Having problems with your Jeep Cherokee ?

Viscous coupling I have a jeep cherokee 2.8 crd 2005. It need a viscous coupling, how much is one likely to be?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Jeep Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Viscous coupling I have a jeep cherokee 2.8 crd 2005. It need a viscous coupling, how much is one likely to be?


... Jeep Cherokee

I have a 2002 Jeep Cherokee with a 4.7 engine. I replaced the power steering pump only a year and half ago. Now it is leaking again, but I haven't had much luck finding the leak. I fill it up one day and two days later, it is empty again. Do I need to have someone turning the steering wheel while I watch for leaks underneath the Jeep? Any products or suggestions to try would be appreciated.


Yes you would see where its leaking cos it will positively squirt out under pressure when operated, it is likely the rack end seals that are leaking.\015\012\015\012These can be replaced in most models but some need a new rack.\015\ ... 2002 Jeep Grand Cherokee

Battery dies after a couple of days of not driving it. did the fuse test (electrical draw off the battery)found one. it was the dome lights, cargo, etc. i have tested all the wires and unhooked them nothing is working so far to find the ''one'' that needs to be replaced/rewired. what else should i do? 96 Jeep grand cherokee.


Check the grounding wires from the alternator to the engine block and look for any corrosion of the connectors. ... 1996 Jeep Cherokee Country

Have 1996 jeep grand cherokee larado with chrysler 318 engine and auto transmission, all the time four wheel drive with I believe to be a NP249 transfer case...have not used the low gear range for years....just never needed it....now went to use it and could hardly get shifter to move....finally got it to move to low position, but when put from neutral to drive, hear hear grinding in transfer case like it is not going all the way into gear...one time it did go into gear and it drove in low range


... 1996 Jeep Grand Cherokee

I own a Jeep Grand Cherokee 2003 CRD 2.7 Diesel. My problem: I drove one hot day and my powersteering just dissapeared. I have replaced new powersteering pump, checked my new fanbelt, but my powersteering is still not working. Can you please advise me as what to do? I have checked the oil flow through the radiator. Is there any sensors or valves that I need to check?


If you've replaced the power steering pump to no avail,then i would look towards a bad power steering rack. the rack could be clogged or just a bad power steering rack,located under the jeep. at the center of the front end under the motor,just to rea ... 2003 Jeep Grand Cherokee

The transmission/clutch on my 1998 Nissan Pathfinder LE 4x4 (automatic transmission) was slipping a little bit yesterday. Only a couple times, and it's been good since...so, knock on wood hoping it was just a fluke. If not, how much time am I likely to have before it goes out completely? Also, can anyone give me an approximate range as to the cost for this car's transmission should I need to invest in a new one? I know sight unseen you can't give a specific number; I'm only looking for a general


I paid $1,000 dollars for my sons tranny auto 4X4 ... 1998 Nissan Pathfinder

I have a 1989 jeep cherokee that has a roaring noise in the right front. it sounds like a wheel bearron and or u joint going bad. is it very difficult to change and do I need specal tools to replace the wheel baerron and u joints. I have replaced the rear main oil seal without pulling the trans or droping the front end, which all the information said I whould have to do one or the other. Can you help?


Sounds like a wheel bearing,to check jack it up on that wheel then from top to bottom grab the tire and then try to move it up and down like your trying to pull it off if it moves alot its bad.no it doesnt take any special tools but it is difficult t ... 1989 Jeep Cherokee

My 93 jeep grand cherokee started to vibrate pretty violently while it is in idle. As soon as I would take off, it stopped, but then the other day while I was driving, the car died. It started up right away. I know that I need to change the fuel filter. Would the fuel filter cause this problem or do you think that this sounds like the fuel pump. A couple people think that it might be my alternator. Can anyone tell me what they think is causing the problem?


That vibrating your mentioning is not the fuel system or an altenator. Its your cams screaming at you to check the oil level after you let it sit for a good hour or so. If its full, unfortunatly you may need new cams. also have the lifters checked as ... 1993 Jeep Grand Cherokee

My 2001 Jeep Cherokkee engine light has been on for a couple of years and at one point it was running very rough and I spent about 2 grand having 2 different shops work on it at that time This work (fuel injector cleaning, new plugs, etc,they also told me I needed a new alternator which I suspect that was not part of the problem) did not totally solve the problem and now it is running rough again. I will try to describe some of the symptoms. The check engine light will flash much of the time


Check that the throttle body is cleaned out, throttle position sensor and o2 sensors are clean. ... 1985 Jeep Cherokee

I need to install a couple of 2001 Mitsubishi Eclipse Trunk Hatch Lift Support, the ones i got dont look like the ones it currently has. researching, i found the same item is sold anywhere ( i got them at o'reilly auto parts) so it should be the right ones. and can you please tell me the tools i need???? tnks!!!!!!


You need no more than a small screwdriver to pop the clips out.\012look at the new ones... and you will see how they go on...\012to remove the old ones you need only pop the clips to release the ball from the socket...\012the new on ... Mitsubishi Eclipse

I have a 1997 jeep grand cherokee. Water is sloshing around iside the dash. I've seen articles where they tell you there is one and there isn't one. I can't find one on my jeep. I did find where the evaporator drain is . Its inside the passenger side floor board underneath the carpet on the left hand side. A suggestion is to drill a hole and plug it. I really don't want to do this. I would really like to know if a drain tube or hose exisist out the exterior of the car. Thanks


Question I have after reading what you posted is : Left hand or right hand drive? On ones where the evaporator is located on the right (passenger side) there is a short stub hose that protrudes from the engine side of the firewall, even with the bo ... 1997 Jeep Grand Cherokee

Clunking noise I have just repaired the CV axles in the front. They were deff in need of it. Shortly after I have noticed a clunking when I go over a bump like something may be loose. I doubt very much that I installed the axles wrong because I took my time. Unless there is something special that needed to be done. It almost sounds like the springs are broke. One time when I was on the toll road and going around the loop getting on, I felt the car kinda slip like something fell out of plac


Have you checked your struts? Sounds like either lose or failing. Also recheck lower ball joint and control arms, although that will also be felt in steering. Good luck and have a good day. ... 1996 Subaru Legacy

Just bought a 1995 Jeep Cherokee from my father in law. The road noise coming from the rear is rather loud. Sounds like a roaring noise. I was told jeep rear ends are loud but this one is louder than normal. It sounds more like tire noise than anything, but I'm not sure. Where should I start or should I not even worry about it.


These are notorious for rear end failure and a new set of bearings is not extremly expensive as a new set of gears and bearings will be. The rear end will need to be inspected by a professional , this is not a job for a do it your selfer. There are 6 ... 1995 Jeep Grand Cherokee

Loaned car n they put to much oil in like 2 quart to much an I didn't know till after I drove it from work an back. it was jerking an idling rough an dieing on me all the way home raised hood an checked oil an freaked out. draied all fluid out n put new in ay right amout. now it's like 3 months later an I've been car less . Jeep Cherokee keeps dieng starts up great when it does an run .sometimes doesn't start at all


A. Do a Compression TestB. Do a Cylinder Leak Down TestC. Change Spark PlugsD. Run Sea Foam in the TankE. Get back to me.... ... Cars & Trucks

I have a jeep grand cherokee limited 5.9 liter and the turn signals just both stopped working. The diagram in the owners manual doesnt look anything like the one on the jeep. Which one is the right fuse to change for the turn signal?


... 1998 Jeep Grand Cherokee

I have a 1996 Jeep Cherokee Sport 4x4, straight 6 engine with a manual transmission. I was turning left tonight and it sounded like something dropped off my car and then it made a horrible noise, almost like the sound your car would make when the CV Joints need replaced, and now my Jeep won't go into 5th gear or reverse. Is there a way to see if it is just the linkage or if it is something internal without having to taqke it to a mechanic? I just don't want to take it in and be told it is som


... Jeep Cherokee

I have a 1994 jeep grand cherokee laredo inline 6, sometimes when i turn it seems like it has a hard time doing and sounds like maybe one tire is pulling faster/slower then the other one so it makes a skipping kind of sound, any ideas?


Could be a few things wrong(ball joints,tie rods,u joints),check your air pressure and if its ok take it to an alignment shop to get it checked out. ... Jeep Grand Cherokee

I need a front differential, how much labor is involved? I have a 98 jeep cherokee, and need a front differntial, about how much labor will be involved in replacing this?


You can usually locate a good used differential for between $150 and $250. New units are very expensive. It isn't a terribly difficult job if you have a half-way decent set of tools and some time. It takes about a full day to do the job on the ground ... 1998 Jeep Grand Cherokee

I have a 2001 jeep grand cherokee and the fan relay keeps blowing on me , the last time i changed it i also changed the fan motor, because i found that it was drawing to much power and blowing the relay....this fix lasted appox 6 months now i'm in the same situation .....what is the permanent fix for this problem? I have a 2001 jeep grand cherokee and the electric fan never comes on . is it the fan relay? and what does it look like.


Its almost always the relay..ther is a recall for that coling fan check with your local dealer with your vin to see if it applies to your truck... the relay is located under the right headlight under the bumper.... the best way to get to it is remove ... 2001 Jeep Grand Cherokee

I have an 01 Jeep wrangler within the last year the clutch assembly and components have been replaced. I let my vehicle sit for about 3 weeks and now the clutch will not disengage. It is almost like it has air in the line but when I was looking for the bleeder screw there is not one. Like I said it is a replacement master, slave and everthing else. I need help I really need to get this thing running for the fall. Any suggestions on how to bleed the air out without the bleeder screw I used the Ha


You'll need a friend\015\012\015\012Hold down the clutch (Not running) and crack loose the line fitting where it goes into the slave cylinder, be sure the master cyl is over full to allow for lost fluid\015\012\015\012that sho ... 2001 Jeep Wrangler

I replaced a climate control fan modulator on a 2003 jeep grand cherokee... jeep gave me one with a different wireing harness... i color matched the wires... the fan blows hard but not getting much air through any of the vents...if i turn it on auto for position it blows harder, but not much... when i put it on auto fan, i barely hear the fan... it has a 3 wire harness that i had to splice in... do you have any ideas


The wiring going into the fan motor itself are backwards. The fan isn't spinning the right direction. just switch these wires and it should work better ... Jeep Grand Cherokee

I need to replace a LDP valve in my 2001 jeep cherokee and I don't know where to find it. I've been looking online for an engine diagram but I was unable to find one, if someone was able to p


Under the Air cleaner assembly on the left front of the engine compartment ... 2001 Jeep Cherokee

1994 jeep grand cherokee. i just purchased this jeep and just had it looked at at a shop and everything, lately when i first turn it on it wont start, it wont even make that noise like the engine trying to turn, after a couple tries, it comes on and starts but the jeep is shaking very hard, the more i continue the drive the more the shaking stops, but this worries me especially after having it looked at by two diff places!! i was told to put fuel injector/cleaner in the gas tank and did so but i


It could be anything realy!\015\012get it checked again where you had it done last time as timing may have slipped its not uncomman! \015\012a compression check would be a good idea!\015\012as it may be low on a coupleof cylinders! ... 1994 Jeep Cherokee

2007 Jeep Cherokee 2.8 CRD. Glow plug light comes on when starting cold engine, then you will hear "ding" warning sound and the glow plug red light flashes continuously during the drive. Jeep replaced glow plug no 3 yesterday. This morning, same thing happened as before - light does not go off once engine is running. Jeep explained the problem might be water dripping on the glow plug - could be cracked cilinder head. Does this sound like a reasonable explanation? What can cause the glow plug to


... Jeep Cherokee

The block heater in my 2003 gmc w3500 is not working anymore and i need to replace it, could you send me a picture of what it looks like so i can get a new one. The one i got does not seem to be the right one. Thank you very much


Http://www.amazon.com/s?ie=UTF8&rh=n%3A15725551&page=1You will need the engine size. ... GMC W3500
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.9898 seconds