Having problems with your Hyundai Elantra ?

I have a 1998 Hyundai Elantra the signal, brake and tail lights are not functioning. I replaced the flasher fuse thingy. Can you help? I read it may be a combination switch but, I do not know where that may be located.

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

First of all, I have no IDEA what a 'flasher fuse thingy' is. I suppose if you want to start replacing components without determining they are the cause of the problem, I think you should start with the battery and work your way to the rear tail lights. OR, you could have the problem properly diagnosed and then you'd know exactly what's wrong with your vehicle and precisely what's needed to fix it. Ya think?
Repair Help & Product Troubleshooting for Hyundai Elantra

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 1998 Hyundai Elantra the signal, brake and tail lights are not functioning. I replaced the flasher fuse thingy. Can you help? I read it may be a combination switch but, I do not know where that may be located.


First of all, I have no IDEA what a 'flasher fuse thingy' is. I suppose if you want to start replacing components without determining they are the cause of the problem, I think you should start with the battery and work your way to the rear tail lig ... Hyundai Elantra

Had a diagnostic done and it read the code p0453 had a new fuel pump so the problem may involve the fuel pump if the evap is in the gas tank so i am trying to find out where the evap sensor is located is it in the fuel tank or is it in the engine somewhere. if its in the fuel tank i am covered for a year and can get it fixed cuz the shop apparently put it in wrong or something but if its in the engine i am screwed but need to know where the sensor is located so i know whether to bother fighting


The code discription is evaporative emission control system pressure sensor high. the sensor is located on the top side of the fuel tank. perhaps they did not connect it properly, kinked a hose or blocked the inlet port. ... Ford Expedition

I have a 2000 Tahoe with a remote starter. A combination of buttons may have been pressed on the remote, which is possibly the reason my ignition won't start with the key. I was told there may be a kill switch (toggle) that could reset it. I've looked everywhere except the right location. Does anyone know where the toggle switch might be installed.


... Chevrolet Tahoe

I have a 2001 Hyundai Accent 1.3i. Recently the washers stopped working even though they were full of water. My stepfather has checked and the fuse under the dashboard but still not working. I have read on other websites that it may just be an issue that the washer is clogged up but we don't know where the washer pump is located on my car or how to go about cleaning any gunk out, any help appreciated please


The washer pump is installed on the washer reservoir itself just look for the filling cup of the reservoir and the pump is right below RH fender probably.most probably you need to replace it ... 2001 Hyundai Accent

Lambda Sensor I have just had the entire exhaust system replaced on my 1997 1.6Si escort. The guy at the exhaust centre was pretty keen to sell me a Lambda Sensor (for a meer £100 fitted). I had my CAT go on my Mondeo and replaced the CAT and no further problems. I have read up on these sensors and it may be that replacing it is a possibly good idea. I can obtain one for £31 of the NET but I would like to know where to locate this part on the car. Can you tell me? Thanks, Chris


I have looked at the downpipe from the manifold and hey presto, sticking out of the downpipe rather than the manifold itself is the sensor. The wire is in a sheaf with a clip attached.\015\012\015\012This will be childs play in rectifying ... 1997 Ford Escort

1992 lexus sc300 with a 1jzgte twin turbo, i think the fuel pump is dead, it wont make any sound when you turn the key on also i want to know where is located the fuel pump relay it may be bad, the car wont start. please if u experts know where is located the fuel pump relay let me know it would be helpfull..


... 1992 Lexus Sc 300

My 2008 Toyota Camry Hybrid navigation system does not track my location. It may start correctly, but with a 5 mile drive it is off by .5 miles. My Toyota dealer does not seem to know what to do. It worked great until the built in CD player stoppede working and they replaced the entre unit including GPS system. Now it won't work at all. I believe the system may not be getting satellite updates as the car is driven and thus doesn't know where I am and what my direction is.


This same problem happened to me today. I just had the defective CD player replaced in my 2008 Hybrid Camry yesterday and now the nav system is tracking my car miles away from where I am. I haven't found out yet out to reset the nav system. I tried t ... 2008 Toyota Camry

My temperature gauge does not work. There is a good amount of heat coming out of the heaters so I know it's not thermostat related. I also checked all of my fuses and there fine. I think the problem may be in one of the modules located with the fuses under the hood but I don't know which one. The vehicle does not have an owners manual for reference. Can you tell me what the cause of the problem may be?


There are two coolant temp sensors one is for the ECM and the other is for the gauge. They should be located near the upper rad hose water outlet. Normally the one for the gauge is a single wire sensor. Disconnect it and turn the key on take a test l ... 1999 Ford Explorer

Using a MT2500 snapon scanner I found the code P0332- Knock sensor "2" signal short/low . I understand that there may be two knock sensors equiped but can only find one, located on the driverside of the motor. I would like to know where the other knock sensor may be located. Thank you.


... Chevrolet Colorado

Car is sputtering popping loud noise on acceleration.code read mass air flow sensor, replaced it but it did not solve the problem. The only other code its read is o2 bank 2 sensor 2 downstream. Do u know where this is located? Do you know what could cause this problem? Service engine light is now off. Any thoughts would be greatly appreciated.


You should try to avoid driving with this condition.If it is misfiring that is bad.I am not familiar with the location of the O2 sensor on your model,but a dealer or a shop will tell you for free to attract business.If your engine is backfiring,there ... 2000 Saturn LW

I need to know where the throttle positioning sensor is located in a 1995 pontiac transport minivan 3.8L so I can replace it. The code read low voltage. I replaced the alternator with a brand new one, not a rebuilt one, and it doesn't charge at all. All the gauges are not giving accurate readings also. I replaced the oil and the oil pressure sending unit and it still does not read accurate (10 - 20 lbs.).


All that sounds like your missing ground to engine.how dose it tern over ? have some one tap on the gas pedal look for the throttle body top of engine near that movement sho ... 1995 Pontiac Trans Sport

We have a new style VW Jetta (1999) .. need to locate the speed sensor. Check engine light is on again after sensor was replaced by mechanic. Car would /will not shift into high gear and chk eng light is back on. Don't know if mechanic actually replaced the sensor. Now says it may be an internal problem. I'm thinking it may have been a loose or bad connection that is 'acting up' again or if it was replaced then this one is bad also. Don't see the logic in mechanic saying now that it may be in


What you say sounds right, but good be internal, the first thing is to check the wiring to sensor and also a defective part is not an uncommon thing, the speed sensor is located on the rear of the trany,near the axle housing, i would check the connec ... 1999 Volkswagen Jetta

I may need a new oil sender/switch for my Capri XR2. My mechanic can't find the OEM one, it's discontinued. I have found some aftermarket ones with a range of 15-100 PSI. I read that operating pressure is 30-60 PSI and the gauge is 120 PSI range. I can't locate the correct PSI specs to determine which sender/switch to buy for the turbo model. Right after my oil change, the gauge was reading low. At start up, it's usually ok. As it warms, it's reading lower than normal. After a short sit and rest


I myself would go for the pressure sensor, should be located either on the side of the block or on the side of the side of the oil pan. If you're concerned about the reading, the aftermarket sensors you mentioned should work just fine. ... 1991 Mercury Capri

When I try to start my 2002 Ford Explorer, there is a repetitive 'tick'ing noise and nothing else happens. My battery is fully charged. Someone told me it may be the solenoid, but I don't know where it is even located. Do you think they are right? Where is the solenoid located? What is the best way to check the solenoid? THANK YOU to whomever can help me.


May also be the battery terminals or cables. Try cleaning/tightening cables first. If that doesn't work, you can try to jump the solenoid using tips here: ... 2002 Ford Explorer Sport Trac

Where is the camshaft sensor located? The engine light came on, so I took it to Oreilly and ran the codes. The camshaft sensor malfunction is the code it read. So, I need to know where it is located, so I can replace it. Thanks


It depends on which engine you have. It's between the cylinder heads either on the front (by the belt) or the back. Your sensor looks something like this:\015\012 ... 2005 Ford Taurus

I have a 1997 Holiday Rambler with a 1996 Ford F Super Duty chassis. The blower fan has failed but I know it works. I have troubleshot fuses, relay, fan selector switch, but nothing. Occasionally the blower decides to work and it sounds great, but it has not worked for a few days. I believe it may be the resistor but I don't know where the resistor is located. That is my next try. Where is it? Can you help. What does it look like?


It is not the resistor that gives you problem, open your fan blower and change the carbon brush inside maybe it is too thin already.... ... Ford Super Duty

Ecu malfunction 1992 cadillac deville. had a diagnostic and it read that the ecu is not working. what i would like to know is where in the car its located,how i would know that it is that what is causing the problem, and what does it cost


... 2001 Cadillac DeVille

I have a VAF computer reading. I know its Volume Air Flow, but I don't know what it is or where its located. help!


Vaf is about the size of a pack of cigarettes or smaller. usually located between the air filter housing box and the air intake at the throttle assembly. ... 2001 Buick LeSabre

My starter is going and some times it starts today it won't. I read if I hit it it may start but I can't locate. The starter to hit it. Where is the starter located?


I had a similar problem, hitting it may work some times but I think the contacts in the solenoid are worn out, replace the contacts, I managed to buy them at the local Auto shop, but not easy to find, or replace the starter.Removing and replaci ... 1991 Toyota Previa

ECTS location Would like to know the location of the engine coolant temp. sensor 2002 S-10, 4wd, 4.3, 6 cyl. Believe it may be faulty.


The sensor is on the left side of the engine between cyl 2 & 3. It can be removed using a deep socket or a ratcheting box end wrench. It is a pain but can be done. ... 2002 Chevrolet S-10

Where is the fuel filter located in a 2004 nissan sentra se-r spec v? My car doesn't start....it cranks over just fine, and the battery, alternator and spark plugs are good, and the fuel pump turns on...i'm thinking that it may be a logged fuel filter, but just don't know where it is located.


Inside the fuel pump which is inside the tank. its a complete unit. just changed one today ... 2004 Nissan Sentra

I have a 5.9 liter high output turbo cummins diesel. i lost all power and i have a read out that says, p2146 Fuel Group 1. i think the turbo may have went out. i lost all power while pulling a fifth wheel. please let me know what this read out means.


... Dodge Pickup

I have a 2001 chrystler sebring coupe lxi 3.0 where is my oxygen sensor its reading bank1 sensor2 pl let me know where to locate this sensor location thnks


So what your saying is there is not another O2 sensor on the exhaust manifold like the one in front of the car? What is the sensor that is by the firewall in the exhaust that looks like an O2 sensor but has a different plug to the harness ... 2001 Chrysler Sebring

With with key on and engine NOT running my oil pressure guage reads HIGH oil Pressure. This is true even after changing the oil and filter. I want to change the oil sending unit but having trouble locating it. I know it is on the side where the oil filter is but not exact location. Everything else is normal and engine runs good. Does not use any oil and no other issues with 149,000 miles on it.


Is it the 4.0 litre engine? if so its screws into the oil filter adapter ... 2002 Jeep Grand Cherokee

1993 Subaru legacy computer location. I was told my computer may be bad but i don't know where it is located on my car


It should be on the passenger side behind the glove compartment. ... 1993 Subaru Legacy
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.6746 seconds