Having problems with your Mitsubishi Pajero ?

2000 nm pajero drive belt picture

\015 I need a picture of how the drive belt fits around all the pulleys.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Mitsubishi Pajero

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2000 nm pajero drive belt picture


... Mitsubishi Pajero

I have just purchased a Mitshibushi Pajero2.8 turbo diesel it ios an import and now a right hand drive. My mate from Canada and I are driving to Australia in June. We did a lot of research and the Pajero as far as we are concerned is the best wheels 4x4 for the job. What spares would you recommend we take. I thought starter motor alternator, fuel pump disc pads belts full set gasket injectors What do you think Rico pinto


... 1988 Mitsubishi Pickup

I need a picture of a serpentine belt and a drive belt for a 1994 Bonneville sse how it is installed


I have the diagram but need your engine size and your email to send you the diagram. ... 1994 Pontiac Bonneville

I repaced my powersteering serpentine belt and power steering pump 3 months ago. today it was 32 below 0 C', I started my truck and all of the sudden no power steering I parked it the night before and it was fine no noise or whinning and in the morning the steering was stiff , and never inproved after 40 min drive .what do you think is wrong?


You have a leak fords are noritas for this although its a great disgin madza disgined this pump it works like a rotery engine and last for ever its likely the plastic resiveor had swolen and the seal is likely leaking. You could try putting fuild in ... 2000 Ford F150 Flareside SuperCab

I recently changed my timing belt on my 2007 1.7dti corsa utility. The problem now seems as if my turbo takes a while to function as I have to drive a short distance before it kicks in. There is a power loss from start as it doesn't want to go past 80km/hr. 0-80km/hr even takes more than 30sec. Any idea what is the problem? No hard start is experienced on the vehicle.


... Cars & Trucks

RENAULT ESPACE DRIVE BELT PICTURES - 1995 Geo Metro


Renault in metro forum? ... 1995 Geo Metro

Need picture of serpintine belt for a ford 3 0 ohv 2002 tauris


... Cars & Trucks

Ls400, 4.0, engine code 13, came on after changing timing belt, changed right cam sensor, still has same code, also RPM not working (fluctuates 0 to 1000 when driving ), when taken out of overdrive it has feels like a miss at cruise, car has power and shifts great, help


... 1991 Lexus LS 400

I drove my 98 Camry 200 miles to reach home with flickering low oil light but oil was ok, got home and had checked with oil pressure gauge, pressure goes to almost 0 after 10 minutes of drive. Engine noise not too great may be little noisy then before. I have 102k miles on the car, up for timing belt change etc. Wondering if this repair is worth it if i have already done damage to the engine. Can you advise what are my options. Sem


There's a low oil level light and a low oil pressure light. You checked the real pressure and the right pressure is35PSI not more than 80 If ti revs up and the pressure doesn't rise your stopped up some way. ( sludge). If you got a little money to ... 1998 Toyota Camry

Montero/pajero gearbox gearbox needs repair ,and i would like some tech pictures to guide me through a rebuid please i own a pajero 2800 diesel wide body with 4m41 engine. last week i change the flywheel oil seal and gearbox oil seal. but the same day the oil seal break and the AT oil empty. second day go to work shop and change new oil seal. still can drive the car. but second day suddenly the car stop .... engine running good condition. when enggage gear to d4 or any gear, the engine stopped.


Hey dude,\015\012\015\012\015\012download the repair manual for pajero 1986 :)\015\012\015\012\015\012Hope it wld help u to solve this as well as any other issue :)\015\012\015\012\015\012 ... 1986 Mitsubishi Montero

Fiat x19 conversions, electric fuel pump, electronic ignition, twin 36dcnf weber carbs, 35/75/35/75 cam, headers, free flow exaust. The issue that i am having is it will not start to run, it tries and i have checked things as fuel delivery, spark, Timing (New belt installed) set drive cam to 0 deg TDC and overhead cam mark at center of engine mount.


... Cars & Trucks

Need a drive belt diagram for 2006 monte carlo 3.9 have no routing picture underhood!


... 2006 Chevrolet Monte Carlo

Belt snapped looking for a picture where the pulleys are so i can see how to put this belt on. Its the one for the alternator.The other belt is still there and operational. I need to see how to take the other belt off to put the new one on. Also is there a tension pully there? If there is;is it supposed to be in a fixed position when there is no belt there? That's why i need to see a picture of it. Unless you can tell me.


U dont need no diagram or picture to change the belt just look how your old one is on there and change the belt by unscrewing the alternator bolts and push the alternator down and take the belt off. ... 2004 Nissan Sentra

The v belt, surpentine belt, is getting shredded, my problem started off with the truck squealing as your driving.. then tthe a/c stopped blowing cold air and the noise got loader and constant, i was ckecking fuilds and spilled a little brake fluid on the tensioner pullie the the noise sstopped just for a while, because the belt looked worn i replaced it , only to drive 3 blocks and i popped the hood this new belt was toast. i did notice that the belt loked as if it was riding mostly on yhe ten


Seem you need to relace the tension pulley its froozen up ... Mazda B3000

Timing belt i replaced the timing belt got the car to start..first problem...it started but the drive belt tensioner wont stop moving now and it is making a knocking noise everytime it bangs ...second..the car wont turn off when i turn it off it will run for like another minute or two...third i have a broken throttle position sensor..will replacing the throttle position sensor and the drive belt tensioner fix my problems...or did i not time the engine right when i changed the belt..keep in mind


You obviously need to replace your TPS, and you may need a new belt tensioner as well. On these cars the timing belt setup is not about no 1 cylinder being top dead center. Here are the proper steps to do a timing belt on this vehicle:\015\012 ... 1996 Ford Escort 4 Door

One of the three drive belts on my 1986 corolla (4a-c engine) is frayed and needs replacing. The belt loops around the idler pulley, air conditioner? and crank. Can I just cut this belt out and not use my air conditioning? Or if it needs to be replaced, which pulleys/ alternator bolts do I adjust to loosen, remove, and replace the belt properly. I have to remove the main drive belt to remove the one that is frayed. Thanks for any help you can give


To replace the belt you need to see what size socket the tensioner has on the inside. with a ratchet attached put the socket on the inside bolt and push in the rotation to move the spring down taking the tension off of the belt. Pull the belt off a ... 1986 Toyota Corolla 2 Door

2002 KIA SPORTAGE. REPLACING FAN BELT NEED RO REMOVE THE DRIVE BELT TO PLACE FAN BELT ON ENGINE PULLEY. I CANNOT LOCATE BELT TENSIONER TO REMOVE THE DRIVE BELT.


Hi, there are up to three belts if you have A/C. Each belt has a tensioning system. Diagrams and instructions from autozone.com are paste below. Please let me know if you have any questions, and thanks for using FixYa.\015\012\015\012A ... 2002 Kia Sportage

My 2005 Hyundai Elantra has cracks on the drive belt so my dealer recommends replacing all the belts including the timing belt. The car has 33400 miles. Is this premature and is this drive belt type of diagnosis correct? Thecost is $550. Thank you.


Depends on your local climate ,if its dry and hot then the belts can fail early as the plasticiser that the belts are made with dries out ,di iso butyl phylate is a common one used and yes if they say this then are no doubt correct ,we have a simila ... 2005 Hyundai Elantra

Transmission jerking When in low gear when I give it gas to take off up hill it jerks really bad. Even in high taking off slowly it jerks Real bad and when u get going it quits. Took off the belt Cover and belt looks good but just behind the back wheel on the belt drive there is a disc shaped piece that almost looks like a rotor but when I turn the belt and the ranger begins to move it moves as well. So it must be part of the drive train and it is very loose I can wiggle it back and forth wit


NO AUTOMATIC NOR MANUAL TRANSMISSION....THAT I AM AWARE OF WORKS OFF OF BELTS IN ANY WAY!I REALLY DON'T KNOW HOW MANY TIMES I MUST STATE THIS...BUT....PEOPLE REALLY...GIVE MAKE-MODEL-YEAR-SPECIAL EDITIONS...ETC......THIS IS LIKE ASKING:' does my ... Cars & Trucks

Can I drive my 1999 Honda CRV with the compressor belt off, apparently the compressor is jammed up and the auto parts dealership deemed it to cost $1403.99 to replace the compressor. I'm wondering if I were to drive it with out my air condition working. I also want to know if the Compressor belt is removed will that create a problem with fluid cycling through the engine. I was under the impression that just the Alternator Belt, and the Power Steering Belt were all that was actually required


No leave it on.... it wont hurt the car. ... 1999 Honda CR-V

I had a creaking sound from the belt tensioner, when drive is selected, so replaced it with genuine merc part. Now I get low grunting noises from around the power steering area which seems to get worse when I switch the aircon on and the belt appears to jump slightly.could this a power steering problem? Ihave replaced the belt with the shorter non aircon belt to isolate the aircon pully. There is less strain but the low groan is still there in drive. Any ideas would be much appreciated.


Probly need to have steering pump inspected -the library has many books in section 629 for more opinions ... 1997 Mercedes-Benz C-Class

VAUXHALL ZAFIRA 2.0 DTI DRIVE BELT DIAGRAM


... Cars & Trucks

VAUXHALL ZAFIRA 2.0 DTI DRIVE BELT DIAGRAM


... Cars & Trucks

New water pump, drive belt tensioner and aux drive belt all fitted to x type jaguar and still leaking coolant under car


I would start at my coolant hoses there is one on the rt side of the car check coolant overflow hose and the bottle check heater hoses as well or it might be that the pump isn't sealed or something could be left loose ... 2002 Jaguar X-Type

Hit armadillo which caused undercarrage splash guard to cut power steering drive belt. belt pulled out wire going into lower engine just above crank drive pully. replace belt and car will not try to start. motor turns over but no fire to motor. what does the wire go to?


Possibly crank angle sensor\015\012it needs this for spark and injectors ... 2001 Mitsubishi Eclipse
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.9495 seconds