Having problems with your Dodge Dakota ?

Cooling line fitting at transmissssion broke

\015 2004 dodge neon. the car was wrecked and the front frame is pushed into the radiator causing the cooling line to the transmillsion to shove forward. the fitting is broke at the transmission. i am going to pull the frame back out but can i get a diagram for replacing the lines?\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Use the fitting as a sample, have someone at a garage, or parts place, flare a piece of tubing to it as long as you need to attach rubber line, or did you want to put back like original?
Repair Help & Product Troubleshooting for Dodge Dakota

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cooling line fitting at transmissssion broke


Use the fitting as a sample, have someone at a garage, or parts place, flare a piece of tubing to it as long as you need to attach rubber line, or did you want to put back like original? ... Dodge Dakota

I am changing the vapor canister on my 04 toyota matrix xr and I'm having a problem with the small line that has a special clip on fitting. I can't get it off and I broke the line trying to get it off.Luckily, it was just the end that has that fitting, so there's enough to buy a new fitting and put it on. How difficult is it to find that special fitting?


You can get a new Fitting at the Toyota Dealer unless the Fitting is part of the line. Some Car Mauufactures, to make more of a profit, will only sell the part as a Whole Assembly i.e. Hose, Fitting, Canister, instead of selling them individually, so ... 2004 Toyota Matrix

Chevrolet Silverado cooling line fittings on radiator


... Chevrolet Silverado 2500

I have a 1999 taurus 3.0 v6. The trans cooler line was leaking bad. the shop replaced the connector fitting at the trans. this is a snaplock type fitting, an o-ring inside and a plastic insert to lock it in place. well it still leaks bad, what i need to know before i have them replace the cooling hose/tube ,is could they have not installed the tube end in the fitting wrong. the hose replacement bill will be about $300.00 thank you for any help


You can buy a snap in replacement end that can be bent and attached to 3/8 th's fuel line and by pass the rotted metal line. I have been doing transmissions Since 1981, and have the same rotted lines on my 01 Windstar. I just went to all hose except ... 1999 Ford Taurus

1999 Chevy Cavalier Can not remove the quick connect fitting from the fuel filter. Looks like someone tryed and broke the black plastic part around the fitting where you squeeze to release the line from the fitting. Where do I go from here.


You can use a pick to remove the plastic clip,And use a fuel line disconnect tool to release to line.If you do not have that tool you can get one at advance auto parts.Be patient it may take some time to remove it. ... 1999 Chevrolet Cavalier

I broke the brake line on the drives side when i tryed to loosen nut off.Now i have to put a new line from the master slinder to the flex hose. What size brake line and fittings for a 1998 saturn se frount driver side


No substitution when it come to brake line due to safety factor, i very doubt you going to find it at the local auto parts store and would not recommend to modified or rig the brake line due to high pressure involved. I would either pick ... 1998 Saturn SL

I broke a rear brake line and replaced it myself and now i cant bleed the air out of the system and yes ive inspected all lines for holes or leaks checked all fittings and book doesnt have any info about it and says to take to the dealership and i dont have that kind of money so some help would be nice


Some times there is so much air in the system after a repair like this that it takes a Looong time and a lot of diligent pumping to get it all out... the proper procedure to do it manually is to have two people and when the helper pushes the pedal do ... 1990 Toyota 4Runner

Any online manuals sowing how to replace rear driver side brake line. Brake line is broke off at the fitting on the back side of the wheel


Replace the wheel cylinder. You'll never get the broken fitting out of the old cylinder. ... Ford Ranger

My transmission cooling line that runs into a fitting on the radiator is leaking ,not from the nut but around the fitting


You can remove the fitting and put teflon tape on it but use the teflon for lp gas It should be the yellow roll not the blue,. ... 1997 Saturn SL

Old transmission cooling line fittings dont fit new radiator


... Ford Windstar

My air conditioner quit cooling. i was going to add freon but cannot find the low pressure port. it has 2 ports on the same line and my fill tool will not fit but one. the freon will not go in.


The ports are keyed - you found the proper port if you have the proper hose. If the Freon will not go in - and you have complied with all the package instructions ... right? ... Freon is not your problem. Going much beyond what you have done alread ... 1999 GMC Sierra

I have a 2000 gmc safari, the air conditioner blows thru the defrost vents. I see the vacuum line that is broke but cannot find where the other end fits. i need a diagram


... 2000 GMC Safari

Removing fuel lines at pump broke fittings how to fix


Replace the lines or take them off and have someone put new fittings on them. ... 1995 Saab 9000

Where can i get the compression fitting on the end of line going into the radiator. made the mistake of trying to take it off without the right tool, and broke it.


Any auto parts store should have one. take the pieces of the old one with you so they can match it up ... 2006 Ford F 350 Super Duty

My hydraulic clutch line where it meets w tha connector under the fluid box in the motor compartment broke @ the fitting..... What do I do


Mine broke to i used copper tubing to replace mine it want break on me again i hate cheap made clucth line ... 1992 Chevrolet S-10

Have a 94 ranger need to replace the rear brake lines. Took them off, took the old fittings w/me to the parts store they sold me 2 40'' 3/16'' lines with fittings and 1 3/16'' to 1/4'' adapter,the adapter seems to fit on the wheel cylinder but not on the fittings on the new lines and the new lines don't want to fit on the truck. Did they sell me the wrong size or wrong thread or what??!


Yes they sold you the wrong size ... 1994 Ford Ranger Supercab

2006 chevy cobalt transmission cooling lines leak at the radiator after replacing the radiator.


... Cars & Trucks

Transmission cooling line leak


Its very hard to find a shop that fixes anything any more ... 2003 Chevrolet S-10

I just replaced all the steel brake lines and the 3 flexible lones on my 98 dodge ram 1500 4 wd pickup. I am not able to get brake fluid out the bleeder valves . I might have routed the lines from the masterc cylinder to the proportioning valve and rear abs incorrectly . do you know of a routing diagram i can look at to check. the lines I got were pre bent stainless steel and are direct fit replacements but im stumped . they look like they only fit 1 one way, thanks john


Is it only the rear brakes you cannot bleed or all of them ?? ... Dodge Ram 1500

On my 2004 gmc sierra z-71 it has the low and high side airconditioing port it looks like about 8 in apart on the same line u can put a recharge can and guage on the 1 closest to the firewall it reads 65-70 psi if you lower the 134a to what the guage says it should be it wont cool. works when charged to the 65-70 psi but my problem is while setting still it wont cool enough. I am looking into the cooling fan not working right.why is the ports on the same line?and why is the preasure not what


There is a orifice in the line.On one side you will have high pressure.After the orifice you will have low pressure.Like having a garden hose with a small nozzel and putting the same size hose over the nozzel with the other end open.Not sure what the ... 2004 GMC Sierra 1500 Crew Cab

00 jetta ac not cooling, fans and a/c comp./clutch is working but no cool air.. unhooked the low side switch i think it is up top near the fire wall clutch kicks off on the a/c compressor so im guessing that switch is in working order.. a/c lines are not getting cool and blowing hot out of the vents, did blow freon out of the high and low sides of the line.. what could be the issue thx..


I would guess your freon has slowly leaked out, and now simply needs to be recharged. You can buy an AC recharge kit with R134 at Walmart or someplace, and do it yourself quite reasonably. If it doesn't cool after that the way everything else seems t ... 2000 Volkswagen Jetta TDI

2004 Hyundai Tiburon R134a AC works off and on, I figured low freon. Tried my autozone gauge to read presure but the quick-connect dosent appear to go on far enough and wouldnt show any pressure. I then tried another line with an open can of freon but it too didnt go on deep enough to open the feed. The AZ gauge line and fill line worked on my Honda Passport which these fittings appear to be the same? Does this system have a different fitting? I know it was on the low pressure side, (smaller val


Wrong system altogether,needs proper system,differant valve lenths and differant pressure.adrian,,,, ... 2003 Hyundai Tiburon

Gauge stays on cool but comes up to just the normal line used to come up a little more and sometimes stays at cool line for 20min. Then will come up


Your car is normal, the gauge can be anywhere near the normal zone and be fine. as lond at it leaves the C and dont make it to the H your fine. ... Cars & Trucks

I bought an after market replacement radiator for my 2002 Cadillac Seville SLS. The new radiator looks identical to the old radiator except: the transmission cooler lines screw into the old radiator, but the new radiator has built in quick connect fittings. What do I need to make the lines fit in the new radiator?


There are two types of radiators for this vehicle. One type is with an engine oil cooler, the other type is without an engine oil cooler. The type with an engine oil cooler has the quick connect fittings, the one without does not have th ... Cadillac Seville

I am looking for the water cooling diagram for a 1991 water boxer 2.1 l to route the cooling lines and the heater lines on to my 1978 westfalia


This is going to be your best bet, it's all that's out there...A repair manual for the waterboxer has what you're looking for. ... 1986 Volkswagen Wagon Camper
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.7222 seconds