Having problems with your Oldsmobile Intrigue ?

The back blinkers work but not the front would that be the blinker flasher

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Hi,

When the right side turn signals do not work you still hear the clicking, but the indicator and the front and rear bulbs do not illuminate?

According to the schematic, since you can hear the clicking and the cornering light illuminates, that partially rules out the turn signal switch. There are two separate circuits from the switch so you will need to test the second one.

There is a purple wire coming from the hazard switch and going to the turn signal switch. If you have power on this wire with the key on and the turn signals on then chances are likely that there is a problem in the switch. You can verify this by checking power (output side) on the dark green wire coming from the turn signal switch.

If there is power on purple wire, but not on dark green then replace the turn signal switch.

If there is no power on the purple wire I would replace the hazard switch.

If you have power on both wires when the turn signal does not work then you may have a problem where all the wires splice together (we will check that if we have to).

Something you can try: Turn on the hazards and see if the right side does not work sometimes. If the right side goes out I would replace the hazard switch.

I had a case like this a few months back. I left the hazards on for about 20 minutes and the one side quit working. Replaced the flasher switch and all was well.

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!
Repair Help & Product Troubleshooting for Oldsmobile Intrigue

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1. Truck has a clicking noise up front on passenger side. We have already changed the relay switch on the passenger side plus the 4 way flasher, but it is still clicking. It sounds like a blinker and when you put your foot on the brake it stops. 2. The drivers side back brake light does not work. all other lights and blinkers work. Tried two new bulbs and still no go. 3. Truck had a security light on plus it would not start randomly and if I waited 10 - 15 minutes it would start... and I


... 2001 GMC Jimmy

The back blinkers work but not the front would that be the blinker flasher


Hi,When the right side turn signals do not work you still hear the clicking, but the indicator and the front and rear bulbs do not illuminate?According to the schematic, since you can hear the clicking and the cornering light ... Oldsmobile Intrigue

I have a 2008 jeep commander...the blinkers,wipers both front and rear, headlight brights and running light adjustment on blinker lever stopped working at the same time. meanwhile the headlights come on automatically with ignition start up and the running lights, brake lights as well as back up lights work. I'm working to access the interior fuse panel but would not know where to start once inside since there is no (or is there) specific fuse that would affect everything i've mentioned


... 2006 Jeep Commander

My left blinkers front and back do not work on my 1995 isuzu rodeo - right blinkers work and both sides flashers work also..when the left blinker is turned on it makes an awful buzzing sound


Check the flasher unit ... 1995 Isuzu Rodeo

I have all four - front and back blinkers working - but when I turn on the turn signals to go either right or left they just glow - no blinking. I just bought a flasher but don't know where to install it. Question: could it just be the flasher is burned out or something else. where do I install it? I also got a dashlight dimmer switch which I installed. It has a dimmer wheel on it and it worked great. Now it has stopped working. I have checked all of the fuses and they are good. Qu


Most cars do have a separate fuse for the dashlights (usually the only 5 amp fuse in the box) A bad flasher could do that, it is usually located in or near the fusebox. Another thing that could cause these problems is a bad dash or body ground. Th ... Nissan Sentra

I have a 1990 full size ford Bronco. The rear right turn signal went out and I replaced in and it still did not work but the rest of the turn signals worked. I then took it to a shop and they looked at it for twenty minutes and could not figure it out. When I got home the rear tail lights brake lights , turn signals (all one multifunctial bulb) would not work and also the back up lights. Also the front blinkers will not work now. I have tried the fuze and that is not the problem. I don't think


... 1990 Ford Bronco

I have a 1990 full size ford Bronco. The rear right turn signal went out and I replaced in and it still did not work but the rest of the turn signals worked. I then took it to a shop and they looked at it for twenty minutes and could not figure it out. When I got home the rear tail lights brake lights , turn signals (all one multifunctial bulb) would not work and also the back up lights. Also the front blinkers will not work now. I have tried the fuze and that is not the problem. I don't think


... 1990 Ford Bronco

My left rear turn signal is out on my 2006 Malibu. The bulb is good, but I replaced it anyway since I had the assembly apart. The left front flasher works fine as well. Before I try and replace any fuses, I was wondering if that would even solve anything seeing as how everything else is working and there doesn't seem to be a separate fuse for each blinker. I don't have a full repair manual and I don't know much about the electrical system in this vehicle. All the lights work, but the left


... 2006 Chevrolet Malibu

Just picked up an 86 El Camino with no turn signal or hazard flashers. When installing flashers they just fall out. I pulled the fuse block and there isnt anything running to either flasher. Would like to see what the back of working fuse block looks like so I can purchase and install proper wiring. Fuse diagram only shows the front view.


... 1986 Chevrolet El Camino

2000 Acura 3.5 RL suddenly has no tail lights or tag lights. Brake, reverse and blinker all work. Checked fuses-all appear fine. Decided to replace bulbs and noticed front right marker light out so changed that too. Nothing until that marker light bulb was replaced and magically all lights then worked! Except my brake lamp light on dash below car diagram lit. But brake lights were working and dash light went back off. Over next couple of days, brake lamp light would come on intermittently and th


The only thing that both the brake lights and tail lights use is a ground connection. Keep in mind the warning light on the dash may be for any exterior lamp. You may need to check the sockets and grounds on all four corners of the car. ... 2000 Acura 3.5RL

I have a 1984 Mercedez-Benz 300 SD Turbo Diesel. The emergency hazards lights would not go off after the red botton was pressed completly through the control panel. We tried to pull the fuse to force em haz'ds to shut off and to prevent running battery down. When the fuse was pulled the head lights would not work nor the blinkers. Placing the fuse back in all other lights and functions were fine. The flashers still would not go off. We had no other choice but to cut the wires that are in main da


Your turn signals and hazards operate on the same circuit...... thats why you lost turn signals when you snipped the wires behind the hazard switch...your hazard switch is faulty, stuck in an open loop (always on).......replace it ... 1984 Mercedes-Benz Mercedes Benz 300 Class

The truck would run on the front tank then would act like it would run out of gas I would switch to the rear tank and it ran fine again then I would switch back to the front tank and it ran fine again the same with the rear. then the front tank stopped working completely and the rear tank would work at slow speeds like the fuel was restricted. I dropped the front tank and tested the fuel pump it works fine. when I puled the lines to the rear tank the gas would barely tinkle out. the pressure rel


Check all lines and filters. berrydalewolf ... 1983 Ford F 250

Right front side turn signal does not work replaced all bulbs and checked fuses headlight flashers work when hazards are on front to back except driverside turn signal ,in dash right stays solid left


I don't believe it would be a bad ground for just one light. It could be a wire, a socket connector, or the bulb socket itself. See if the wire has power at the socket when signaling left, with key on. If there is power, probably a bad socket or con ... Cars & Trucks

Light bulbs work right front and rear blinkers dont work but stay on (they do not blink) left front and rear blinkers work all 4 blinkers work when hazard light is on. I was told its not the flasher box if the left blinkers work we dont know whats going on our jeep is a 93 laredo Grand Cheerokee


You may want to replacer your flasher relay anyway, it sounds like it is bad and they are not that expensive. ... Jeep Grand Cherokee

All of a sudden my front blinkers started blinking very rapidly. My front emergency flashers work fine. However, neither of my rear blinkers work, nor do my rear emergency flashers work.


You probably have a lamp that is burned out ... when you have only one turn signal light, it reduces the load on the flasher by 50% causing the bi-metal strip to heat at twice the rate as with two lamps. \012\012Check it out ...\01 ... 2007 Kia Optima

1987 toyota camry s/w back left (driver's side) turn signal does not work, bulb and ground are good, front left signal works but flashes fast, rt side signal both working ok. when emg flasher is turned on 2 front and back rt lights work ok but back left still out. Dennis


Problem solved, Since 3 of the 4 turn signals worked I did not fuse was a problem\015\012but after checking the turn swithch, I pulleded out the fuse which looked ok, but when\015\012I put it back in all the turn signal lights woked! App ... Toyota Camry

1993 buick lesabre, the blinkers lights quit working all at once with no warning signs. none of the regular blinker lights work when you turn the blinker on, the side light in the front comes on but no other lights, if you are pressing on the brakes then the correct brake light goes off but no blinking. the emergency flashers work correctly. in the past when the flasher unit goes bad the blinker lights will come on but not flashing. checked the fuses and no bad fuses. is the emergency flas


The unit for the emergency and the flasher is usually the same unit as your possible problem is in the selector switch of the flasher/blinker which is the multiple point cluster switch.\015\012It will be g ... 1993 Buick LeSabre

We have a 2011 f550 the front right side flashers work but the back of truck has no stop and blinkers all fuses are okay


You have got a wiring problem and that occurs mostly when u fit in the wrong voltage bulbs go under neath the car and check the wires in the right hand of the car (drivers side) juss near the spear wheel and check if u see any cut wires there and if ... 1999 Ford F250 Regular Cab

I have a problem with a 93 Jeep Cherokee Laredo 4W - The right blinker & brake light works like they should. However,the left brake & backup lights are out ( new bulbs have been installed & still out). When I use the left turn signal it looks like emergency flashers are on in the back. The front of the vehicle looks normal. What could the problem be?


By emergency flasher "look" do you mean both rear lights are flashing? If so,The problem may be in the signal switch. otherwise it could be the ground for the light sockets not being connected well. Try swapping the four way flasher with the directio ... 2000 Jeep Wrangler

I recently purchased a 89 grand prix coupe. The biggest problem with it so far is the turn signals. When I use the blinker lever nothing happens - no blinkers on the outside, front and rear. No blinkers flash in the dash either. I tried the emergency flashers and then the blinkers in dash blinkd indicating the outside lights should be blinking. On the outside passenger side, the rear blinker and frontside blinker work. I also noticed the yellow lights on the lower front grille dont work, e


Cant say about the wires you found, but usually this is a faulty flasher relay module or bad earth on the flasher units them selves. The relays are behind the glovebox, or in the engine bay fusebox, or in the kick panel beside the drivers feet just f ... 1989 Pontiac Grand Prix

The problem started a few months ago and the front speakers would either work or not work upon start up. Then all at once the fronts stopped working all together and now every now and again one speaker or the other will work for a few minutes or until I turn the car off. The wires in the back of the radio are secure I have no idea what else it would be.


... 2009 Pontiac G5

Blinkers My blinkers are acting weird. I thought my right blinker was out, because my blinker indicator was going faster than normal. Well, I got out and check the front light and it was blinking a little faster then it should. Then I checked my back light and it wasn't blinking at all, but my bulb was still on. The other side was working just fine. Now here is where I'm stunned. I go and take my wife to work and my right side blinkers are working so I'm like sweet it works. I turn on my


You can check your blinker relay located in the fuse box. You should have 2 of them. 1 is for the emergency blinkers. Trade them to see if this corrects the problem. The other issue could be the multi switch is not functioning properly all the time ... 2007 Ford Fusion I4 SEL Sedan

Turn signals don't blink. All signals front and back come on but stay steady. Hazard lights DO work and blink. Replaced the Flasher behind the fuse box on driver side and still doesn't work. Went back to auto parts and got another flasher and still doesn't work. I have a 1996 Ford F-150 Eddie Bauer Edition Reg Cab 2-wh Drive Straight Six. 5 Speed.


Check all your turn signal bulbs. When one goes bad it doesn't complete a full circuit causing your lights to stay steady. ... 1996 Ford F150 Regular Cab

I took my 2006 Mazda 6 in for an oil change yesterday. The mechanic said when he tried to start the car to back it out of the garage, the car would not start. He checked the battery and said it had a bad cell. He jumped the car to start it so we could take it home and I would replace the battery. While driving home, we found the auto down function of the power windows quit working and the drivers door switch for the passenger front power window will not work. The passenger front window will work


Usually the autodown feature needs to be reprogrammed. there are usually 2 ways of doing this. First, roll the window down and hold the switch down for a about 5 seconds and then roll the window up and hold for about 5 seconds. Repeat if it does ... 2006 Mazda 6

My front and rear fog lights dont work . fuse ok bulbs ok had front bumper of about 3 months ago if the connectors where not put back correctly would this cause both front and back not to work


Yes ... 2001 Renault Sportwagon
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.1105 seconds