Having problems with your Toyota Land Cruiser ?

I have a 1977 Land Cruiser. I can turn the engine over but I am not getting spark to the plugs. I need to know how the wiring goes on the starter solenod.

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

That's a good question. There IS a coil wire on the solenoid to bypass the ballast resistor when starting. It is the black wire with a yellow stripe and it can attach to either the start terminal or the large starter terminal on the bottom of the solenoid. It just needs to get battery voltage when the key is turned to start, and any of the terminals except the top one will do that for you. The top one is always hot, so don't hook it there. Please let me know if this doesn't solve the problem or if you have any other questions.
\015\012
jturcotte_1572.gif
Repair Help & Product Troubleshooting for Toyota Land Cruiser

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 1977 Land Cruiser. I can turn the engine over but I am not getting spark to the plugs. I need to know how the wiring goes on the starter solenod.


That's a good question. There IS a coil wire on the solenoid to bypass the ballast resistor when starting. It is the black wire with a yellow stripe and it can attach to either the start terminal or the large starter terminal on the bottom of the s ... Toyota Land Cruiser

I need a wiring diagram for the spark plug wires. or from left to right from the spark plugs- to the bottom connections, how do i wire them. i need step by step directions for each spark plug wire. i need to know exactly where each one goes please and thank you. 1993 saturn sedan sl 1.9 litre single head


Http://autorepair.about.com/library/firing_orders/bl-saturn-firing-00.htm ... 1993 Saturn SL

Car will not start is has drained the battery it is now replaced. I have spark down to the plugs off of the distributor/coil assembly to all 4 wires... I am getting fuel I can smell it when I try starting the car.... I think I may need to have the starter checked I do not know where it is located on this vehicle....


Try kicking the gas tank on the drivers side, it could be a bad gas pump/ short, it really will start if this is the only problem, i had my stratus towed to the dealer because it wouldn't start, by the time it had been off loaded off the tow truck th ... 1998 Dodge Stratus

BATTERY DRAINING I JUST DROP IN A NEW MOTOR FOR MY GRAND AM BUT THERE WAS ONE LOOSE WIRE IM NOT SURE WHERE IT GOES NEAR THE STARTER, CRANKED UP THE CAR AND THE CAR RAN PRETY AS HELL FOR ABOUT 45 MINS BUT FOR SOME REASON MY BATTERY IS DRAINING ITS GOT A BRAND NEW ALTERANTOR SO I KNOW ITS NOTTHAT I NEED TO KNOW WHERE THE OTHER WIRE IS I BELIEVE ITS A GROUND WIRE BUT DONT KNOW WHERE IT GOES CAN ANY ONE HELP ME ?


That wire is the charge wire, what size is it? If it's a #8 loop it goes on the positive side of the starter the other end connects to the alternator output. If the starter has three wires one is BATT large one is Ignition or ING. Which is star ... 1999 Pontiac Grand Am GT

I need to know where the starter is located on a 2000 dodge intrepid. then i need to know where the positive battery cable starts. i know the it goes from the battery to the starter. how do i get to it.


There is a panel in the right side inner fender that you need to remove to find your battery[i know ,why why why].You may need to pull the right front tire off to gain access to it. ... 2001 Dodge Intrepid

There is a wire is the starter that needs replace but cant get to needing to know what the name of the wire is called. Its a copper wire thats connected to the starter


If it's a big wire about 1/2' thick, it is the battery cable from the battery positive post to the starter, it provides the heavy current to run the starter.\015\012Another small wire is the 12 volts low current that activates the starter relay ... 1998 Ford Crown Victoria

My roomie just bought an 87 dodge ram50 at an auction, they told him it ran, it doesn't (he shouldn't have trusted them, I know!). Anyway, I'm trying to diagnose why it won't start. While I know more than him about cars, I still don't actually know all that much. So far I have 1 checked for spark at the wires running to spark plugs (spark plugs look new), it has a good spark 2 put starter fluid as deep in the engine as I could get it, still wouldn't start 3 popped off the distributor cap


Pull all the spark plugs out, and pour a small amount of oil in every cylinder. If it cranks up, they're right: It's lack of compression. To formally test it, grab a Compression Tester, it threads into the spark plug. It should measure ~120-160 PS ... 1987 Dodge Ram 50

I screwed up my 1999 Saturn SL 1.9 SOHC spark plug wiring while trying to put in new one. I tried to do each one separately but the saturn's have a wiring holder i just couldn't get apart to do this. what I need is from left to right looking at the engine spark plugs which cylinder goes to which coil terminal from left to right. There are four coil terminals Please help I am desperate. I can get the car to start and run but it runs really really rough now and I dare not drive it. Stalke


... 1999 Saturn SL

I need some explanation on the firing order on the spark plugs and how to properly install them. Because my husband changed them out and now the van starts but won't turn over and go! I have the same problem . I know the firing order 165432 blazer zr2 2002 v6 but I would like to know how to place the wires on the distibutor also we have removed the distributor and I need to know the piston # one is tdc but know what to do with the distributor so I can get it back working thanks Dan


Your plug num,bers should be on the cap. ... 2002 Chevrolet Blazer

2002 pt cruiser non turbo died on me while driving yesterday ran some tests found no spark so replaced the coil packs wires and plugs. Still wont start. it cranks over the battery is fine the starter is fine there are no codes coming up on the obdII. Tested the three wires leading into the coil pack the middle (power) wire is getting continuity with the test light hooked up to neg and pos but the two outer (negative) wires are not getting any continuity. I am stuck and need serious help please


Crank sensor getting bad or is shot.This sends the power to the coil ... Cars & Trucks

Installing new starter on 2000 chevy venture... need to know where a yellow jacketed wire goes??? also, the "S" cable (wired mesh) is connected by itself with no other wires with it???? please help with where wires go !!! cant install till sure of where what goes...thx


... 2000 Chevrolet Venture

NO SPARK I have a 1992 Toyota Camry LE. that is getting no spark. I had someone look at my car and try to fix it and they said they put in a new starter relay, new cap and rotor, the whole distributor, ignitor pack, and new used computer and the car is still not getting spark. They are telling me i need to replace my engine wiring harness. Any suggestions?


I do not think the wiring harness needs replacing, although it may be a bad connection somewhere in a car this age. See herehttp://www.turboninjas.com/camry/ig. ... 1992 Toyota Camry V6

Need to know what gauge of wire goes from starter relay to the starter on my 2001 sunfire?? Need to rebuild fusable link!!


It is the batterys positive that goes directly to the starter fusble link? autozone is your best bet with friendly service and knowledgable people ... 2001 Pontiac Sunfire

When i turn the ignition, i get the normal chime, all the gauges reset, and then i hear a buzzing sound from under the hood, and the car won't start. when i looked into it closer, i discovered it is the fuel pump relay buzzing. i have replaced it twice, the starter, and all the spark plugs and wires, cause a friend of mine told me it might be a spark issue. none of these things have helped, and i'm told that it might be a ground wire. can anyone help with this? i need a description that i can ac


These GM's are famous for their side post battery issues. Double check your contacts at the battery first and then voltage standing. If it's below 11v replace it. ... 2003 Pontiac Sunfire

Need schematics for 1982 Ford with 351 engine . (hot rodding a 51 ford, and need to know engine wiring for ignition of a 82 351 cleveland) to get spark) It's got a distributor, and a 2 and 4 wire connector off the ignition module.


I worked at the library and you can go to the Reference section ( those books can't be checked out) but you can copy what you need, they have old repair manual that are extremely detailed at the professional level, pictures of schematics, complete br ... 1982 Ford F 150

Wires pulled from starter need to know what goes where, got the main to the battery and 1 smaller wire don't know if theres another or not.


It depends on the year model of the truck. Most have 3 wires. The large one to the battery, the second one feeds battery current to the wiring harness. And the third goes to the small bolt to activate the starter. ... Chevrolet 1500

I pulled the wires out of the abs plug that goes to the sensor im going to cut the other plug off and splice the wires together without the plug i need to know what i should pair the green wire to and what the yellow wire get paired with the other tto wires are black and white


Splicing your wires together will accomplish nothing but to waste your time.The sensors send an electrical signal to the computer.No signal means no ABS and the light will turn on.You will not get a signal by splicing the wires. ... 2007 Chevrolet Colorado (Extended Cab) New Cars

Wiring schematic i need a wiring schematic for a baja bv250 street bike. some one butchered the wiring and now i dont have any spark? does anyone know where i can get wiring schematics and or a service manual for one of these bikes?


... Cars & Trucks

I am going to install a new car stereo/cd player system. but my car wanst equip with one already. and i need a wiring diagram to try to sort out the wires and to know which goes were and why... can i get a wiring diagram anywere in the web.? 1994 chevrolet cheyenne K2500 4WD Single Cab.


All you need to do is go to the parts store, and get a wiring kit for your vehicle. It will plug into the factory harness, and the colors on the new pigtail will be same as the aftermarket c/d player. Hope this helps. ... 1994 Chevrolet K2500

I need to know if a 2001 pt cruiser motor will go in 2005 pt cruiser i just put the motor in the car but i notice the crank shaft sensor was on the back side of motor near altanotor i extende the wires to reach but i don t know if you use the old sensor right now i cant get no spark dont know


... 2001 Chrysler PT Cruiser

WIRE PROBLEM I have restored a 1948 jeep willys cj2a and now ready for the elec. and only have some factory to go from. need to know the location of wires from dimmer switch,brake switch,key switch(three wire),push button start & fuel gauge. the system is 6volt and has a 6volt starter relay being used. (I have all new parts)but I can only get the headlights,park,& ammeter to work.


. The company in the link below will have everything u need, harnesses and info on how to hook them in.\015\012\015\012http://www.tellico4x4.com/i ... Jeep CJ

Cant get starter relay wired properly dont know which wire goes where


Hey Mark,Dark Green from ignition and Black/White go to relay coil.Red from battery to relay commonDark Green from starter solenoid to relay N.O.Mike ... 1986 Jeep Comanche

1996 izzuz hombre ... turns over wont start sometimes . sometime does start. when start runs real rough, missing. things i know - new starter, new fuel pump, doesnt fire on 1st spark plug and no one know why. right now just turning over but wont start PLEASE HELP ME I NEED TO GET MY KIDS TO SCHOOL!


Your problem sounds like the distributor, points and pig tail wire.I suggest you try changing the distributor / servicing the points and pigtail wire.The reason why p 1 inst firing is cause it isn't getting any power from the distri ... 1996 Isuzu Hombre

I Have a 2000 Chevrolet Cavalier that someone replaced the starter. It wasn't installed correctly and I need to know what wires go where so that I can get it started. With a battery boost the car powers up, but the starter does nothing when the ignition is turned on


There is only one way to hook the starter up. You have a big wire and a small on or a plug in harness connector. If they were hooked up wrong you would have major electrical damage. I bet you have a igniton swith issue if the batterys test good o ... 2000 Chevrolet Cavalier

I have a 92 toyota corolla that i just replaced the starter on and i need to know where the clip on wire thats on the starter goes to


... 1992 Toyota Corolla
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.2733 seconds