Having problems with your Chevrolet Cavalier ?

How do you do 1 revolution of the engine on a 2002 cavalier by hand?

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Put a socket on the center Harmonic Balancer Bolt and using a 1/2 ratchet or breaker bar turn the engine one revolution, 90* at a time so you can keep track. You may have to use a small extension also.
Repair Help & Product Troubleshooting for Chevrolet Cavalier

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you do 1 revolution of the engine on a 2002 cavalier by hand?


Put a socket on the center Harmonic Balancer Bolt and using a 1/2 ratchet or breaker bar turn the engine one revolution, 90* at a time so you can keep track. You may have to use a small extension also. ... Chevrolet Cavalier

1999 Chevy Cavalier Trying to get this ready for my kid to go back to college. Recently replaced both front tires, brakes, drivers wheel bearing and exhaust leak. The car makes a lot of road noise while driving. I do not believe it is exhaust, if cruising say at 55 put it in neutral the noise remains the same. Engine RPM doe not effect the noise. While cruising a long right hand turn will quiet the tone to almost normal left hand turns remains the same. Both front struts probally need replacing


I have the same thing going on with my 2002 cavalier. I replaced wheel bearings with no luck. My tires also wore uneven toe. Going to try alignment. I'm sure it's the same problem as you describe and it's really annoying. Right hand turns remains the ... 1999 Chevrolet Cavalier

03 cavalier engine mounts. i only found 2 of the 3 mounts the one missing is imposible to get, is a big mount at the left hand top of the engine.


Check at your local junkyards/parts stores ... 2003 Chevrolet Cavalier

I have a intermittent problem with my Fuel gauge dropping below the 0 line after I start driving the car. Yesterday, the brake light on the dash stayed on after I released the hand brake, this went off after i restarted the engine. Today the alarm came on after I unlocked the car and the guage went below 0 again, are they all linked?


THE FUEL GAUGE SOUNDS LIKE A LOOSE GROUND WIRE - THE BRAKE LIGHT COULD HAVE BEEN WET AND I HAVE SEEN THIS BEFORE - NO THEY ARE NOT LINKED BUT THE VIB's FROM THE ALARM COULD HAVE MADE A LOOSE WIRE LOSE CONTACT ... Lexus IS

Engine stops after starting the car and driving it for a few minutes, if I make a stop on a intersection his revolution will go to 0 and stop, then I have to started again and acelarate for it not to stop. What coul be the problem.


It can be the catalytic converter.clogged catalytic converter cause lost of power. that's why the RPM drop to 0.some experience backfire.it can be clean or replace. ... 2002 Mitsubishi Lancer

I have a 2004 Cavalier LS automatic. Yesterday, when I took off from and stoplight my thermostat needle went from the half way mark up to between the 3/4 mark and the red zone. When I turned the engine off the needle didn't go all the way back to 0 as it normally does. This morning when I started the car the needle stayed just at the half way mark, however when I turned the car off again and restarted it the needle went to the red zone and only came down to the 3/4 mark. do you think it coul


Sounds like your thermostat is bad or at least sticking. Replacing it is faily simple and even the good ones are less than 20 bucks. Hope this helps! (rate if useful) ... 2004 Chevrolet Cavalier

I have a 92 7.3 and i have an issue where the engine cuts out between 40-45 mph and it still speeds up but the tac hits 0 and then back up to 2k also ive lost power and fuel economy and i have no o2 sensor no camp or crank sensor and no maf but i have put in a new tp or fipl switch and i have a speed control sensor in my hand but im not sure what the issue is please help


My bet is it has to do with either your fuel pump or your injector pump hopefully your fuel pump but if its not giving enuf pressure to your injector pump your truck will run like that ... 1992 Ford F250

My 1983 Porsche 944 has a rather noticeable hollow knock. It only does it when the car has been driven for at least a half hour and mainly when making right hand turns. The knock does not increase with engine revolutions. I have checked both front wheel bearings. Sometimes it is hard to get it to knock at all..


Check your ball joints 944s have known issues with them ... 1983 Porsche 944

I have a 2003 chevy cavalier and last night as i was driving home a little yellow light that looked like a small engine came on ..it was at the bottom right hand corner of the dashborad


That is your Check engine light or also known as a service engine soon light, that means there is a code set in the computer. Did you get gas recently? If you did it may mean you left the gas cap loose. when reinstalling gas cap after fueling make su ... 2003 Chevrolet Cavalier

92 CAMRY- The A/C does not work. It was charged up by replacing the R-12, with R-134. Still it doesn't work. The A/C light, after about 5 seconds of compressor being on begins to flash. Also at the same time the second fan motor, when the A/C is pressed does not turn on. The clutch while the engine is turned off can be turned only by hand about 3/4 of a revolution before it sticks. Is there any idea what is wrong?


Re-evacuate the system by vacuum pump and recharge with fresh replacement gas. ... 1992 Toyota Camry V6

My 99 cavalier 2.2 is leaking water / coolant on the left hand side of the engine area. It leaks while driving and while the car is not running. As far as i can tell its not leaking into the oil and not out the tail pipe. We replaced water pump and its still leaking, at a good rate. Does it sound like a frost plug???


No freeze plugs are located on the sides of that engine... the front and back when viewed under hood.... i believe your resivoir- overflow is on the same side as you describe the leak so id check that first otherwise it seems youve a thermostat housi ... Cars & Trucks

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil. if you rev engine or increase rpms it goes to 0 and stayes there. let off and it jumps around like it did when started (0 to 40). No engine pecks while running. Display indicates low oil pressure and stop engine. orange light (check gages) comes on when at 0. any ideas. Service engine has not c


There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the ... 2003 GMC Envoy Xl

Hi, I'm new to this site, I recently brought a 98 1348cc 8valve daewoo lanos. The oil pump was gone so I fitted a second hand engine, the problem is it will not start when cold unless I squirt easy start into it, and then it struggles to rev! it seems to lose power at high revs. I know the engine I fitted was running fine. If I use my hands to restrict the flow of air into the inlet it will rev as it should but when I remove my hands on full throttle the engine will die and stall! Any ideas beca


Does it have a Mass air flow sensor? If yes, unplug it and see how it acts. ... 1999 Daewoo Lanos

I just installed a 2.2 L engine from a 97 Cavalier into my 96 Corsica. The crank sensors are differant in length and connection, with the Corsica being a 3 wire and the Cavalier a 2 wire. Is there a sensor made for the Cavalier engine what is compatible with the Corsica engine?


No you will have to replace the plug that is internal in the car ... 1997 Chevrolet Cavalier

Ford Focus engine diagram Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V


... 2001 Ford Focus

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

91 Corvette - Service Engine lights, Speedometer goes (usually) to 0, Average miles per gal goes to 5Y5, engine stops. Engine cranks but will not start. Wait a bit, remove key, insert key and it will usually start. only code is 12 which is normal. (Speedometer sometimes goes to 108 or 17 instead of 0 - while sitting and Idleing) Can sometimes get out of engine stopping by flooring it - must be driving to do this.


... 1991 Chevrolet Corvette

Cavalier 2.4 intermittent engine die/won't start code p0600


Check the catalitic converter in the exaust. It may be stopped up. This can cause these symptoms. ... 1996 Chevrolet Cavalier

Ignition When I turn on the ignition I drive a few feet and when I stop the rpms goes down to 0 and the engine turns off, some times it turns on but the rpms go down to 0 without driving and the engine turns off. No check engine light is on.


Check your fuel filter and fuel pump. ... 2000 Mitsubishi Montero Sport

I have BMW 318i petrol car. Suddenly it showed engine oil and exhaust system telltale sign and started making funny sounds. Mechanic advised to buy a second hand engine as it is beyond repair. Is he right and if so how much a new or a second hand engine costs


... 1996 BMW 318

I am working on a 1953 Ford tractor, model Golden Jubilee, which has been sitting outside and unused for some time. I am trying to get it running again, but the engine is stuck. Know where I can get diagrams for the engine to use while I take it apart? or, do you know if this model has a hand crank, and if so, where it goes? how can I hand crank this engine with out breaking it? Starting a winter project in Maine, Mike


Try looking at the Carpenter.com site, or DennisCarpenter.com site. This company will really help you in getting all you need in parts and their ordering photos have clear diagrams. You will be able to get Emblems, sheet metal, Ford logo tires, as ... Ford F-150

What other Cavalier engines will fit in my 2001 cavalier 2.2L, Being the engines are bigger?


... 1997 Chevrolet Cavalier

I want to replace a 1999 Chevy Cavalier 2.2L engine with a 2.2L engine from a 2004 Cavalier, will it swap with no problems?


No. Only a 1999 and 2000 will work. ... 1999 Chevrolet Cavalier

Honda civic 2004 check engine light is on can't get it to turn off with a hand held code reader. Reader says there are no codes in the hand held. but the check engine light stays on?


Try disconnecting the neg. ground to the battery for at least 30 seconds. This will reset the light & computor. Good luck! ... 2004 Honda Civic

98 buick lesabre oil pressure dropped to 0 and engine died. added 1 quart oil, waited 30 minutes, started and drove 5 miles then oil pressure dropped to 0 and engine died. does this sound like a bad oil pump? where is the oil pump and is it hard to change for a "handy" person? thank you.


My sister had the same problem. There are 2 sensors that can cause this when they go bad. One is the oil pressure switch, which is located near the oil filter. When the PCM reads this switch, and gets a low reading, it will automatically kill the eng ... 1998 Buick LeSabre
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.2406 seconds