Having problems with your Subaru * Legacy ?

How to fix code c0109? - * Legacy Subaru Cars & Trucks

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Subaru * Legacy

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to fix code c0109? - * Legacy Subaru Cars & Trucks


... Subaru * Legacy

Fix for fault code p2138 - Legacy Subaru Cars & Trucks


... Subaru Legacy

How to fix subaru legacy speedometer - Legacy Subaru Cars & Trucks


... Subaru Legacy

1999 subaru legacy outback wagon P1443 code - Subaru Cars & Trucks


... Subaru Cars & Trucks

Fault Code P1307 - Legacy Subaru Cars & Trucks


... Subaru Legacy

Fault code p0223 - Legacy Subaru Cars & Trucks


... Subaru Legacy

Code 66 turbo's not boosting - Legacy Subaru Cars & Trucks


Could be a vacuum leak look for any hose that goes to or from the turbo make sure that its not cracked or missing to include the cold air intake tube (black accordian) usually deals with the air filter as well. ... Subaru Legacy

My car is kind of getting wrecked. I dont know if it is me or the mechanics i take it to. i spent $500 for them to fix some leakish or overheating problem. after i got it back my pwer steering was too hard to turn and i payed them 185 to fix. Now my power steering is playingup again. question is,should i take to a Subaru Specialist or get a new car.its a 2000 Subaru Legacy Gt Wagon Tiptronic. And also my turbo does not kick in so my car goes real slow uphills.


To be honest, ide take it to another garage, getting another car i think sounds more expencive than getting the work done, but deppends on what other car you are going to get, so realy, it would be up to you...hope that helps ... 2000 Subaru Legacy

Bad head gasker on a 2001 subaru legacy - Legacy Subaru Cars & Trucks


... Subaru Legacy

Diagram 1997 subaru legacy gt motor - Legacy Subaru Cars & Trucks


... Subaru Legacy

1999 SUBARU LEGACY WILL NOT TAKE GAS - Legacy Subaru Cars & Trucks


... Subaru Legacy

Ecm fuse location on a 1993 Subaru Legacy - Legacy Subaru Cars & Trucks


... Subaru Legacy

99 Subaru Legacy timing belt diagram - Legacy Subaru Cars & Trucks


... Subaru Legacy

Subaru legacy 1996 fuel intake diagram - * Legacy Subaru Cars & Trucks


... Subaru * Legacy

1996 subaru legacy automatic no reverse - Legacy Subaru Cars & Trucks


... Subaru Legacy

1999 Subaru legacy power steering - Legacy Subaru Cars & Trucks


... Subaru Legacy

2001 Subaru Legacy L runs rough. I think that it is getting hot. I get a number 4 misfire code. I drove the car for about 7 minutes with my scanner on it and it said that the water temp got up to 202 degrees just before I shut it off. The fan never kicked on and the temperature gage in the car just read normal. I open the radiator cap and nothing shot out. The coolant was a little warm. Could it be the water pump or the thermostat? I just replaced the knock sensor because I got a code.


202 degrees is not hot at all,check the fuel for contamination,coil boots and spark plugs,this is the most likely causes for the miss fire,also,the coolant sensor can cause the problem. ... Subaru Legacy

Looking for Subaru Legacy B4 2005 MANUAL - Legacy Subaru Cars & Trucks


... Subaru Legacy

3rd generation subaru legacy owner's manual - Legacy Subaru Cars & Trucks


... Subaru Legacy

Wiring diagram for subaru legacy - Legacy Subaru Cars & Trucks


I need the wiring diagram for the radio on my1991 subaru legacy. can you help ? ... Subaru Legacy

1996 subaru legacy workshop manual - Legacy Subaru Cars & Trucks


... Subaru Legacy

I have a P0106 error code on my 97 Subaru Legacy Outback. I just had a valve job done on the heads. I put the engine back together and put it back in the car, taking great care in the process. All hoses and wires were reconnected properly. The car runs fantastic. The only problem is the "check engine" light, P0106 error code. Would the pressure sensor go bad all of a sudden? Is there something I missed?


Using a scan tool, watch the MAP sensor value with the key on, engine off. Compare the BARO reading with the MAP reading. They should be roughly equal. The voltage for the MAP sensor should read approx. 4.5 volts. Now start the engine and look for a ... Subaru Outback

Clutch judder and squeaking subaru legacy - Legacy Subaru Cars & Trucks


You will have to change the clutch pressuse plate, bearing,and clutch disc and i am sure your problem will be all over. ... Subaru Legacy

I need a manual for a 1992 subaru legacy rs - Legacy Subaru Cars & Trucks


Cna check this link about Subaru (Go to "Activate" and register) or visit autozone.com (free register) and select the year, make, model and engine size for free ... Subaru Legacy

Timing chain on a 95 subaru legacy wagon - Legacy Subaru Cars & Trucks


What about it? this engine uses a TIMING BELT. ... Subaru Legacy
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.8091 seconds