Having problems with your Cars & Trucks ?

1998 gmc c6500

\015 I am trying to figure out why the intake heater is not working on this truck. It has a 3116 Cat diesel engine in it. There are no schematics available from Chevy for this truck so any help is greatly appreciated.\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Gmc c6500 Where is the cabin air filter located on the GMC C6500


... Cars & Trucks

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil. if you rev engine or increase rpms it goes to 0 and stayes there. let off and it jumps around like it did when started (0 to 40). No engine pecks while running. Display indicates low oil pressure and stop engine. orange light (check gages) comes on when at 0. any ideas. Service engine has not c


There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the ... 2003 GMC Envoy Xl

97 gmc suburban, no start, has spark and fuel. no codes. scanner shows no problem, except cam ******=0 knock ******=0 and spark ******=0 doesnt show inj. pw. leaning towards pcm??any help would be great


... 1997 GMC Suburban

Gmc c6500 harsh down shift to 1st - 2000 GMC Sierra 3500


... 2000 GMC Sierra 3500

Is it possible to change the miles on a 1992 GMC Sierra (1500)? I just switched out the v6 with a new 305 and for personal preference I wouldn't mind setting the miles back to 0. Not selling the truck, I mean I could always write down it's current miles to know how many miles are on the engine but it would be nice to set to 0 since its a new engine.


No if you want one with 0 miles you will have to get a new one ... 1992 GMC Sierra

Gmc c6500 topkick shut off when is hot - 1998 GMC Yukon


... 1998 GMC Yukon

Gmc c6500 won't start - GMC Cars & Trucks


... GMC Cars & Trucks

I have a 1994 GMC SUV, early in the morning when i start the engine the oil pressure is normal. but whe it warms up the oil pressure goes to 0, when I hit the gas petal the oil presssure goes a little higher, but when i let the gas go it goes back to 0,


You need to have the oil pressure checked with a manual oil pressure gauge you may have a bad sending unit. If the you oil pressure is the same with the manual gauge then you have a oil pressure problem. ... 1994 GMC Suburban

TIMING MARK FOR 1999 C6500 GMC 7.4L


... Cars & Trucks

1999 gmc c6500 topkick 3126 cat ,I change thermostat,&gage went,Up


... Cars & Trucks

Ichange thermostat on 1999 gmc topkick c6500 & heat gauge went up is normal


... Cars & Trucks

Ichange thermostat on 1999 gmc topkick c6500 & heat gauge went up is normal


... Cars & Trucks

99 GMC C6500 Derates


... GMC Cars & Trucks

2003 gmc envoy,oil pressure read 0 at idle raise engine fine or driving


... 2003 GMC Envoy Xl

1995 GMC truck won't start, good battery, battery guage shows nothing, when it does register truck will start. It is a random problem that has been getting worse. Usually when it does this I can turn the key off and on a couple times and it will come back to normal and start. It is almost like the computer isn't sending anything to the coil the motor will just turn over, but not start. In it's normal condition the batt guage reads about 10-12 volts, and when it acts up the guage sits below 0 vol


Try replacing your Negative battery cable...had this problem b-4. ... 1995 GMC Sierra C1500

I have a 96 gmc 4x4 standard trans. the speed odometer just started working intermiten from 0 to jumping up to speed. tac seems OK.


I had the same problem I replaced my instrument panel ... GMC Sierra 2500

Were shold the mark on the harmonic balancer be for tdc on no.1 piston 1991 gmc c2500 4x2 5.7l Have it at 0 and it wants to start but when I advance or ****** the distributer cap it backfires thru the throttle body


Sounds like you have plug wires off by one cylinder, rotate the wires 1 position each way on the dist. cap until you have it right,... ... 1991 GMC C2500

I have a 1985 GMC Rally Custom van with a 5.7 liter v8.automatic trans. with 59 thousand original miles.When the van is cold I have a bad stumble /hesitation in 1st gear , from 0 to about 15 to 20 miles an hour,when the van warms up to operating temp the stumble clears up to where it is alot less noticeable but still present.The van has not ever stalled on me, it is just unnerving when trying to get on the freeway and it hesitates. I changed the fuel filter, it still stumbles . Can someone help


Where exactly is the fuel filter on your van i have the same van and cant find mine please email me the answer [email protected] ... GMC G2500

The tires on my 2000 Gmc Jimmy have gotten very choppy in that they pretty much have the sawtooth-wear-pattern (not side-wall to side-wall but in the rolling direction of the tire) predominantly on the outside edges of every tire. The tires make an outlandishly annoying noise and vibration throughout the normal speed range, 0-70mph, while being a lot noisier when turning (maybe more noise/vibration when turning one particular way, but to me it's so annoying and loud that I have no patience/desi


First of all, the biggest problem I see is taking a vehicle to a dealership that no longer has a factory warranty! Can you say PRICE RAPED? Dealerships never do what you ask of them because of turn over. The more cars they get done in a day the more ... 2000 GMC Jimmy

Low oil presure on gmc 5.3 manual gauge shows 0 psi at idle 20 psi driveing


Oh my!! I'm guessing the "oil pressure relief valve" is stuck open. Does the motor sound OK no knocking or ticking? The "oil pressure relief valve" is built into the oil pump. ... 2002 GMC Sierra C/K1500

Hello, I have a 2002 GMC Envoy and my check engine light is on. The code populated is P0014, I've read different solutions to this code, however I am still unsure as to which route to go. Would the replacing the Camshaft sensor resolve my issue? Also, when my AC is on the timing appears to go up and down (from 0-2), as if my truck wants to shut off, and then Pressure Oil Low // Stop engine displays. Thank you for any assistance you can provide.


DTC P0014 - "B" Camshaft Position - Timing Over-Advanced or System \015\012Performance \015\012 (Bank 1) = to see Trouble Code P0011DTC P0011 - "A" Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)What ... 2002 GMC Envoy

1997 gmc jimmy 2 door 4wd i was driving 40mph the spedometer went to 0 the anti-lock brake light came on Ishifted to 2 and could only go about 35mph after a short time the problem cleared up and it ran normally this has happened about four times in a two week period.


Sounds like the electronic speed controle sensoe is going out. it is located either on the transmisson or rear differntal. or take it to a transmission shop and let them hook to a didnostic machine. berrydalewolf ... 1997 GMC Jimmy

How do I remove 2001 GMC C6500 power steering supply hose?


... 2001 GMC Safari

2003 GMC Yukon XL All gauges on instrument panel stopped working. They all stopped at 0, including spedometer, rpms, fuel, oil, etc. The electrical odometer is still working. Is this a fuse problem or does the entire instrument cluster need to be replaced?


If this is an intermittent problem,\012remove the IPC 10A fuse in the fuse box under the hood,\012not in the fuse panel by the driver side door,\012for 5 minutes.\012The electronics will reset. ... 2003 GMC Yukon XL

Gages I have a 99 GMC Yukon and whenever I stop the check gages light comes. Whenever the oil gages goes down it comes on when I stop and whenever I take off it goes off. When I stop the oil gage goes close to 0 or the line it is on when the truck off.


Yoyu dont mention the mileage on your Yukon but low oil pressure will indeed light the CES light when it reachs o psi. Have you checked your oil? Have you changed your oil and filter. High mileage and poorly maintained motors will eventually wear out ... 1999 GMC Yukon
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5366 seconds