Having problems with your Cars & Trucks ?

I had a hydro air perseus 450 pump with a air tube that would start the motor. I have now bought a spek badu pump 45/16 and cannot find where this tube needs to go for installation. Please can you advise how this pump starts/stops where is the on/off function? Thanks for your help.

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I had a hydro air perseus 450 pump with a air tube that would start the motor. I have now bought a spek badu pump 45/16 and cannot find where this tube needs to go for installation. Please can you advise how this pump starts/stops where is the on/off function? Thanks for your help.


... Cars & Trucks

A.I.R. Pump Does the air pump need to be hooked up? I live in a non-emission state. The car has no power and exhaust gasses are back feeding in to the air lines. The metal tube that runs from air pump to the exhaust manifold is corroded and leaking, Is this the cause of no power?


Sounds like it to me ,but without seeing it ? its difficult to advise ... Jaguar XJ6

Need to find the part # on my secondary air injector pump


Hi Jeff,\015\012I just pressed the "I can solve this" button but maybe I can't :-) All I can do from here is ask if you got 0410 or 0411? If so, maybe you don't have a defective $600 pump or $300 solenoid, just a cracked or leaky $5 length of a ... 2001 Volkswagen Passat

1994 Ford Explorer Eddie Bauer Edition - a pully flew off (literally!), and I can't tell if it's the water pump or some other part - it's directly below the alternator. I need to know what that accessory is - if it's not the water pump, is it the smog pump or just a serpentine belt tensioner? Please advise, because I can't find an engine diagram anywhere on the web! 4.0L V6 engine... 4x4 automatic tranny... w/ AC/PS/PB, etc...


I would bet it is the belt tensioner or belt idler, but can not be sure as I can not look it. At one time there were belt routing diagrams on a sticker under the hood, but I do not know if your Explorer was one of those. If I find a link to the belt ... 1994 Ford Explorer Limited

I NEED TO KNOW WHAT IS THE PART ATTACHED TO THE MASS AIR FLOW (LARGE TUBE). I NEED TO CLEAN OR REPLACE IT AND I AM TRYING TO FIND THE COST ON THE AUTOZONE OR ADVANCE AUTO WEBSITES.


MAF, Mass Air Flow Sensor. If you dont know what it is, how do you know you need one? ... 1997 Isuzu Rodeo

I need to find out what the name of the rectangular plastic box that sits on top of the motor and holds the air filter is called. It busted into several pieces and I need to replace it. Also, will this missing part have anything to do with the fact that after it happened the brakes are not working properly...have to pump them to bring vehicle to a stop.


Air filter housing or Airbox for short.\015\012\015\012Your brakes are power assisted by vacuum generated in the intake.\015\012I don't think your braking problem is related unless the broken airbox caused the vacuum line to be cut ... 1995 Ford Econoline

Need to find why secondary air pump fuse is blowing in my 2000 a4 1.8 ecu when i star the car


... Audi Cars & Trucks

Po171 code keeps coming up, I changed the fuel filter. Pressure at fuel filter is 45, pressure at fuel rail is 45. Pressure is 50 with pressure relief valve disabled. Diaphram is good at pressure relief valve. Code keeps coming up during in warm weather when things are good and hot. Do I need to replace the fuel pumps? Are they weak? Is it trying to vapor lock on me? Mass air flow has been cleaned. Intake throttle body is cleaned. Can't find any vacuum leaks. 460 gas motor. Help?


Did you check the o2 sensor bank 1 ? cause de p0171 code say sistem too lean bank 1 do you need replace this sensor and get a better fuel saving . or maybe is disconected or the o2 sensor wires could by cut o burn, i think about you problem is not th ... Ford F-250

I changed the termostat in sunday the car had no problems in monday regular driving from 65 miles with 60 miles average speed .today I had like 100miles and when I got stuck in the traffic the car start overheat , when I am moving the temperature drops to normal and if I stop rises again , the coolant is above normal , the water pump was chenged was year,and the air filter needs change the car is 96 altima with close to 85k miles please advise for the posible problems and how to fix them.


If it overheats while you are sitting in traffic and not moving then you need to check the fans. A quick way to check them is to turn on the a/c and see if the fans kick on. If they dont then you need to check for power and ground at the fans if po ... 1998 Nissan Altima

Where is a 1989 nissan z24 4 wheel drive fuel regulator located? starter went bad, replaced it, fuel line had a leak, replaced it, fuel pump wont push fuel through it, bought a new one and now the truck wont start and the air has been pushed through the line. Truck was running fine up till the replacing of the starter (had to roll start it till starter was replaced) all the above happened one after another in one day. Think it might be the fuel regulator but cant find it. Need help! any ideas?


Fuel reg. is connected to the fuel rail where the return line is connected, my thoughts are you mentioned air in your lines.. crack open fuel lines and run fuel pump to release air from lines. Pump then should prime all lines must be primed turn engi ... 1989 Nissan Hardbody King

I searched online to find a way to eliminate pinging on the 307 olds engine and found a site saying by removing the carb and drilling out the egr ports to remove carbon buildup as well as cleaning the egr valve and tubes, says the computer is very sensitive to egr. Does this sound like a solution or not. Car has 87k original miles, and has a freshly rebuilt carb and accelerator pump and full tune up, plugs, cap, rotor, plug wires, air and fuel filter.


Well the pinging you hearing could be detonation try premiun fuel or try retarding the timing by a couple of degrees. do not drill out the ports. it won't fix it. don't believe everything you read online please. hope this helps you out!! ... 1986 Cadillac Fleetwood

Acceleration problem hello i have a problem with a 1992 mitsubishi 3000gt sl. My car drastically accelerate without pressing the gas pedal, and in some other ocasions it does the opposite and looses power. I've already changed the air sensor and filter, along with the water pump and the timing belt . Unfortunately the problem persist. I really need help n finding a solution to my problem.


It's called a trottle position sensor ... 1992 Mitsubishi 3000GT

Possible cause high carbon emission reading 400ppm during NJ State inspections. Ford dealer could find no electronic/sensor problems an recomended tune-up. New plugs and wires installed - same problem. Van had 106,000 miles on original tune-up. Plugs all clean when removed. Engine runs very well, no smoke, 17mpg. Innitial rejection was "unable to get a reading" with exhaust probe/exhaust leak. Exhaust leak repaired with OEM tube from air pump to exhaust pipe. Failed three times now. Fru


I need to know what all the tailpipe gas readings are to help u plus what engine you have, I work for Ford and diff engines have diff problems, I can help, I have been a class A smog inspection and emission system repair tech for 40 years, it is t ... 1988 Ford Econoline

I have 2001 Chevy blazer. I replaced the plugs, wires, air filter recently. And the fuel pump last year. and after a months running find it stated to not start. I have to use starting fluid to get it to start, and then it runs fine till i shut it off. And have to add starting fluid to get it going again. Any idea on what may be going on. I have run out of ideas to check. The check engine on show codes for the oxygen sensors needs check


Replace your fuel filter - locateted on the drive side next to the frame. If that doesn't cut it - check your injectors ... 2001 Chevrolet Blazer

1999 malibu chevy has p0410. The air pump is working find. when the pcm apply the 12v the air pump is pumping a lot of air to the check valve. I check the 12v on the solenoid that controlled the check valve and is always has the 12v even the air pump is not working.please give me a diagram or piture for this problem that cause this p0410


Keep in mind that not always the things can be repair, anytimes need be replaced; this occur with a code P0410 may mean that one or more of the following has happened:* Water may have collected in the AIR pump or the vent solenoid and \015\012f ... Chevrolet Malibu

Cant find I have a 1993 xj6 and had the fuel pump changed and come to find out the connector that connects to the fuel pump was burnt. I need to find this part i went to the jaguar dealership and they couldnt identify it. I showed them the part and the id number on it and they still could not find. Its a intank fuel pump which sits inside my trunk. Any help would be most appreciated.


Yes order the harness, they were just playing dumb, parts tech's can do that, I will bet my pay check they knew u needed the whole harness, they love to play games like this. I m a dealer tech of 35 years, so seen it many times. ... 1993 Jaguar XJ6

Need the location of the fuel pump relay for 1992 ford mustang 4 cylinder. Can not find the place for it. We replaced the fuel pump and that did not fix the problem. We need to know where to find the


Http://www.autozone.com/autozone/rep ... 1992 Ford Mustang

Volvo S70 secondary air pump needs replaced. Expensive ($700) and it was due to check valve allowing moisture or water into air pump, so that needs replacing too. Is this an easy repair to do myself? How long can I drive this before it causes other issues?


... 1998 Volvo S70

My 2001 Buick LeSabre has electronic load control. The air pump stays on, so my car is jacked up very high at the rear. What do I need to do to fix this problem? Read more: My 2001 Buick LeSabre has electronic load control. The air pump stays on, so my car is jacked up very high at the rear. What do I need to do to fix this problem?


Your load control sensor under the vehicle is broken or has become disconnected so it thinks you have a heavy load and is constantly running the compressor. you have get under vehicle and look for the sensor it is connected between the rear suspensio ... 2001 Buick LeSabre

I have a 2006 ford escape limited 4 wheel drive the water pump went out and now i need to know how to bleed the air out of the cooling system?


Just run the car with the rad cap or resavoir cap if no rad cap off and continue topping up until no more bubbles come out. reving the car up to about 2000rpm will speed up the prosess because the pump will circulate the coolant faster. then when lev ... Cars & Trucks

HELP cant take off power steering pump, I located two bolts in front of the p/s pump and took them off, I cant find any more in front of the pump from top view, could there be more bolts under or on back of the pump? do I need to get under the van to be able to remove the pump? I really need to remove the p/s pump so I can replace the broken pulley


There is a nut on the back of the pump near the top. It may be accessible from the top if you have long thin arms and a fairly short wrench (15mm, I think) There is a stud on the back of the pump that goes through the bracket and the nut goes on tha ... Plymouth Grand Voyager

Check engine light on 2004 GMC Envoy. Had air intake sensor replaced. Failed inspection diagnostic code came up P0128. I have been told I needed an air pump, a tune -up, injectors cleaned etc. etc., I have spent a ton of money and still failed inspection. I did not have the air pump put on yet, does this code mean it is actually the pump


Code P0128 indicates a faulty thermostat, more than likely it is always in the open position causing the coolant to come up to operating temperature too slowly.My suggestion is to find a different repair shop. ... 2004 GMC Envoy

When it pumps up it leaks right back down that is when it actually pumps up but with soapy water in a spray bottle i can not find a leak one. but there is a leak in the main line t still it is very small and once the air bag pumps up the solinoid is supost to hold the air there and not allow the air back out right


I am going to assume you are referring to the front airsprings. The right hand side has a top cover plate that actually seals the bag to the strut. In some instances the a/c line that runs over the top of the plate leaks condensation onto the plate, ... 2003 Lincoln Navigator

Need to purchase secondary air injection check valves. Must I go through a dealer ? '01 Olds Intrigue. Air pump replaced 2 months ago , now informed I need above referenced parts. (Secondary air valves...need Bank1 and Bank2. Tried 2 local parts dealers no luck.


I would, get them from dealer, this way you get the right parts, i checked a couple of places also and no luck also, dealer can order parts if they dont stock them, if you want try rock auto.com. i just checked and they can get it.there are two types ... 2001 Oldsmobile Intrigue

2003 focus zx3 2.0L. Acting like fuel pump may be not putting enough pressure out. Car runs, but only up to 3000RPM. Stalls after a few minutes. Car is drivable as long as u feather it and stay below 2500RPM. New filter was installed. Pump runs for 1-2 second or so at key on. When cranking, pump runs again for 1-2 seconds. Need to check pump pressure as well as rail pressure. Cant find any place to check rail pressure on the rail? Need to know what those pressures should be.


... 2003 Ford Focus
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4542 seconds