Having problems with your Subaru Cars & Trucks ?

Install Windshield Trim 1997 Subaru Legacy'

\015 Install Windshield molding\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Subaru Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Install Windshield Trim 1997 Subaru Legacy'


... Subaru Cars & Trucks

I lost my only key to my 2003 Subaru Legacy GT. I believe the key had chip installed in it. How do I get a new one? Problem is, I am military and stationed in Germany. The vehicle was purchased in Japan (Japanese spec). There is a local Subaru dealership in this area but they are telling me to go to the dealership where i bought it and get a new one--which is impossible! Plus I purchased it from a personal owner. Can I purchase a new ignition and have installed? I even called a locksmith


In most cases you can\015\012get the key made from lock smith and get it reprogrammed at the dealer. They\015\012charge it for reprogramming but it works. But if the dealer as well as the\015\012locksmith both are saying that they cannot mak ... Subaru Legacy

1993 SUBARU LEGACY CRANKSHAFT PULLEY IS OF BEFORE FINDING TOP DEAD CENTER WHAT MUST I DO TO PROPERLY INSTALL THE CRANKSHAFT PULLEY IN RIGHT POSITION AND DOES THIS PULLEY GET A KEY STOCK INTO THE SLO


... Subaru GL

Install o2 sensor subaru legacy 200


... 2000 Subaru Legacy

Windshield of subaru legacy 1998


VYRON, the best place to buy the windshield price wise would be an auto salvage yard. Many have an internet database they can check to look for your windshield at other salvage yards, so you don't have to run around to different places looking, they ... 1998 Subaru Legacy

I have a 1997 Subaru legacy Outback. It has a Subaru alarm installed by original owner aft purchase. Didn't know alarm was there till car wouldn't start. Parking lights flashing, clicking noise, no turnover. Was told it had locked me out. Turned key 3 times fast


... 1997 Subaru Outback

How to install power steering pump in legacy - Legacy Subaru Cars & Trucks


... Subaru Legacy

I have a 1997 Subaru Legacy station wagon. My check engine light, and Battery icon light are on indicating an electrical problem. I've had to jump my car repeatedly in order to get it started. I purchased and installed a brand new battery from Auto zone. Although I was able to star the car the "lights" (engine and battery icon) are still on indicating that maybe the alternator is bad. Since my funds are low at this moment I'm unable to purchase and install an alternator and I have to use t


On a battery there is a plus + and minus - plus is generally red and minus or negative is generally black. if you have hooked them up you will likely blow the main fuse. you mention it will not start... does it even turn over ? also autozone will ... Subaru Legacy

I just install the timing belt on my 2003 Subaru Legacy, following the Haynes instruction manual. The engine turns easy by hand turning, can I try to start before, install the radiator and all the other parts?


Yes, you can start it, but I think I would put the radiator back in first, there really was no need to take it out actually, just the shroud and cooling fans should give you enough room to get the timing exposed. ... 2003 Subaru Outback

97 subaru legacy outback, two alternators test OK at autozone and advanced. When installed and tested no voltage is detected...new battery installed also, noticed the ground at the starter where the wire from the battery connects glowing while jumping the car when the battery ran dead from the alt not working...any suggestions would help..thanks


The ground cable is bad,replace it and you'll be good as new. ... 1997 Subaru Outback

Install Of Aftermarket Techometer In 1990 Subaru Legacy Sedan


On the negative side of the ignition coil ... 1990 Subaru Legacy

96 subaru legacy timing belt install


Its all in the name ... 1996 Subaru Legacy

Cambelt installation problems on a subaru legacy 94


There is a belt tensioner on the front of the engine block that needs to be taken off and compressed(use a vise if possible) you can use a small allen key or something of similar size to lock piston intoethe compressed position . Then reinstall. I a ... 1994 Subaru Legacy Outdoor

1996 Subaru Legacy Outback will not stay running. It was running just fine before I changed the oil and air filter (the correct oil and air filter were installed). I checked the areas where I was working to make sure no vacuum lines were disconnected. When I start the car I have to keep my foot on the accelerator to keep it running. It really sounds like it is missing.


Make sure wires for the Airflow sensor are hooked correctly. They are the the wires hooked to the aircleaner tube. Hope this helps and good luck.Have a great day. ... 1996 Subaru Legacy

How to install air fuel ratio sensor in subaru legacy 2004 turbo 2.0l


... 2004 Subaru Legacy

1994 subaru legacy wagon 2wd auto leaking oil, after installing new valve cover gaskets, cam seal, and timing belt.


Probably resulting in bad instalation !\015\012i sugest you to klean the area with large amount of break kleaner and then drive the car to find the exact location of leakage to make the repair easy ...could also just try to tigntnig a bit all t ... 1994 Subaru Legacy Outdoor

Morning - trying to remove rear light on Subaru legacy estate 1997 to fit towbar wiring - any ideas? have taken quite a bit of trim off to access and loosened two bolts appearing to be holding light on but wont budge ! thanks


... 1999 Subaru Legacy

I recently installed a transmission in my 98 Subaru Legacy L Sedan 2.2 L engine. the tranny pan is leaking. I removed the pan and cleaned off the old gasket material and used silicon to reseal and it is still leaking. I need to know the torque specs as to what it needs to be tightened to.


Install the oil pan assembly. Tighten the bolts to 36–48 inch lbs. (4–5 Nm). ... Subaru Legacy

Subaru Forester 2006, 2,0, lpg converted.Now 67 000 km. Recently instaled FlashLube with injector. Please, could you tell me when and if should I adjust the valves. The car is running fine.


... 2006 Subaru Forester

1997 subaru legacy 2.5 emission code P0170 fuel trim 1 ,2 . how due you correct this?


If I am correct the po170 code is a lean condition. Usually this is caused by a cracked air duct leading to the air filter. Or the air filter box is not secured properly. I work in the service department at subaru and when we do big services we do ... 1997 Subaru Legacy

How much time does it take to install a starter in 1991 Subaru Legacy?


About an hour ... 1991 Subaru Legacy

Recently, I bought a Jaguar 2003 X-Type with 2.5 liter engine. It was used with only only 75,000 miles. It was missing the ower's user manual. I need the user manual and a repair manual, if available at reasonable price. The Jaguar leaper came off without any damage other than the wire that normally secures it to the hood. I need diagram and installation information so that I replace it properly. I also noticed that the black windshield trim on driver's side that hides the edge of glass is missi


The Leaper Emblem will come with the wire attatched and is mounted with the bolts if the wire is seperate from the emblem it is broke at that end , the trim can be ordered from a dealership or check E-Bay , the emblem should come with instructions bu ... 2003 Jaguar X-Type

Car does not start, Lights work, makes no effort to turn over will not Jump start. 98 subaru legacy outback. Sometimes it starts and sometimes it doesnt. I have had a new battery, starter and alternater installed. when the car doesnt start it usually needs to sit for an hour and it starts right up. It happens more often during the day when the car has been used. however; it often want start early morn or late evening when it has sat for a while and it's not hot outside. when it is not feeling l


The culprit would be the route from the ignition switch to the starter solenoid, but there are a lot of areas that causes the problem and in between the route i mentioned there a lot of contact point to check on that may need physical check-up or dia ... 1997 Subaru Legacy

How to install front windshield trims on a 1967 Ford Mustang


There should be several clipps around the glass. It has been a few years since I did my 67. You should be able to press down and wiggle the trim till it pops onto the clipps. The trim has a small groved edge on the back that the clipps grab onto. The ... 1966 Ford Mustang

1998 Subaru Legacy - dealer installed alarm sounds when in valet mode. siren and lights - not the horn


... Subaru Legacy
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0779 seconds