Having problems with your Dodge Cars & Trucks ?

Where is the 6.7L dodge exhaust gas temp sensor high bank 1 located

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Dodge Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is the 6.7L dodge exhaust gas temp sensor high bank 1 located


... Dodge Cars & Trucks

Location of exhaust gas temp sensor bank 1 - 2007 Dodge Sprinter


... 2007 Dodge Sprinter

2011 ford f550 looking for exhaust system diagram for exhaust gas temperature sensors. code p2470 exhaust gas temp sensor circuit low (bank 1 sensor 4).


... Cars & Trucks

Need location of #1 cylinder on 2006 dodge 4.7. I am getting a P0038 code indicating theres a problem w/ the o2 sensor. Says bank 1 sensor 2 heater ctrl circ high. There is a very small nick in the wire running to the sensor. Can it be cut out and spliced back in or does the sensor need to be repalced? Thanks


#1 is the drivers front. The O2 your looking for is on the drivers side after the catalytic converter. You can certainly try to repair the wire. If you use a **** style connector make sure it is one with a heat shrink wrap to protect the wiring from ... 1998 Dodge Ram 1500 4WD

Can't find location of exhaust gas temperature sensor bank#1 sensor#32008 6.4 f-250 diesel


... 2008 Ford F 250 Super Duty 4WD

I have a 2004 dodge neon sxt, the check engine light is on and when i drive it the exhaust is loud and the car accelerates horrible. I get it up to 30 max and it takes a little while. Got it diagnosed and it came up with codes P0038 and P0700. P0038 = Heater Control Circuit High (Bank 1 Sensor 2). I was advised that the downstream o2 sensor is most likely the problem and so i replaced it. The sensor was definitely bad but its still doing the same thing and I'm now lost. I know very little about


... Dodge Neon

My 04 cadillac srx has suddenly started to not want to start. it's very rough on start up, a lot of white smoke from the exhaust. If I give it extra gas on start up it'll start and everything clears up. the check engine light is on for 02 sensor (bank 2 sensor 2 high voltage). I changed the air filter 2 days ago, the problem started yesterday and again today. any suggestions?


U have leaking engine cylinder gasket or gaskets, this engine is known for this, the coolant leaks into the cylinders as the engine cools down, after you start it it burns off and clears up, have the cylinder head gaskets checked by a shop with a gas ... 2004 Cadillac SRX

Dodge caravan 2004 i have p00073 abient air temp sensor high. what cause this check eng. light to turn on. please tell me where is the location for this sensor if it need to be replace. thank you


It will be in the air box,or the air duct to the intake,it most likely has trash on it,or needs to be changed. ... 2005 Dodge Caravan

My dodge intrepid 2000 will not start. When it went out it felt as if i ran out of gas almost. Although i have a full tank, I had my camshaft sensor located on the front mid of the block changed, that is what the computer hooked to the car said the problem was. Specifically it said 90340 Camshaft Position Sensor A- Bank 1 malfunction AND P1391 DTC Definition not found. CAN SOMEONE PLEASE HELP ME?


HelloSorry to note that problem with cars are not related with my expetise. OK. ... 2000 Dodge Intrepid

My 99 Volvo s80 t6 is reading a bunch of codes p0118, engine coolant temp sensor circuit high input.p0238, turbo/ super charger, boost sensor A circuit high.p0236, turbo/ supercharger boost sensor a circuit range performance.p0050 Ho2s heated, o2 sensor / control circuit bank 2 sensor 1. And p0114,(iat) intake air temp sensor circuit high temp. I hear that the transmission control module could be causing all these problems? I really dnt know thought any ideas please help!!!!


... Cars & Trucks

2003 Beetle turbo-13 trouble codes-PO300-multiple cyl misfire-PO171-system lean, bank one, PO301, PO303, PO302,PO 304-cyl one thru four misfire, P0012-intake cam position timing over-retarded-bank one, PO333-knock sensor curcuit high input-bank #2, PO328-knock sensor 1 bank one-curcuit high input, PO721-output speed sensor curcuit range/performance, PO731, PO734, PO 729 all trans incorrect gear ratio codes. Unit runs but exhausts back into the intake after 10-15 seconds after start up. All this


Low fuel pressure will cause many of those codes to set.Should have around 3.5bar pressure at idle and full throttle.Check to see if VW has a recall on the ignition coils. They are cheap to replace however.....you will need yo ... 2002 Volkswagen Beetle Turbo S

Where is Bank 1 sensor 1 located on a 2001 Yukon Denali. I can only find one located on drivers side after cat.( I had the code read it was a po 138 hearter sensor malfun. bank 1 sensor 1) I have been told the sensor is located by the # 1 spark plug. The only thing I see by the plug looks like a water temp. plug going it to the head with some # on the block over it.


Start at the exhaust manifold flange on the drivers side. The first sensor you come to before the cat. converter is the sensor you are looking for. ... 2001 GMC Yukon Denali

2005 dodge magnum keep cutting off, check problm code is p0406 exhaust gas recirculation sensor A circuit high, what does that mean?


... Cars & Trucks

Where is the exhaust temp bank 1 sensor 3 located 2008 F250 6.4 liter


... Cars & Trucks

HAVE 1998 Dodge Dakota that is stalling (intermittently. Checked the codes and im getting the following: 351- Ignition coil A Pri/Sec circuit 420- Catalyst system efficiency below threashold (bank1) 545- Exhaust gas temp circuit low (bank 1) Please help!............Bad coil ? ............Don


Sounds like this engine light has been on for a while and codes are piling up, lets start with the po351, note all codes should have a po or a p or b in front of #s.anyway lets go, first is po351 which means you have a bad # 1 ignition coil, replace ... Dodge Dakota

Fuel Problems I just purchased an 89 Ford F150 with a 302 and it will not start without ether or gas but once it starts it runs on its on and at idle is running rich (black smoke out of exhaust). I've replaced high pressure pump, fuel filter, pressure regulator, and cooling temp. sensor. With key on engine off it has 40 pounds fuel pressure. The check engine light stays on constantly and the fuel pump runs constantly and when I try to get self test codes the light never blinks..it just stays on.


Check for air inlet at carburettor leaks. ... 1989 Ford F 150

Temp Sensor im trying to change the tempature sensor on my 04 chevy imapla. Its a 3.4L and im having trouble finding where it is located. The box on the sensor says SU109 Temp sensor. Hope that helps :/ i appreciate it. P.S. My impala temp gauge has been reading high for a bit but when i get home i can shut the car off and turn the ignition on and the gauge will reset back to zero. Then when i start the car it reads that the temp is normal. So i think its the temp sensor if you think its somethi


The temp sensor known as the engine coolant temp. sensor tells the computer if the engine is overheating and so forth and tells the injectors how much fuel to give the engine. The temp. sending unit is what controls what your guage reads. It sounds l ... 2004 Chevrolet Impala

On a 2001 chrysler sebring coupe lxi 3.0 where is the O2 "oxygen sensor" physically located, computer says bank1 sensor2. I know Bank 1 is the side where the #1 cylinder is which I "think" is on the firewall side? Someone on this site previously said in another answer it's located on the exhaust manifold at the firewall, sensor 2 is the O2 sensor after the catalytic converter but that is under the car and not at the firewall. There is a sensor on the exhaust manifold at the firewall but it's no


My 2001 chysler sebring lxi 3.0 liter will not start and the starter is brand new ... 2001 Chrysler Sebring

Location of oxygen sensors on 2002 dodge grand caravan with 3.3 liter engine after considerable maintance work done by a dodge dealer my gas mileage dropped by as much as 6 to 8 miles per gal. after a time i after dealer done routine maintence on my 2002 grand caravan with 3.3 liter eng.mileage droppe 6-8 mi. per gal. took car back to dealer was told oxygen sensors were bad. were are the oxygen sensors located on engine I


The o2 sensors are located on the exhaust system.The upstream in on the rear exhaust manifold and the down stream is in front of the catalytic converter.Usually when they are bad they will make the check engine like go on.Make sure the air filter is ... 2002 Dodge Grand Caravan

Where is the exhaust pressure sensor on the 3.0 diesel engines? Cars setting a po471 exhaust gas pressure sensor 1 performance, also sets a po299 turbo charger underboost. Im guessing its the exhaust pressure sensor? can't locate this sensor to save my life. Thanks


... 2007 Jeep Grand Cherokee

1996 Dodge intrepid 3.3 O2 sensor bank 2 sensor 2 location? This is coming up on scanner but I can't find any diagram that has a bank 2 sensor 2 only bank 2 sensor 1


Just change the o2 sensor tha code its saying is irrelvant to that model cause it has a generic ECM that fits several other models ... Dodge Intrepid

I HAVE A 2002 MERCURY MOUNTAINEER, IT HAS A LOW OIL LIGHT AND HIGH TEMP LIGHT ON AND THE OIL PRESSURE GUAGE IS NOT WORKING. CAN U TELL ME WHERE THE SENSOR IS LOCATED FOR TH LOWE OIL AND HIGH TEMP LIGHT IS LOCATED OR WHAT MIGHT BE CAUSING THIS PROBLEM ?


... 2002 Mercury Mountaineer

Need Help Locating the Coolant Temp Sensor on 2002 Dodge Caravan.


If You Look Below the Coil Pack Rack there you will Find it.\015\012According to Aldata on the 3.3L ... 2002 Dodge Grand Caravan

I have an error code of P0131 which I believe means I have a bad O2 sensor. Bank 1, sensor 1. I think I can probably replace this sensor myself but I am not sure where it is located on my car. I have a Pontiac Grand AM GT with the 3.4L 6 cylinder. Where can I go to see where this sensor is located. I believe it can be either on the manifold or on the exhaust.


... 2000 Pontiac Grand Am GT

I have a 2006 Dodge 2500 that is throwing a p1129 code. I have changed the o2 sensors. Bank one sensor one had the wires out of the computer side of the sensor plug in. I hooked them back up and put a sensor in it. I now have this code on Bank two. I am going to check the temp on the CAT to see if the CAT is plugged. Any suggestions.


... Dodge Ram 2500
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.8493 seconds