Having problems with your Cars & Trucks ?

Ford reverse sensing system

\015 I have a 2002 F-250 Ford Pickup. The Reverse Sensing System (RSS) has stopped working. How do I fix this problem.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ford reverse sensing system


... Cars & Trucks

REVERSE SENSING SYSTEM - 2004 Ford F150


Not a problem ... 2004 Ford F150

My reverse sensing system beeping is gone, can not hear it. I just purchased this 2000 lincoln navigator a eek ago and I did purchase a "Chiltons book for it but I don't see any wiring diagram on the Rear Sensing system in it. I would appreciate it if I could get some electrical diagrams. thanks


... Lincoln Navigator

REVERSE SENSING WONT WORK ON OFF BUTTON STAYES ON OFF WHEN I PUSH IT TO TURN ON IN DOESENT AND WHEN I BACKUP REVERSE SENSING SYSTEM WONT WORK


I just quote the procedure use for othwer Ford Owners; here's a guide as to how...\015\012\015\012Open the rear liftgate and remove the four philips screws on each side \015\012holding the rear taillights in place. Gently pull each tailli ... Ford Excursion

Hello, I need to know what type of power door lock system is installed in a 1991 Ford Taurus. I'm installing a remote starter and would like to utilize the remote power door lock/unlock feature of the system I'm installing. Specifically, is this system a reverse polarity? Do I need to add a relay? If so, a wiring diagram would be very helpful.


It is a reverse polarity system ... Ford Taurus

Fuse diagram for reverse sensing ford escape - 2005 Ford Five Hundred


... 2005 Ford Five Hundred

I have an older (1988) Motor Home with a Ford 460 engine on a John Deere chassis. I am having trouble with the ignition system start/run function. I am looking for a wiring diagram for the system and including details of the ignition switch It is a 1988 Pace Arrow made by Fleetwood. The ignition switch is located on the top of the steering column and connected to the rest of the switch at or near the bottom via a rod. It is difficult to see any details. This probably doesn't make any sense and


I would assume that you have checked that the wiring connections to the switck are secure. Sometimes the spade terminals in the connector plug to the switch come loose and get pushed back inside the plug when it is connected. They are held in place i ... 1988 Ford Ranger

Reverse Sensing System doesn't sound


I want to know wich is the relay because i have the same problem thanks ... 2005 Ford F-150

Reverse sensing system switch


How do you check the connections on the sensors. Do the sensors pop off the bumper or do you need to remove the bumper skin? ... 2004 Ford Freestar

Reverse Sensing System does not work when backing


... 2006 Lincoln Mark LT

1997 ford E250 Cold air is coming out of the vents when the heat is turned on. I installed a new thermostat, also the heater core was flushed in reverse. There is still no heat, it feels like the cold air is from the a/c system.


Check the heater hoses going through the firewall, they should be warm to the touch.Is the heater core itself warm also? If these 2 checks are good, I would look to either the dash control module or the blend doorWhen you move the t ... 2002 Ford E250

My reverse sensing system on my 2000 Windstar SEL quits. Is there any wiring diagram for diagnosis?


... 2000 Ford Windstar

Where is the fuse for the reverse sensing system


... 2003 Ford Escape

The following electrical systems on my 1999 Ford Explorer (4.0 SOHC) have stopped working in the following order. 1. Digital Compass (dead) 2. Radio (intermittent) 3. Cigar lighter (dead) 4. Drivers side brake light (Tail & reverse are fine) 5. Power Mirrors (both dead) I just bought a Haynes manual and I can't find circuitry the diagrams for 1-3 & 5 above. Do you have any suggestions, or as to where I can get better wiring diagrams.


Can't tell you where to get a better diagram other than to see if a Ford dealership can print you one off or fax you one but i can tell you some places to look.The radio,compass and cigar lighter should be protected by either a maxi fuse under the h ... 1999 Ford Explorer

I have a 1988 bronco II 2.9L V6 automatic 4X4 push button transfer case. I had bought it with the engine tore out of it bought a long block through ford replaced everything in the fuel system except injectors. Has a miss when the engine is running will idle and rev up no problem miss seems to go away a little bit when idled up. I Borrowed a scan tool ( Mac task master ) and on a self test it's giving me codes 13,21,41,73 the only one that makes any sense to me me is the O2 sensor code but I can'


Check for a vacuum leak in a hose that was not fitted correctly or is broken ... Cars & Trucks

2004 mercury monterey Reverse Sensing System stopped working


... 2004 Mercury Montery

2 questions. i dont have the security code to program my own code for the keyless entry, how can i program it? my reverse sensing system (back up sensors) arent beeping anymore?


The entry of your own code is pretty standard for Ford products. The normal procedure is:\0121. Enter the factory set code (the one that came with the vehicle)\0122. then enter the 1/2 button within 5 seconds\0123. Then enter your 5 ... Ford Expedition

Ten months ago the local Ford dealer replaced the heater core and temp blend door on my '98 Expedition. The heater core failed again and I was told that due to oxidation I will basically continue to have this problem. The system was flushed when I had the first core replaced. Does this failure make sense? Is there something else that should have been done the first time the heater core was replaced?


There may be a corrosive in the system. Flushing the system should be done at least every 2 years. Your vehicle is now 12 years old, but I have not seen a heater core go bad in 10 months, it may have been defective, and should have some type of warra ... 1998 Ford Expedition

2001 ford windstar reverse sensor system not working


... 2001 Ford Windstar

Why is reverse sensor system not working - 2001 Ford Windstar


... 2001 Ford Windstar

I have a 2006 F350 and the reverse sensing system is not working I press the button and the off lihgt stays on


The common area that cause this are the rear sensor wiring, check it, also the sensors can be defective, that is about all the problems that i have found on these back up sensors, if th sensors are ok and no wiring problems are evident y ... Ford F-350

Reverse sensor speaker module in a ford super duty


... 2011 Ford F-250 Super Duty

Ford super duty reverse parking speaker/module


... 2011 Ford F-250 Super Duty

I have a 2001 Ford Ranger that has a battery drain. When the car sits overnight the next morning the battery if completely drained. I've done some research and found that it may be linked to the Security System (Ford's stock system with the chip in the key that corresponds to the ignition) in the truck, and if I disconnect the system, the car won't start, and to disconnect when I turn it off and reconnect when I go to start it is inconvenient. Any suggestions on how to fix it or how to find a


... Ford Ranger

Wiring diagram ford escort for installing nav system and stereo controls


Here is some info:http://www.the12volt.com/installbay/stereodetail/845.html ... Ford Escort
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.7518 seconds