Having problems with your Hyundai Motor S ?

HOW TO PUT A 1992 HYUNDAI SCOUPE IN TIMING - Motor S Hyundai Cars & Trucks

Posted / edited by AnonymousUser on : 16-10-2017

Answers :

Theres a knock pin in the upper timing gear and it needs to be at the top and with it at the top theirs and mark on the edge of the gear that lines up with the mating point of the valve cover and the top of the cyclinder head. the lower gear has a dimple on the block at about2 O'Clock and theirs a cut out dimple thats on the back edge of the lower gear that can be turned to line up withthe dimple in the block, the zero mark on the ting cove will also line up in this position with the cover on and the lower pully installed. Manuel trans models also have a mark on the frywheel gear on the clutch cover under a rubber plug in the top of the transmission bell housing that will line up too only have to see the one lined up good, with the new belt on turn the motor over by hand till you see the marks line up again as it's easy to put the belt on one thooth off. make sure to tighten the tensioner bolt as it's easy to forget and the belt will come off soon and with bad results.
Repair Help & Product Troubleshooting for Hyundai Motor S

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0082 seconds