Having problems with your Chevrolet Cars & Trucks ?

Replace master control switch 2008 chevy 1500

\015 How to replace the window switches on driver door\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Chevrolet Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2007 Chevy Silverado climate control switch does not work on 5 it only works 1 through 4 when I first got the truck everything work good the number 5 what out on the climate control then the resistor burn up so I replaced the resistor still does not work on 5 any suggestions


... Cars & Trucks

Replace master control switch 2008 chevy 1500


... Chevrolet Cars & Trucks

Power windows will only work from the driver's side master control switch and then only if the lock window button is on. If the lock button is off none of the windows will work at all and you have to push the lock window button back on and hold it while pushing the driver's side button to get the windows to work again. I have a 2005 Ford Taurus. We have replaced the master control switch but still have the same problem. The switch seems to get hot if you move the lock button to unlock.


... 2000 Ford Taurus

None of the windows roll up or down from the master control switch. 1998 isuzu rodeo LS v6 3.2 replace the master control switch with a new one and there was a car alarm install years ago but lost the control 2 years ago.


... 1998 Isuzu Rodeo

2004 Buick Rendezvous - Heater/AC fan switch shorting out. I had issues with the switch working on only 2 speeds. I then replaced the resistor block. I then got all speeds except 2. The AC Light came on with #2 but blower not working. Also, the AC and other 'directional' switch didn't work either only worked for a 10-30 seconds. I then pulled the dash and found the switch burnt on a couple of pins. I replaced the switch and control head BUT now the fuse keeps blowing the moment of going from 0 t


... Buick Rendezvous

2005 Chevy Colorado Wipers not working properly.New wiper motor replaced 1-month ago.Wiper switch replaced yesterday. With the switch in the off position turn the ignition key on the wipers come on for 3-seconds then go off. wipers do not return to the park position.In the low postion the wipers come on for 3-seconds then go off. In the hi position the wipers come on and stay on but do not return to the park position when turning the wiper switch off.I can monitor the command from the switch and


... Chevrolet Colorado

2006 Chevy 2500hd. Fan speed control switch will not work at 5 setting. Will not work for a short period and then kick back on. would the entire module need to be replaced or is there a cheaper solution like just replacing the speed switch? Thanks!


Can you say recall notice? Chevy knows about this problem and has extended the warranty through 2016 or 150,000 miles. Just had my 2006 Silverado fixed at dealership @ no cost to me. It takes the shop approximately 45 minutes to correct. ... 2006 Chevrolet Silverado 2500HD 2WD

2006 Chevy Impala - Heater recently worked on by garage and "control unit" replaced. Now heater motor runs on high at all times irregardless of fan speed control setting and whtehr ignition switch os on/off or even key in/out of switch. Returned to garage and mechanic appears more confused than I. Can you please offer any suggestions?


The blower motor resistor is damaged probably in the process of removing the heater core replace the blower motor resistor, and please dont forget to rate me!! ... 2005 Chevrolet Impala

On my 1994 S-10 Blazer, the AC/Heater stopped blowing on high speed about 2 years ago. By switching the speed control quickly back and forth, sometimes High would work. But not anymore. I had the A/C compressor replaced 2 weeks ago and settings 1-3 still worked, but still no High setting. Now, it only blows on Low no matter what the control is set on. I replaced the blower motor resistor assembly (attached to the blower motor housing) AND the blower motor relay (5 pin relay attached to the ba


Sometimes the electrical connecter burns on the back side of your switch. You can get just the switch and replace it and repair the connecter when possible. ... Chevrolet S 10

Hi i own a 2002 chevy impala LS3800 and at night my dashboard lights go out and darken aswell my engine light stays on and security and battery light flash, i've charged my new battery overnight in hopes of resting the system and have tried to reset the body control modular by turing key to on and waiting in 10 minute intervals but that does nothing i have been reading about other owners replacing their headlight switch or dimmer switch others replaced their BCM or PCM or both can anyone shed so


HAVE VECHICLE CODE SCAN.SEE WHAT CHECK ENGINE LIGHT CODE YOU ARE GETTING. ... 2002 Chevrolet Impala

I have a 2006 F150, just last week the heater switch that controls speed from 1-4 started giving trouble, first it stopped working on 1, then a few days later, 2 stopped, then 3 and now all I have is high #4, could this be the resister and not the switch itself and if so, where is the resister located so I can replace it?


Your truck uses a speed controller rather than a resistor. You will probably have to replace the controller. ... 2004 Ford F150

I replaced my break switch on my 2002 dodge dakota because it wasn't going out of park, now my break lights won't come on. I tried 2 new Switches in case 1 was bad but still no luck. I noticed not all the wires were connected on the old one and maybe that is the problem, but I don't know what color wire goes into each terminal. I know 1 and 2 work lights 3 and 4 work abs and 5 and 6 work speed control (which has never worked, maybe because it wasn't hooked up) But I need to know what color wire


... 2002 Dodge Dakota Club Cab

I have a 2000 Chevy Silverado 1500 5.3L engine, automatic transmission, automatic transfer case. It has the push button 4wd system. My service 4wd light is on, and i cant figure out what the problem is. I read that the transfer case control switch will often go out and cause this, so i replaced it. no luck. I rebuilt my front differential to find two pitted bearings, meanwhile i replaced the actuator. still no luck. Then i decided it must be the transfer case control motor, which mounts t


Hello rwells.The transfer case shift motor is the usual suspect in most 4x4 engagement failures.Inside the shift motor there is a position sensor that signals the module where it is.Because this is a digital signal it can get "confu ... 2000 Chevrolet Silverado 1500

Power windows only operate from the driver master control. replaced master control switch and the other windows still do not work, fuses all OK 2001 jeep cherokee sport


Check the ground circuits. Find out what wires are the ground suppllies. take a 12 volt test light from battery positive and probe the circuit if it lights up the ground is good is it does not bad ground. I would first check the wires in the door ... 2001 Jeep Cherokee

I have a 2001 Chevy Impala. The drivers side window wouldn't roll down so I ordered a new switch. While waiting for it to come in the mail I noticed the back drivers side switch didn't work either. I replaced the drivers side master switch and front and back drivers side still won't roll up or down but it will work on the passenger side front and back as did the old one. What else could be the problem? Thanks, Teresa johnston


... 2001 Chevrolet Impala

I replaced both rear window regulators/motors but only the rear driver's side works. I notice on the master window switch that the rear passenger control will push up but won't push down. Coul


Change master switch first! ... Cars & Trucks

I just purchased a 1985 Ford Crown Victoria w/84K miles. It has Automatic Climate Control. The HVAC system is going crazy. The heat does not work at idle/deceleration, but will roast you under acceleration, versus, the A/C will not work under acceleration, but will freeze you half to death at idle/deceleration. I have replaced the following parts to no avail: 1. Motorcraft Thermo Lockout Switch 2. Motorcraft Mode/Damper Door Switch 3. Universal Vacuum Heat/AC Check Valve I am almost certain t


There is definitley a vacuum leak..more info coming... ... 1985 Ford Crown Victoria

Yesterday, after replacing the 6 year old worn battery in a friend's 2002 Chevy TrailBlazer (4.2L, 130,000 miles) a wierd problem developed. It starts and runs fine, the alt/bat charging gauge shows 14v (like normal), but when any control on the heat/AC (fan, temp, whatever) is adjusted, the engine idle is super low, the charging gauge shows under 12v, and the engine usually dies, and unless you hit the heat/AC control power OFF switch, the engine idles normal again. I disengaged the blower mo


Have you preformed a load test on your charging system.\015\012youll need a volt meter to preform the test\015\0121.Sart the engine.\015\0122. Hook your volt meter to your batt Take your reading should be about 13.5v ... 2002 Chevrolet TrailBlazer

I have a 2004 chevy venture, 3.4 l v6 engine. the red brake light stays on on the dash and on the convenience center it tells me i have low brake fluid. the brake fluid is not low and if you disconnect the wire harness from the switch in the master cyl, the light and warning sign goes out. i replace that switch and it did not cure the problem .help please.


This can also be caused by the park brake switch, go under the dash and locate the park brake switch, it is a simple ground switch (it is located on the actual park brake mechanism), remove the wire connector to the park brake switch and ground it to ... Chevrolet Venture

I have a 2006 pontiac grand prix and none of my power windows will roll down I replaced the master control switch on the door not the problem I hear a buzzing noise when button pushed down but nothing happens all windows will not roll down on any of the controls any ideas 2 mechanics have looked and dont know what to do


Follow the buzzing noise,to find the relay module,it is the problem ... 2006 Pontiac Grand Prix

The heating/AC fan only runs on the highest setting on my 2000 Chevy Venture. My 1998 Olds Silhouette (sp?) ran all speeds but high. The fuse box has a seperate circuit for heating/AC fan high vs. the other settings. All fuses are OK. Since I had one circuit go bad on the Olds and the other on the Chevy I was wondering if this is a common proble with this platform with a routine fix? I have already replaced the control switch on the dash so don't offer that as a possible problem!


There are two types of blower fan speed control. One uses a rheostat, and the other one uses electronic circuits. The speed control is atually located on the blower fan housing. It is fastened with two screws. The rheostat kind uses nicrhome wires(sa ... Chevrolet Venture

My son has a 1994 Chevy K1500 z71 4x4, getting ready to replace ball joints, (upper&lower), swaybar links, idler arms & possibley 1 control arm--try to find tear-down diagram & picture of a factory control arm. Any help would be appreciated--thanks.


Sorry to tell yall but on a z71the ball joints are held in by rivets and have to be drilled out ... Chevrolet 1500

Fuel problems 1999 Grand Prix GTP 3800 Supercharged VIN 1: car starts, but shuts down within 10 seconds. You can see the fuel pressure drop within those 10 seconds. If I flutter the throttle, the fuel pressure will jump back up to 50lbs & back down to 0-10. But, you can keep the car running by doing that. I have replaced the fuel filter & helped a little bit, but still shuts down. Replaced fuel pressure regulator & fuel pump & oil pressure switch & still nothing. HELP....


T.p.s. censor ... 1999 Pontiac Grand Prix

1. Most of the lights on the controls in the steering wheel are out. How do I replace them. (Are the lights as I have heard integral to the switches?) 2. The cruise control button is stuck how do I get at it?


You are correct-the lights are led bulbs soldered inside of the switches-the switches can be removed by gently pring them out of the steering wheel-----BE CAREFULL THOUGH-the connectors are very small and there is not much wire to pull out ... 2000 Buick LeSabre

I am having a problem with the instrument gauge cluster in my 1996 Chevy Cavalier 2.2L Coupe. I have been on here before for problems, and the best one was the dimmer switch could be bad. The problem is that the cluster lights, along with the A/C - Heater controls illumination does not come on AT ALL. Headlights still work, Stereo works fine, etc.. Can someone give me a link or explain/show how i replace the dimmer switch? If you think this may not be it please feel free for another explanatio


Aside from the dimmer, there is also a 10 amp fuse you can see in the diagram below. Sorry I cannot find instructions on changing the dimmer, but if you can short the connector and get the lights to come on, then you will know it is bad.\015\0 ... 1996 Chevrolet Cavalier
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 6.4626 seconds