Having problems with your Suzuki Cars & Trucks ?

Emission control problem - Suzuki Cars & Trucks

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

And what is the problem.
the test failed.
and if yes, what were the numbers. post the numbers for
HC, CO, O2, NOX.
the numbers speak , volumes.
Repair Help & Product Troubleshooting for Suzuki Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Emission control problem - Suzuki Cars & Trucks


And what is the problem. the test failed. and if yes, what were the numbers. post the numbers for HC, CO, O2, NOX.the numbers speak , volumes. ... Suzuki Cars & Trucks

Emission control light is on - Suzuki Cars & Trucks


Hi there:Sound like a fault in the emission control system. When this \012happens, the computer that controls the emission system usually has a \012backup program that runs while the fault is present. (These backup \012programs are often refe ... Suzuki Cars & Trucks

Emission control system Light has come on - it this a serious problem? Car going in for full service and MOT 21/2, will this be covered SUZUKI ALTO


Its likely to be your EGR (exhaust gases recirculation) system blocked or just a valve malfunction.\015\012Since you are going for a full service ,they should sort it out by either cleaning the egr valve or replacing it.\015\012Your car w ... Suzuki Swift

Emission test hello I went to emission test today they could not perform the control because the traction control is engaged , when the car run on the street, the light is off and i can engage or disengage the traction control any time i want , the problem happen only at the emission test


Why aren't they just using the OBD II port instead of the dynomometer? Which state are you in? In Washington, where I work as an emission test specialist, we don't even use the dyne (rollers) to do the test. The OBD II port doesn't require the car to ... 2001 Hyundai XG300

I have a suzuki grand Problem with the Suzuki Grand Vitara Cars & Trucks i have a suzuki grand vitara 1.6v petrol 2004, yesterday the temperature gauge kept going up to just under the red and then back down to the middle then a few minutes later going back to the under the red and then back down. this has never happened before. i have checked and there are no water leaks. none of the fan belts have snapped but when i start the car up the water does not seem to be pressurising?? could this be


Thermostat! ... 2004 Suzuki Grand Vitara

HERE'S A PROBLEM, SUZUKI GRAND VITARA 2006 WITH A CODE P0174 AND WHEN THIS MALFUNCTION INDICATOR LIGHT CAME ON MY CRUISE CONROL QUIT WORKING AT THE SAME TIME. THE MALFUNCTION INDICATOR LIGHT IN THE BOOK IS FOR THE COMPUTER-CONTROLLED EMISSION CONTROL SYSTEM. aND NO PROBLEM WITH THE FUEL FILLER CAP. AND TWO WHEEL DRIVE VEHICLE.


Here is a site that should help. If I could hook my scanner up I could tell you in minutes if the O2 sensor was working by watching the data stream. the code means you are running lean on the #2 side. This can be caused by a vacuum leak or even a bad ... Suzuki Grand Vitara

Car codes Had a problem with my 2001 lexus. VSC and check engin light on. Had car hooked up to a computer and got these codes....p0440 emission control malfunction.....p0441 perge flow fault.....p0446 vent circuit malfunction...how do i know what the code problems mean.


When you have P0440, P0441 and P0446, it is a very good bet that the fuel cap was loose, or the fuel cap rubber seal is compromised. You will get all three of those codes every time that the cap is loose. Always make sure that the fuel cap is as tigh ... 2001 Lexus RX 300

I have a 2001 Oldsmobile Alero. The ignition control module fuse blows when u try to crank the car. I put a higher amp fuse in the place or the fuse, and it has blown 2 control modules. I dont have any codes coming from the car. I have replaced most of the sensors trying to fix this problem. Please help.


... Oldsmobile Alero

I tried to charge my car battery with a Chicago Electric charger model 66783. I followed the directions for charging the battery in the vehicle. After selecting the charge rate of 10 AMPs, the ammeter pulsed back and forth between zero and about 9 AMPs. The 'Charge Complete' light cycled on and off also. This is not consistant with what the directions describe is supposed to happen. Do I have a charger problem or a battery problem? I have not driven my vehicle (1954 Chevy truck) for about 6 mont


Relax, the charger is working fine. What it is doing is charging the battery to 15.5V. During this time, the "charge complete" LED is off, and the current meter shows the needle going to the right. When 15.5 volts is reached, the current is shut of ... Chevrolet Classic

1997 jaguar xj6 passenger side engine bay fuse box fuse # 10 IGN control (low current) 5 amp blows as soon as turn the key then the battery drains and car dies what is happening and how do i fix it. Also does this fuse have anything to do with the key tumbler because my new problem is now when i start the car i can take the key completly out and the car will still run and drive even though there is no keys i must remove the battery cable to turn the engine off. do i need a new tumbler or could i


The fuse failure is a direct result of a short to groundthe car running after removing the car is a tumbler issue or an ignition switchhowever, looking at both concerns you can speculate that the ignition switch is the source ... Jaguar XJ6

1997 jaguar xj6 passenger side engine bay fuse box fuse # 10 IGN control (low current) 5 amp blows as soon as turn the key then the battery drains and car dies what is happening and how do i fix it. Also does this fuse have anything to do with the key tumbler because my new problem is now when i start the car i can take the key completly out and the car will still run and drive even though there is no keys i must remove the battery cable to turn the engine off. do i need a new tumbler or could i


Chances are its a shor on the tumbler involving the ignition wires that are also connect to the tumbler..I'll suggest you replace the tumbler.. ... Jaguar XJ6

1997 jaguar xj6 passenger side engine bay fuse box fuse # 10 IGN control (low current) 5 amp blows as soon as turn the key then the battery drains and car dies what is happening and how do i fix it. Also does this fuse have anything to do with the key tumbler because my new problem is now when i start the car i can take the key completly out and the car will still run and drive even though there is no keys i must remove the battery cable to turn the engine off. do i need a new tumbler or could i


I think your thumbler is shorting and blowing the fuse..; replace the tumbler..your ignition is wired to the tumbler.. if thats shorting it will explain your issues. ... Jaguar XJ6

Electrical problem 1997 jaguar xj6 passenger side engine bay fuse box fuse # 10 IGN control (low current) 5 amp blows as soon as turn the key then the battery drains and car dies what is happening and how do i fix it. took out battery completly charged it and when i re hooked it up imediatly without even putting key in or anything my cooling fan and instrument pannel lights came on then when i went to start car the fuse reblew and when i went to shut car off turned key off and removed key the en


Your ignition likely is shot and will need to be replaced ... Jaguar XJ6

Wont take fuel took to auto zone and 4 codes came up P1404 auxillary emission control-P0442 small vacuum leak-P0340 camshaft sensor-P1507 vehicle speed control. Can I replace these parts myself? Does any one part fix two or more problems? Car runs good! just wont take fuel from pump only half gallon at a time. Also a little surge idle is felt on idle at light I think or coasting with brake on. Those are the only two performance issues and both are minor. I would like to fix this my self if I cou


I would try to find and fix the vacuum leak, as this will be causing other problems, like the emission control.. other than that I am afraid I can be of little help. ... 2000 Hyundai Accent

Check engine light on and car will hesitate when accelerating. When driving at steady speed rpm will go up a little then back down and it will affect cruise control. Checked code on the engine light and it says emission problem. Can you pin point the problem


I would check the codes and tht will tell you which component has failed ... 1999 Chrysler LHS

How change 80 amp fuse suzuki ignis - Suzuki Cars & Trucks


... Suzuki Cars & Trucks

2005 suzuki swift starting problem - Swift Suzuki Cars & Trucks


... Suzuki Swift

Starter 20 amp fuse blows some times when starting car, replaced starter it helped but did not solve problem. It blows most the time after it has been driven and shut down for a short time. Was told that ECM controls voltage /amps going to the starter solenoid and may be problem, or starter has or is going bad again


The pcm does control the voltage from the altenator through the electrical system. Chances are the pcm is going bad, need to have it checked and or replaced to correct the problem. Check the electrical wireing from the battery to the starter solenoid ... 2001 Dodge Stratus

FORD ESCAPE EMISSION CONTROL WARNING LIGHT PROBLEM: I have a Ford Escape XLT, 6 cylinder, 2002 model, and the above warning light comes on, on the dash. The problem is, that it only comes on after the car has been started, but once this light is on, it says on for a long period of time. I have been advised by a mechanic that it could be the Oxygen Sensors, so I have had these two replaced, but this light still comes on. Do you agree with the opinion of this mechanic, or do you think it could


There is a problem being logged into your computer for the light to be on. Take a little advise and check your local parts stores for a code reader. Some parts stores will hook to your car with their reader and tell you the problem. If the mechani ... Ford Escape

Fault code F0441 "EVAP Emission Control system purge flow fault" for a 2000 Hyundai Elantra. When fueling up with car shut off it is hard to restart once fueled, but if I leave the car running it isn't a problem to go. Also causing studder during acceleration from stop.


\015\012\015\012P0441 : Evap. Emission System Incorrect Purge FlowGeneral DescriptionThe evaporative emission control system prevents hydrocarbon (HC) vapors from the fuel tank from escaping into th ... 2000 Hyundai Elantra

MY CAR IS A HYUNDAI 2003 elantra my problem is engine lite is on dtc po446 evaporative emission system vent control circuit i like get some anwer cause my last question where, answer was needthey. ask mi for all information already posted and i do and ,was ignored please tel me where the vent control is located also my air bag,lite is on with dtc (1) flash on dash board


Your post is fairly vague...a P0446 can be caused by many things including but not limited to a defective gas capto diagnose you need a factory scanner and a "smoke machine"with these two you can control the system and f ... Hyundai Motor 2003 Elantra

FORD ESCAPE EMISSION CONTROL WARNING LIGHT PROBLEM: I have a Ford Escape XLT, 6 cylinder, 2002 model, and the above warning light comes on, on the dash. The problem is, that it only comes on after the car has been started, but once this light is on, it says on for a long period of time. I have been advised by a mechanic that it could be the Oxygen Sensors, so I have had these two replaced, but this light still comes on. Do you agree with the opinion of this mechanic, or do you think it could


... 2002 Ford Escape

I own a 2003 Kia Spectra I have owned the car since 2005. Every 6 months or so the emission control light comes on on the dash and the car shudders sometimes whilst driving and it will just cut out which is quite dangerous. I have taken it to my local Kia dealer a number of times and they have advised that it doesn't show up a code so they cannot fix the problem. What could this be??


I have seen this problem before ,the dealers are pretty much useless in diagnosing the problemIm about 90% sure the problem is within the exhaust system more to the point the catalytic converter .What is happening ... Kia Spectra

I have a 1997 Ram that i just picked up. Car ran great during test drive but vehicle was already up to temperature. Its running at about 200. When i cold start the vehicle it will idle but when i put it in gear to drive when ever I stop it wants to stall or will if i dont give it a little gas. The minute the truck reaches temp the problem is gone. Any ideas truck has new plugs, wires, coil. Thinking maybe idle control, throttle sensor? any ideas. thanks


Well youre in the right area check with the dealer there may be a sensor for the cold mode like a choke that is not working ... 1997 Dodge Ram 1500 Club Cab

Suzuki fuel problems - Suzuki Cars & Trucks


It can be low fuel pressure or clogged fuel filter or worn out fuel pump.Check the help links mentioned below to troubleshoot the isue:----FUEL SYSTEM PROBLEM\012\012--------\012\0 ... Suzuki Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6916 seconds