Having problems with your Cars & Trucks ?

I have a 1998 chevy blazer 4.3 L vortex. I have a

\015 I have a 1998 chevy blazer 4.3 L vortex. I have a brand new fuel pump and a brand new fuel filter. I resided the harness and the 3 hoses are brand new. The fuel is still not pumping out of the fuel pump and their is not fuel getting to the filter. I really want this car to start. It starts when I sprayed starter fluid into it and then it shuts off when right when I stopped spraying. Can somebody help me figure this out? \015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Check the ground back by the fuel tank. There should be a 13mm bolt on top of the frame rail or one of the cross members.
Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I was given a 1994 s10 Chevy Tahoe vortex blazer


... 1994 Chevrolet S-10 Blazer

I have a 1998 chevy blazer 4.3 L vortex. I have a


Check the ground back by the fuel tank. There should be a 13mm bolt on top of the frame rail or one of the cross members. ... Cars & Trucks

I have a 1992 chevy s10 blazer 4x4 4.3 v6 and when i drive it and it gets warm and i come to a stop the oil pressure drops to 0 and the whole truck starts shaking but when i take back off it goes up unless im driving a long distance it will drop to 0 and stay there


Y0ou need to get the oil pressure sending unit checkd if it is working and your oil pressure is really that low then I suspect your oil pump is failing and your engine will soon lock up on you starnding you wherever it fails. This can't be post poned ... 1992 Chevrolet S-10 Blazer

I have a 1994 chevy blazer 2wd wiyh a 4.3 chevy vortex engine . i have changed the fuel pump out 3 times since the origenal one went out. all of them run but they spit and sputter and surge


Check to make sure the short high pressure line between the pump and outgoing fuel supply line doesn't have any cracks (the small line inside the tank) -- I had same symptoms only to find pump could not hold pressure because of the bad line ( make su ... 1994 Chevrolet S-10 Blazer

Chevy s10 diagram for the poppets running from the injector on 94 chevy s10 blazer vortex engine


... Cars & Trucks

Chevy s10 diagram for the poppets running from the injector on 94 chevy s10 blazer vortex engine


... Cars & Trucks

1995 chevy blazer 4.3 vortex bad idling repaired fuel injection leak and replaced sparkplugs .its missing and lopes while idling trouble codes po300/po756/p1351/p1406/po122 help.


... 1995 Chevrolet Blazer

I have a 1991 chevy s-10 blazer 4.3 l engine not vortex. The fuel line is cracked can I buy the fuel line at a parts store or Do I have to go to the dealer to get it.


You should be able to go to a parts store and get it but i might go to a junk yard to see if they may have one in decent shape cheaper ... 1991 Chevrolet S-10 Blazer

I have a 1995 Chevy S10 Blazer, V6, 4.3L Vortex and I have been having a lot of problems with it. The major one I am having right now is trying to keep it running. It will start and idle for a couple of minutes and then shut off. It will start up no problem, I just can't keep it running. It will idle and the shut off. I can't figure out why. I have already replaced my fuel regulator, and all of my injectors are good. I have good fuel pressure so I know that its not my fuel pump. Please help m


Possible vacuum leak ... 1995 Chevrolet Blazer

My heater coil went bad,and i recently bought a new heater coil and it was placed in the truck-1994 chevy blazer s10 4 door,vortex engine,the problem is now,that the blower is not working or the fan,and no heat is coming out,but the heater coil is heating up underneath where it is located-but there is no heat coming out of the vents.When i turn the heater switch up-it makes a really bad clicking sound which seems to be coming from somewhere under the hood in the front of the truck.Im afraid now


I ASSUME you replaced the heater CORE? You need to find the ticking noise in front, just turn key on, turn blower on, and find out where its coming from. It cant catch fire, not from that anyhow. The radiator releases the heat from the engine, you ... 1994 Chevrolet S-10 Blazer

I need a wiring diagram for under the hood of a 1995 chevy s-10 blazer 4x4 with a 4.3 vortex engine, distributor cap is on side of the motor not on top


Check this link and as you read a bit down,you'll see a further link to get the diagrams:\015\012http://w ... 1995 Chevrolet Blazer

1999 chevy blazer is giving me lukewarm heat at 0 degrees. could it still be the heater core?


You say 'could it still be the heater core', did you have it replaced? 1st thing I would check is the engine temp when it's that cold while driving. Is the temp gauge indicating it's in the 'normal' zone, or is it in the cold or lower range? How l ... 2000 Chevrolet Blazer

Need wiring diagram of 1995 chevy blazer 4x4 with 4.3 vortex engine


I have a 1996 Chevy Blazer Lt. The ecm fuse continues to blow reguardless on what type fuse i put in it . I will replace the fuse the Blazer starts and then when i put it in drive it will blow out after i had just replaced it not two minutes before. ... 1995 Chevrolet Blazer

1996 chevy blazer with vortex engine bad fuel mileage


You failed to mention what fuel mileage you are getting. The 4.3L Vortec engine is rated at 19 mpg city driving and 21mpg highway driving. That's for the 4 door 4wd automatic transmission. If you are getting considerably les ... 1996 Chevrolet Blazer

Fuel pressure regulator diagram for 1994 chevy blazer 4.3 vortex


... Chevrolet Blazer

I have a 2001 chevy blazer with a 4.3 vortex,the crank sensor is hitting the crank.what could cause this problem?


... 2001 Chevrolet Blazer

I have a 1995 chevy blazer with the 4.3 high output vortex motor no cat in it did the fix to the 02 so it would read right just changed the fuel pressure regulator and now it blows white smoke and runs like **** any help would be greatly appreciated


White smoke is typicaly coolant, sometimes trans fluid will also apear white. I would pull the plugs first off to see if one or more is "wet" with fluid, also dbl check fluid levels. ... 1995 Chevrolet S-10 CA Edition

2000 chevy blazer 4X4. After driving twenty to thirty miles on freeway when I pull off to the off ramp and come to a stop my battery gauge will start to flicker as well as my fuel gauge, will do that everytime I come to a stop in town. Get back on the freeway drive 40 to 50 miles then car will lose rpm no acceleration when i give it gas when it reaches 0 rpm the car will shut off. the car will turn over but wont start for thirty or so minutes,cant get very far. Fuses are hot as well as the engin


Are there any codes in the pcm? \015\012There are quite a few things that could cause this;\015\012Make sure the battery cables are tight and clean.\015\012If you have a way to do it, need to find out what the fuel pressure is at w ... 2000 Chevrolet Blazer

Just bought a 94 chevy blazer 4.3 vortex motor.digital speedo not working how do i hook it back up?


Your "speed sensor" is located on the transmissions tailshaft. It's possible the wire clip is detached, but usually the issue is a bad "speed sensor". There are a few different types of speed sensor for your vehicle year; depends on 2wd, 4wd, and vin ... 1994 Chevrolet S-10 Blazer

Diagram for the firing order on a 4.3 vortex chevy 4x4 s-10 blazer


For the 1993 Chevrolet S10 Blazer 4.3 V6, Both: 2WD AND 4WD:Firing Order:1-6-5-4-3-2Cylinders:.......(back).......|..6..|.......|..5..| ... 1993 Chevrolet S-10

I have an 1993 S10 Chevy Blazer 4x4 with a 4.3 vortex, and my problem is that when I go on the road, it shifts from 1st, 2nd, 3rd,..gear before I even go 20mph.... My transmission is automatic.


Check your flywheel or check your gear rate. ... 1994 Chevrolet S-10 Blazer

95 chevy blazer with a 4.3 Vortex that I just put back together after putting in new head gaskets. It ran great for a short time, when had a push rod come loose. I took it to a shop, my friend who runs the shop told me it was the push rod causing the problems. He had it apart most of the way and gave it back to me like that so I could fix it myself to save him time and me money. Got that fixed and back together but now it will not start. I have checked for spark and it does not have any spar


No spark indicates four possible places, \0121 The ignition module\0122 The crankshaft position sensor\0123 The camshaft position sensor\0124 The coil\012Good luck\012Randy ... Chevrolet Blazer

My 2006 chevy blazer says v6 vortex what Liter is it, and the tailgate and rear window will not open with electic or with a key


I don't know what wrong with your tailgate but your engine is a 4.3 liter ... 2006 Chevrolet Blazer

My 1999 Chevy Blazer is leaking coolant from the back side of the motor. It has a 4.3 Vortex V-6 and is 4 wheel drive. Can you give me some ideas as to what maybe causing it to leak? It runs out pretty good when the motor is running.


... Chevrolet Blazer

I have a problem with a chevy S10 blazer 4.3L CPI (VORTEX) 4x4. I have changed the MAP sensor Coil Spark plugs Spark plug wires fuel filter and battery. The fuel pump works fine and it rolls over. When it does start it will stall within 5 mins unless you keep accelerating. Can't find out the problem. No engine codes either.


Most likely will have to remove the intake, and replace\015\012the pressure regulator and spyder poppet/assy\015\012\015\012Are the spark plugs wet & a gas smell ? ... Chevrolet S 10
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3163 seconds