Having problems with your Cars & Trucks ?

How to replace head gasket on 2000 Lincoln navigator

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to replace the head gasket on a 2004 lincoln navigator

... 2004 Lincoln Navigator

How to replace head gasket on 2000 Lincoln navigator

... Cars & Trucks

90 lincoln was running hot 3 yrs ago,and no heat just replaced head gasket,heads pass pressure test,no cracks in heads, head gasket was bad,still no heat,heater hoses hot, pressure test cooling system holds pressure,top hose collaspes sometime when rev up,did have heat on idle yesterday no heat today on idle or rev up, any tips?

Have you even considered the heater core? Have the heater core checked/replaced. As for the top hose collapsing...that is not good. Have the entire system checked out by a qualified mechanic. ... 1997 Lincoln Continental

I have the 1998 Lincoln Mark VIII with Over Heating Problem. I replaced Sensor which had low input and Thermostat. You stated that I have Blown Head Gasket. (emissionwiz) Would the motor run rough is this condition though? Also, when draining Anti Freeze water felt oily so this may make sense, but the car when driven runs like a raped ape, but overheats in 2-3 miles when warmed up. I was going to try the Water Pump next and then radiator. Is there a way to verify a Blown Head Gasket?

You should have found the oil floating on the top of the radiator, A compression check will tell you real fast if the head is blown and even tell you which piston it is, The exhaust should have steam in it. Hope this helps. ... Lincoln Mark VIII

I have a '02 Lincoln Ls with 77k miles. Since last July (08) driving home on highway it started overheating. Took it to my regular mechanic as check engine light was on and he told me that I had a blown head gasket. Apprently, the computer told him that there was a misfire in one of the cylinders. Took it to second mechanic... He tested the block and determined that there was no blow head gasket. Replaced the hydrulic fan, changed hydrulic fluid/oil, serviced the cooling system, changed the ther

Guys it is the heat sensor part # TS465 Google it and you shall find it. The tempurature jumps to hot then to low. Shut the car off and just minutes later it is back to normal, does this not send up a red flag that it is a false alarm. The car slows ... 2002 Lincoln LS

I have a 1998 lincoln continental and I am replacing the head gaskets on it, the problem appeared t be a blown head gasket, it had antifreeeze coming out of the exhaust. But my true problem is, I can not get the water bypass tube off... is there a special way this should be done?

Takes a special tool that is dealee item only ... 1995 Lincoln Continental

Replace a 2002 lincoln ls head gasket - 2002 Lincoln LS

... 2002 Lincoln LS

How to replace a head gasket on a lincoln ls - LS Lincoln Cars & Trucks

... Lincoln LS

I have 2011 dodge 3500 cummins smokes when cold started? when started first thing in morning only around 0 blows lots of white smoke smell like unburnt diesel and shakes a bit for 10 to 15 min has had piston rings, injectors, head, a few head gasket all replaced already still does not start right after sitting overnight seems like cylinder six is missfiring when capped of does not smoke. does anyone have anyother ideas of the cause of all the smoke thanks

... Dodge Cars & Trucks

1996 SL1 after engine overhaul oil is having to be added regularly. Rings replaced, valve seals replaced, valves ground and reseated and head pressure tested by machine shop, head gasket replaced, timing cover gasket remade, oil pan gasket remade, crank and connecting rod bearings replaced, intake and exhaust manifold gaskets replaced. Compression on all cylinders 120 psi or better, no smoke in exhaust, cleaned EGR valve and throttle body. Used upper and lower gasket sets to replace all gaske

Depending on how long since the overhaul, and how much oil is being used, you may not have any worries.Engines built in the factory are within very close tolerances. Engines rebuilt in the shop are not.So like it was 50 yrs ago, your rebuilt ... 1996 Saturn SL

Help me hello how are you ?? i was wondering if u can help me with a carby 3F engine on my 80 series landcruiser please? i recently blew a head gasket on the engine i took the head in to get it repaired it had all the valves replaced seats reseated and a new head gasket a new inlet/exhaust gasket as they are all on one side of the head being an old 3f engine and all anyway i replaced the exhaust with an extractor set and a replaced the following 1. spark plugs 2. thermostat 3. leads 4

Hi John, I suggest first carrying out a compression test. As you'll know a difference of readings between combustion chambers can result in misfire and loss of power. It would seem to me that if pressure is building in the cooling system there is som ... Cars & Trucks

I just replaced the intake gaskets on my 2003 pontiac grand am , but when I went to fire it up it was still running like **** come to find out the head gasket on cylinder 3 is blown or the head is cracked. when i go to replace the head or head gasket do I need to repace the bolts on the intake that I just put on or can I get away with using the same ones. I just put them on!

Theres an easier way to fix a blown gasket, its called seal-up you pour it in your radiator and it chemically welds it back together look it up on google most auto shops sell it or something similar, but replaceing the gasket is the best way ... 2003 Pontiac Grand Am

My 1998 lincoln navigator is blowing alot of smoke but the head gasket is fine what can it be

... 1998 Lincoln Navigator

1999 Lincoln continental how to replace head gasket

To replace the gasket you need to remove the head and many things.The best thing is get a repair manual. ... Cars & Trucks

How do i replace head gasket on a 93 lincoln continental

... 1993 Lincoln Continental

Estimated cost of replacing head gasket on 2002 lincoln ls

... 2005 Lincoln LS V8


I would have this looked at it may not be a head gasket are you loosing coolant ... 2004 Lincoln LS

Just purchased 2000 lincoln ls v6 and half way home stopped for gas and noticed steam? coming from under hood and smelled like radiator fluid. Drove the car home and still noticed steam coming from under hood and smell. looked for coolant on ground but nothing . added coolant to empty radiator . next morning drove it to work(35mls) 5min into trip engine light came on but car ran fine . almost to work and noticed antifreeze smell again. Dealer says head gasket was replaced. Whats going on???

I would take it straight back to the dealer and demand they fix it or give you full refund! ... 2000 Lincoln LS

How to replace oil filter housing gasket 2001 Lincoln Navigator

... 2001 Lincoln Navigator

How to replace the head gasket for a lincoln ls 2000?

... 2000 Lincoln LS

Would a vacume leak cause a 1998 Lincoln navigator to miss while driving? I replace the erg valve, 3 02 sensors. Coil packs, spark plugs, intake gasket. Oil change and it still misses at low rpm. Any help would've wonderfol.

... Cars & Trucks

My 2001 lincoln navigator is leaking oil, is it a blown head gasket?

... 2000 Lincoln Navigator

Just replaced the head gaskets and timing chain on my 91 firebird with the 3.1 v6. ive rest the timing to 0' tdc. the distributor is new and just about everything else as ive been trying to resto

No idea here ,look at the valves on no1 or any cylinder come to that then take not of what cylinder it is then rotor arm should point to that HT lead,the inlet valve should be up and to the left and the exhaust up and to the right piston at the top , ... Cars & Trucks

How to replace oil pan gasket - 2003 Lincoln Navigator

... 2003 Lincoln Navigator

One of the head gaskets is leaking antifreeze down the side the engine. I need a manual with detailed instructions on how to replace the head gasket. It is the lumina car with the 3.1 engine. The manual needs to cover everything that needs to be remove to get to the head and the specifications needed to replace the gasket.

Go to your local library and find a "Chilton's Auto Manual" it will take you step by step through the entire process and you can take it home and use it during removal and replacement ... Chevrolet Lumina
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8114 seconds