Having problems with your Chevrolet Blazer ?

1998 chevy s10 flasher keeps clicking

\015 I can hear the flasher clicking all the time until I push the brake pedal\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Chevrolet Blazer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1998 chevy s10 flasher keeps clicking


... Chevrolet Blazer

I can't put gas into my 2001 chevy s10 blazer very fast,nozzle keeps clicking off


... Chevrolet Blazer

1997 Olds Acheiva - Flasher relay keeps clicking on and off even though the turn signal indicator is off. Turn signals work but relay keeps clicking like it on for turn signals. Does anybody have a solution to stop the relay from clicking? Tried changing BCM it did not stop it, Tried changing Turn signal Switch and still clicking. Need Help Please!


... 1997 Oldsmobile Achieva

Fuse diagram on chevy s10 pickup extended cab. I am looking for the signal flasher that makes the blinkers work. The blinkers lights in cab come on as if the blinkers are on but you flip blinker they won't flash but when you step on break and then flip blinker the brake light shuts off on which ever side you have your blinker on for. I need to know where to locate flash fuse in my chevy s10 1995


Behind the radio, take the radio and the cover that goes over it. it should be there next to the hazard ligths flasher. ... 1988 Chevrolet S-10

Flasher switch keeps clicking after the switch is turned off


Check the switch in the colum that works all of that it might of melted and you have wire shorting out in there if so replace plug and probly a couple bulbs if there burnt out ... 2000 Pontiac Grand Am GT

I have a 2006 chevy silverado 2500hd with a 6.0 liter v-8 that i keep getting "engine coolant hot" or "engine overheated" message and the temp guage keeps jumping. the funny thing is the truck never overheated. I replaced the thermostat and the coolant sensor but its still doing it. The oil life message keeps going to 0% even after i just reset it and now the engine light is on.


... Chevrolet Silverado 2500HD

Hi i have a 1998 chevy truck s10 4.3 new batt. started to click when trying to start try a couple of times then stater would ingage then just stoped cranking just clicks so i put a new starter in same thing just clicks at the starter but wont crank any ideas what else could be?


... 1991 Ford F250

I have a 2006 chevy silverado 2500hd with a 6.0 liter v-8 that i keep getting "engine coolant hot" or "engine overheated" message and the temp guage keeps jumping. the funny thing is the truck never overheated. I replaced the thermostat and the coolant sensor but its still doing it. The oil life message keeps going to 0% even after i just reset it and now the engine light is on.


... 2006 Chevrolet Silverado 2500HD 2WD

2000 chevy s10 runs for a few minutes then dies. Had fuel pump, fuel pump relay and fuel filter replaced at shop but the thing will still not run properly. You have to keep your foot on gas to keep it from dying so the idle has to be above 1500 rpms to stay running. If you let foot off gas it dies. So you have to keep foot on gas pedal and one on brake to drive it. Someone help me I am about to run the thing off a bridge


I doubt very much this is electrical. Rather do a visual inspection for vacuum pipes that are leaking or have become dislodged especially around the throttle body(Where the throttle cable is connected to) and plenumb chamber. If you find a place that ... Chevrolet S 10

Ecm ignition fuse keeps blowing on my 1994 chevy s10


... Cars & Trucks

Clicking noise from flasher on 2003 chevy malibu


... 2003 Chevrolet Malibu

#10 emc/ign fuse keeps blowing.i have a 97 chevy s10 4.3 vortex engine changed the fuel pump but still keeps blowing fuses,what can i do


Short there; check wires and harnesses connections and ground. ... Cars & Trucks

I have a 1995 Chevy S10 Blazer, V6, 4.3L Vortex and I have been having a lot of problems with it. The major one I am having right now is trying to keep it running. It will start and idle for a couple of minutes and then shut off. It will start up no problem, I just can't keep it running. It will idle and the shut off. I can't figure out why. I have already replaced my fuel regulator, and all of my injectors are good. I have good fuel pressure so I know that its not my fuel pump. Please help m


Possible vacuum leak ... 1995 Chevrolet Blazer

I have a 1992 chevy s10 blazer 4x4 4.3 v6 and when i drive it and it gets warm and i come to a stop the oil pressure drops to 0 and the whole truck starts shaking but when i take back off it goes up unless im driving a long distance it will drop to 0 and stay there


Y0ou need to get the oil pressure sending unit checkd if it is working and your oil pressure is really that low then I suspect your oil pump is failing and your engine will soon lock up on you starnding you wherever it fails. This can't be post poned ... 1992 Chevrolet S-10 Blazer

Chevy Equinox 2006 Turn Signal Flasher was clicking after disengaged randomly. Then the Flasher/relay stopped working altogether. I went to auto zone to pick up a generic one and none of them work. I blew a fuse when I tried to install the off brand which was rated for 12.8v just the the original flasher was. Also the replacement was a 3 prong exact match. But when I went to the GM dealer they wanted $102.20 for this little tiny relay. Do I have any other options or am I stuck with only buying t


... 2006 Chevrolet Equinox

My 2001 chevrolet impala ls has a problem with the emergency hazard flashers. when I press the button to turn them on they come on and work fine, and when I press to turn them off, they go off ,but the clicking sound like they are still on keeps going. When I turn my key off the sound goes away but when I turn my key back on it starts up again. It sound like a blinker light, but it is my emergency flashers. The lights work, but when I turn it off the noise like they are on stays on.


... 2001 Chevrolet Impala

Turn signal keeps clicking when signal not on... replaced master flasher, still clicks.


Change the switch ... 1998 Oldsmobile Bravada

Chevy Equinox 2006 Turn Signal Flasher was clicking after disengaged randomly. Then the Flasher/relay stopped working altogether. I went to auto zone to pick up a generic one and none of them work. I blew a fuse when I tried to install the off brand which was rated for 12.8v just the the original flasher was. Also the replacement was a 3 prong exact match. But when I went to the GM dealer they wanted $102.20 for this little tiny relay. Do I have any other options or am I stuck with only buyi


... Chevrolet Equinox

2001 chevy impala won't start. battery is showing 12 volts. turn key 'on' and nothing happens, no dash lights, no clicking, nothing. turn key 'off' and a rapid clicking sound starts (similar to turn signal) this may continue for 3-4 minutes, even if key is removed. when it stops, the door chime will sound until you insert key and turn 'on'. the only thing on dash that displays is the clock, but it keeps resetting itself to 12:00. What's up????


... 2001 Chevrolet Impala

2000 chevy s10 wont keep running many scan codes


Your truck has an antitheft system called passlock. It runs thru you bcm. When this system fails, your truck will start for 1-5 seconds and then stall. The fuel enable is switched off, and injectors fail to squirt. This may be your problem and is a ... Cars & Trucks

1998 chevy blazer turning signal flasher started clicking


... 1998 Chevrolet Blazer

Flasher relay keeps clicking but stops when the brakes pedal is pushed.


... 2000 Chevrolet Blazer

Flasher location 2004 chevy s10 blazer


... 2004 Chevrolet Blazer

1985 Chevy S10 Indicator light on dash keeps blinking


HAVE YOU CHECKED TO SEE IF IT AINT IN 4WHEEL DRIVE MODE ...OR TRANSMISSION MIGHT NEED SERVICE? ... 1994 Chevrolet S-10 Blazer

Ecm fuse keeps blowing on my 1994 chevy s10 2 wheel drive 2.2 liter engine have replaced the fuel pump and the ignition module


... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.7942 seconds