Having problems with your Cars & Trucks ?

1996 Geo Metor

\015 Where is the computer on the 1996 Geo Metro and can you provide a picture\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

e8021e3c-b821-429a-85ca-8401f859df33.jpg278718db-8c8b-4814-9079-3130bda69625.jpg
If you pull the glove box door down, it's pretty easy to get to. It has 3 connectors plugged into it. Hope this helps....
Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1996 Geo Metor


... Cars & Trucks

Replace timeing belt on geo priszm is this a 0 clearance engine


Yes it may bend valves if belt is off. ... 1993 Geo Prizm

92 geo 1.6 l shoc sounds like a missing v-8 exhaust has a lot of raw gas smell to it and it runs extremely rough until warm, if trying to drive before it is warm, tach will drop to nearly 0, engine will almost stall then jump up to 2500 rpm drop back down about 1000 rpm. runs perfectly normal once warm


... 1992 Geo Storm

What should i set the timing at for my 94 geo metro i have a timing light should i set it at 0?


Unless you have replaced the hood or the sticker has been removed, there should be a label on the inside of your hood that lists the correct timing. Make sure you short the two appropriate wires in the 'test plug' before setting the timin ... 1994 Geo Metro

Can anyone tell me what these engine fault codes refer to on a 1998 mercedes c180 auto,1.8 petrol. I suspect it may be releated to tempeture sensor. Total of 6 codes 065 (2,2,0,41) resistance too high 104 (2,2,0,68) resistance too low 122 (2,2,0,7a) resistance too low 126 (2,2,0,7e) resistance too low 129 (2,2,0,81) resistance too low thanks jim 161 (2,2,0,a1) resistance too high


Most common is o2 sensor ... 2002 Mercedes-Benz C-Class

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil. if you rev engine or increase rpms it goes to 0 and stayes there. let off and it jumps around like it did when started (0 to 40). No engine pecks while running. Display indicates low oil pressure and stop engine. orange light (check gages) comes on when at 0. any ideas. Service engine has not c


There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the ... 2003 GMC Envoy Xl

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

I have just purchased an Antler cabin bag with a TSA lock, should be preset to 0 0 0 as per factory setting & I should be able to open it, unfortunately this is not the case, any suggestions????


... Cars & Trucks

97 gmc suburban, no start, has spark and fuel. no codes. scanner shows no problem, except cam ******=0 knock ******=0 and spark ******=0 doesnt show inj. pw. leaning towards pcm??any help would be great


... 1997 GMC Suburban

The oil pressure gauge is going directly from 0-80.....as soon as you crank up the vehicle....Its running fine, no lights have come on, running smooth like normal, its just that the gauge in the dashboard is going from 0-80....what could this be ....this is the gauge that has 0-40-80 and the picture of the little oil container


It sounds like there is a problem with the oil pressure sending circuit. The oil pressure sender changes voltage according to the differences in oil pressure. If it is pegged all the way to the max, there may be a short (or open, depending on the w ... 2003 Chevrolet Tahoe

1990 toyota 4 runner Gun timing mark?? 0 or degrees after 0??


... Toyota 4Runner

1990 corvette tachometer problem, when the key is turned on the tach needle moves from slightly below 0 up to 0 but does nothing more when the engine is started and revved up


... 1990 Chevrolet Corvette

Fitting 0-320 cylinders on 0-290 lycoming


\012You may have this\012posted in the wrong product category. Please select another category\012appropriate to the problem and re-post the problem so the correct\012expert will see and respond to the question.. \012\012This is for ... Cars & Trucks

Frieghtliner m2 fault codes eng 0, 4376, fail 5 and eng 0, 3361, fail 05


... Cars & Trucks

Maintenance switch on a geo tracker under left frnt speaker cover to reset engine lite ,..whitch comes on every 50,000 and 80,000 and 1000,000 miles to make you think your geo is not running rite...an


... 1996 Geo Tracker 2 Door

Como puedo poner a tiempo un geo metro 94 - 1994 Geo Metro


... 1994 Geo Metro

Geo storm my geo wasnt running then i changed the air flow sensor and it started running but with really high rpm's also i changed the throttle positioning sensor but nothing changed


Try uplugging throttle sensor see if any change ... 1991 Geo Storm

Gas tanks will a 1993 geo prism gas tank interchange with a 1995 geo prism?


Yes from 1993 thru 1997 everything is interchangable ... 1995 Geo Prizm

How to replace control arm on 1993 geo prizm - 1993 Geo Prizm


... 1993 Geo Prizm

I have a 98 plymouth voyager se 3.3l auto (4 speed) and the speedo bounces cause the vehicle to have a jerking motion. when the speedo stays a 0 the vehicle runs fine but this doesn't last long befoer the speedo bounces. it also bounces when you are not moving the bouncing goes from 0 to 200 and when moving its between 20 and 80 . any help would be appreciated We have the same problem and had the speed sensor replaced three times. That was not the issue. Now when sitting at a stand still the sp


I would suggest taking it into a Jiffy Lube or Another Auto-Repair company. They can fix it for sure, and if they don't, you get a refund, and an apology. ... 2000 Plymouth Voyager

Geo metro my geo metro is realy bumpy and sound like **** and it has a blown cylider how do i fix that


Well if you know it has a blown cylinder they you need to rebuild the motor and that cant be explained over the internet. the easier thing to do is to buy a used motor and replace the whole thing. those motors and small and cheap. you will waste more ... 1995 Geo Metro

In the trip computer - the fuel range is showing 0 and I have fuel. is this a fuse problem? My 03 Acura MDX shows 0 on the range and has a full tank of gas


How many indicate the fuel gauge? , if ok then disconnect the negative battery terminal few minutes and reconnect and star the engine , check ... 2003 Acura MDX

Speedo bounces 1994 Toyota Scepter (Camry). Speedo sits on 0, when I drive over a bump or ease off the gas it bounces up to correct speed. Re-accellerate and it goes back to 0. Is it electrical or other?


Yes is elctrical . a small part on the side of the transmision caled speed sensor sending unit replace it ... 1994 Toyota Camry

I have a 92 plymouth voyager that while I'm driving the instrument gauges will go crazy then everything thing will ping out to 0. What I mean is it will say I have no gas and though I am traveling at 55mph it will say that I'm at 0 is there a reset on this or do I have to repace the instrument cluster?


On-board computer needs to be re-booted.  This is done by disconnecting battery - just the negative post is sufficient - then re-connecting and starting the vehicle.  \015\012\015\012My 1992 Voyager did this for the first time after I ... 1998 Plymouth Voyager

1993 geo tracker 5 speed wont go into gear - 1992 Geo Tracker


Replace clutch bearing ASAP ... 1992 Geo Tracker
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0752 seconds