RPMs to make it shift. I think it needs to be bled. how do you bleed the clutch? the clutch is not disengaging all the way when the clutch is depressed to the floor.

Posted / edited by AnonymousUser on : 19-02-2018

Answers :

These are very hard to bleed, also check your fire wall for damage where the clutch master bolts up. another thing is take a good look at the clutch pedal asm, the frame sometimes wears and cracks so you loose a little pedal travel.another thing is a bad preasure plate,spring breaks on plate,
There should be a bleeder screw on the clutch cylinder. Have someone depress the clutch and hold it down, while you loosen the bleeder screw, air/ and or fluid should come out. Repeat until a solid stream of fluid comes out, tighten bleeder, release the clutch pedal. Check the fluid resevoir level.
Repair Help & Product Troubleshooting for 1985 Ford F 250

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0052 seconds