Having problems with your Citroen DS ?

Which cables are going to/from the ignition coil

\015 It's a Citroen DS21ie of Feb.19971. The cables going from/to the ignition coil are mixed up. Cranking, but no spark. Is there any wiring diagram?\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Citroen DS

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

There is no power going to spark plugs why? and how can i check the ignition coil?(the ignition coil and the alternator{ part which all cables for spark ploge out from it} are new) car not started there are 12 v. on the 2 inputs of the coile and also 12 v. on the output


You can test coil by pulling coil wire and holding close to a grounded source while someone cranks the car (wear gloves strongly advised). The only way to test an alternator if car is not running, is to take alternator off & bring to a parts store to ... 1989 Mercedes-Benz 190

There is no power going to spark blog why? and how can i check the ignition coil?(the ignition coil and the part which all cables for spark blogs out from it are new) car not started


Test lite , remove one wire and see if any power coming out. Becaus e if your not getting fire to the plugs your not getting any from the coil. Good luck to ya, ... 1998 Mercedes-Benz E-Class

I have a 91 toyota pickup. It has a starting problem mostly when I do alot of stop, shop , and go. I replaced starter, starter relay, starter ignition, clean + battery cable, - ground cable, and check coil. I even change a new ignition key and still have the problem. Battery tested 12V. I know alot of people have this problem, but no one seem to know the cause. They just recomend adding an extra power push button lead to the starter. What is it that I am not getting? By the way I have one automa


Not sure how similar it is but I had a supra of the same year with the same issues. It ended up being a bad connection where the chassis harness met the engine harness. I bypassed this section and the issue was resolved. ... 1991 Toyota Pickup

Which cables are going to/from the ignition coil


... Citroen DS

'86 chevy G20, randomly won't start or stalls out and won't start, then randomly starts up again, no rhyme or reason. replaced the battery, plugs, wires, alternator, coil, rotor, ignition control module, then the entire distributor, battery cables, and now the starter. no effect. i can tell if it's going to start or not by the batt gauge, if it's going to start, it's up at 12 volts, if it's not going to start, it's a half-to-full volt below, and i've been told by a tow guy that it's not getting


Are you getting 12 volts from the red wire from the ignition switch and 12 volts from the pink wire from the ignition switch? The pink wire runs to the distributor. How many miles are on the vehicle. When the vehicle starts, does it stay running?And ... Chevrolet G20

The bypass hose had busted and now the car will not start. I pulled the cable off from the ignition coil and there is no spark going to the distributor.


Just sounds like something has got wet that sholdnt have, when it dries the vehicle will start again. i had one and i was washing the engine off at the car wash, done the same thing, died, and wouldnt start. got the coil dried back off, wires, and di ... 1990 Toyota Cressida

I have a 1992 Toyota 4runner V6 that will crank but has no fire. We have replaced the distributor, the ignition module, and the coil. We have good wires going into the ignition module and coil but there is no spark going out of the coil. Someone mentioned a crank position sensor, where would that be located. Do you have any ideas as to what might be wrong? It has a new timing belt. The timing has been checked and is good. Why wont it start?


... 1992 Toyota 4Runner

My 1993 honda prelude wont start. i tested the fuel it is working. but there isnt any spark. so i replaced the igniter and still nothing. so i tested the ignition coil but nothing comes out. so i took a test light and i have power running into all 3 wires that go into the ignition coil. does any1 know if the coil suppose to act like that or is it using the body as a ground.


SOUND LIKE IGNITION COIL OPEN. ... Honda Prelude

My 03 galant has burn the ignition coil 2 times and the scan showed random misfire ,we got the ignition coils replaced and the car ran again for a couple of blocks and it started vibrating.. the ignition coil on the driver side keeps going bad and they told me it could be the ECU computer Help!


Check for a shorted spark plug ie. touching central and side electrodes. ... 2003 Mitsubishi Galant

I was driving home the other day in my 1987 Ford Ranger when it died on me. I checked the ignition coil but was getting no power so i changed the control module and the ignition coil. I still aint getting any power to the distributer. I have power going in the ignition coil but none coming out. What else could be the problem? Oh and it does have gas.


Distributor contact to the tfi module is probably corroded and not making contact. Replace distributor. ... 1987 Ford Ranger

96 pontiac grand prix se 3.1 service engine light is on and flashing. car runs bad. sometimes it has no power to get up an go. goes through alot of gas and smells of fuel bad. had it put on computer all kinds of codes came up. mass airflow, egr valve, ignition coil, coil module, cylander #3, multiple missfire. bought the ignition coil didn't need it. check coil modules all are working fine. any help?


... Pontiac Grand Prix

Ignition off,there is no power to headlights. WITH ignition there is no power at all to anything. Cleaned the battery cables, moved negative cable to different location but there still is no power. Checked starter, wires,all seems to be ok. I did notice when I turned ignition to start position, there were some wires moving under dash that go to ignition switch.


Hi,The no headlight at any position is significant. it indicates that the entire electrical system is not getting B+12. Since there would only be two terminals on the battery and you have checked/confirmed that the negative is body ground ... Chevrolet C1500

1992 ford econoline van wont start power going to coil coil good, no power coming out of coil have replaced the following: pcm ecm coil distributor condenser ignition switch ignition module key swith


How can you say that you have power going to the coil and lot leaving it and still say its good?\015\012kinda answered your own question there i think\015\012just my opinion...\015\012hope this helps ... 1992 Ford Econoline

My 1999 saturn sl2 will not start. It cranks, fuel pump is working but I no spark from the ignition coils or spark plugs. A few months ago the wipers started acting funny (going off when they wanted to) it stop by itself. Then the car started shutting off after running for a while I thought it was because of the car overheating so I replaced the coolant heating sensor and the crank shaft sensor. I have replaced the ignition coils, spark plugs, ignition control module, battery, and alternato


Sounds like a bad timing chain. ... Saturn SL2

Could not get my 2005 chrysler pacifica out of park. took apart console and replaced pink thing. Now it is still stuck unless i push pink thing fowadr with a screwdriver and press brake pedal at same time.But now i cant get the key out of ignition, the key wont go past acc., so now i must disconnect a battery cable every time i park. My question is did i stretch the cable going to the pink thing , if so how do i replace the cable?


I can only add that you should check your Brakelights to see if they are working. You may have worked on the wrong part.\015\012\015\012They use a safety switch usually on the Brake pedal lever and it unlocks the circuit. If you do not get ... Cars & Trucks

Ignition timings Hello. I just replaced the spark wires on my 1994 Cavalier RS 2.2L 4 Cylinder. Problem is, I did it wrong. I didn't push hard enough on the ends that go into the ignition coil, and when i tugged on them to make sure they were tight, the wires for spark plugs 2, 3, and 4 fell off. I don't remember the positions the Originals were in, I replaced them the best I could. Currently (from Spark Plug to the Ignition coil), SP1 in in the first spot, SP2 is in the third spot, SP3 is in th


The coils should be number 1 is 1.... 2 is 2.... ect. ... 1994 Chevrolet Cavalier

Sunbird died going down road and wont start. I am getting no spark will turn over but no fuel coming out of injector. would it be my ignition relay? I tried to dump gas down carb and wont fire. tried changing ignition coil, did not help? ther is 12 volts to the coil but no output on the coil or on the plugs?


If you are getting no fuel it would more than likely bee the fuelpump ... 1990 Pontiac Sunbird

Car hesitating 2004 Chev. Cav. when i start my car, the engine light blinks and the car putters. When I drive, i smell gas and the car sucks gas bad!! I have changed the ALL the parts that have to do with the spark plugs, includ. the coil pack and boots, spark plugs, the silver ignition piece on top of the coil pack. That silver ignition piece on top of the coil pack screws into the top of the piece that goes over where the cap to the spark plugs go- I changed that and the car worked fine for ab


It might be a long shot, but i have a 04 cavalier and i once smelled gas and had a putter issue. Turns out the fuel pressure regulator basically sits on the fuel rail with one screw on the side. Over time, the regulator either goes bad or becomes u ... 2004 Chevrolet Cavalier

Engine turns over but no spark at the plugs. checked coil ok changed ignition moudle no luck changed rotor no luck. checked voltage from coil to cap getting 12vdc. checked voltage going to and coming out of ignition module 12vdc. what does pick-up coil do and can you change it out or do you have to change complete distributor?


You can change pick-up coil, you need to remove distributor (mark where rotor is pointing first) Then you need to remove pin in cam gear on end of shaft to remove gear so you can remove shaft from housing. Then you can replace pick-up coil. Install i ... 1990 Chevrolet C1500

I have a 1985 cj-7 with the 258 engine and manual transmission. I had a problem with the coil, the center had corroded, so I replaced it and things ran fine for about four days. Then it just died and acts the same. I changed the coil, no go. I can't find the ignition module the book says it has. It does have a computer behind the glove box. The resistance for the pickup coil is within tolerance. Where is the ignition module or did it have one?


The Ignition Control Module is located under the Plastic coolant bottle inside the left front fender. ... 1985 Jeep CJ7

2006 Jetta - emission warning light came on so I took it to the dealer who charged me $113 for diagnosis. Told me the car needs 2 new cooling fans and a new ignition coil- total cost $1000. I said no thanks- checked fans myself and see that one(the bigger one) runs that other doesn't even if ac on. The temp guage stays at 190- so something is wrong- just not sure it costs 1,000. As for the ignition coil- not having any problems with driving the car. Any help would be appreciated. Going to take i


Missfire detection can cause fan to run continusly one may be failed should have some codes. ... 2006 Volkswagen Jetta

I've had three sets of ignition coils go bad on my 2001 Mazda Protege ES within approximately 18 months and 20,000 miles. What could make these coils go bad??


Major problems with 04 rx8s. Flooding etc. Many motors replaced under warranty. Check your plugs, heard that could be a problem, and not sure about this, but also heard that the alternator and voltage regulator my have something to do with it. ... 2004 Mazda RX-8

Vehicle engine jerks while under load when going up a hill. Fuel economy has noticely dropped . Checked spark plugs, likely need replaced @ 96000 kilometers,no plug indicated failure, other than the gap being slightly over Max. Suspect ignition coil failure, any way to troubleshoot ignition coils?


... 2006 Ford Escape

Replaced ignition coil, rotor, cap, plugs, wires. Power going to ignition coil and out. Engine turns off, but no spark. What else could it be.


Check to see that the rotor is properly seated I have seen this before turn the rotor untell it drops in place I would try that. good luck cj ... 1991 Geo Storm

I have a 1999 pontiac grand am and I am not getting any spark.I changed the ignition module under the coils and that wasnt it.I changed both of the crankshaft sensors and still nothing. It stalled on me and I ended up having a bad battery and now I replaced it it still cranks but wont start.Can anyone give me an idea what to check next?I am going to replace the coils next since I have no clue what is going on with it. Any help would be appreciated.


Have you checked for power and ground on the module when cranking. Check on the two wire plug on the module that has a pink wire and a black wire. ... 1999 Pontiac Grand Am GT
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.0812 seconds