Having problems with your Skoda Octavia ?

How do i replace rear brake pads on mk1 skoda octavia vrs

\015 Mk1 skoda octavia vrs\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Skoda Octavia

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do i replace rear brake pads on mk1 skoda octavia vrs


... Skoda Octavia

2007 uplander rear brake repair - what type of brake pads came as original equipment? Ceramic or semi-metalic? The dealer service states that the original were semi-metalic. I've replaced the front pads twice and replace the front rotors once. Does anyone have any photos of the stages of rear brake pad replacement? An inspection at the dealer resulted in their suggesting replacement of both the rear brake pads and rotors. Where may rear jack stands be placed in order to service the


Pads last about 20k, rotors about 40,for the fronts and about 30/50 for the rears,they are all semi metallic.if you look under the car you will see the places for the jack(not to be used when working on the car OTHER than replacing a tyre.)for all ma ... 2007 Chevrolet Uplander LT Minivan

I have a 1996 Chrysler Town & Country. The front brake pads were replaced about 3 months ago, the rear pads were replaced about three weeks ago. The brake lines or cylinders were not touched. I experienced a total loss of braking about two weeks after the rears were replaced. Took the van to Big O. They replaced the rear cylinders and completely flushed the brake fluid. The van now has a hard pedal the first time you press it, then goes to the floor if you release the brake and press it agai


All this is because the brake lines have not been 'bled' properly. That's why when you pump the brakes, it changes how they feel. Air in the line does that. Have them bled again. ... Chrysler Town & Country

Rear brake lights not working have replaced brake light switch,checked bulbs and fuses, skoda octavia


... Skoda Octavia

1998 S10 Blazer 4x4 Rear disc brake pads worn out so I replaced pads Now the brakes stick bad enough to smoke badly after just 2 miles on both wheels . I really thought this this would be just like front disc pads as ive replaced prob a 100 of those over the years. Never had a rear disc brake car. What am I doing wrong? Thanks for any help [email protected] Mo


Make sure all the caliper slides are free from rust and make sure they are lubed. It sounds like the caliper isn't floating on the bracket. ... Chevrolet S 10

Troubled brakes ok had a mechanic replace brake pads on my 05 liberty 4 wheel drive all disc brakes. a week later rear calipers locked up i loosend brake line took a pry bar and was able to release brake caliper. i then drove home with front brakes the next day sunday i replaced calipers pads rotors tried to bleed system and was unable to so i called the mechanic who replaced the pads and i explained the situation he drove it to his garage and said it was a master cylinder i said cant be but i s


TAKE IT TO THE DEALER, SINCE VEHICLE HAS ABS SYSTEM . THE BRAKES MAY NEED TO BE BLEED WITH DRB/SCANNER. OR YOU MAY HAVE LINES CLOGGED. ... 2005 Jeep Liberty

REPLACED FRONT AND BACK BRAKES ON VEHICLE. HAD ROTORS MACHINED AND PUT BACK ON THE VEHICLE ALONG WITH NEW BRAKE PADS. THE ENTIRE CAR SHAKES WHEN I APPLY THE BRAKES AT SPEEDS IN EXCESS OF 15 MILES PERR HOUR. THE SHAKING IS NOT IN THE STEERING WHEEL. THINKING IT WAS A FRONT END PROBLEM I REPLACED THE FRONT ROTORS AND PADS AGAIN. BEFORE I REPLACE THE REAR ROTORS AND PADS WHAT COULD STILL BE CAUSING THE PROBLEM.


Hi,\015\012\015\012This is an extremely annoying problem especially as you have already replaced the components most likely to be causing it. A few quite often undervalued issues can be causing the symptoms you describe.\015\012 ... Cadillac DeVille

Hi i have a 1995 cheverolet silverado 1500. For years i've had the problem of a really soft brake pedal that goes all the way to the floor before it brakes. It has abs, front disc brake and rear drum brakes. I have recently replaced the front brake discs and pads and rear brake shoes and drums. We then went on to replace the brake master cylinder and the brake booster but it still has the same problem even with numerous number of attempts to bleed the brake lines. There is no air in the system t


If you haven't already, check your rubber lines for weakness; they could be ballooning under pressure. ... 1995 Chevrolet K1500

What should a rear brake and rear rotor replacement job cost for a 05 denali. Job description reads: replace rear disc brakes with new pads. lubricate & inspect caliper and mounting hardware, refill brake fluid, adjust parking brake. Road test.


Depends on cost of pads in your area of town ,but for doing a job like this ,well if takes more than an hour to do i would sack the mechanic ,sounds like a dealer job to me with dealer waffle and dealer prices for being good with a pen .i would charg ... 2005 GMC Yukon Denali

Pontiac Vibe 2003. After a full stop of the car, there is a slow lowering of a pedal of a brake. At emergency braking the brake system works normally. Front pads and rotors are replaced, rear pads and drums are replaced. The main brake cylinder is replaced. Where is a problem? Thanks Sincerely yours Dmitriy


If there are no fluid leaks than I would bet you replaced the master cylinder with a re-manufactured unit instead of new. The re-manufactured ones are fine as long as you don't mind trying several of them to get one that works. If it is re-manufactur ... Pontiac Vibe

How do I replace brake pads on skoda octavia 2007


... Cars & Trucks

Rear brake pad replacement instructions for mk1 focus st170


Hi. I have just changed my rear discs and pads on my ford racing puma. I wound the piston back as far as it will go, once the pads are in and bolted up the wheel will not turn even though the handbrake is not on.. Have I missed something or do I need ... Ford Focus

2001 yukon xl pings a lot but never sets a code, also after i replaced the rear brake pads and park shoes, the right side has worn out the pads and left side is hardly worn, replaced again and right rear again is throwing off tons of brake dust like it's doing most of the breaking.


... 2001 GMC Yukon XL

Rear brake pad dragging. I recently replaced the front and rear brake pads on my 2000 chevy silverado 1500 truck. The driver side rear brake seems to be dragging and getting hot. I removed the tire and caliper again but did not find anything wrong. Any suggestions?


ADJUST THE BRAKE CLEARANCE ON ALL FOUR WHEELS. ... 2000 Chevrolet Silverado

I have had a pulsation in the rear in my 2002 f150. I had the front and rear rotors and pads replaced and also had a bad passernger side rear bearing and axle replaced. The Pep Boys that did the job scratched their heads and gave me a credit on the brake job and sent me packing without the problem being fixed. They said they looked at the abs sensor but really wasn't trained at that. The abs light has bever came on anyway. It still pulsates and rear ends feels like it is hopping when I brake, Go


You may have loose universal joints check by blocking tires and putting the truck in neutral grab the drive shaft and push and pull with both hands to check for play at the universal joints front and back, the only other thing that comes to mind is a ... Ford F-150

Had a backyard mechanic replace the rotors and brake pads on my 93 New Yorker. Prior to job my left rear brake was metal on metal. Immediately following the job, that same left rear brake pad won't release from the rotor(disc). Note...I didn't see the brakes bled when mechanic completed job.What might be the problem? God bless, Doc


Most likely, and especially if that pad wore completely out and the other pad had substantially more material left on it, the caliber needs to be rebuilt or replaced. The piston inside the caliber can not release and that has nothing to ... 1993 Chrysler New Yorker

How do I know if my rear rotors on my 1997 chevy need replacing? I am hearing a noise when I brake. I have had my front pads replaced rear brakes cleaned. It was thought to be rear drum on right side but once rear drum was put on it still made the same sound? Please help if u can.


If your rotors are really shiney "glazed" it is recommended to have them turned or replaced. Is ita screaching noise or grinding? ... 1997 Chevrolet Lumina

Brake question Does the 2003 Ford Taurus have rear brake pads or shoes?Also, if they have gone to the point that the brake pedal has to be pushed all the way to the floor and the rear brakes are screeching does that mean that the drums will have to be replaced as well as the pads or shoes?


Give these websites a try www.alldatadiy.com and www.autozone.com and ... 2003 Ford Taurus

Hi,my 1992 dodge dakota 4x4 extended cab with a 318 engine is giving me problems!! The brake light and anti lock lights are both on,brakes were working but I found a leak in the rear brake line. Replaced rear shoes,rear cylinders,rear brake lines,front pads and master cylinder. Bench bled the cylinder and then after installing I bled all the lines till there is no air and only clear brake fluid. Tested the power assist and it holds a vacuum. When the engine is off I can get resistance and the br


... 1992 Dodge Dakota

Just replaced rear pads now it feels like i have air in the line, the pedal goes about 3/4 of the way down. i used a tool to turn the caliper piston in until it seated then put the pads on. now the abs light is on and the brakes feel spongy,the abs light went out after i replaced the pads now it is back on. I also here a click in the middle console when i push the brake pedal


The click is normal. That is the brake switch releasing the shifter so you can get it out of park. Did you open the bleeders when turning the caliper back in? If so you may have gotten air in the lines. Also there are two slots in the caliper piston ... 2000 Volkswagen Beetle

I recently replaced the rear brake pads on my daughters 06 tiburon. Couldn't get the rear passanger and front drivers to bleed cuz she was saying they brakes were spongy afterwards. Replaced thr rear passanger caliper but the main line is acting plugged and same with front drivers. Took it to firestone and they were clueless. I could use some advice asap. She has a new baby and is afraid to drive it now


Replace the rubber brake hoses. sometimes those swell and won't let fluid through. open bleeder valve and let run for 10 mins each side. make sure master cylinder is topped off. if no fluid, slowly pump pedal until fluid runs out. then let run for 10 ... 2006 Hyundai Tiburon

Had pads and rotors replaced at a local shop that I have been happy with for other services... Found squeaking from right rear and pulsing in the brake pedal with wheel revoultions during braking afterward. Took it back to the shop numerous times but they did not solve the problem, though they replaced the pads with higher quality pads. I suspected the rotors, so swapped them, and the noise moved with the rotor, to the left side... Found that the lug holes in the rotors were larger than


A lot of vehicles have nothing but the wheel nuts holding them tight because the actually caliper will hold them tight and aligned as well. What I would be concerned with is the fact that the diameter of the lugs seems larger. I would strongly sugg ... 2004 Ford Windstar

I am replaceing rear disc brake pads on a 2007 ford exp do i have to or sould replace the brakes in side the rotor? they look like only enmer, brake pads?


If there not worn just adjust them, if worn replace them you will the parking brake for inspection. ... 2007 Ford Expedition EL XLT

Brake pedal needs to be depressed very hard to stop,pedal is mushy,pads and shoes have been replaced, rear wheel cylinders have been replaced.calipers have been replaced, front brake lines have been replaced,master cylinder has been replaced,brakes have been bled till they run totally clear. seems like front brakes will lock up on snow and ice and skid this is a 1996 suburban k1500 with 112,000 miles,I'm completely stumped what am i missing?


The pedal goes down a long way(Rear brake shoes out of adjustment) or the pedal is hard to push and you have to about use two feet to stop the truck? (booster problem) ... 1996 Chevrolet Suburban

Replace rear brake cyllinders, rear brake pads, tank and left driveshaft


Rear brake cylinders are straight foward you shouldn't have any probs withe brakes side of things. the drive shaft bolts on and off with no problems forseen i have done many just take your time and think before you act good luck ... 1986 Honda Accord
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.5759 seconds