Having problems with your Cars & Trucks ?

2004 silverado 2500 hd will not start . How can I check the neutral safety switch

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1998 Toyota Corolla, automatic. I have trouble starting my car. When the key is engaged to the start position sometimes I just get a click. I have checked the battery w/ a hydrometer and have cleaned the battery terminals. Sometimes, if I jiggle the automatic gear shift while in Park the car will start. 1) Does the car have a neutral safety switch and if so, where is it located and what's the easiest way to replace it? 2) Are the ignition switch and the neutral safety switch the same thing


\012I tried to find a \012Toyota Corolla \012Wiring Diagram 1998 | If you go to your library y ... 1998 Toyota Corolla

Eagle Talon 95 neutral safety switch questions. I've had intermittent stalls lately and then problems starting the car for awhile. Everything I've checked is fine but then the starting problem went from cranking and not starting to not cranking. Long story short I unplugged the neutral safety switch and car starts (without clutch) and runs good. I drove all over and couldn't get it to stall. My main question which is very important so don't answer if your not sure please. Does the neutral sa


... 1995 Eagle Talon

I have A 2003 toyota Corolla with a no start problem. It wont turn over, so i checked the battery, the starter, the alternator, the starter relay, the neutral safety switch, and replaced the ignition switch to no progress. I also use an OBD II sensor and no codes were found. I tested to see how many volts are going through the starter and found only 1 v. I am at my wits end and would apperciate any help offered.


You need to see how far the power is getting through the circuit. you will need a volt meter and maybe a friend to help. so start at the small wire on the starter. this should have power when you turn the ignition key. no power? then move to st ... 2003 Toyota Corolla

S10 1999 bearings bad 0 oil pressure,removed and rebuilt engine, replaced most all. back in and...Won't start, not a crank or a ticking from the starter. Starter and starter selanoid, battery all tested OK.conecting to starter and starter getting power. Replaced neutral safety switch twice , check all 3 relays all OK. Still no response. Lights and accessory lights all go on when ignition turned. Have tried all gears but still nothing. Could I have forgotten to replace something. Is there a way t


Yes, you can hotwire the starter, use a button starter to energize the solenoid. there is a chance thet the new or rebuilt starter isn't working. it has happened to me I went an bought a newly rebuilt starter but it was no good, it happens sometimes. ... 1999 Chevrolet S-10 Pickup

2004 silverado 2500 hd will not start . How can I check the neutral safety switch


... Cars & Trucks

1999 Altima A/T with factory alarm wouldn't start. Showed power from ignition, shorted out starter, car started. Swapped out 6-pin Inhibitor Relay switch, no start. Replaced Relay with a jumper between 5-6 pins (switch) and car starts. Put jumpers on all pins (1-1, 2-2, 3-3, 4-4, 5-5, 6-6 with relay) and grounded #2 pin (ground side of relay coil) and car started, so believe problem is Neutral Safety Switch. Switch plug shows a bank of 5 pins in line and a bank of 4 pins in line but I can't find


... Nissan Altima

1984 Ford Econoline 350, The vehicle was able to start when removed from park after finding the neutral gear selection. It will not start now even after trying to find the neutral gear. I was told to check along the lines of a Neutral Safety Switch.


... 1984 Ford Econoline

Starting Proble Car died while driving down the road. Car will not start or turnover. Checked all connections, fuses, battery, neutral safety switch etc. All check out. I have heard it might be the Ignition Module. Would this be a possibility and can it be checked by a parts strore if it is removed.


My car did this, it would somtimes idle funny and then die. i would then have to wait 30 min b4 it would start. it was my fuel pump, check it out... ... 1996 Pontiac Grand Am

Truck won't start. All lights come on. Think it is the neutral safety switch, but cannot take it out of park to check if it starts in neutral. How do you put the (automatic) transmission into neutral with the motor not running?


Press on the bake pedal ... 1996 Dodge Dakota

Neutral safety adjustment- we have a 95 mitsubishi montero. It has trouble starting up while in park. You have to play with the shifter. it starts right up when in neutral. my husband took a look at the neutral safety switch. when he puts pressure on it and lines it up it starts right up. How do you adjust the safety switch. any suggestions on what the issue could be? doesnt sound like a bad switch if we are able to start it up? also, do you know how to change out the fuel tank sending unit. t


OK, so the tank gauge will be easy to replace by removing the cover form the boot compartment area on the back side of the car and in the middle you will find a reund cover screwed. remove the screws and you will be able to access the guage.\01 ... 1995 Mitsubishi Montero

96 monte carlo has power when you turn key on but when you tourn it all the way to start there is nothing. Changed neutral safety switch and key switch, checked all fuses, but still nothing. I can turn the key on and jump it across the starter and it will start for about 5 seconds and then shuts off, Security system.


When you changed the key switch, did you program the key to the car? do you see a lock and key on the dash board? ... 1999 Chevrolet Monte Carlo

My 1989 Ford F-250 keeps trying to start without the key on. I replaced the starter, the solenoid, the ignition switch in the column, found 1 wire that was cracked and taped it, when the battery is hooked up it still trys to start. What else could be wrong? Neutral safety switch or steering column wiring, Im at my wits end!


You still have a bare wire somewhere ... You probably did this already ... I would remove the wire from the ignition switch to the start solenoid and see what happens ...\012\012Good luck on your search ...\012\012Thanks for v ... 1989 Ford F 250

2003 Ford Windstar - no crank/start problem. Our 03 will not crank on cool (65 degrees and lower) mornings but will start later in the day when it is warmer, Have changed - alternator, starter, ignition switch (electrical), TPS (aka - neutral safety switch), battery and changed out several relay and fuses. Checked ground in three places - clean and secure. This a.m. mechanic tried to read codes - only thing coding was that the key was not being recognized - yet it would and does start on oc


... 2003 Ford Windstar

1999 Ford Explorer XLT 5.0 AWD - starter will not engage. I hve replaced the starter/solenoid, ingition relay, ignition switch, neutral safety switch and battery. battery cables are clean and solid. I can start the Explorer by jumping across the solenoid. Once it starts it run's fine. No check engine light. I have also connected an ODB Code Reader and it does not show any codes.


If you replaced the solenoid was there one wire to the solenoid or two? If the new solenoid had two small posts did you connect the single wire to the S (starter) or I (ignition) side? If you connected to the I side this is your problem. If you ha ... Ford Explorer

2005 pt cruiser automatic non turbo went to store came out will not start no clicking or anything took starter and battery in to have it checked and both are good car acts as if there is no starter hooked up i have the 12 volts at the power cable at starter i have had a problem the past week with having to "jiggle" shifter to get the key to release from ignition im thinking neutral safety switch but dont know if it is or where switch is if it is the switch


Sounds like it could be to me ,run a hot wire direct from battery to small terminal on starter and see if it will start before you go any further ... Chrysler PT Cruiser

I have a 1990 cadillac deville, it was running great and one day just would not start! Any Ideas why? Neutral safety switch has been checked and replaced also computer, new battery, and the ignition switch, ignition lock cylinder is being replaced now. Thanks


If you're saying it turnes over but doesn't start I think of two things. If it is not getting power to the spark plugs I think it is the ignition module inside the distributor(small black box on bottom inside). If it is getting power to the spark plu ... 1999 Cadillac DeVille

My 92 dakota 3.9,4x4 won't start unless the check engine light comes on. It could take 5 min or 5 days to get it to run.I changed the distributor,all sensors except temperature and speed sensor.Checked the wires for corrosion and they seemed ok.A couple of years ago I changed the computer and ignition switch. Is it possible that a wire in the dash pannel got pinched or I an missing a bad wire or ground some where.I also changed the neutral safety switch because I had no backup lights, I still ha


No it wont. The wiring from the OBD port, to the ECM, is just remote wiring. Either the ECM is (broken, bad ground or bad power Connection) I can try to get you the wiring but you actually will need more then that. I'll get back to you asap. ... 1992 Dodge Dakota

2001 bmw wagon , last week would not start , could not jump either . 1. checked battery ? it was good 2. replace starter 3. worked for 2 days 4 now same symptons again will not start or jumped? I was thnking neutral switch ?


It is a possibility that it is bad or the ignition switch. cause a bad ignition switch will not send voltage for starter to start. an ignition switch handles a bout 50% of all voltage needs. the safety switch does it start in nuetral, or any othe ... 1999 BMW M3

Dodge grand caravan 2005 can't start at all start is good got it check think it might be the neutral safety switch


... Cars & Trucks

In my '94 Rodeo, when i turn the key, nothing happens-- no noise what-so-ever. After checking just about everything, we found out that there is not power going to the starter and no power going to the starter fuse. We checked the ignition and the neutral safety switch and they were both fine-- so was the starter. what could possibly be the reason that my car wont start?


Have you checked your Battery? Next with the car in park, check for voltage at the from the battery to ground,. If the battery is good and there is no power make sure that you have a good ground from the batter to the chassie. ... 1994 Isuzu Rodeo

Ok my tiburon 03 gt 2.7L I have been through a lot. I try to start it and nothing. I have gotten a new starter checked the altinator and battery. I have replaced the Clutch Neutral Safety Switch and still nothing. I can push start it. I have tried to jump it. I am doumb founded now any help would be great.


{{{ you can push start it }}} ! sounds as if the starter is not the proper one or need a shim but im guessing from the explination you gave it simply isnot meshing to the flywheel allowing it to engage ... Hyundai Tiburon

I have a no-start condition on a 2003 Chevy Silverado with a 4.8 l V-8 Vortec engine.I have battery power and did'nt fail load test.I have power at the starter and have jumped across terminals and it will crank. When trying to start with key,all power is lost. the lights all go dead.someone suggested a neutral safety switch is common to go bad on this.to me it acts like a shorted battery, but load test denies that. what is going on?


Check the negative ground cable. It may get some power to pass test but not enough to crank. Otherwise check starter relay and lastly power from ignition switch ... Chevrolet Silverado 1500

Code po705= Transmission range sensor, circuit malfunction (PRNDL input) Check engine light on & overdrive light flashing. Car hesitates when driving until shut off & restarted. Overdrive light shuts off & check engine light remains on only for a short period of time. I had the safety neutral switch replaced once. Problem returned 1 month later.


I ve run into this problem a few times,with no cler results,i checked all wiring from computer to switch and all check out fine i also replaced switch and a month later same code,this one ended up with a bad pcm, another one had a bad wiring for over ... Mazda Protege

2002 Dodge Caravan, 3.3l,V6 Wont Start.All my gauge lights work. Cant hear click when turn ignotion over from starter. Took to shop to have check engine codes diagnosed, they changed oil and we started it fine, then trid to start and wouldnt turn over. Had them doa diagnosis and they said it was bad ECM. Tookfor second opinion and mechanic told me it was a neutral safety switch. He said he got the starter to trun, but no enging crank. Also, with the key on, you get a clicking noise from the ASD


The ringing/dinging only started last friday, so its not when i put the key in it. Its a fast ringing and when i take the key out it does it for like 45 seconds ... 2002 Dodge Caravan

I want to bypass the clutch pedal neutral safety switch because my truck won't start with! it


... Chevrolet 1500
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6902 seconds