Having problems with your Chevrolet C1500 ?
1966 signal light switch
\015 How to replace 1966 chev full size car signal light switch\015
The switch handle either unscrews or unbolts. You must remove your steering wheel first. Once you get it off, you will see the screws that hold it in place. The wires just unplug. Be careful , you will have some springs in there that can pop out when removing the switch.
Repair Help & Product Troubleshooting for Chevrolet C1500
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
In my 88 camaro the low beams dont come on! i can pull the light switch out all the way high beams come on when i get out all the 4 lights on the front of the car work i pull it out just a little bit i get the yellow runiing lights but no lowbeams! also when i hit the right signal light switch the drivers side right signal light doesn't light up and the side light doesn't flash either i look at the back right signal light it flashes but no driver side on all the left side signal lights work fron
Ok...silly question, and dont be offended that i asked please, but have you checked the globes...as i have had alot of cusomters coming in with noticing that all the lgiths have blown, but they do not realise until they have none, they dont seem to n ... 1988 Chevrolet Camaro
Tiburon 04, left turn signal lights stay on once activated by either turn switch, hazard light switch, or alarm. Can sometimes get them to go out by using right turn switch position, or playing with hazard light switch. currently they are stuck and I've pulled the fuse. The turn signal clicker makes normal noise even though the left turn lights stay hard on.
Replace the turn signal 'Clicker' also known as the turn signal relay. Most likely the problem unless you have a really wierd electical issue that will be hard to isolate...\015\012\015\012Peace, ... 2004 Hyundai Tiburon
About 6 months ago, I was driving and about to make a right turn. When I switched my right signal on, it began to click fast. It turns out that my front right-side signal light gave out. Now, every time I switch my right signal, the light on my dashboard blinks and clicks faster than normal. A month later, the back light, on the right side as well, gave out. Last month, I changed the light bulb from my back light but it never turned on. And now every now-and-then while I'm driving, my dashboard
There is a flasher reley under the dash it needs replaced ... 2001 Volkswagen Jetta TDI
I am working on a 1991 Audi 100. The turn signal lights stay on steady and not flashing when the signal switch is turned on after I replaced the wiper switch. Also the emergency lights only work when the ignition key is off. I installed a new flasher relay and checked all the light bulbs but it makes no difference. In addition, when the dash lights are turned on, the signal indicator lights come on dim. I know there could be some current feedback in the system but do not know how to trace it. An
If you replaced the wiper switch and this problem occured, you have a bum switch or the wrong one. ... 1990 Audi 100
Brake lights do not work at rear of truck ,no brake light signal in wireing harness at rear,cab brake light does work ,brake pedal switch good ,turn signal switch good,light switch good tail & turn lights work at rear & front correctly
Check the relays and connections at the tail lights and under the truck, has the truck ever been off road or in deep water? ... 2002 GMC Sierra
I have a 2000 Nissan frontier SE. when i apply the brakes, both my turn signals faintly light up. when i turn on left or right signals they appear to work fine, sometimes the blink faster as if i had a bulb out....but when i go to hit the brakes while my signals are on they stop blinking and both signals light up as well as reverse lights. bulbs are all fine. Not sure if i have a wire grounding out or if its a problem with the brake switch/ turn signal switch or what?? Any suggestions.
... Cars & Trucks
2006 Tucson: Noticed today when I turned off car, exited and locked car tha the marker, parking and tail lights were on. Looked inside and the light switch was in the off position. Waited a few minutes no change. Opened door turned light switch on then off and the lights went out and stayed out. Also recently noticed when I use my turn signals the switch does not turn signals off most of the time. Any ideas what is causing these problems? Is there a history of this with 2006 Tucsons?
... 2006 Hyundai Tucson
Jeep88 Turn on park lights and only the Front left comes on. The rear park lights never came on.when you turn the park lights on the right front turn signal also goes on. Changed headlight switch, nothing changed. Fuses are good and stay good. The brake lights work but when you put the brake on, the front right turn signal goes on. After I changed the headlight switch now the turn signals don't work. HELP???!!!
Try making sure all the grounds are good ... 1988 Jeep Comanche
I have a 73 plymouth satellite and my issue is the brake lights not working they only light up when i turn my headlights on at night and when i press the brake they dont flash up as in the "secondary flash" when i hit the brakes..i checked the brake switch and bought a new one and the turn signal switch is brand new, my turn signals work.on the brake light switch connections i discovered a white wire that leads to connector and a red or pink feeds into the hazard flasher switch that might be bl
... Plymouth Sundance
I had my turning signal, hazard and brake lights all go out at the same time. I had an extra brake switch from a neighbor that also has a 2003 Durango. Anyway, swapped that out and everything was still not working. The fuse for the Hazards and Turning Signals looked okay but I swapped it out anyway. Turning signals and Hazzards work now but still no brake lights. Tried putting back in the other brake switch and still nothing. I can't find a fuse for my brake lights under the hood or in the cab s
It seems that there is a fuse which is causing this fault,I would suggest you get a meter and test each fuse at a time,do not assume fuse is ok by just looking.Now if the brake lights work and your signal lights starts to play funny then test the fla ... 2002 Dodge Durango
The turn signal relay keeps ticking even after the turn signal switch is in the off position. when I hit the brakes it stops, but if I press too hard on the brakes it makes a rapid clicking noise. The thing is the turn lights don't come on when this happens, only when I turn the signal lights on do they come on. and so far there are no warning lights on the dash. Plus a friend of mine pushed down a little on the 4-way flasher switch on the top of the steering column, and it went away if he held
I had the same problem and I took the switch a part due to the almost $600 new one. You have to be patient everything is plastic. But once a part I found that the contacts were tracking ( a lot of dirt and grease build up.). The steering wheel doesn' ... 1998 GMC Jimmy
After towing another car quite a distance with the hazard lights on, the next day the turn signal werent working. i was told to change out the signal switch on the steering wheel so i did but a new one didnt make the signal work. then i checked the fuse and bulbs and those were fine as well. the parking lights and everything on that switch works except for the turn signal itself. so i called auto zone and they told me to look for the turn signal flasher box nside the glove box but could not find
OK, you've been thru the wringer. Unf, i cannot find info on where your flasher is, but there are a couple common places to check. It's usually under the dash on the driver's side. Sometimes it's plugged right into the fuse box. Other times it's ... 2004 Pontiac Grand Am
My head lights are not working the high beams flashed one night and i tried to turn them off and when they went off the never came back on i have changed the turn signal switch and the light switch but still no lights the parking lights and turn signals all work just the head lights
Was it a new switch fitted or a junk yard one ,if the later then that could be faulty as well ..right seperate light switch ,check for a feed coming from this switch to the stalk on the column first ,if no feed then thats your problem ,no feed could ... 1994 GMC Yukon
My problem is when I turn on the headlights, the parking lights comes but not the headlights, but when I hold the turn signal switch / highbeam to the rear the driving lights comes on but I will have to hold it in place to rear without clicking over to the highbeams for the lights to stay on. When I releases the turn signal the lights goes off. What causes this or is the turnsignal switch bad ?
You might just have two bad low beam headlights, I have seen it before. Only other problem would be the switch that turns on the headlights is bad. Best way is to Test power going into the headlight when the low beams are turned on to rule out the sw ... 1983 Oldsmobile Cutlass Supreme
How to change turn signal switch, brake lights don't work third light works signals work hassards work replaced brake switch at brake pedal new bulbs changed sockets around ,back-up light sockets down to tail and brake etc position but still no brake lights
... 2000 Chevrolet Cavalier
Brake lights not working on 1994 gmc sonoma changed turn signal switch brake light switch and checked fuses still no power from pedal switch and turn signal switch wirering
... Chevrolet Cars & Trucks
My 87 ford rangers brake lights will not go out unless i unhook the turn signal switch. I thought it was the brake light switch but i unpluged it and they stayed on so i tested it and shows to be good so i thought maybe it was the turn signal switch so i found two used ones, one i know should be good the other not sure about, but got the same results out of all three switchs. Even tried pulling fuses and nothing else will kill them. NEED HELP! I would like to get it back on the road. What in the
You must have some wires shorted together somewhere ... 1987 Ford Ranger
Front driver side turn signal light doesn't flash.replaced bulb,replaced socket,all other lights work on emergency flasher,except front driver side.rear driver side turn signal light works,but flashes fast,also when turn signal switch is on for driver side turn signal,no indicator light on instrument panel.running light driver side front has power,just no flash.
Replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block ... 1998 Buick Century
My 2002 Mercury Sable Panel lights are out in the speedo/guage cluster area, but the turn signal indicator lights are both on when the light switch is turned on. The panel dimmer dims the indicator lights, but has no effect on the panel lights. All other lights that illuminate with the light switch operate normally as well. This car has the auto on/off type headlight switch. Others have had this problem as well, any solution?
... 2001 Mercury Sable
Brake lights in tail lights not working. I have replaced bulbs, dash lighting switch, lighting switch on steering colum. I have checked the switch on the brake pedal with 12 volts on each of the two connection point. Where do I go from here. Also the third brake light works along with turn signals, running lights and hazard lights.
You never said if you have a good ground to the taillights, check the sockets ... 2003 Ford Crown Victoria
Brake lights wont turn off changed stop light switch, and turn signal switch. I have to take out turn signal fuses to gets light to turn off.
... 2000 GMC Jimmy
1998 chevy prizm when headlight switch s on head lamps dont work and if turnsignal is turned on car will die parking lights work and turn signals will flash normal and car wiil run if the headlights switch is off ar just park lights is on turn signal blinks normal speed also but car dies and blinker flashed very fast. also car dies when emegency flasher is on no matter if lights are on or not
... 1998 Chevrolet Prizm
Hazard lights work, but no turn signals not even on dash also no brake lighs but the brake light in rear window does work ive checked the turn signal switch,fuses,flasher relay and all are working. i pulled out the turn signal switch and tested it and it is fine
The problem is the multi-function switch.This takes the place of the turn signal switch.It is in the steering column.Hope this helps.Good luck. ... 1995 Chevrolet Monte Carlo
1995 S-10 Blazer. I don't have any brake lights. My turn signals work. I put in a new brake switch on the brake pedal but I still have no brake lights. I didn't see any type of adjustment on the brake switch. I can't find any fuse in the fuse box blown. I checked the bulbs and didn't see any bad fillaments. It has cruise control. I know the turn signal and brake lights were on the same fuse on the older cars, but I'm not to familiar with the newer cars. Thank you for the help.
Check to see if there is power getting to the brake switch. If there is no power, trace the wire to wherever it leads off to. Chances are the problem will lie in that area. Look for broken wiring, corroded or loose connectors.\015\012If you do have p ... 1997 Chevrolet S-10 Pickup
I have a 1992 Chevrolet Corsica LT. I'm having trouble with the turn signal's. I've checked every bulb, socket, and ground wire. I've replaced the fuse, flasher and the turn signal switch. All the other light's work fine including the parking light's, brake light's, and 4 way flasher's. The turn signal's still don't work, not even the light's in the arrow's in the dash don't work for the signal's but DO work for the 4 way flasher's. I could really use some help here.
DID YOU REPLACE THE BULBS ... 1992 Chevrolet Corsica