Having problems with your Cars & Trucks ?

05 blazer. Having prob with what I think is the transfer case vacum switch. Take off, hubs seem between 4wheel,2wheel drive...hit 4x4switch then back to 2hi noise gos away..has an evap leak(p0449) is that connected to that vacum?

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

If the evap system is leaking then the overall vacuum pressure will be low. Had this same problem on my Dodge Ram 1500 4x4.
Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

05 blazer. Having prob with what I think is the transfer case vacum switch. Take off, hubs seem between 4wheel,2wheel drive...hit 4x4switch then back to 2hi noise gos away..has an evap leak(p0449) is that connected to that vacum?


If the evap system is leaking then the overall vacuum pressure will be low. Had this same problem on my Dodge Ram 1500 4x4. ... Cars & Trucks

Vacum noise on my ford focus 04 1.4 model lambada sensor on the exchaust and 1 in the engine was replace but noise still there the check light went of but came back on


... 2004 Ford Focus

I have a 06 Navigator and theres a hissing noise coming from the back passenger side, is it a vacume leak ?


Duplicate question. ... 2006 Lincoln Navigator

06 front locking hub makes noise only in 2hi, checked vacume but didnt solve the problem.


This is a very common problem. You must have a leaking IWE and you have to check it at each individual wheel. WIth a vacuum pump and gauge, test each side individually. If either side (or both) cannot hold about 5inhg for even 10 seconds that's li ... 2005 Ford F-150

Dodge Ram1500 2001 5.9 Engine , Runs Rough after 2 minutes for a short period of time, A rush of air can be heard from the air cleaner, wiil cough and back fire loss of power for 30-45 seconds, will do it again after cool down, never happens if truck is running for short drives, start and stops, TPS, IAC, O2 sensors work fine, no misfires, fuel trim good, fuel voltage and pressure good, no evap codes or problems, engine tune good, no vacum leaks, cts and ambiet temp nomal, thermostat gd


Check the fuel pressure with a known good gauge - sounds like pump may be failing. Does it only run poorly if it's below 1/2 tank or all the time? ... Dodge Ram 1500

I have an 2004 chevy blazer 4x4 and the four wheel drive does not engage on the fly and it also will not engage when in neutral. Four wheel low will work but when you press 4 wheel hi it blinks twice and then goes back to 2hi, I do hear a click noise from the tcm on the pass kick panel.


... 2001 Chevrolet Blazer

I was in a car accident with my 03lancer and when i got it back from the shop its been making a loud kinda like a vacum link .the noise gets louder when i turn the sterring wheel...my father couldn't find the problem...what can it be ??????he said it could be the sterring box but hes not sure....thanks alot...carolyn


Could be as simple as the power steering fluid being low due to loss in the accident. ... Mitsubishi Lancer

Hotmaimy 2001 buick la sabrer in the morning when I first back up has a growling or grinding noise. It has been getting louder and louder. sounds like coming from the back end. took it to the mechanic who checked the brakes said backs were fine but changed the front brakes and roder saying they were a little thin. Still the noise. took back to mechanic who took the back brakes apart and can find nothing wrong and doesn't know what the noise is. Help.


Did the technician check the rear axle bearings for excessive play or the source of the noise when he checked the rear brakes if this was not checked properly you may have a bad bearing that is making the noise. ... 2001 Buick LeSabre

I used my 4 wheel drive today on my 2001 Nissan Fronteir. After I took it out of 4 wheel drive I headed down the road. I heard a constant noise so I slowed and put it back in 4 hi. The noise stopped but when I put back in 2 wheel drive it continued. I then stopped and backed up and applied the brakes and when I went forward the noise stopped. What could that noise be? Thanks


That would be the lock for the front axle not disenguaging all the way. it used to be you should do like you did put in reverse, then move forward. look in owners manuel it may be a normal condition. ... 2001 Nissan Frontier Crew Cab

Loud noises When driving my car down the highway i attempted to reach the speed limit which was 55. Once i hit 45 a loud cranking noise began to occur, sounded like it was coming from the engine. Then i began to smell burnt rubber. I began to drive back home and upon reaching 45 mph my car felt like it was pulling back and making a loud noise and then shut off. I tried turning it back on but it just made a loud sound and didnt turn on. The check engine light came on but then turned off. Once i g


This could be your alternator bearing seizing up if its smelling like rubber your fan belt is not turning so you would start overheating also did it ? if so thats it also lights would go dim because you wont be charging ethier ... 1987 Chevrolet Blazer

I have a 2007 2-door hatchback Focus. Since about September 08 the power steering pump has been making noises. I know is the power steering pump because the noise gets louder when I turn the wheel. I keep taking the car to the dealer and they keep replacing different parts: o-ring seal or power steering pump, but the noise keeps coming back. There are bubbles in the power steering fluid that appear when the noise appears. Finally, this February 2010, the noises came back with a vengeance. They g


If air is being produced in the fluid (cavitation) there is a leak.There is a Technical Service Bulletin (TSB)...\015\012\015\012\011\011\011 \011\011\011\011\011\011\011\011\011\015\012\015\012\011\011\011 \011\01 ... 2005 Ford Focus

Noticed a noise under hood that sounded like a belt slipping. sounded more like it was coming from the back of the motor.rnWith the car running,I took the oil cap out and the noise will stop;put it back in and it (noise)will start again.can hear a suction sound when oil cap is removed. what is making the noise that I am hearing


Every car has a carter recirculating system: in the carter there are gases that escape the cylinder during compression; if they would be left there they would in the end explode on their own causing damage; because of that they must be extracted simp ... 2006 Volvo S40

2006 volvo s40 50,000 mi. noticed a noise under hood that sounded like a belt slipping. sounded more like it was coming from the back of the motor. With the car running,I took the oil dip stick out and the noise will stop;put it back in and it (noise)will start again.can hear a suction sound when dip stick is removed. what is making the noise that I am hearing?


The oil filter housing also houses the pcv system. What causes the noise is that there is a check valve in the pcv system that is supposed to regulate the pressure in the crankcase. The valve gets stuck and causes vacuum to build in the crankcase, ... 2006 Volvo S40

I took a 97 civic dx 1.6 engine and put it in my 97 lx 5 speed, the dx has no plug for the evap can, and i was geting a check engine light for the evap,, SO i cut the plug off my old engine and put it back on my evap can, This is a 2 wire plug, red/yel and blk/yel the red/yellow i ran back to PCS on the PCM plug, the Blk/yel i ran to a junction connector that was all black/yellow wires in it, But im still geting the same check engine light for this evap sensor, I cant use


Even if you could get a fit the bigger problem is the computer programmingThe difference is in how long the computer pressurizes the system so unless you want to replace all the electronics including the harnesses then you may ... Honda Civic

Replaced wheel bearings two months ago, noise gone, but now a similar noise cropped up when I got back from a trip. I had no issues when i parked at the airport, but on the way back it was making noise as I drove straight and not when I turned. Now it has increased to when I drive. It is not engine noise, no power steerig issues.


... 2001 Chevrolet Venture

I have a 2000 Chevy Tahoe. When I drove from NC to FL it started making this loud noise that got louder as i went. Oil Pressure was good little under 40. I turned off the tahoe and started it back up after a few mins, noise went away, oil pressure at 40. loud noise came back after a few miles and it would stop after i turned off the tahoe. (that was on the 23 of Dec. 2009) Okay so they changed the oil (on the 24 of dec.) to 20w x50 (oil pressure was above 40 when i accerlated the oil pressure wo


A little hard to determine but sounds like your getting a kinda ticing/ratteling/knocking noise when the oil pressure is low correct? If so you could very well have spun a bearing or have a oil passage blocked. If that's the case your oil pressure w ... 2000 Chevrolet Tahoe

When we turn on our 2000 Toyota Sienna van everything sounds fine but the minute we put it into reverse to back out of our gararge it makes kind of a high pithced noise and it kind of sputters when we step on the gas. If we put it back in park the noise stops. Also the check engine light will come on and stay on and some times it will blink off and on. We can also hear the noise if we put the van in drive and you can feel the sputter in drive also. Any ideas before I take to the dealer and pa


Before you take it to the dealer, take it to an independent shop to diagnose it. they will charge you a lot less. A scanner can be hooked up to diagnose the problem. You do not have to take it to the dealer, for there are shops that are just as quali ... Toyota Sienna

Ok i had drop my tranny and i took my car to the cadillac dealership so they can replace the tranny. Ok so i got my car back on wednesday and there was a strange noise coming from the front i only heard it when i backed up and i couldn't figure out what or where it was coming from but knew it was under the hood well the second day since having the car back my brakes go out on me and the noise is increasingly louder every time i go to brake so i park the car and when i lifted the hood smoke comes


Its very possible that they could have accidentally pinned the hose.On your car the motor had to be removed so its highly possible like I said that it accidentally got pinched.But without seeing the position of the motor in ... 2004 Cadillac CTS

My 2004 Mitsubishi Eclipse has been shifting funny. I particularly notice it when driving through town when I start to slow down, and then speed back up. It started making the noise within the first 30 days I bought the car. I took it back to the dealer, and they told me it needed a transmission flush and that my warranty would not cover it. I got my fluid changed and the car ran better for about 6 months. Now, the shifting noise is back and it even seems to be hitting the gears kinda hard at ti


... 2004 Mitsubishi Eclipse

I have a '93 buick century. Recently there is a loud grinding type noise coming from the back, but can only be heard if you're sitting in the back seat. Up front it sounds like a ticking noise when you apply the brakes. I'm assuming it is the back brakes, correct? What does this generally cost to fix?


First of all you need to check your brakes in back if they are drum brakes the break lining has to be thicker than the metal shoe if close replace. also if they are really bad may be metal on metal of so you will need new drums/rotors. Make sure if t ... 1993 Buick Century

My 06 chevy avalanche has been driving fine no problems for the year we have owned it. Yesterday my husband went to leave, backed out of the driveway and put it in drive and it acted like it was in neutral. He put it in park and it made a loud grinding noise. Put it back into drive and it drove fine for about half a mile the acted like in neutral again. I started it this morning and it idled fine for a few mins. Put it into reverse and it made a grinding noise. Back into park and a louder grindi


... 2006 Chevrolet Avalanche

1995 Ford Bronco 4x4. Has howl (metal on metal noise) in left front hub area. I have pulled hubs apart and checked bearings, they looked good, but were loose and the grease was thin like liquid. I cleaned hubs, filled with new grease, repacked wheel bearings, and put all back together and still makes the same noise. i used wd40 to spray on back side of hub where the axle shaft goes though into the hub, thinking it was dry and making noise, but still no change. removed auto locking hub and drove


A howl usually is a bad bearing ... Ford Bronco

My 4x4 fuse keeps blowing in my 2005 trailblazer. Ussaully I can put a fresh one in, then change the transfer to 4 hi or back to 2hi and then it will blow again. To put it back into 2hi or 4hi, i must put in a fresh fuse again. I put a fresh one in a week ago, just to get the service 4x4 light off on the dash.. and it was fine until today when the light came back, and the fuse is blown. Noone even tried to put it into 4x4 this time. It just blew.


... 2005 Chevrolet Trailblazer Ext

I have a 2005 passat with 22k mi,..i have a ticking noise coming from the passenger side,upper side of motor,..as i take of the oil cap when motor running,noise gets louder and car struggles but keeps running as i put the cap back on noise goes away for a few seconds and comes back,..please,help


Catyalytic converter ... 2005 Volkswagen Passat

4t60e transmission when car idles there is a knocking noise in the transmission, i know it's not the engine because i disconnected the torque converter started the car let it run for a while reved it up no noise bolted torgue converter back up noise comes back


Well good luck cause it didn't fix mine instead it got worse so i just got a used transmission ... 1997 Buick LeSabre
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.2983 seconds