Having problems with your Lincoln Town Car ?

I have a Honda Passport it loses power under excels rating and backfires under decelerating and we have ruled out the catalytic converter being stopped up

\015 My Honda Passport in running very rough and it loses power under ex celebrating . then when I decelerate it often backfire. I ruled out the catalyctic converter today so now I am stumped. please help!\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Timing plugs or leads or could be exsesive fuel
leaking valves
Repair Help & Product Troubleshooting for Lincoln Town Car

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Honda Passport it loses power under excels rating and backfires under decelerating and we have ruled out the catalytic converter being stopped up


Timing plugs or leads or could be exsesive fuelleaking valves ... Lincoln Town Car

Replaced Fuel filter, Plugs and wires, PCV valve and the Throttle air control valve. Still running rough. Could it be an 02 senor or the catalytic Converter? Car wants to dye out when coming to a stop or while decelerating. But not all the time..... ??? Seems like it's starving for fuel.


Hi there, i had a similar problem with my Legacy B4 RSK Blitzen, 2 litre Twin Turbo, Engine EJ208. Car would idle sort of ok when cold, after warming up it would idle erratically (idle hunting) and cut out sometimes. I notices the boost gauge huntin ... 2002 Subaru Legacy

Replace muffler, not the catalytic converter which started to rattle. Stop running, will crank but will not start. can it be the catalytic converter.


If the converter is rattlin then it needs to be replaced because the element inside is broken. if the jeep still does not run try removing the catalytic converter to see if the restriction is too much. should start if the converter is restricted. if ... 1996 Jeep Cherokee

I went into a passing gear at high RPMs and the car stalled, pulled over turned it off and cranked it up fine. But noticed high RPMS but not much speed building. Took it home and checked a few things. Apparently the catalytic converter was stopped up and blew the intake manifold gasket. Rodded the catalytic converter out and replaced the intake manifold gasket. But it's still has high RPMs and low speed building, and shuts off when at complete stop like RPMS are getting too low. You can also hea


Check PVC and ERG valves. ... 2001 Pontiac Grand Prix

When my engine light came on, i was told that the codes read ''catalyst below efficentcy''. i was told it meant i need a new catalytic converter, but not to worry with it now. about a month later, my car began to stall when i stopped at lights. i cranks up fine, but after a few mins of driving, it starts to stall when i stop. is this the converter, or something else is going on


Change the catalytic converter ... 2002 Chrysler Sebring

I have a 2003 Mitsubishi Lancer ES w 110k miles. Recently it has been vibrating severely (almost to the point that the rearview mirror shakes) while i'm accelerating. My car struggles up inclines and sometimes hesitates out of a full stop. My mechanic found a hole in the flexible pipe and I had it replaced. No dice. I tend to think that it may be the catalytic converter, but I haven't gotten that rotten egg smell. How can I be sure that the catalytic converter is the problem before blowing some


Welcome to FIxYa.com\015\012\015\012\015\012\015\012 Have your tech put a vacuum gauge on and bring to operating temp 20 hg is top when you accelerate does gauge ... Mitsubishi Lancer

2001 toyota sienna, 6cyl 3l, must accelerate very slowly from stop or van seems to bog down badly, may take 2 miles to get to 55 mph, going up bridges it bogs down very badly, diagnostics indicated catalytic converter clogged. it has 3 converters, 3-way converter system. can the converters be removed and solve the problem? must they be changed because of sensors? how do i troubleshoot if really converter problem or sensor problem?


Brake loose connection between cat and exhaust manifold , it will allow exhaust gas to go out before cat , and see if it's restore the power on the engine.\012If it does then your cat is clogged.\012If not it's also might be Throttle Posi ... 2001 Toyota Sienna

My honda accord's catalytic converter was rattling, now it's stopped noise. do i need a new one?


... 1995 Honda Accord

I had my old catalytic converter turn red and was told by a work mechanic that I needed a new one. So I had a new one professionally installed. I have changed the spark plugs, spark plug wires. PCV valve, 2 02 oxygen sensors, and the converter is still turning red.Also I have had 2 dignostic test done on my 1991 cadillac eldorado, but even the new converter is still turning red. What can I do as I am spending money and no results. I need to know what I can do, to stop this. Thanks


Engine is running rich. Some reasons might be MAF sensor or computer. Is the engine light still on, or what are the codes you got from the previous scans? ... 1991 Cadillac Eldorado

Would my catalytic converter stop my car from starting


Plugged ... Cars & Trucks

Got a 1997 monte carlo and im having a problem with either the fuel pump or the catalytic converter as one or both are causing the car to stall at low speeds or when i stop and then takes about 20 min


You have a pressure port test on the fuel injector rails,when you stall out just cycle the key go to the test port and which is nothing but a tire valve looking,press in the shrader fuel should squirt out and just dribble out,if it dribble out you ma ... Chevrolet Cars & Trucks

1996 jeep cherokee stopped while driving it. I thought maybe it was the catalytic converter since it started rattling after I put a new muffler on it.


Check if you have spark if not replace crankshaft position sensor as this controls spark ... 1996 Jeep Cherokee

A rattling from what sounds like the catalytic converter. It only happens as you slow down to a stop and then again when you accelerate from a stop. sounds like a part sliding back and forth on a bolt, but everything is tight?


Checked heat shield above it? Perhaps the inside of catalytic converter has broken up. Piece of the honeycomb like ceramics moving around. When it's cool, try hitting it with side of fist or rubber hammer slightly to see if you hear anything. ... 2002 Nissan Altima

Engine light came on 2000 toyota avalon. auto zone said error code indicated it needed a new charcoal canister for emissions. today, car sounds ruff as if valves are knocking and wanting to stop at low speed. stopped again to have checked and was told the entire catalytic converter system, including everything that runs to it, is failing. can this actually cause the car to run so ruff that it sounds like the valves are knocking?


Take the vehicle to a close by local repair shop, that has beenin the same place & same owner for 25 years or moreThe chain store places aren't what you needYou need a proper diagnoses of the entire cars engine etc ... Cars & Trucks

91 honda civic dx 1.5L quit running properly. Starts, runs for a few seconds just fine then stumbles and starts running rough, check engine light comes on then it stalls. Started as an intermittent problem. I have ruled out the fuel pump. I changed the fuel filter, spark plugs, distributor cap, rotor cap. I checked the ignition control module and ruled out the catalytic converter. Has spark at all four plugs and is getting fuel. I can keep it running by revving the engine but it runs really roug


Bro, check ur main relay. its under the dash. replace it, check also ur distributor(replace it). and also your ECU ... 1991 Honda Civic

Original problem car was loosing power found a plugged catalytic converter when i changed it the car started then died now the car starts idles rough for a few seconds then dies. have changed iac,tps map,ign module,coil,plugs, wires etc,brought it up to top dead center rotor is at #1 ruled out timing chain,changed pickup coil in distributer, have spark,40lbs fuel pressure& using a noid light have voltage to the injectors.also ruled out the vats system i think cause the car cranks over &the inje


Make sure all the hoses to the cat con are in the correct places. as that is where the problem started,\015\012 fitting a new cat shouldnt cause problems to any of the other items you checked. ... Pontiac Firebird

2001 Taurus started chugging & wanted to stall while waiting at a stop light. Car did not have good power so we parked it. It popped no codes. Now the only way to keep it running is to constantly pedal the accelerator. We changed the coil pack & Idle sensor, same problem. When we slowly press the accelerator it will have power and will drive, difficulty is stop signs, lights and traffic. Difficult to get it started, must pedal the accelerator. Was told it is possible the catalytic converter may


Get a friend with a hacksaw and a welder to chop it off and put a piece of straightpipe on it. it'll be fine. but first, unplug the mass air flow sensor and/ or the manifold absolute pressure sensor and see if they are fouled out first. check all sen ... Ford Taurus

How to change the 2 steel coolant tubes that are at the back of motor 3.8 against the fire wall they go down the bottom of floor toward the rear heater. they are approximately 3 foot long and stop just past the catalytic converter they stop and change to rubber hose. the bottom area is a nobrainer,but how do you get to the connections behind the motor????


Some you have to have a special tool to remove them. we really have to see what it look like. some you can squeze and pull apart. best of luck ... 2000 Dodge Caravan

My catalytic converter seems stopped up, but it looks to be more than one. Which one on the pipe is the converter.


YOU HAVE TWO CATALYTIC CONVERTERS A PRIMARY AND SECONDARY WHICH LOCATED IN THE MIDDLE OF EXHAUST. YOU HAVE TO SCAN CAR TO SEE WHICH ONE READING BAD.TO ME I WOULD REPLACE BOTH .NOT GOING TO BE A CHEAP FIX. ... 2003 Mitsubishi Lancer

My 2003 nissan altima is shaking everytime i pull to a stop sign or red light or just stop for a minute. The car is shutting off on me every other block. i just put a new catalytic converter and a new air mass flow sensor and the problem still exists please help with any solution to this problem if u can thank u very much....Vanessa.


Hey vanessa.. Ok first thing ,, get a diagnostic done to see if you have any error codes,, especially those relating to the Air temperature sensor and engine coolant sensor.. Fix and clear error codes..With that in mind,,, in the mean ti ... 2003 Nissan Altima

I have the same problem with my 2005 Mazda MPV as the unresolved problems showing: It keeps stalling and no check engine light comes on. Upon start-up, it idles low and at stop signs and red lights, it dies. I was told by the dealer after 3 days of trouble-shooting that the catalytic converter needs replacing, but upon further research online, I'm finding out this very possibly isn't true. The PVC (or PCV?) valve and hose were replaced, which did nothing to stop the problem.


SOUNDS LIKE AIR BYPASS VALVE STUCK ... 2005 Mazda MPV

What are the symptoms of a stopped up catalytic converter?


... 2005 Honda Accord 2.4 LX

LOSS OF ACCELERATION ON MY 2002 AVALANCHE, CATALYTIC CONVERTER WAS RATTLING NOW STOPPED


... Cars & Trucks

The truck will run well but then begin to idle at high RPM's...shut it off and then it won't restart until it has cooled for a couple of hours...have had the catalytic converter replaced along with the automatic throttle senser...but it still will idle high and then die at a stop sign and then not start


Replace the fuel pump its faulty giving you low fuel pressure. ... 1995 Toyota Tacoma

My altima turns over but doesn't start. It gets fuel pressure (though it seems like weak pressure to me, I can stop it with my finger over the line) I put a spare plug I had lying around on the wire, grounded it against the engine and got spark. i replaced my plugs thinking they might be bad. the only code it throws is that the catalytic converter is partly clogged, but even so it should start, even if it would stall and it went from running fine to not running at all one day to the next.


... 2000 Nissan Altima
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3527 seconds