Having problems with your Ford Contour ?

Rear brake lights in 1996 ford contour not working. Tail lights, signal lights and 3rd independent brake light still working,

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Ford Contour

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Rear brake lights in 1996 ford contour not working. Tail lights, signal lights and 3rd independent brake light still working,


... Ford Contour

I have a 95 chevy blazer and my brake lights and signal are not working however the 3rd light works. Just replaced the signal switch and the brake lights work now however the signal still does not work. My dad is trying to get it working for me but we are at a lose as to why it not working. We are on a time crunch because I head back home tomorrow. Thanks for any suggestions you can offer.


Do the lights turn on on the dash when you signal left or right?Do the four way flashers work?If no to either of these check the turn signal flasher module. ... 1996 Chevrolet Blazer

Brake lights My 3rd brake light works i changed all the bulbs, fuses, brake light switch and my tail lights still dont work my signal lights work but my tail lights dont when i push on the brakes do you know what else could be the problem, could it be the brain in the computer of the car, Jermaine West ([email protected])


No it is not controlled by the BCM the issue is most likely caused by the turn signal switch itself, a bad internal connection, very common on GM cars and trucks. ... 2000 Pontiac Grand Prix

2005 pontiac montana SV6, last 6 months blowing the same rear drivers signal light( fishy ) so i cleaned the connection and put dielectric grease, problem solved( i thought ). recently the "service park lamps) " warning turns on with no other issues. then one day weeks later both signals (rear is also brake light) front and back stop working, however 3rd brake light still works, light in the van flashes real fast both sides. What i've tried... changing fuse #20 10a fuse(park lamps), blown- repla


Never replace a circuit with a fuse that is stronger than what is asked for as you will then burn the wiring.i would get my hands on a wiring schematic and trace the problem with a tester.once found replace the bad wiring or relay with the right part ... 2005 Pontiac Montana SV6

I have a 2001 Dodge grand carava Sport 3.3 liter. My problem is, my braking light is not glow when i brake, other than that all light are good. Left turn right turn and emergency signal are working except the brake light. This including the 3rd light on the back too. I already replace the break switch module over the break padal but still didn't work. I really need help.


Most likely, the wire is broken sending electrical power is broken somewhere. ... 2005 Dodge Caravan

Lights I used my emergency flashers, and now my brake lights and turn signals do not work, but 3rd member brake light still works, can you please help?


Engage and disengage the 4 ways a few times and see if problem clears, if not u will need to replace the flasher switch. ... 1998 Chevrolet Lumina

Have the 3rd brake light, turn signals, tail, reverse, etc...everything but the main brake light (both sides are out) and hazards. Ive replaced brake switch, the circuit boards, and am continiously looking for shorts. I was towing a trailer, they worked, then just stopped? No trama to the vehicle, just quit. Did find blown fuse and replaced which is why I was thinking short. Since replacing brake switch, I still have no brake lights, and now have a lockout problem where I can not get the veh


Change the bulbs if not there a switch is on the brake peddle it could b it ... 1996 Chevrolet K1500

I had my turning signal, hazard and brake lights all go out at the same time. I had an extra brake switch from a neighbor that also has a 2003 Durango. Anyway, swapped that out and everything was still not working. The fuse for the Hazards and Turning Signals looked okay but I swapped it out anyway. Turning signals and Hazzards work now but still no brake lights. Tried putting back in the other brake switch and still nothing. I can't find a fuse for my brake lights under the hood or in the cab s


It seems that there is a fuse which is causing this fault,I would suggest you get a meter and test each fuse at a time,do not assume fuse is ok by just looking.Now if the brake lights work and your signal lights starts to play funny then test the fla ... 2002 Dodge Durango

2003 CHEVY IMPALA BRAKE LIGHTS NOT WORKING REPLACED BRAKE SWITCH, TURN SIGNAL SWITCH BULBS FUSES AND RELAYS STILL DONT HAVE BRAKE LIGHTS ONLY 3RD BRAKE LIGHT


... Chevrolet Impala

All lights work and brake light at top works. brake lights on bottom left and right don't work. It was hook up to trailer wires connection. going down the road and when you turn on the right turn signal the cruise control would go off. the brake lights would come on but the right turn signal would stop working. as soon as you let off the brakes the turn signal would work again. I took the trailer connections off and replaced brake fuse and they still don't work.


Check a few things...\015\012- The bulbs\015\012- Check for ground at brake lamp connectors\015\012- Check your wiring at the connectors for power\015\012- Check for another fuse blown \015\012- Do not hook up the traile ... 2000 GMC Safari

I have a '05 Ford Ranger. I bought a camper shell that has a Third Brake Light and I would like to hook it up so it works when I apply the brakes. Hooking the camper shell 3rd Brake lights to the p/u brake lights won't work as the p/u does not have separate turn signals. So if I turn the signals on, the camper shell 3rd brake light will blink. There has to be a way! thanks!


There will be four wires going to your lights you will have to test each wire to see which wire is for the brake light and tap into that wire. on all ford rangers one bulb controls everything so you can't just hook it up thru your bulb so you will ha ... 2005 Ford Ranger

Here's my problem...My truck has four wires for my trailer, Red-Brake, Brown- Running lights, Yellow-Left signal and Green-Right signal. My trailer also has four wires, Yellow-Left signal, Green-Right signal, Brown-Running lights and White-Ground. My Question is, how do I get my brake lights to work on the trailer when all the wires are already used up for signals and running lights. I still am left with the brake wire on my truck. Am I able to get brake lights working on my trailer too?


Also try http://www.etrailer.com/faq-wiring.aspx. They have easy to follow directions and color codes. Plus you can order anything you might need. Hope this helps. ... 1987 Toyota Pickup

I recently replaced the front rotors, brake pads and master cylinder in my 2003 Durango. I've since discovered that the brake lights are not working, including the 3rd brake light in the tailgate. I checked and the top bulb in the left and right assemblies as well as all 3 bulbs in the 3rd brake light assembly were burned. The tail lights, reverse lights and signals work fine (other than the 2 top bulbs). I replaced those 2 bulbs as well as the 3 bulbs in the 3rd brake light assembly but sti


Hello, Well there is not much more it could be unless you have a shorted wire or a burned fuse. I would normally think that the turn signal canceler was bad but the 3rd brake light will still work if that is bad so I would check all fuses and for bar ... 2003 Dodge Durango

How to change turn signal switch, brake lights don't work third light works signals work hassards work replaced brake switch at brake pedal new bulbs changed sockets around ,back-up light sockets down to tail and brake etc position but still no brake lights


... 2000 Chevrolet Cavalier

No turn signals and no rear brake lights the 3rd brake light still works i have checked all fuses and relays


Im, having same problem did you find a solution? ... 2001 Dodge Ram 2500 Truck

95' Buick regal, 3rd brake light works, tail lights work, turn signals work, stoplight switch seems to work ie 3rd brake light working, fuse is ok, changed bulbs, but no rear brake lights.


I dont have a diagram but the brake light switch has to feed the turn signal switch, Either that wire has a bad connection, or the turn signal switch is bad. Jiggle the turn signal lever and see if the brake lights try to work. ... 1995 Buick Regal

My 88 jag xj6 has a tail light problem. the turn signals work. the brake lights work. the tail lights work. but if you have the turn signals on and hit the brakes,there are no lights on that side in the rear. the blinkers still work in the front. the opposite side shows brake lights. i'm confused as to what would cause this. any advise?>


Hi, you have a bad earth connection either where it connects to the light unit or to the body, suggest you clean and refit at these points. ... 1988 Jaguar XJ6

Have 16' cargo trailer and the drum brakes went out when the side lights stopped working. The signal lights still turn on and the brake lights work too. I replaced the pig tail on the trailer hook up wire in the front. Still did not work. The lights and brakes worked fine the day before this happened. What could it be?


You have the wiring crossed up ... 1990 Toyota Pickup

I have a 2000 Lincoln LS that is giving me a check right brake lamp error when running it's self diag. The problem is that none of the brake lights are working. All of the other lights (turn signal, rear lamps, etc.) are working just fine, just not the brake lights. I have checked all of the fuses, and have checked and replaced the brake lamp switch but they are still not working at all, and the car is still giving the same message.


Hi, odds are your REM has failed. Remove the carpet lining on the passenger side of the trunk, the module is bolted inside the quarter panel. Check to make sure the signal from the brake light switch is coming into the module on the or ... 2000 Lincoln LS

Ok - changed all the blubs for turn signals, brake lights etc and still they wont work - signals keeping going fast, no tail lights, no fan from the heater but the heater works, Brakes lights work and head lights work - so would lke to know what to do thanks


Did you check your fuses? it may be blown fuses or a short in the wiring ... 1994 Chevrolet S-10 Blazer

2000 Mercury Marquis lighting problem.No brake lights,except one in back window is working,no headlights,dashlights,turn signals or flashers. Replaced LCM with used one,don't know if it's a good one but brake lights work now. Still no headlights,turn signals light but don't flash, flashers work but real fast and erratic, and no dash lights. Did I get a bad module or do I have other problems.Anyone have diagrams?


All these functions are controlled by the LCM, this module is unique to each cars paticuliar accessory package, u may have the wrong one or like u said it is defective, the module can be self tested for proper function by a ... Mercury Grand Marquis

I have a 1992 Chevrolet Corsica LT. I'm having trouble with the turn signal's. I've checked every bulb, socket, and ground wire. I've replaced the fuse, flasher and the turn signal switch. All the other light's work fine including the parking light's, brake light's, and 4 way flasher's. The turn signal's still don't work, not even the light's in the arrow's in the dash don't work for the signal's but DO work for the 4 way flasher's. I could really use some help here.


DID YOU REPLACE THE BULBS ... 1992 Chevrolet Corsica

2005 impala rear (passenger side) blinker and brake light wont work... the parking lights work fine. I changed the turn signal light figured that was the problem since the front passanger blinker works just blinks very fast. Any ideas? The 3rd brake light and rear driver side brake light and blinker work just fine


... Cars & Trucks

Chevy S10. When my running lights are on everything works (except turn signals), front lights, tail lights brake lights. When I turn on my headlights turn signals still dont work everything comes on fine but when I push on the brakes my tail lights/brake lights go out except for the tail light above the bed of the truck. Please Help!!!


Check the grounds on your wiring.\015\012If you have a trailer harness, make sure there are no shorts, or crusty connections\015\012\015\012Good Luck chasing the gremlins ... 1996 Chevrolet K1500

Inside the car my turn signals blink rapidly, outside the car neither brake lights or turning signal work. i have replaced the bulbs and still nothing. at night my tail light are on but neither brake light or turning signals works, WHAT CAN IT BE?????


Are you sure you installed the correct bulbs .Double ck you installed the bulbs in the correct socket and that the bulb #(1157)(3157) is the right bulb installed. ... 2000 Buick LeSabre
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.6694 seconds