Having problems with your GMC Cars & Trucks ?

Bleed valve for power steering pump

\015 1999 bleed valve for power teeming pump\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for GMC Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bleed valve for power steering pump


... GMC Cars & Trucks

This is about the high pressure side hose from the power steering pump which has a sort of electric shut off. Dati nag leak at pinalitan ng bagong hose using the same valve. after 2 months, umingay na na pag pihit ng manibela. Pag inalis mo yung connection ng kureyente o ibalik mo man, parang walang epekto. Ano problem? Yung electric shut-of o yung hose o and power steering pump. Magkano yong pump, o yun bagong hoes assembly kasama yung valve. Thank you Eugene Calicdan E-mail: [email protected] ya


First try to replace the Hi side hose w/ original one before u buy a PUMP assembly!\012U could buy cheaper part in Banawe, Young Bros. is the store, they could get u a replacement and original w/ discount! ... 1996 Nissan Sentra

My IH 1256 tractor lost power steering and new pump did not work. The 3 pt went out also. Put a new p steering pump and can't prime, but 3 pt started to work again. Will change spring & filter next. Old oil very dirty with sludge, bought used recently. Old & new power steering pump both pump if stick in bucket of hydraulic oil and spin gear by hand. Understand there is a check valve that might have sprung open while pulling land leveler. Not sure where it is located. Any help appreciate


... Cars & Trucks

Is there a bleed valve on the power steering pump?


... 2000 Pontiac Grand Am GT

New power steering pump put in, lines bleed, and still having whinning noise. Is there another part with the power steering pump we can check?


Are you sure the noise is comming from pump and not the belt tension pulley right next to it ?I use a wiffle ball bat with both end caps cut off (hollow tube) held to my ear to help localize noises on running engines I have ev ... 2001 Hyundai Santa Fe

I have a 2002 Saturn L300 and recently (02/01/2010) had the following work done: 1. Pads, disc brake rear 2. Replaced Pressure control solenoid valve 3. Replaced Serpentine Belt 4. Replaced air cabin filter 5. Replaced water pump and timing belt 6. Power steering pump replacement and leaking O rings. I now am having problems with leaking gas - gas pump needs replacing and leaking power steering. Could these latest problems have been caused by the previous repairs? If so are they covered by 12 mo


None of the above have any bearing on the failure of said parts in any way or form.as they are not even connected to each other. ... 2002 Saturn L-Series

Taurus noisy power steering pump? power steering pump was noisy and fluid with bubbles was pushed/forced out through the cap; replaced the P/S pump and it is still doing the same even after system was bleeded.


... 2000 Ford Taurus

II have a 1994 sedan devill the power steering dosn't work the reservoir is full of fluid and I can't find any leaks the drive belt is tight there is no noise comming from the pump even when you turn hard to one side and hold it do you think this is a bad pump or a problem with the steering gear it turns smooth just very hard also the book mentioned somthing about a pressure controle valve and manifold on some models on the rack and pinion so could this pressure valve be bad if so were is it an


This is hard to tell what is wrong, without doing some tests. I would say that the actual power steering pump is the problem. The Deville had lots of problems with the power steering pumps had lots of problems in these cars. ... Cadillac DeVille

I have a 2000 ford ranger 4 cycl engine i just replace driver and passenger upper and lower control arms and shocks and stabilizer bar links and now my power steering pump is squeling and the fluid is a tan color and when i tried to bleed it i filled it like i was suppose to but if i turn the wheels while the truck is turned off than start the truck it shoots the fluid out the top of the pump where the cap is........is that common and ok or do i have a problem in my power steering system ?


Okay....first, you have a lot of air in the system...hence the tan color. You need to do this procedure about 12-20 times.\015\012\015\0121.) With the engine off and the front wheels ... 2000 Ford Ranger SuperCab

Steering HELLO, I have a steering problem on my 66 mustang I have power steering, When turning left or right the steering wheel will pull or jump. I dont see any leaks in or around the pump or hoses, should i replace the pump? I was also told to check the check valve on the pump/okay where is it located?


Ok, if your a do it your selfer, her you go. http://www.stangerssite.com/Optimum/index.html\015\012\015\012this link will take you ... 1966 Ford Mustang

I have a 1990 Toyota 4 runner that i just replaced the front seal in the power steering pump and the seals in the steering box and now the pump will not pump-i have tried everything the haynes repair manual said on bleeding the system but still the pump is not working. Anyone got any ideas?


Did you use a power steering puller tool to remove and reinstall the power steering pulley?\015\012If you even tapped lightly on the pulley to reinstall it you probably broke the clip that locks the power steering shaft to the pump inside. ... 1990 Toyota 4Runner

Had to change the power steering pump and high side hose, now the p.s. works when it wants to. The unit has the speed sen. steering and all is hooked up and bleed but it just works some times and doesnt some times. I also have the 3 lights on the dash (ABS Trac and service soon) and was reading that this is mostlikly a bad speed sen. on the front end. Would this also effect the power steering?


Its an electrical problem ... 2000 Oldsmobile Alero

Power steering My sister used my car to go on a trip. She checked all the fluids on a pittstop but did not replace the power steering cap. It did not seem to run completely out but got hard to steer after I filled up the tank. I have had no luck getting a new cap or even used so i made a makeshift one for now. Not losing any fluid but still hard to turn the wheel when stopped or going slow. is there a bleed vavle somewhere that i can not see or is the pump shot. and If air did get into it how mu


Try filling the P/S pump resevour and slightly turning the steering wheel side to side just enough to activate the P/S pump. Remove the return line from the pump and keep turning the wheel until you have a really good flow out. Be sure to keep adding ... 1998 Plymouth Breeze

How do you bleed the power steering pump


Fill up with fluid. Start engine and let idle. If there is no blockage, turn steering wheel lock to lock, three times should do it and then refill with fluid. ... 2004 Lincoln Aviator

03 land rover range rover, loss of power steering. Replaced power steering pump and switch on rack and pinion


... Land Rover Cars & Trucks

Replaced power Steering pump and bleed it still will not turn


... 2000 GMC New Sierra 1500

We have a 99 dodge Durango bringing up codes po123 and po443 and it runs pretty good but after driving for a bit it just dies then start up again and dies again we have changed pcv valve, fuel pump & filter & lines, the Tps, plugs and wires, fuel cap, rotor, distrib. Cap, purge valve/ sylenoid, power steering pump, battery and cables, air filter. We just don't know what else to try its got us boggled and penniless lol any ideas???


Code 123 is for a problem with the throttle position sensor circuit. So if you have replaced the sensor, either it is not calibrated or there is something going on with the wiring back to the computer.Code 443 is for the EVAP purge control circu ... Cars & Trucks

Hi I have a Mercedes sprinter 314 petrol i have removed some pipes from the power assistant pump in order to remove a radiator. As I have refitted all back together I have this noise coming from the power steering assistant pump. I heard that it might will need for the fluid to be changed and the system to be bleed. Could you please confirm?


I have never heard of anybody bleeding the power steering pump, if you drained it or it just drained with the hoses removed, just fill it back up. It will pump itself through. The only noise out of that pump would be squealing from no fluid. I don't ... Mercedes-Benz Sprinter

I have a 2005 gmc serria with 60k miles, replaced the power steering pump, but after bleeding the pump and running for about an hr, the fluid burns and is hard to steer


OK, I would maybe try to jack up the front, and turn the steering wheel left and right a few times and check for the fluid level to make sure it's not low.\015\012\015\012Try to bleed again, if necessary.\015\012\015\012How do ... 2000 GMC Sierra

How to diagnose 1999 Pontiac Grand Am Power steering problems. Power steering fluid level seems fine. Loss of powersteering. Fine on the road hard on start up from standing start. Do I need pump, rack, bleeding, or ??????


It could still be the pump is it making a whining noise,and does the fluid smell really burnt.jack the car up and put it on jack stands set the e-brake and chock the rear tires so it can not roll,then start the car and see if there is any binding the ... 1999 Pontiac Grand Am GT

Have 2 Hummers ( both 1995) that have a Hydrualic 'boost' loss to steering when brakes applied. Steering power increases if I flip the throttle which allows me to turn the wheel when throttle is hit. Brakes also lose some power. Not noticiable at speeds over 15mph, only on slow turns. Fluid levels for both systems are normal and no leaks from the lines. Is there a proprtioner valve that controls pressure from the hydrualic pump that may have failed and if so, where would it be found ? Denni


At the back of the pump where the high pressure line attaches. I'm not saying thats your problem, but thats where the valve is. I think if you disconnect it, it should have full boost. ... Hummer H1

How to bleed power steering pump on 2000 mercury sable


No bleeder vavle on power stering will get the air out on its own ... 2000 Mercury Sable

1995 ford escort power steering pump valve


... 1995 Ford Escort

How to bleed power steering pump on 2007 gmc 3500 diesel


... Chevrolet Silverado 3500

How do you bleed the power steering pump on a 2000 ford taurus


... 2000 Ford Taurus
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.0863 seconds