Having problems with your Cars & Trucks ?

Chana Star 1300

\015 What is the tappet clearance setting of a Chana Star 1300\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

E36 convertible Hello i have problem with e36 convertible ,rear windows work fine ,but front works only at pulse, when button is pressed window star working for a short time 0,5 seconds and stop,when pressing the button again it continues for same short time 0,5 seconds and stops.


... Cars & Trucks

Transmission Problem? I Have an automatic 2001 Pontiac Sunfire with more than 150,000 miles. Last year going to a party I forced the engine driving uphill. In my way back star doing the shift between gears really rough, I stop the car and few minutes later the car was driving just fine. Since then, and some times not always, when I star driving it takes longer than usual the shift from first to second gear, and the arrow in the miles it dosen't move at all, it stays on 0 until the RPM goes up to


The cheapest and best way to approach this problem is 1st to have the transmission fluid and filter replaced, trans fluid wears out an filters plug with debris from norman trans clutch wear, this service could cure your problem, also mak ... 2001 Pontiac Sunfire

Chana star cab wiring diagram


... Cars & Trucks

Chana star workshop manual


... Cars & Trucks

Chana Star 1300 tappet clearance settings


... Cars & Trucks

Chana Star 1300


... Cars & Trucks

How to remove chana star back wheel bearings


... Cars & Trucks

Tappet clearance for a chana star cab 1300


... Cars & Trucks

Chana star 2008 model 1.3i tappet settings and head torqe


... Cars & Trucks

Was drving my 2000 dodge caravan and the car stopped working while on the expressway. The RPM went from 2 to 1 and then finally 0 and the car wouldnt accelerate. The check engine light came on but changed the oil not to long ago; less than a month. When I tried to star the car everything works electronically and have a full tank of gas. The engine doesnt start.


Did you find that your engine overheated? What was the approximate ambient temperature? Has this occurred before? Periodically? These are just some of the questions I would need answered to better assess the cause of your problem. Nonetheless, what ... 2000 Dodge Caravan

Timing mark diagrams chana star 1.0 - Cars & Trucks


... Cars & Trucks

Need workshop manual for a chana star bakkie 2007


... Cars & Trucks

Chana star 1300


... Cars & Trucks

How to set the timing on a single cap 16 valve Chana star ?


... Cars & Trucks

Timing mark for chana star 1.3l 16v - Cars & Trucks


... Cars & Trucks

Chana star bakkie torque settings


... Cars & Trucks

I need the timing mark positions on the campully for a chana 1300 star


... Cars & Trucks

Wiring Diagram for chana star 1000cc - Cars & Trucks


... Cars & Trucks

Does a chana star bent valves when cambelt break


... Cars & Trucks

Chana Star Truck Valve Clearance Guide - Nissan Cars & Trucks


... Nissan Cars & Trucks

Peugeot 406 98model has S and star lights blinking on dash board, diagnosis says: '[Ie,94,0,30] please refer too relevant manual intermittent fault'


... Peugeot Cars & Trucks

Indicator i am lking for the flasher unit on a chana 1.3 star bukkie


... Cars & Trucks

Chana star head bolt torque settings


... Cars & Trucks

Chana star 1000cc:Torque settings,main bearing,bigend bearing &cylinder head.


WHAT IS THE SETTINGS OF MAINS AND BIGENDS ON A CHANA 1100 ... Cars & Trucks

3.0 d4d wont star after refuelling - 2006 Toyota Fortuner 3,0


... 2006 Toyota Fortuner 3,0
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.9253 seconds