Having problems with your Cars & Trucks ?

How do you unstick a 5 speed transmission on a 1989 ford f-150 xlt lariat

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you unstick a 5 speed transmission on a 1989 ford f-150 xlt lariat


... Cars & Trucks

1990 ford bronco 351 windsor engine, e40d at transmission. Drove on hwy at hwy speed for 2.5 hrs, turned off and engine started to sputter and pop with very low idle rpm. Shortly idle went to 0 rpm and engine stopped runing, 1 hour afterwards engine started up and ran normall next day also. What is problem?


I have an 89 with a 351w. Mine did the same thing. Sounds like its vapor locking. After you let it sit for an hour or so it should start up but you should take the EGR valve off and either replace it or clean it with carb. cleaner. That should el ... 1990 Ford Bronco

I have a 1999 ford contour 2,0 lt 4 cyl. the problem I have is with the transmission. the car will not move forward on D from stop. i have to started on 1 and speed up so I can gear up to D. I have been told it could be service by disassemble the gear box, replaced damaged parts and assembled. On 2 is starting to slip. the car is in venezuela and I have been told replacement parts could be found


You will need to have the transaxle rebuilt\015\012\015\012In your case, a remanufactured trans with a warrantee,\015\012may be your best bet,if you have to have it shipped in ... 1999 Ford Contour

2000 ford explorer input turbine speed sensor. code po715 was pulled on the obd scanner.does any 1 no were this sensor is located at on my transmission, i beleiv e it has the 55r5e trans but not quit sure. engine is a 4.0 sohc with over drive and 4x4 any 1 can help would be great im going nuts ovewr this. also auto zone sold me a input turbine speed sensor but i cant find the part they sold me any were on transmission, so not sure if thats even the rite part i need ...(i need the input turbine s


The is also known as sensoer c it is your pressure control solenoid. if you drop the transmission pan and remove the transmission filter it is on the side of the valve body. DO NOT REMOVE THE VALVE BODY PLEASE ... 2000 Ford Explorer

I have a ford escape 4X4 2005 AT transmission, after 1 hr driving the vehicle i got the O/D OFF flashing , after and turn it off and turn it back on there was no light , and then after 1 hr again the light is on flashing but this doesnt happend all the time , i checked the transmission oil and is ok , theres no codes in the computer the vehicle is running fine i checked others forums and they said is speed sensor or cables problem any idea?


Only a scan tool with Ford enhance can detect this one but there is a TCS that always and is common to breakage. This is for the floor shift models the wire brake at the base of the shifter during range selecting and its possible this connection is b ... Ford Escape

I have a ford escape 4X4 2005 AT transmission, after 1 hr driving the vehicle i got the O/D OFF , after and turn it off and turn it back on there was no light , and after 1 hr again the light is on flashing but this doesnt happend all the time , i checked the transmission oil and is ok , theres no codes in the computer the vehicle is running fine i checked others forums and they said is speed sensor or cables problem any idea?


... 2005 Ford Escape

Is a E4od Transmission(Ford) the same that is in my motorhome and in my f350 pickup truck,, 4 speed with OD? i have 1 1994 fleetwood bounder with a 460 ford and an e40d thansmission in it,, as well as my 1995 f 350 pickup,, i was driving my motorhome and it acted like it was not going into overdirve, and at about 65 mph the front seal blew out of the transmission, dumping all the fluid ,, the motorhome just had a new engine installed and the mechanic said he was going to put in a new front seal


It might have just run low on fluid while driving,the front seal may not have been installed correctly,or the cooler lines or cooler might be plugged causing the trans to overheat which will cause it to leak a steady stream...for example,my 94 bronco ... 1994 Ford F350 Crew Cab

1995 ford aspire 3 speed automatic, hose that comes from top of transmission but does not terminate anywhere,,transmission shifts hard from 1 rst gear to 2nd gear.


\012HelloThe engine\012and automatic transmission in this vehicles drive train\012are fully electronically controlled by a computer called the PCM\012(Power Train Control Module). Whenever a problem like this occurs ... 1995 Ford Aspire

Transmission problems My 1996 ford windstar has a transmission problem. I just had the transmission rebuilt about 1 month ago. It ran great the first week and know it seems to be slipping and it does not go into 2nd gear. Sometimes it works good but then sometimes it doesn't. Today I took off on the road slowly and it took 2nd gear then all of a sudden it started slipping when I increased the speed to 40 miles per hour. IT sometimes also will start shaking from the front side of the van. Sometim


I would take it back to the rebuilder. Perhaps it just requires adjustmnet. ... 1996 Ford Windstar

Have noticed strong jump/**** during acceleration from 1st to 2nd gear. Suspect transmission, though I just replaced the transmission fluid. For a 1991 Ford F150 XLT Lariat 4X4 with the 300 V6 4.9L 147K miles.


... 1991 Ford F150

Its a 1989 Ford XLT Lariat 150 4x4 5speed standard transmission, cruise control. Where does the speedometer go. Is there a diagram anywhere on this. Believe it or not I called the Ford dealer parts department and they didn't know. One said it mounted on the rear end. Are there any reasonable repair books out there on these trucks.


The speedometer cable should go into the side of the transfer case. ... Ford F-150

Transmission makes a whine at speeds in excess of 20mph in all gears 1-5 and lower speeds 0-20 it clicks whether the clutch is in or not


I assume its a manual transmission, sounds like the gears are whineing, check the fluid level, most manual are splash lubricated so low oil means not lubrication, also could be syncronizers, bearings, worn gears, out put/ in put shaft ... 2001 Chevrolet Blazer

I can only shift in 1 and 2 speed on my ford focus 2002 manual transmission


... 2002 Ford Focus

What type of transmission is in my 1989 ford f150 lariat xlt


Three different transmissions 1. E4od Electronic 4 speed automatic with OverDrive 2.5speed manual with overdrive 3. NP 435 4 speed manual ... 1989 Ford F 150

1978 Ford F-150 XLT 351 motor manual transmission 4 speed


... Cars & Trucks

I have a 2004 ford escape 2.3l XLT and recently i had the ATF replaced (over 45K miles on it) but the filter was not. Now it will hesitate to engage on high speeds but for drive or reverse it works ok. HELP! is the transmission busted?


... 2004 Ford Expedition

I have an 89 ford f150 XLT lariat 302 5 speed. Have 2 problems. First is when key is turned to start nothing happens. Replaced clutch lock switch and soleniod. Still nothing. Second problem is when it cranks it wont fire. Replaced fuel pump and filter


Check the modules. And fuel pump ... Cars & Trucks

I need to know what oil should be used in a 1988 Ford F350 XLT with 8 cylinders and a 5 speed manual transmission?


10W30 weight. ... 1988 Ford F 350

My speedometer doesnt work and the cable is fine it just came unconnected from the tranny i guess and i cant find where it goes back in.???? its a 1991 ford f150 xlt lariat with cruise control, 5 speed


Up towards the front top, there should be a hole ... 1991 Ford F150

Im having my tranny rebuilt on a 1997 ford ranger xlt. The Drive went on it, Im down to the lower gears of 1 &2 and reverse is very hesitant. the mechanic is doing a complete overhaul. Was this the only solution? And what are my chances of getting a good to great working truck when he's done? (take into acct he's a "mister transmission" specialist) Also any feedback on cost would be great!? I also have my running lights not working. (tail lights) brakes and signals work but not the tail lights w


Chris\015\012\015\012 Not so much Ford Trans, but rather Ranger Trans are are just a poor fit. Everything about them is just ify. I agrain reman is the better way to go, just for the long term money and expenses.\015\012\015\ ... 1997 Ford Ranger SuperCab

Ford transmission ado 4 speed will not change gear in drive or manual control like it has only got 1 st or 2 nd gear park ok reverse ok neutral ok drive dose not slip oil new thanks johnny mack


Is your linkage Bent to the transmission ?Or perhaps something under the boot obstructing from engaging into gear ... Ford F-100

Ford Focus engine diagram Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V


... 2001 Ford Focus

Hi.. i have GMC suburban v2500 4x4. 1991. i have two problems. 1:how many speed does the TRANSMISSION have. 1: the transmission takes so long after the 3rd speed to change and some time doesnot change and i feel a lot of presure on engine? 3: is there any link between the problem mintioned above and high tempreture? THaNKS


3 speeds ,plus overdrive. May need a good trans shop to ck it out for you, stay away from any Chain Store trans shop. ... 1991 GMC Suburban

1985 ford pick up with a 1 ton clutch c5 transmission carborated will not fire


Check your timing. Sounds like the bolt holding the distributor may have come loose and let it turn a bit or your rotor in the cap is loose and not giving spark to the correct cylinder at the correct time. ... 1985 Ford F150

Hi, I own a 1997 Ford E 350 Econoline, I have the following transmission engagement problem: Truck will not start: Transmission will not engage any gear, neutral or park. The shift lever feels like is not engagin any thing (moves freely) except at the very bottom (like 2-or 1 position, I feel like engage 1 or 2 gears). I did the following troubleshooting? myself: Raised vehicle and manually moved transmission lever to the park position with the following results. 1.- The truck started 2.- Transm


The weld on the manual lever is known to break loose. First, with the wheels off the ground, with the lever in the park position, does the drive shaft lock in park? If yes or no sometimes, drop the trans pan. I bet the nut on the lever camd loose. ... 1994 Ford Econoline
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.1446 seconds