Having problems with your Chrysler Town & Country ?
Town and country slow to start
\015 Initially van started to miss while driving. Went to local shop to have fuel filter put on. They noticed piece was broken from fuel pump and said it was trying to pull air and anything else in to engine and this caused engine to miss. New filter and pump put on, 1 week later, engine was slow to start ( following sitting for a while, overnight etc.). Eventually, ( like 2 days later) low fuel chime went off and needle was going crazy( had 3/4 of a tank). Shop put new pump on ( it was under warranty) Vehicle started up like a champ and ran well until I hit around 60-65 and started to miss. Took back to shop and they siphoned some gas out and showed me there was water in gas. Ok, after all that, my question is this: If the problem with the slow starts was the gas, why did it start up like a champ following both fuel pumps being put on? Also shop checked fuel pressure at engine and said it was fine.\015
\012The engine\012and transmission in this cars drive train are fully\012electronically controlled by a computer called the PCM (Power Train\012Control Module). Whenever a problem like this occurs the computer\012stores a record of the problem (there are of course some exceptions\012to this, like the fuel pump, engine coolant temperature sensor and\012MAF sensor for instance) in the form of a fault code in its memory,\012to read these fault codes you must have the systems memory scanned\012with a special tool. Once the fault code(s) are read you then must\012perform the appropriate diagnostic testing to find and resolve the\012problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN\012HAS DIAGNOSED THE PROBLEM TO AVOID SPEDING YOUR HARD EARNED MONEY ON\012PARTS THAT MAY NOT CORRECT THE PROBLEM
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Town and country slow to start
\012The engine\012and transmission in this cars drive train are fully\012electronically controlled by a computer called the PCM (Power Train\012Control Module). Whenever a problem like this occurs the computer\012stores ... Chrysler Town & Country
My 2005 town and country touring drivers side power sliding door has completely stopped working. It started off slow and then quit completely. now my husband said that the drivers side rear window wont work either any suggestions of things to start changing?
For the sliding door,check the wiring that is housed in the plastic chain at the bottom of the door.the problem with the window may be the switch in the driver door ... 2005 Chrysler Town & Country
I have a Chrysler 2003 mini van town and country, with 74,000 miles.Since when it was at 70,000, it started stopping at every stop signal,in slow motion when the engine is started. I got changed the fuel filter and the spark plugs. of no use.Now the mechanic recommends to change spark plug wires. I am not sure that it will help. Some times it runs perfectly all right with no problem at all . Any good suggestion ?
This happened to me. The valve that controls the air intake gets stuck which stalls the motor. I removed the air intake hose and wiped it clean using Acetone (nail polish remover). Its been running perfectly ever since.... ... 2003 Chrysler Town & Country
On a 2003 Town & Country, it was shifting hard into first gear. Mileage 135,000 Sometimes it would act like it was cutting out and could not decide what gear to shift in. I took it in and had the transmission fluid and filter changed. It still does the same thing. It seems to shift hard when starting out slow.
When was your last tune up? with that kind of mileage it could be possible that the transmission itself has wear and tear that a fluid and filter will not help. How does the car idle etc. Have you had the problem diagnosed by a professional mechanic ... 2003 Chrysler Town & Country
Battery drained last week and radio power clicked on and off at a slow rate for about a day, even though car started fine. Suspect water caused the radio to draw current? How to fix this 2000 town&country?
You can always verify if it is your radio that is drawing the current of your battery down or at least you can narrow it down to which circuit it is. Remove the negative battery terminal and connect the negative side of a test light to the negative c ... 2000 Chrysler Town & Country
1999 Chrysler town and country starting stalling problems
... Cars & Trucks
My chysler town and country does not start most of the time what could it be? if you let it sit over night it will start. 98 chysler town and country.
Does it crank or turn over y/n\015\012if it cranks over change the pickup coil/ignition control moduel if it doesn't crank check the battery cables / alternator / if it sets overnight and starts in the morning the battery is good ... Chrysler Town and Country
2006 TOWN AND COUNTRY STARTS THEN WHEN YOU SHUT IT OFF IT WILL NOT START WAIT FIVE MINUTES IT WILL START
... 2006 Chrysler Town & Country
My 2005 Town and Country is slow to accelerate
... 2005 Chrysler Town & Country
Bad key town and country won't start car - 2010 Chrysler Town and Country
... 2010 Chrysler Town and Country
2002, town, country, remote start - 2002 Chrysler Town & Country
... 2002 Chrysler Town & Country
2005 chrysler Town&Country clicks when attempting to start
If the click is one click then that points to the starter. Make sure the battery connections are tight. If it clicks like a machine gun then it is either the battery or a bad connection. Good battery voltage is 12.6 or more and 13.6 when running. I d ... 2005 Chrysler Town & Country
Remote start 2005 town and country - 2005 Chrysler Town & Country
... 2005 Chrysler Town & Country
07 town and country hard start when cold - 2007 Chrysler Town & Country LX New Cars
... 2007 Chrysler Town & Country LX New Cars
08 chrysler town and country will not start - 2002 Chrysler Town & Country
... 2002 Chrysler Town & Country
2000 town and country wont cold start - 2000 Chrysler Town & Country
Assuming the check engine light is not on, I would check the fuel pressure with a gauge before and after startup.Could be a fuel pump relay or the pump, among other things. ... 2000 Chrysler Town & Country
Describe your 1999 Chrysler Town & Country Problem-Won't start up all the time, takes me 7-9 cranks for it to start. sometimes it starts with no problem at all. Someone told me my battery was too small for the size of the vehicle. Starter was replaced 3000 miles ago. Battery sounds like its dying after repeated cranks to get it started sometimes. Three hours later I start it right up.
Does it not start hot? if so it sounds like a crank sensor ... 1999 Chrysler Town & Country
94 Chrysler Town and Country won't start with key. Battery and cable connections are good. 12 volts directly to the starter solenoid starts the engine. All gages come on turning key to start position but only a click and no start. Replaced ignition switch and starter relay - no change. Traced 12V wire from starter solenoid to fuse box and the starter relay and wire is good. Applying 12 volts to the socket of the starter relay results in starting the engine. Is this a failure of the PCM?
Has it got an immobiliser / if so there is a fault there. If not an ignition switch itself. ... 1997 Chrysler Town & Country
Why wont the car start? 1997 Chrysler Town & Country van - won't start. Was sluggish starting for a couple of days. Put a trickle charger on battery. Shows battery is charged. Now when we tried to start it, it just makes a clicking sound and won't start. Battery and alternator were checked showing they are good. Starter problem?
May be starter motor problem ... 1997 Chrysler Town & Country
2003 Chrysler Town and Country van / Will not start on its own. Will start with Starting Fluid
Your description matched a faulty check valve in the pump letting fuel pressure drop back into the tank when the engine is off. But replacing the fuel pump should have fixed that.I guess its possible the fuel pressure regulator could be faulty a ... Chrysler Town & Country
1998 chry town n country it started n stoppd 3-4 times then had nothing took to the chry dealer they said pcm was bad the replaced it everything was ok then but the put on the order advise to replace bcm n cluster. without saying why it was bad.everything worked. 2mo later same problem start stop start stop towed back to the same dealer. this time they replaced the the bcm and cluster BUT DIDNT FIX IT they replaced the pcm again car started HOWEVER they REPLACED THE BCM 4 TIMES 1st time running
This is not fare.As the bcm they replaced before.This part comes with a warranty/ guaranty of 1 year.If no warranty of 1 year then it has testing warranty of 3months.If in 3 moths the same problem occurs then they have to replace the part for free.Wh ... 2002 Chrysler Town & Country
1992 Chrysler Town & Country, Starting problems
Have you cycled key , on,off,on,off,on, leave on, & see if check engine light flashes out any codes? It will give a few quick flashes, then pause, then a few more flashes. For example: 3 flashes, pause, 3 more flashes, is code 33. 2 flashes, pau ... 1992 Chrysler Town & Country
1998 town & country. It won't start again.
We had the same problem. It was the circuit board in the dash. There were crackes in one of the solder spots. My mechanic removed the dash and did a spot solder on the place with the cracks. It has worked for two months. It seems the solder spot ... 1998 Chrysler Town & Country
Starting problem I have a 1998 town & country van. I had the transmission replaced now it will not start. It was starting before the transmission was replaced.
Check the Battery connections, specaily earthing or ground which come from negative terminal from the battery how is fitted and where you fitted. ... 1998 Chrysler Town & Country
NO START, NO power as if battery is dead, (no dome light, when turning key to start a buzz is heard under dash, like a door open buzzer, opening the door makes the buzz louder, then power comes up, no rhyme or reason, then vehicle starts 1998 chrysler town and country
I have a similar problem just no buzzing obd2 code reader says tcm not communicating with ecm .# 1 cause failed ecm . bad computer . ... 1998 Chrysler Town & Country