Having problems with your Chevrolet Tahoe ?

Canister purge valve solenoid

\015 Where is it located on a 2008 chevy tahoe\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Chevrolet Tahoe

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I got a Error Code P1441 Definition EVAP System Flow During Non-Purge Conditions Possible Causes: EVAP purge valve, purge pipe, or the charcoal canister has a temporary blockage (this fault could cause an intermittent fault) FTP sensor is out-of-calibration, damaged or it is skewed EVAP purge solenoid valve is damaged or has failed PCM has failed TSB 00-06-04-022 contains a repair procedure for this code Condition For Setting The Code: DTC P0107, P0108, P0112, P0113, P0117,


P1442 usually gas cap. P1449 usually vent solenoid. P1441 usually always a faulty FTP sensor. Very problematic to Malibu, Grand Am Cavaliers and Aleros. That would be my first area to check. They are also known for poor wiring connections at the Left ... 2001 Pontiac Grand Am SE

1997 malibu / I had faulty code po440 . I Replaced Purge valve behind engine, canister valve solenoid, gascap from dealer, charcoal canister, smoke test. 1 week later check engine light on again wi


... 2001 Chevrolet Malibu

2002 saturn l-1 replaced canister vent solenoid but still get code po446, do i need to replace the canister purge valve solenoid next. I am very puzzled by this ,,,help


... Pontiac Vibe

P0449 buick terraza I replaced the vent valve solenoid and the purge valve solenoid still getting the same codes hose connections are ok does the charcoal canister need to be replaced.


... Cars & Trucks

1997 malibu / I had faulty code po440 . I Replaced Purge valve behind engine, canister valve solenoid, gascap from dealer, charcoal canister, smoke test. 1 week later check engine light on again wit


Diagnostib Test Code (DTC) P0440 is defined by SAE J2012 simply as "Evaporative Emission System".This code is what I call a "catch-all" code for the evap system. This is the code that sets when all the other EVAP codes do not a ... 2001 Chevrolet Malibu

Printout picture 2002 KIA sedona evap canister purge solenoid valve


... 2002 Kia Sedona

Canister purge valve solenoid on a 3.1


... 1997 Chevrolet Lumina

Diagram for 1996 pontiac grand am gt. on where the canister purge valve solenoid


... 1996 Pontiac Grand Am

Where is the canister purge volume control solenoid valve located on a 99 infinity i30


... Infiniti Cars & Trucks

I have a 2008 Chevrolet Silverado V8 Reg. cab and a check engine light on with error code P0449. Can I get a picture of the EVAP vent solenoid and its location on the vehicle? A picture of the purge valve solenoid and its location as well as the vapor canister. Which wiring or connector should I check dealing with this code. Can I do this work or should I take it to a mechanic?


Your dealership service department has a book on the vehicle that they will let you copy a page from. ... 2008 Chevrolet Silverado 1500 2WD

Check engine light continues to be lit. had a computer diagnostic run and the probable causes are: - failed canister purge valve - failed EVAP pressure sensor - failed canister vent solenoid


What code number do you have or do you have 3? ... 2002 Nissan Frontier Crew Cab

2006 gmc sierra 1500 4.3 . check engine light on. code po449 on reader. is it canister purge solenoid or vent valve solenoid


More than likely the evaporator vent valve. ... 2006 GMC Sierra

2000 Hyundai Elantra misfires and stalls when evap purge valve (solenoid) closes and canister close valve opens.


... 2000 Hyundai Elantra

How do you tell if code is for canister purge valve or purge solenoid


... 2005 Chevrolet Silverado 1500 2WD

Check engine light on. Vent solenoid on the vapor canister showed 11.6 volts when ignition switch on, better than 13 volts when engine on--but is in open position. Could problem be the evap purge valve--where is that located on the vehicle. Can the fuel vapor canister be saturated and cause the problem,?


... 1998 Oldsmobile Silhouette

Getting an engine code 1450 on a 2003 ford Explorer 4.0 SOHC. Cleaned and inspected EVAP canister vent solenoid. Replaced EVAP canister purge valve. Any suggestions?


Did you check the block box connected to the vent solenoid? There's a hose that comes off it that appears to run nowhere, that's the fresh air vent. If it's blocked it won't allow air into the system which will set the trouble code. If that's clea ... 2003 Ford Explorer

2004 Chevy Cavalier 2.2 eco Automatic 94,000 miles Trouble Code: PO455 Evaporative, Emisson Control Leak, Detected Large Leak. Question: Between the EVAP canister purge solenoid valve, and the EVAP Canister, near the gas tank which one of the two would, cause Dected Large Leak PO455 All hoses & connenctions Look Good!. Thank You!


In my experience the usual culprit is the evap cannister. the problem is it gets moisture in it and freezes during winter thus cracking the plastic. if you lay under the car and look at the evap box it black plastic and if you see a loose or cracke ... 2004 Chevrolet Cavalier

1991 Lexus-- Check engine light comes on and can't get through emissions. One mechanic says that the purge canister and Purge canister solenoid have failed. Never heard of a purge canister failing. Could the problem be a bad neoprene hose to the canister? Also, was not aware that there was a solenoid to work what I thought was an inert part. Please help...


I just did a car today for nissan 1996 had light on with code po1447 turned out to be purge canister its just a mushroom shaped piece of plastic with 3 vacuum hoses gong to it.. ... 1991 Lexus LS 400

Code P0441 (code P0441 dodge 2004 intrepid) could be any or all of the below but I need to know where these items are located and what they look like bad vacuum switch evap line or canister open in PCM purge command circuit open or short in voltage feed circuit to purge solenoid faulty purge solenoid restrction in evap solenoid, line or canister corrosion or resistance in purge connector bad PCM


... 2004 Dodge Intrepid

1999 hyundai accent canister purge solenoid valve location and replacement steps...


There is a purge solenoid for the EVAP system and it is item no.# 1 shown in the diagram below. You have to follow the purge valve vacumn hose to find the charcoal cannister if you need to inspect. \015\012 \015\012 ... 1999 Hyundai Accent

Codes P0102&P0443 Monte Carlo SS 2000 came up and I replaced MAF and EVAP Purge Canister Solenoid Valve. Keeps coming back after I clear the codes and check engine light. What do I check next. Also, I have checked the wires... all good


... Cars & Trucks

Steps on how to replace evap canister purge solenoid valve 2004 cadillac srx


... 2004 Cadillac SRX

Were is the Canister Purge Valve Solenoid on 2001 Chevy s-10 pickup with v6


... Chevrolet S 10

I have a recurring PO442 code, new purge valve and solenoid. Had the truck smoke tested and no leak. Bad canister?


... 1998 GMC Sonoma

I was given a 1990 Legacy sedan. Obviously it needs work. It does start and run, but dies when the RPMs drop after revving. I analyzed the codes and it is telling me there are 8 errors! Crank angle sensor (no sig), cam angle sensor (no sig), water temp sensor (Abnormal signal emitted), air flow sensor (abnormal voltage input entered), O2 sensor (inoperable), speed sensor (abnormal voltage input), canister purge solenoid valve (inoperable) and airflow sensor (use of improper airflow sensor). Is i


... 1990 Subaru Legacy
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4994 seconds