Having problems with your Nissan Quest ?

How do I replace my brake rotors on my 1999 Nissan Quest

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Brakes are a fairly simple thing to change but it is not a procedure you want to learn how to do in a forum like this where there are no pictures. Do not take this process lightly. Your brakes are very important.
Go to the local auto parts store and get a Haynes or Chiltons manual. This will go thru the process completely and accurately. It will also explain what (if any) special tools you need.

Good luck!
Repair Help & Product Troubleshooting for Nissan Quest

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I replace my brake rotors on my 1999 Nissan Quest


Brakes are a fairly simple thing to change but it is not a procedure you want to learn how to do in a forum like this where there are no pictures. Do not take this process lightly. Your brakes are very important.Go to the local auto parts store ... Nissan Quest

2001 brake pad replacement 2001 nissan quest


The hard part is pressing the caliper piston abck into the caliper so you can get the new, thicker pads over the rotor. A large C Clamp works best.\015\012\015\012\015\012\015\012\015\012\015\012\015\012SECTION 206-03: Front Disc Brake \0 ... 2001 Nissan Quest

I have a 1998 Nissan Altima with a broken stud on the passenger side front rotor. I have the brake calliper off and the center nut on the rotor off. I used a claw puller to try and remove the rotor. The puller pushed the spine back through the rotor, stopping with a small amount of the spline threads still protuding from the rotor shaft. It will go no further. How do I get the rotor off so I can replace the broken stud??


Chances are your rotor is rusted to the drive axle. Another thing is there might be 4-bolts securing the rotor to the hub. Unless you get those bolts off, the roror won't come off. If you have Haynes manual, it is a good guide because you see things ... 1998 Nissan Altima

On a 2008 Nissan Altima Hybrid after replacing brake pads and resurfacing rotors on all 4 wheels, the ABS, Brake and brake warning light are on and I feel that the car is pulling to one side when you apply the brake pedal, please help!


... Nissan Altima

Replacing brake pads on 2002 nissan quest


... 2002 Nissan Quest

1999 nissan quest brake pad replacement


Remove wheel & tire,\015\012remove 2 torx bolts that go from the inside to the outside of the vehicle. They are on the inner side of the brake caliper.\015\012lift the caliper out of the rotor.\015\012remove the brake pads. ... 1999 Nissan Quest

I have a 2002 Nissan Quest and the rear brakes are making grinding and squeaking noises while braking. The rear brakes were replaced a month ago and since then it's been making those noises. I have read couple others forums of people having the problem but they don't have a clear answer on how to fix it.


Make sure the rotors (the disks that the tire rim are mounted on), are smooth. If they are rough, then they are wearing your break pads down. Even if the break pads are new, bad rotors will grind them down. Change the rotors... ... 1994 Nissan Quest

I have a 1997 nissan quest xe and it runs pretty good in the morning when the motor is cold, but as soon as it warms up it starts to spit and sputter and sounds like it is fixing to die. We have changed the spark plugs plugs, plug wires, cleaned out the catalytic converters,replaced the fuel filter, replaced the rotor button and cap.


When your engine is cold it runs in open loop, and bypasses the oxygen sensor. When warm it goes into closed loop, with the oxygen sensor controlling the fuel mixture. Replace the sensor. murf427 ... 1997 Nissan Quest

Distributor on 97 Nissan Quest makes noise above 2000 rpm. Removed cap and everything looks ok. No play in dist shaft. Engine runs fine despite the noise. Car has 107K miles. Noise sounds like parts rattling about . If I need to replace the distributor is it still held in with a locking bolt? Do I just take note of the position of the rotor when taking it out and then put the rotor in the same position with the new distributor? Thanks in advance Phil Vourtsis


Ok can hardly make a noise that the dealer can be\012 is what you have run a little and listen to the dealer to hit a spark, \012if you get the dealer must mark the position in which you pull it out \012and put the new one in the same pos ... 1997 Nissan Quest

2000 Nissan Maxima front brake makes grinding noise. They replaced rotor and pads. Then said was a shim that was not lubricated and replaced. Works for two weeks and it starts up again. Help?


If you will take my word, you will ignore the sound and leave it as it will stop in a little while. I am talking from experience.Cool down.Please rate this afterall. ... 2000 Nissan Maxima

Hello, my husband replaced the brake pads and had the rotors turned on our 2006 Nissan Murano, as well as rotating the tires. Ever sense we have had a weird thumping and vibration on the vehicle when we apply the brakes ONLY when we are going 5o mph or faster. The steering wheel shakes and it feels like the wheels are going to fall off.


You have a wheel calber sticking,replace them or rebuild them.or maybe just clean them with 10w40,if you live in snow country with a lot of salt,i would recommend replaceing them ... Nissan Murano

I have 70,000 miles on 2006 Nissan Murano. All scheduled maintenance has always been administered. Just had brakes and rotors done less than a year ago. Now, every time I turn right or accelerate, I have a scrubbing type noise that seems to be getting louder and louder. Any suggestions or ideas? I do have an extended warranty through Nissan and I know that the motor mounts and radiator bushings need to be replaced per the dealership. It's covered under my warranty and I have appt to have t


Would need to drive the vehicle to know exactly ,could be a bearing or a drive shaft coupling but without a drive its nearly imp?ssible to say ,sorry ... 2006 Nissan Murano

Hi. The front brakes on my 1991 nissan maxima are becoming really hot even after a short drive. not long ago the rotor and pads were replaced. I think the pads are staying too close to the rotor. Any ideas about how to solve this? Thanks


Are the brakes making any noise ? Do you have pedal pulsations?\015\012The pads and rotors were they Dealer products or aftermarket?\015\012Regardless of which type check to make sure that are suitable for your vehicle the friction materi ... 1991 Nissan Maxima

1994 nissan quest brake lights staying on when vehicle off; unplugged the brake light switch and they do go off...... how do you replace the switch?


It is plug and play.... just a twist gets it out ... 1994 Nissan Quest

1996 nissan quest the front brakes are locking up still after i have replaced brakes cailbers bearings i don't know what else it could be please help


... Cars & Trucks

Brake pads how do i replace brake pads on a 2004 nissan quest


This page offers an excellent guide\015\012\015\012http://www.autozone.com/a ... 2004 Nissan Quest

1999 Nissan Quest. Driver side brake lock up. The mechanic replaced ABS, valve, caliper, master cylinder.....nothing seems working. The left front brake still lock. This is crazy. HELP.


Possible brake hose collapsing , interrior deterioration ... 1999 Nissan Quest

I have a 2000 Chevy S10 ZR2 i just replaced the back brakes on it they are disk brakes. The one side i replaced the rotor and the other side i replaced the rotor and caliper. The side i replaced the rotor and caliper the squeaks randomly, but if i tap on the brakes while its squeaking it quits. The squeak isnt like a constant squeak like its rubbing all the way around the rotor on at a certain spot. i switched rotors from one side to another that same side still did the same thing. not sure what


The pads are probably chattering against the inside of the caliper. there was a metal shim that goes between the back of the pad and the inside of the caliper that should be reinstalled. if not available there is a product called disc quiet that can ... 2000 Chevrolet S-10

How to remove an replace brake rotors on 1998 nissan frontier 4wheel drive


... 1998 Nissan Frontier

1996 nissan pathfinder brake rotor remove and replace


... Nissan Pathfinder

How to replace brake light switch for 2000 nissan quest


... 2005 Nissan Quest

2007 uplander rear brake repair - what type of brake pads came as original equipment? Ceramic or semi-metalic? The dealer service states that the original were semi-metalic. I've replaced the front pads twice and replace the front rotors once. Does anyone have any photos of the stages of rear brake pad replacement? An inspection at the dealer resulted in their suggesting replacement of both the rear brake pads and rotors. Where may rear jack stands be placed in order to service the


Pads last about 20k, rotors about 40,for the fronts and about 30/50 for the rears,they are all semi metallic.if you look under the car you will see the places for the jack(not to be used when working on the car OTHER than replacing a tyre.)for all ma ... 2007 Chevrolet Uplander LT Minivan

REPLACED FRONT AND BACK BRAKES ON VEHICLE. HAD ROTORS MACHINED AND PUT BACK ON THE VEHICLE ALONG WITH NEW BRAKE PADS. THE ENTIRE CAR SHAKES WHEN I APPLY THE BRAKES AT SPEEDS IN EXCESS OF 15 MILES PERR HOUR. THE SHAKING IS NOT IN THE STEERING WHEEL. THINKING IT WAS A FRONT END PROBLEM I REPLACED THE FRONT ROTORS AND PADS AGAIN. BEFORE I REPLACE THE REAR ROTORS AND PADS WHAT COULD STILL BE CAUSING THE PROBLEM.


Hi,\015\012\015\012This is an extremely annoying problem especially as you have already replaced the components most likely to be causing it. A few quite often undervalued issues can be causing the symptoms you describe.\015\012 ... Cadillac DeVille

1999 nissan quest brakes over heating


If your already going to a mechanic what's the harm in price shopping? by that i mean call around and take it to a different mechanic. a second opinion never hurts ... 1999 Nissan Quest

I have a wheezing sound coming from my 2000 nissan maxima se. Though i just had my muffler, belts, pulleys, tensioner, brake rotors and pads, and stabilizer links replaced recently, it's still there. Any suggestions


SOUNDS LIKE A VACUUM LEAK SPRAY SOME WD-40 ON THEN UNTIL YOU FIND IT AND ALSO SPRAY IT AROUND THE INTAKE ... 2000 Nissan Maxima
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4068 seconds