Having problems with your Mazda Millenia ?

Right hand indicator(turn signal) doesn't go all the time. When it isn't working the 'indicator ticking' on the dash is very fast

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Look and see if one of the turn signal lights is not working. I fast flasher usually means there is an open curcuit on one of the lights (front or rear turn signal). It could be just a burned out bulb.
Repair Help & Product Troubleshooting for Mazda Millenia

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Right hand indicator(turn signal) doesn't go all the time. When it isn't working the 'indicator ticking' on the dash is very fast


Look and see if one of the turn signal lights is not working. I fast flasher usually means there is an open curcuit on one of the lights (front or rear turn signal). It could be just a burned out bulb. ... Mazda Millenia

1984 chevy 1500 driver side brake and signal light not working. Parking light works but is too bright. volt metre shows a ticking the same readings as the passenger side until a bulb is inserted then shows nothing. recently problem got worse. signal light indicator on dash for right hand signal stays on when lights are turned on and brake lights and signals don't work at all. was going back to normal after a drive down the road but now stays like that. -Other things that might be help


Sounds like a short, no way of knowing fwhare for sure till You run a tester the lenght of the wire. ... Chevrolet 1500

Toyota Prius 2007, just over 100,000 miles, taken good care of the vehicle so far just drive a lot. I have had this issue 2 times where I turn my car on and the dashboard lights do not light on. I have thought both times that my car wasn't even on but when I go to drive it, it drives but can't see my speed, headlights work but not showing on dash, seatbelt indicators not working...anything on dashboard not working. On the little screen the mpg indicator doesn't work. The car thinks its still of


Did you check the fuses? ... Cars & Trucks

The high beam headlights in my 2005 Nissan Altima have both stopped working at the same time. The low beams still work perfectly. I get indication on the dash that the high beams are working. I never use the high beams and have just found out that only one fuse controls both the high and low beams. I 'm thinking dimmer switch but would I still get indication on the dash that the high beams are on with a faulty dimmer switch?


... 2005 Nissan Altima

"trac off' and "abs" lights on dash board stay on intermittently and the indicators stop working. Have to turn the engine off and back on again or have to keep pressing the "hazard' button off and on several times. some times everything is ok and other times as mentioned the indicators don't work.


Had the exact same problem with mine. All you need to do is replace one or both of the hub sensors and the lights will go off. Although I have had to replace them several times because they keep going 'bad.' ... 2001 Oldsmobile Alero

I have a BMW 1988 3/1 touring. There s something really wrong with the body electrics. Right indicator switches between flicking at a normal speed and flicking really fast. the petrol indicator is not working, nor is the engine temp guage. the lights inside the driver dash display (speedometer, engine temperature, guage, petrol guage) are not working. The heater works on engine start, then stops working. Please help!!


... 1988 BMW 3 Series

97 Passat Dash Lights GONE! Last night I switched my headlights on and had no dash lights. This includes all illumination for the climate control and console (automatic trans). To the best of my knowlege everything else works, all gauges read, cruise works, MFA reads and cycles properly. Fuse cover does not state "dash/instrument lights" or anything that would indicate that there is a fause for them. I have cycled the rheostat (dash light dimmer) many, many times, but don't get a flicker or


I would look in my car manual in the glove box to find the fuse for this and check it,if it is not a fuse,then the dimmer for the cluster lps is bad. ... Volkswagen Passat

Dash problems When I start the vehicle the gauges go all squirelly and sometimes i get no headlamps, while this is going on my push button 4wd indicators do nothing yet if I keep working the light switch I will get the dash to work but as soon as I go to park lamp or off I lose the dash, lamps and 4 wd. Sometimes it starts right up and there are times where I have to let it sit for a day and then it will fire right up. 99' S10 p/u


TRY wiggling the ignition key when it is acting up. you may have an ignition switch not passing current all the way thru system.also check your battery cables and make sure they are clean these are bad about corrosion acid will leak down inside cable ... 1999 Chevrolet S-10 Pickup

2006 Ford Fiesta, Left side indicator not working on front or back, globes OK. Left side light on dash working when on and flashing fast. When on Hazzard lights, right side works, but no left side outside vehicle, both sides flash on dash. Any ideas?.


Welcome to Fixya\015\012\015\012If light on the dash is flashing fast and there is no light outside the car. The problem is the bulb. Bulb is already busted. You need to replace the bulb to fix the problem.\015\012\015\012Than ... 1993 Ford Festiva

I have a 03 BMW X5. My radio is not working. When I turn the car on it starts playing but it turns off after about 2 mins. I can?t turn the station or control the volume. My signal light indicator is not working also. The light is flashing outside but you can?t tell that it?s working from the dash indicator. They both started around the same time. Do you know what the problem could be?


2003 x5 radio comes on for 5mins then shuts off ... 2005 BMW X5

A couple years ago, I dropped a coin down behind the dash of my van, and it has done something to the insturment panel, at times the temp meter don't work, the speedometer don't work, and the gas hand don't work, and the lights on the buttons for the rear wiper flashes. My question is how do I get the dash loose to get the coin out, and when the coin is removed will the problem be resolved, Thank you


The coin probably has nothing to do with the dash problem. That is a common problem among Voyagers. Here is some more info. that might help you. Problem\015\012 #1 The blinking lights in the rear wiper rear defrost area can be reset\015\012 by ... 1998 Plymouth Voyager

The turn signals stopped working one at a time over the last year. The first one to go out was the drivers side and it would work as long as I manually clicked it. So now they both don't work. Also the dash indicator for the L turn signal stays dimly lit on the dash.


It sounds as if the turn siganl switch (typically located under the dash) has failed. These can be purchased for $5-$10.\015\012\015\012Hope that helped,\015\012Tom ... 1996 Oldsmobile Cutlass Ciera

Peugoet 206 right indicator is not working properly, first its flashing too fast second middle and the back right hand indicator lights are not working at all. could you please help?


When a Bulb starts to flash fast, it is normally indicative of a Burned out Bulb.. ... 2003 Peugeot 206

2001 Chry Voyager dash lights don't work and can't see the shift indicator or milage indicator. Turing the light wheel on the panel gets it to come on at times but then the speedometer or RPM gauge don't work. My garage guy told me to buy a new light switch which cost around $100 and that SHOULD fix the problem. That's a high price to pay for a possible fix. Any ideas?


... 2001 Chrysler Voyager

I have a BMW 1988 318i, and a load of body electrical problems have cropped up. Right indicator flicks on double time, no lights in the driver display dash with the temp and petrol guage and speedometer, petrol guage also stopped working yesterday. engine temperture guage has not worked since i owned the car. The heater also only works on ignition, then it stops working. is this a fuse problem? i can t find the right fuse box diagram online. do i need to replace the dispay behind the steering wh


... 1988 BMW 3 Series

I have a1998 GMC Jimmy 4x4/ 4 door slt. The blinkers don't work on the front or back of the vehicle. No indication of the green arrows on the dash board our a relay tick either. Also my brake lights don't work. Running light work but when I press the brake, only the third light works... Any solutions? Please help!


Turn on the hazard, does it come on, this is also th e blinker. Sometime the reverse happens when a hazard not knowing it is not working is on and the turn signal dont work, So do this turn the hazard on. okay does it come on. that device is also the ... 1998 GMC Jimmy

R/f turn works only with 4/way's r/rear flashes fast and r/turn indicator on dash works only with 4/ways all fuses ok and flashers work what do i check next


Problem is in the multi-function switch probably. ... 2002 Ford Explorer

During the day my brake lights work, but not my rear signal lights. when i turn on my head lights, the brake and signal lights will not work. my signal lights in front work all the time, but they blink real fast. i checked my fuses on the dash panel box, all are ok. i checked under the hood and those fuses were ok also, but i do not know about the square big multi pronge fuses. i replaced my rear tail light bulbs also even though my old ones were ok. could there be a loose ground wire or a bad b


U have a short loose ground or power wire check all bulb sockets ur head light switch can be bad also ... Ford Ranger

Front passenger window was working fine. the person in passenger seat was putting window up or down at same time driver was putting same window up or down. now the passenger window does not work at all. there was no indication of any mechanical problem in linkage. no bad noises. up until this problem both front and rear windows on passenger side were not quite as fast as driver's side going up or down but all four windows worked good and sounded good. what is wrong here?


It may be off track or it is not getting power now. Can you take the panel off yourself? ... 2004 Ford Crown Victoria

On my 2004 impala, the front right turn signal doesn't work, (only works with hazard lights). And the back right signal is fast. The signal "clicking" sound is non stop but on the other hand both the back and front left signals are working fine. The right signal doesn't even show up on the dash unless its the hazard lights. What do I do?


If the turn signal filament of the right front park/turn lamp is known to be OK and the hazard switch is in the normal position, the hazard switch or the turn signal/multi-function switch could be defective ... Cars & Trucks

I have a fast ticking sound coming from the hazard switch that goes off sporadically. My turn signals and hazard light work perfectly, but the ticking noise is almost all the time. I have even replaced the hazard switch, and the ticking remains. What now? Maybe the turn signal control?


... 2001 Saturn L-Series

Started with the lights, inside and out flashing on and off we resouldered the light switch. the radio did not work so we installed a new one and a couple wires touched each other and sparked not the blower motor will not work the indicator light that shows time date and problems is not working. the auto headlight sensor on top of the dash is flashing as if the hazard lights are on and when you start the jeep it runs for a couple seconds and then dies. None of the fuses were bad so we changed it


What year jeep and model are we speaking of? Did the soldering of the switch resolve the light flashing issue? ... Jeep Grand Cherokee

Signals/hazards Turn signals-hazards quit working. Not even a light on the dash indicating that a bulb would be burnt out for the signals. Both quit working at the same time. Looked in the book, but didn't give any info.


There is two seperate relays for right and left trun singals, they are located under the hood in the relay box. i would start there this is a fuse that powers them both, in the same relay box ... 2002 Ford F250 Super Duty SuperCab

Headlights only working on high beams. the blue high beam indicator light on the dash flashed 3 times, since then, only the high beams work and there is no low beams.


... 2005 Chevrolet Equinox

I have a 1969 Ford f100 3 speed manual trans, column shift it some times gets stuck between first & second gears, when this happens I crawl under the truck and move the shift linkage back and forth, this solves the problem... but what a hassle!! what is the permanent fix? prob #2 my dash lights dont work, the bulbs are good, fuse is good, & I installed a new head light switch. The turn signal indicator lites work fine.


I had a '71 dodge with three-on-the-tree that experienced binding and the only way to fix it is to replace worn parts. as for the lights, find out which connetor supplies power. perhaps it is faulty or loose. also, there may be a separate fuse locate ... 1981 Ford F 100
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.9941 seconds