Having problems with your Cars & Trucks ?

1984 PORSCHE 911 RUNS ROUGH AT HIGH RPM

\015 1984 Porsche 911. Runs rough above 2000 RPM. I replaced spark plugs, ignition cable set, distributor cap, rotor, fuel and air filters, but problem continues. Do you believe the cause could be air/fuel or ignition system? Thanks, Jorge\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1984 PORSCHE 911 RUNS ROUGH AT HIGH RPM


It was related, ignition system..you have to check ignition coil(pack).improper distribution engine runs rough. ... Cars & Trucks

1984 PORSCHE 911 RUNS ROUGH AT HIGH RPM


... Cars & Trucks

I was running it for the 1st time after this winter it was idling fine at high idle 1,200 rpm and i bumped the throttle and it ran really rough and will barely run at all, I just don't know what went wrong,I replaced the plugs and it still won't run. What happened?


Sounds like it might have varnished gas in the system. I would change the fuel filter, clean out the lines with a good carb/fuel injector cleaner and fill the tank with fresh gas. I will run a little rough until the bad gas is run out. If this dont ... Chevrolet Corvette

1995 ford f 250 with 5.8 runs rough,idles high,temp comes up really high while idling. and on a power balance test #1 cyl shows no drop in rpm. {plug was wet}.


Then a cylinder balance test is done,the injector for each cylinder is turned off and the loss of fuel to that specific cylinder causes the rpm drop.If the plug is wet with fuel and number 1 didnt drop rpm's during the test,its most likely due to the ... 1995 Ford F350

I have a 1992 Mitsubishi Mighty Max v6 3.0. It runs rough at high speed (not necessarily rpm) and the check engine light was on earlier this week, but is now off. Does the computer retain check engine codes? If so, how can I retrieve them? Any ideas why the engine would run and accelerate fine through about 45 mph and then start to run rough above that, seemingly regardless of rpm?


Yes, the computer does retain fault codes. They can be retrived either with a scan tool or by using an analog volt meter. (Good luck finding one of those if you don't already own one.)\012Volt meter method:\012Find the diagnostic conne ... 1993 Mitsubishi Mighty Max

My engine runs like the timing is off when I rev it or push down on the gas pedal. 3.5L V6. The engine runs smooth when the rpm's are low, in town driving. When rpm's go high, like climbing a hill, the Pacifica engine starts to run "rough", like the timing is off. I think its the timing system, spark plugs, or bad combustion (poor gas). We have used 89 octane gas every tank since we bought it 2.5 years ago. The engine light comes on and stays on, (it doesn't blink). A tech at the local Aamco sta


This could be a TPC valve or sensor. That is a throtel position control. Your engine will idle or run at low speed fine or in stop and go traffic but highway driving or climbing a hill when the demand changes to heavy or light consumption it will sur ... 2005 Chrysler Pacifica

1993 Toyota Camry V6 starts fine, I let it warm up, I think it's ideling high but I drive off. At the second stop light the car dies. You see the RPM which when ideling is a one notch below the 1, is quivers and then drops to and the car dies. I put the car in neutral and it starts ups and then it makes it thru the next two stop lights before I get on thre freeway. The RPM's still seem to run high on the way to work. I'm driving 65-70 mph and the RPM's are at the 3 versus at about 2.5. Ju


What is required to compliment entire compbustion are new spark plus to create efficient rides eleminating the idleness at stops. ... 1993 Toyota Camry V6

Runs rough at idle and low rpm. misfires. gets better @ high rpm


Sounds to me you have a emissions problem check your EGR valve and MAP senser ... 2004 Chevrolet Malibu

Runs bad rough running but when i mess with the vacume advance it sounds better low rpm it dies choke not sticking new plugs dist and roter if i take off the air filter it goes to high rpm the chugs a couple of time then dies cant seem to get an idle speed without it dieing sounds like bad plugs


I had to replace ever frigging vacuum hose on mine, and that seemed to help... ... 1985 Nissan King Cab

I have a 99 s10 4.3. my engine started running high around 1500 rpm. put new injectors in. Started it up first ran great cut it off. Then started back up and now it's running at 1500 rpm. checked for codes only 1 came up p0785. thanks


P0785 Shift/Timing Solenoid Malfunction.\015\012This code could be set by electrical problems with the wiring harness or\015\012 poor electrical connections, try disconnecting the TCC solenoid and see what ... Chevrolet S 10

1 Solution. 1992 Saturn SC ... Runs rough at lower rpm, but smooths out and runs like a champ @ about 2800-3000 rpm.


... Saturn SC

I have a sandrail with a 1971 type 1 1600 cc stock engine with a single weber carb. When running at high RPM, the engine misses and I don't get the high RPM power I used to have. I just replaced the boots on intake and got the engine in working order after having been out of service for two years. The engine was rebuilt about 4 years ago and has only had 100-200 miles put on it. I've replaced the gasoline and fuel filter as well as pulled the plugs and cleaned and regapped them. The plugs were


Thank you keeping all us updated.that the problem is solved.congratulation.thanks. ... 2000 Volkswagen Beetle

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

92 geo 1.6 l shoc sounds like a missing v-8 exhaust has a lot of raw gas smell to it and it runs extremely rough until warm, if trying to drive before it is warm, tach will drop to nearly 0, engine will almost stall then jump up to 2500 rpm drop back down about 1000 rpm. runs perfectly normal once warm


... 1992 Geo Storm

2005 chevy colardo runs rough and stalls on low RPM at high rpm runs fine


Could be a sticky EGR valve, or a large vacuum hose off or burnt. ... 2005 Chevrolet Colorado

1991 geo metro runs rough! 3 cyl 1 liter engine, runs fine till engine is warm, then it idles high, rough thru 1st 2nd 3rd


... Geo Metro

Runs rough under 1,000 rpm


Maybe timing marks were not set correctly.maybe off by 1 tooth.this will definitely make it run rough and also lose power too.might want to check timing.hope this info helps.take care and good luck, manny ... 2002 Chrysler PT Cruiser

Rpm below 1 when stopped. Car running rough.


... 2003 Chevrolet Monte Carlo

My ford f 150 with a 300 inline six is idling rough but with run, runs good at high rpm but is running rich


I have a 1967 Ford F1oo with the in-line 300 6 cylinder that's running rough what could possibly be the problem The gentleman that I bought the truck from said it would be a burnt valve ... Cars & Trucks

93 Civic LX Running rough and RPM Gauge going nuts only when car runs rough. PLZ HELP


The car needs good tune up.fuel filter. ... 1993 Honda Civic 4 Door

Renault laguna fault code P0050 speed sensor, what does it mean??car running rough ,little misfire no lights on dash, RPM stays 3500- 4000 @ 70 mile.but at low gears rpm is normal. fuel consmp. poor 1. Is it RPM speed sensor 2. ABS sensor or O2 lambda sensor


... Cars & Trucks

Smelling antifreeze,i hear maybe waterpump,engine lightly sprayed on top in front of fan, engine runs rough when idleing but runs great at normal riding speeds running like this since august 08, when purchased ,tachometer reads halfway between 0 and 1 grand car leaks very little oil. put on 11,000 miles.


Could be a hose or the water pump either way when it leaks your fan is blowing the coolent back on your engine and could be blowing on your ignition wires making them wet and causing a miss fire. Do you have to add coolent regulary? ... 1992 Toyota 4Runner

Pliz help after taking my car for engine wash they used water to wash the engine and engine Codes came up . 16502 P0118 Engine coolant temperature circuit-G62:high . 16497 P0113 Intake air temperature sensor 1 circuit-G42:high. 16486 P0102 Mass air flow circuit -G7 0:low input. 16622 P0238 Turbo super charger boost sensor (A) circuit : high. 16955 P0571 Brake switch sporadic (A) circuit : malfunction. 18000 P1592 Altitude sensor /boost pressure sensor :implausible ratio. 16706 Engine RPM sens


Not Good: The Expensive main computer brain sustained a short from either the heat of the solutions or leakage allowing fluids to enter the components. If after a drying period this still occurs; then the computer brain needs replacing. ... 2005 Volkswagen Touran 1.6

When I start the truck when cold the idle goes up to high mayby 2500 rpm. After it warm and touch the gas it runs normal but when put in gear it idles low and runs rough. It run pretty good for an 87 with 207k miles, but when you come to a stop it idles so low it fells like it wants to cut off.


Sounds like tha AIC valve. this contols the amount of air entering the intake manifold.i would have it checked and replaced. ... 1987 Dodge Dakota

I have a 1999 gmc suburban k1500 5.7 vortec it has a throttle body injector it has started to miss at about 4000 rpm runs fine throught the rest of the rpm range it misses no matter the temp i have changed the cap rotor wires plugs are less than 1 year old new coil and high flow air filter can any one help as it stands i can not pass because it pretty much wont accel past the 4000 rpm mark just stays there n misses no problems with idle or reving it up in park or neutral and dose the throttle bo


Check the fuel pressure and the fuel filter. You've eliminated the ignition probables. ... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.4160 seconds