Having problems with your Audi Cars & Trucks ?

Blend door on 2002 Audi A4 3.0

\015 Need to replace the blend door on a 2002 Audi A4 3.0\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Audi Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need to find and fix blend door on 2001 Audi A4 Quattro 2.8L


You would have to remove the dash. i would first check the auxilary water pump to make sure it's not leaking. if your car has electronic climate control turn the heat on low with the engine off the change the temperature and listen for an electric mo ... 2001 Audi A4

Blend door on 2002 Audi A4 3.0


... Audi Cars & Trucks

Looking for pinion gear set differential housing - gearbox All oil drained out from dried up seal. Year: 1987 Make: AUDI 4000S ID: wauzzz81zhao(0)15347 Body: 4 Door Cylinders: 4 CYL fueltype: gas Transmission: Automatic Front wheel drive


You can get it here:\015\012\015\012\015\012http://www.autopartsworld.com/audi_parts/4000/differentialpinionseal.htm ... Audi 4000

Hpw to change blend door Actuator on 2004 Audi A6


... 2001 Audi A4

1999 town car cartier blend door actuator is not properly clocked to fit in blend door tip. i had to replace blend door box assembly , how do i clock blend door motor?


... 1997 Lincoln Town Car

2008 silverado k1500 4.8L V8 - this fall i noticed that when I went to use my heat, the blend door or temp control knob was not functioning properly, either it kept blowing cold air or would not get hot, hot. After I got the blend door to change I noticed that My driver side vents are hotter than passenger side. I do not have dual climate control. So I used my verdict scan tool to look at temp control specs and they change like they should. Does any1 know where abouts the temp blend door is l


... Cars & Trucks

1997 Jeep GC with manual A/C system. Dash temp. control knob will not change the blend door. I removed the blend door motor and on the bench it works when voltage is applied directly to the motor. I replaced the A/C heater dash control panel with a used one with no change. The system works when I change the blend door by hand. Is there a wiring diagram for this system? What should I check next?


... 1997 Jeep Grand Cherokee

I have a 1998 Ford Expedition. The Front heat is not working properly and blows only cold or tepid air. The fan switch doesn't work on first two settings (lo & med). My Mechanic told me it was the blend door, a $500+ fix for labor. I found an alternative fix for replacing the blend door online. After exhausting hours and cutting holes in the heater box I discovered the blend door working properly. After searching online, I found other solutions. The fan could be a resistor or relay, bu


Was your blend door cable operated? I looked up the valve, and it appears to be cable operated. It would be along the heater hose. The lever should move back and forth when the temp is changed from cold to hot. See picture below.\015\012Whe ... 1998 Ford Expedition

Have a 98 Ford Expedition 5.4L EB. Front heater blows cold air while back works fine. Isn't the blend door. I bought a new blend door and hooked up and the new blend door didn't turn. Any idea


... Cars & Trucks

Still looking for a solution for my 98 Olds Bravada. Will only blow hot air. We've changed the blend door motor. Still only turns to the hot side. We've changed the Climate Control Head and the blend door motor STILL only blows to the hot side. It was suggested that the "programmer" may be the problem. We pulled more of the dash out to get to it, unhooked the programmer and the blend door STILL turns only to the hot side. We've tried pulling the fuse to the radio to reset the computer with sti


Check your wiring with an ohm meter. Also ckeck the plugs at both ends and make sure there aren't any pins pushed out or bent. And just to throw this in, you may have bought a bad motor. You have other motors on the plenum, try swapping them to see i ... 1998 Oldsmobile Bravada

How do I change the blend door on my 2000 oldsmobile sillouette, mechanic told my wife the compressor was going out and the blend door needed replaced to fix AC (lack of it). Are these related and how would I change out the blend door? Thanks


... 2000 Oldsmobile Silhouette

My '96 Cherokee AC vent door is stuck in 1 position. At times it clunks & air actually blows out where I have it selected to blow. Is it a cable problem or broken blend door? If the blend door, can I repair it myself by removing glove compartment door & cutting hole into HVAC to replace the door? I'm a handy female with limited funds. Thanks.


Usually it's a blend door problem that is actuated by vacuum tubes. If you remove the radio and heater control panel and possibly the dash, then you can get at it:\015\012\015\012 ... Jeep Cherokee

My 04 Expedition I get no heat flow through the front heater. The air vent doors all seem to work, but no air will flow through the heater core. I was told that it was probably the air/blend door acuator. I have found the door and know that the front dash will need to be removed to get to it. My question is that after removing the screws from the blend door can it just be lifted off the air duct or there are some kind of internal connections to the blend door? I don't want to destroy something


Your climate control only has two settings: HEAT and MAX A/C then the chances are this fix will work for you. \015\012The fix was originally developed by FTE member jfranks - YOU RULE!\015\012I paraphrased the blend door fix from jfrank a ... 2004 Ford Expedition

2002 Ford Focus blend door acuator motor turns a full revolution damaging blend door


... 2000 Ford Focus

I have 97 lincoln towncar. replaced blend door..NOW compressor not kicking in..compressor WAS working find before replacement of blend door


... 1997 Lincoln Town Car

Blend door my heater stopped blowing heat and the air conditioning blows cold when in the red heat setting on the knob. Through my reading the most likely problem is that the blend door is stuck on air conditioning side. I need a diagram on how to find the blend dooor and replace it. Help!!!!


Http://www.f150online.com/forums/hvac/216009-blend-door-replacement-pictures.html Go to this link. You may change ... 1994 Ford F150 Styleside Supercab

I need an exploded view of the lower half of the heater box for a 99 ford expedition. The interior parts. I have a bad hot and cold blend door that is broken on the bottom where the blend door motor is inserted. I'm looking for the part number for the flapper door itself. Thanks. Chuck Varner


Click on this link directly \015\012and get all the pictures of dis-assembly with step by step instructions in detail.\015\012 ... Ford Expedition

My Air Blend Door motor is not working. I removed it and operated the system. The drive coupler on the motor assembly does not move regardless of temperature setting on control panel. I can move the air blend door shaft manually with my fingers. Can the Air Blend Motor operation be tested outside of the vehicle?


... 1988 Chrysler New Yorker

Whats an easy fix 2003 mercury marquis blend door or actuator replace.heat comes out when ac is on blend door not closed or actuator not moving door


... 2000 Mercury Grand Marquis

I have a 2000 Dodge Durango I get air through all my vents but no hot air unless it's warm outside. I've had my heater core replaced I have also had a thermostat replaced. replaced my blower motor with a new wheel. I found my blend door stuck. I had a mechanic position the door shut but it became stuck again how do I fix the problem to get my blend door unstuck?


... Cars & Trucks

I have a tab broken on blend door where rod connects from heater motot. I need to know location of blend doors


... 2002 Ford Taurus

I have a 1993 Jeep Cherokee Larado. I just paid $1200.00 to have the dash pulled and the evaportor replaced. Now I get zero heat. They replaced the thermostat (didn't solve problem) and say the actuator blend door is stuck. They will have to pull the dash again and it will cost me almost $600.00. What does the blend door do? Could my heat problem be associated with the air condition fix?


If it got stuck when they took it apart.yes. It may also be coincedence.the heat worked before they did the evap I beleive I would be more than a little angry.it should of been noticed when they had it apart. Sorry but this is not something I can be ... 1998 Jeep Cherokee

2001 FORD EXPEDITION XLT 4.6L V8 BLOWING MILD WARM BUT NOT WARMING THOROUGHLY. HAVE FLUSHED COOLING SYSTEM THREE TIMES, AND CHANGED THERMOSTAT. HAVE ALSO REMOVED DASH AND REPLACED "BLEND DOOR" AND BLEND DOOR ACTUATOR IN HEATER CORE HOUSING. HOW CAN I GET TO BLOW HOTTER.


You hot air comes from the water circulated through the heater core. It is like a miniture radiator with water flowing thru it constantly. So by opening the "Blend Door" you are permitting so much of this hot air to pass thru.Seems like ... 2000 Ford Expedition

My 2005 jeep cherokee blend door broke 2 years ago so i got it fixed. Now yesterday air started working whenit hasnt worked all summer just heat why does the blend door keep doing this


... 2005 Jeep Grand Cherokee

Temperature of A/C or Heater will not change to hot or cold. It is just kind of stuck in between. Door Blend Actuators are not moving but can be moved freely by hand. I have checked all the fuses and relays, changed one of the door blend actuators and changed the Temperature Control Module on the dash. Water is circulating and have installed a new thermostat. I have also disconnected battery to reset computer memory. Blower motor works fine and airflow can be changed from floor, vent and defrost


Since all mechanical parts are in working order then the problem is in the logic part - the blend doors don't move because they aren't commanded to do that. The only thing that would do that is the failure of the climate control module - you will hav ... 2001 Buick LeSabre
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1079 seconds