Having problems with your Dodge Ram Pickup 2500 ?

P2262 Turbo/Super Boost pressure not detected

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Dodge Ram Pickup 2500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

P2262 Turbo/Super Boost pressure not detected


... Dodge Ram Pickup 2500

I have a 2004 ford f250 6.0 diesel i get a code that reads (turbo boost pressure not detected mechanical)


... 2004 Ford F250

I have 2008 dodge cummins, eng light came on and the fault code said turbo/super boost, pressure not detected, mechanical service. truck only has 12000 miles on it. any help would be great


... 2008 Dodge Ram 2500

Boost pressure problems for audi A6 the car lacks power . The Turbo and the manifold are both intaking air/carbon when the manifold should be pushingthe air to the turbo to the intercooler. It seems an electronic problem... changed all hoses from turbo to inetrcooler and changed pressure boost sensor found on intercooler and pressure valve controller black part found on the bottom right part of the engine with the shape of an inhaller. seems to be an electronic problem....


What is your actual psi? check into the other divertor valve or the n75 valve(electronic) ... 2008 Audi A6

I have a LT35 2.5Tdi Eng Code AVR. This bus will just loose power at any moment , then you just switch off the ignition and on while driving and the power is back . On down loding the ECU with Texa Diagnostics it will give you a "Overboost Pressure Adjustment , Boost Pressure Control Lower Adjustment Limit" With my Bosch KTS550 it will show "Boost Pressure above limmit". I have fitted a new Turbo and Vacuum Control Valve, Set the injection timing from 4-8 Deg, fit a free flow exhaust system,


... Volkswagen Camper

No turbo boost pressure. Ford said the truck needed three injectors and a new ficm. Replaced the injectors and its running fine except for the boost pressure


... 2005 Ford F 250 Super Duty

No power , just changed turbo / boost pressure sensor / new cat / new maf sensor / still low boost / any ideas


... Cars & Trucks

2001 jetta tdi turbo over boost pressure exceeded, is this the pressure sensor


... 2001 Volkswagen Jetta TDI

Boost pressuse i,ve pluged into renault traffic 1.9 dci. heater light is on. code p1804 boost pressure valve coming up as fault code. replaced boost valve and alas, same fault code appears. im at van at present time, any clues


... Renault 181

Hi when i push the car it go's in to limp mode, i had it checked yesterday and the codes 16618/P0234 boost pressure regulation limit exceeded. cover boost condition came up do i need a new turbo ? please help Nigel


In your case the turbocharger is responsible for engine losing power. The car goes in "limp home" mode!!! Fault code: P0234-Turbocharger, engine boost condition - limit exceeded 1. Engine ... Audi A3

My 08 saturn vue has an odd chemical smell and film on the windshield. Had a shop visually inspect for foreign matter in heater box, and used a boroscope to inspect ducts, nothing found. R&I the blower moter, nothing. Pressure tested the cooling system both at cold and operating temps, holds pressure. tested the a/c system charge, good. used freon sniffer to detect leaks, none found. Replaced the cabin air filter. Any suggestions as to what might be this problem?


There was a problem some years ago with sunlight liberating fumes from the plastic on the dash of certain cars and causing a film to form on the inside of the windshield. It could be what you are experiencing ... 2009 Saturn VUE

I have a 2006 GMC W4500 Diesle and these are the read codes (mode 3) that I recieve when it is hooked up P 0087 fuel pressure to low P 0093 fuel system leek detected / large P 0302 Cylinder 2 missfire detected


Have you serviced the fuel filter/water/seperator/heater? P0093 could also refer to the possibility you filled the truck up with fuel when it was running setting that code. The code for fuel pressure is derived at the rail delivery on a Duramax, ag ... GMC Sierra 3500HD

No power from turbo at all. Rear exhaust seal was loose but I still can't stop exhaust from leaking at this point. Turbo spins well without and signs of being loose. It does not seem to build pressure of apply pressure to engine. Old Banks Power Pack is installed so the gauges show high exhaust temp and no turbo boost at all. Any suggestions for a cash strapped owner?


... 1995 Dodge Ram 3500

I have a 2007 Chevrolet Trailblazer with the engine light on. It came on 2 days after filling my gas tank and yes I did top it off (rounded up to the next dollar).. Took it to autozone and the print out says.... EVAP flow during non-purge condition, explanation: The ECM has detected pressure in the EVAP system during a non-purge condition Probable cause: Purge or vent solenoid; Plugged EVAP canister condition: Failed EVAP pressure sensor. Thoughts???? Cost at dealer to repair??


Crank down on your fuel cap, as the computer can take the lack of a sealed system as a more serious issue. ... 2007 Chevrolet TrailBlazer SS

1990 chevy blazer ac clutch not engaging and after two and a half cans of refridgerant plus detect and stop leak shows no pressure. Bought a new low pressure side clutch cycling switch.


... 1990 Chevrolet K1500

I have an 07 sprinter with trouble code 2359 low turbo boost change the turbo because it had an internal oil leak if i turn off truck than restart it smees fine but promblem comes back can a faulty boost pressure sensor cause this promblem? any thaughts will be gladly appreciated


... 2007 Dodge Sprinter

Just replaced the transmission/turbo/fueling/ had my ECU refalshed with the performance software i've had on, the only problem i cant seem to figure out is why im suffering from a boost leak, if i have the pedal to the floor, i'll spike 23lbs of boost, hold 15, once i start getting close to 4,000RPMS the pressure drops to 10lbs. i've checked all vacumm lines and replaced the n75 valve


Is this a Kerma tune? I have the same thing with my 02'. The reason for the drop at higher rpm's is that the volumetric efficency of the motor decreaces in the higher range and doesn't need AS MUCH boost pressure. This is normal. \015\012 ... 2002 Volkswagen Jetta TDI

Interpret dtc codes ford f350 7.3 powerstroke DTC#03- P1316 Injector Circuit/IDM Codes Detected 02 P0478 Exhaust Pressure Control Valve High Input 01 P0470 Exhaust Back Pressure Sensor Circuit Malfunction


... 1999 Ford F350 Regular Cab

When I turn off my 2001 Camry I can hear what sounds like a high-pitched whistling that lasts for about 15 seconds and it appears to be coming from the brake booster.Brake fluid levels were fine and I could not detect any leaks. Brake pressure seems to be OK and so far no noticeable difference in braking pressure when depressing the pedal but I've not yet tried the trick of pumping the brake pedal with the engine off, depressing the pedal and turning engine on to see if it rises or falls.


It probably is from the brake booster. The booster uses engine vacuum to assist in braking. It's either a vacuum hose leaking, or possibly the diaphragm in the booster itself. Apparently, the leak is small right now and is not affecting performance ( ... Toyota Camry

When the car starts to make boost it will jump to 16 lbs and then it will fall back and hold steady at 10 and 12 lbs some times is this due to the head not being built and the boost pressure pushing the intake valvs back open?


Possibly but i would look to see what your waste gate is rated at ... 1996 Mitsubishi Eclipse

Isuzu Hombre pickup (same as Chevy S10), 2.2L Vortec, Won't Start. I have an Isuzu Hombre pickup, 2.2L Vortec engine. It just suddenly stopped running. Here's what I checked: ignition module (good), ignition coils (good), fuel pump (good), fuel filter (new/good), fuel pressure to fuel rail 39 psi (good), battery (good), spark plugs have good spark (good), I hooked up code reader and it detected one code: (PO452 emission control system pressure sensor low). This code can't be the problem with my


... Chevrolet S 10

I have 2004 jetta gls tdi eng. light is on.diagnostic machine says its turbo charge underboost, when im driving it loses pressure and rpms dnt go up,when i restart it it works fine but eventually goes back to losing pressure no boost how do ifix this myself?


In the VW world it's called "Limp Mode" and unfortunately it's relatively common. Here's a link to some useful info on limp modehttp://www.myturbodiesel.com/1000q_how_to/multi/limpmodetdi.htmAlso check out www.tdiclub.com - t ... 2001 Volkswagen Jetta TDI

I have a Touareg VW, 2004, V8 with active suspension, 4 wheel drive and tyre pressure monitors. These monitors always give me problems as they dont detect the pressure and the defect appears on the dash computer. Two of the 4 sensor modules need replacement and they are expensive. Is there a cheaper solution o is better to disconnect the whole monitoring system altogether? Thx


Your not going to be able to disconnect the monitor system with out causing other problems. I've had this same problem and the only solution was to replace the defective pressure sensor monitors. Have you tried deflating the tire down to a very low p ... Volkswagen Touareg

Hi vw experts i have a 05 vw caddy van bought it second hand was ok for a while now engine managment light is on and no boost pressure van drives ok a bit sluggish up hills but no turbo boost also using alot of diesil 1.9 tdi


... Cars & Trucks

Hi I've been having boost pressure problems with my 2003 L200 Warrior. It kept going into limp mode so i took it into Mitsubishi and they fitted a new boost sensor and set it up, however the problem is still there and the old limp mode is driving me mad!, can anyone help?


... Mitsubishi Pickup
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7183 seconds