Having problems with your Caterpillar Cars & Trucks ?

How do you install power steering pump on 1999 w900 kenworth

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Caterpillar Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you install power steering pump on 1999 w900 kenworth


... Caterpillar Cars & Trucks

I need to replace the o-ring that prevents power steering fluid from escaping from the power steering pressure hose of a 2003 ford windstar. When you change the power steering pump, as you take the hose out from the old pump a new o-ring must be installed because the old one will not be useful again. I'm trying to buy the o-ring but i no one knows where or how to get it. This o-ring goes into the power steering pressure hose, which goes into the power steering pump.


... Cars & Trucks

I am trying to replace a power steering pump pulley on a 1998 Grand Marquis but noticed that the steering pump shaft does not have any threads therefore I cannot install Power Steering Pump Pulley Replacer T91P-3A733-A. The small diameter threads on the tool should be engaged in the power steering pump shaft. Do I need to have the pulley professionally pressed in?


On the 98 dodge caravan 3.0 power steering pump there are threads, on this pulley and is pulled by screwing the flange onto the center of the pulley. When you replace it you have to screw it back on, the shaft of the pump is smooth so make sure you g ... 1998 Mercury Grand Marquis

My daughter's 1999 Dodge Neon has a problem with the steering (they all do, eventually). I have replaced the steering rack and pinion as well as the pump (the old rack was very notchy). Currently, the power steering is very week at parking lot speeds but acceptable when on the road. I had the steering rack and assy. replaced and it worked very nicely for a week or two. Subsequently, I noticed a noisy bearing on the power steering pump, so I purchased a new (rebuilt) unit and installed it - tryin


Check the pressure releif valve if your Neon has A/C. this will make a difference to the powers steering ... 1999 Dodge Neon

POWER STEERING WAS NOT WORKING. WE REPLACED THE POWER STEERING PUMP AND IT WORKED FOR A SHORT TIME THEN GOT REAL HARD TO STEER. THOUGHT THE REPLACEMENT PUMP WAS BAD SO INSTALLED ANOTHER. AT THE SAME TIME WE NOTICED SOME MELTED PLASTIC IN THE RESOVOIR,SO WE REPLACED THAT AS WELL. STILLHAS THE SAME PROBLEM.IT'S OK COLD,BUT AS IT WARMS UP IT BECOMES HARD TO STEER,ESPECIALLY AT IDLE.


... 2002 Toyota Tundra

Hello. My '97 jeep wrangler does not have power steering and I would like to install one. Could you please give me information as to what I would need and the steps to install it? I would probably get the gear box, power steering pump & pulley from the boneyard. Your help is greatly appreciated! Thank you!


Personally, if I had a choice I'd install a manual steering box in all my Jeeps. (less chance of leaks) But, yes, getting an entire assembly from a scrapyard is a good idea. Take good notes on how it was assembled on the donor vehicle and just revers ... Jeep Wrangler

How does the power steering pump bracket fit on my 1982 ?Ford F150 pickup with a 6 cylinder 300 engine. Also need a belt diagram. I had someone remove the engine for an overhaul, and now he cannot remember how the power steering pump fit on the engine. I am afrain he may have lost the bracket, because this has been an ongoing project. I need a picture of the setup if that is possible. That is all he lacks completing re installing the engine. Thanks


... 1982 Ford F 150

I drive a 93 oldsmobile cutlass ciera s 3.3L and I am having very difficult time removing the fan because the power steering pump and reservoir is in the way. How do I remove the power steering pump and reservoir so I can remove the heater core fan and install a new one?


GM Celebrity/Century/Ciera/6000 1982-1996 Repair \015\012Guide\015\012Power Steering Pump -REMOVAL & INSTALLATIONGasoline \015\012Engines(see Figures 1, 2, 3, 4 and 5)\015\012\015\012 ... Oldsmobile Cutlass Ciera

(1)I am replacing a 1995 Jeep Grand Cherokee Laredo(not Limited)Power steering pump (AC - 6 cycl.). I wnet to the junk yard and got one off a '93 I believe. I got the old one off and ready to install


Check with the junkyard where you got the pump...you may need to change the pump bracket with the pump, or use a different pump. You don't have a separate tensioner the pump is on a slide mount and is the tensioner (why the parts guy is a parts ... 1995 Jeep Grand Cherokee

My 2000 chevy impala, 3.4, is having power steering issues. The entire system has been changed. New gear box (reman OE), new lines, new PS pump w/reservoir (reman OE thru Auto Zone), pulley was transferred and a new serpentine belt. After installation steering was still very tight after warming up. So, I again replaced the gear box and pump. System was flushed then bled thoroughly. There are no leaks. The problem is when the engine is cold the steering is a one-finger turn with ease. Unf


No there is no high pressure switch/sensor.as you have traced and replace all the possible possibilities which can create this fault still check out \015\012Make sure the power steering belt is tight, sounds like it's slipping then even ... Chevrolet Impala

I was driving and my check engine and p/s light came on and I lost the power steering on my yaris 3 door 2010 I just installed a power windos kit and I guess the prooblem is electrical but I cannot find a fuse for power steering pump. Can anybody give me alternatives


Check where you took the power source,,, sounds like wrong place ... 2010 Toyota Yaris

I repaced my powersteering serpentine belt and power steering pump 3 months ago. today it was 32 below 0 C', I started my truck and all of the sudden no power steering I parked it the night before and it was fine no noise or whinning and in the morning the steering was stiff , and never inproved after 40 min drive .what do you think is wrong?


You have a leak fords are noritas for this although its a great disgin madza disgined this pump it works like a rotery engine and last for ever its likely the plastic resiveor had swolen and the seal is likely leaking. You could try putting fuild in ... 2000 Ford F150 Flareside SuperCab

How do I install the Power Steering Pump Pulley


Tere are two size threads on power steering pump most of the installers are the larger thread however most fords use the smaller ... 1998 Ford Mustang

My timing belt is ever so slightly off on the a/c pulley since the shop recently installed a new power steering pump. Now at 2000 RPM, my truck whines like no other. Also, the power steering comes in and out, usually out when the rpms are sub 1000. Is there a home remedy to get that belt back in line? And why is my PS still messed?


It is an easy fix with the correct tools and elbow grease. First I would recommend taking it back to the shop that did not correctly place the belt in the first place and explaining the problem. To do it yourself, under the hood should be a diagram o ... 1997 Chevrolet K1500

Need to know how to install a power steering pump on a 1996 s420. I need to take the old one off and install the new one. How many bolts hold the pump to the engine. Is there only two hoses to disconnect.


Hello,good day,you have a 119 engine v-8,yes 2 hose tobe remove and 2 bolt holding the pump,try to memorize or draw the rotation of your fan before remove,you can do it,it"s upper part of your engine,ty ... 1994 Mercedes-Benz S-Class

I have had to replace the power steering pump on my 2001 windstar 3 times and it still "growls" when when turning. My mechanic said that I might have to replace the rack and pinion assembly. He stated that when he worked for a ford dealership that replacing the rack/pinion was required to solve "growling" problem with windstars that had to have more than one pump installed. This has been a wonderful vehicle and gets terrific mileage..BUT, the steering has always been VERY FIRM or STIFF....any


New pumps will make noise for a while after install ive had some make noise up to 500 miles after install-just makesure youve move wheel side to side many times thats helps to bleed ... 2001 Ford Windstar

1998 gmc sierra half ton 4wheel drive changed out motor now power steering doesn't work even installed new pump still have no power steering


I am assuming you are using the same belt configuration as before. Is it possible the pulley for the pump is turning in the opposite direction? ... Cars & Trucks

Had a new power steering pump installed about 6


Hose or connection most likely has broken, have you lost fluid aswell? take it back to the garage who did it they might sort it out for free as long as it's not a burst hose ... 2003 BMW 325

Installed rack and power steering pump is good but


To check the pump, squeeze the return line with pliers with the pump running. If the pump is good it will whine when you do this. ... 2004 Lincoln LS

Purchased a 97 Jeep Grand Cherokee with an empty and leaking power steering pump. I replaced the pressure and return hoses and filled it but it makes a chirping noise when the engine runs cold. The pulley also has a slight wobble. I would like to replace the pulley and pump. Is te pump sold with the pulley already assembled or will I need a tool to install a new pulley on a new pump?


When you but a aftermarket power steering pump the only thing you get is the pump so make sure you take off & keep your pulley & reservoir BUT you can buy the pump with the reservoir but you still need your pulley & dip stick... ... Jeep Grand Cherokee

How do i install a power steering pump for a 2001 chevy monte carlo ss


... 2001 Chevrolet Monte Carlo

How do i install a power steering pump into a 2001 chevy monte carlo ss


... Cars & Trucks

Installing power steering pump in 1967 pontiAC GTO


... Pontiac Cars & Trucks

Need to install a new power steering pump on my 1992 lumina


Are you wanting to know how to do it? If so your best bet would to purchase a Haynes manual for your car from advance auto or autozone, pep boys sells them as well. It will take you thru a step by step process. ... 1992 Chevrolet Lumina

INSTALLED REMAN POWER STEERING PUMP AND STEERING RACK... WAS NOISEY AND RACK LOOSE... NOW STEERING SHUTTERS WHEN TURNING.. LOW AND HIGH SPEEDS.. WORST AT LOW SPEEDS . JERRY...


You have air in the system, to clear you need to crack a line of the rack and pinon one side at a time slightly turn the wheel to the left with the line cracked until you get no air coming out. Shut engine down and fill pump reserv ... 1996 Ford Explorer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.1639 seconds