Having problems with your Cars & Trucks ?

Corvette 2007 code 449 - Cars & Trucks

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

Using my OBD II on 2000 honda prelude trouble codes PO401 & (PO401 pd) all reads MIL on, monitors, 1 INC, EVAP, 7 ready, MISFIRE, FUEL, COMP, CATLYST, 02 sensor, 02 HTR, EGR. Will be cleaning out EGR, BUT do I need to replace my Solenoid? My prelude stalls and ideals out of first gear. (Autotranny). Is this stall caused by these trouble codes? Also with 1 pending code, what do you recomend? I ran car and used OBD II a 2nd time and only change was (0 inc) and 8 (ready).


... Cars & Trucks

How to enter code? went online and paid nine bucks, didn't really help me because of the following problem. 5 digit code, car radio has preset # 1,2,3,4,5,6.. one of my code is 0 and 9 how the hell am i suppose to enter it?


Come on here for free ,anyway you press preset 1 and use either the volume or tuning buttons ,maybe even the tape buttons to place the number then when all numbers press 6 to enter the code on the venerable old classic vehicle ... 1984 BMW 3 Series

Pontiac grand am P0133 censor 1 bank 1 codes - Grand Am Pontiac Cars & Trucks


... Pontiac Grand Am

I have a 2002 trailblazer ltz, I go to start the truck and it just clicks under the hood, no noise or anything. The lights on the console comes on and the radio says that's it's on but it only plays static. Also everything seems to be reset in the car like the car was saying "Driver 1" even though I had the driver 2 key and remote and also the time on the radio was reset to 12:00. Also as I'm turning the key the radio screen says "Need AMP". what do you think this could be?


Sounds like either a loose connection at the battery, or your battery has failed. Check your connections and make sure they are clean and tight, if so, then have your battery tested, and change if recommended. ... 2002 Chevrolet TrailBlazer

Code is an ignition 1 control circuit code - Yukon Denali GMC Cars & Trucks


... GMC Yukon Denali

CODE P1135 BANK 1 SENSOR 1 HOW TO FIX - Tacoma Toyota Cars & Trucks


You have a bad heater on your O2 #1 sensor.. These are fairly easy to replace as long as you can get access to the underside of your car. ... Toyota Tacoma

But the check engine light came on yesterday. I checked the car using a OBD scanner, and it found 3 codes for the car: P0012- Camshaft position timing over retarded bank 1 P0301- Cylinder 1 misfire detected P0327 - Knock sensor 1 circuit low bank 1 or single sensor. After I checked the codes, (I did not erase any code) the check engine light went off . I do not notice any problem in the performance or running of the car and am generally not seeing any differences like fuel smells, lea


I think your idea is wrong. A fault code indicates a problem, though, cars can be used normally, but the problem is there, need to be addressed.or you can ask the 24 hrs live technical support http://www.diyobd2.fr/service/ , they will like to help y ... 2002 Mazda Miata

The check engine light came on yesterday on my 2002 Mazda Miata LS with about 140k miles on her. I checked the car using a OBD scanner, and it found 3 codes for the car: P0012- Camshaft position timing over retarded bank 1 P0301- Cylinder 1 misfire detected P0327 - Knock sensor 1 circuit low bank 1 or single sensor. After I checked the codes, (I did not erase any code) the check engine light went off . I do not notice any problem in the performance or running of the car and am general


... Mazda Cars & Trucks

What does code 1-p1167 mean? - Maxima Nissan Cars & Trucks


... Nissan Maxima

Got a code in a gm of p0864 can anyone help - Corvette Chevrolet Cars & Trucks


P0864 TCM Communication Circuit Range/PerformanceTransmission Control Module Network communication circuit either out of range/performance. More specific informa ... Chevrolet Corvette

Code 1128 amp - DeVille Cadillac Cars & Trucks


... Cadillac DeVille

I have a 1994 dodge that blows the 10 amp fuse as soon as you try to start the truck the check engine light is pulling three codes 1-2,3-7,and 5-5 can you help


12 battery disconnected 37 tourque converter solenoid circuit 55 end of messages .What fuse are you blowing and what happens when the fuse blows what do you lose? ... 1994 Dodge Ram 2500

Suburban thanks pyropc.... once ive done this prsumably i can run up the car to the ses light appears pull over, short 1+2 pins, and that will be the new error code for the correct fault?? Just out of curiosity, you dont have any ideas, basically it was coming on at 55.... i gave the truck a full service and it was ok to 60, i then flushed the system with diesel cleaner incase it was bad fuel/build up of ****.... it went to 65. Just replaced the water sensors as they were broken and its now at 7


Good Day,\015\012\015\012If I were you I would clear all the codes, then drive around until your SES comes on. Instead of shorting pins take it to an autozone(they do it for free) or shop that has an OBD2 reader, they can read your code a ... 2005 Chevrolet Equinox

Code 2760 secondary-air system bank 1 - BMW Cars & Trucks


... BMW Cars & Trucks

P0137 code 2002 impala bank 1 sensor 2 - Cars & Trucks


... Cars & Trucks

Code p0171 system too lean bank 1 - Century Buick Cars & Trucks


I had this problem. Codes p0101 and p0171 came on and off intermitantly. The car has about 100K miles and the service record is unknown. Although the car starts and runs fine, I wanted to be sure I could pass the smog test, so here's what I did. Repl ... Buick Century

Auto code squib #1 interpret please - Cars & Trucks


... Cars & Trucks

Code po172 system too rich bank 1 - Fit Honda Cars & Trucks


... Honda Fit

Code P0420 bank 1 o2 sensor - Silverado 1500 Chevrolet Cars & Trucks


... Chevrolet Silverado 1500

Code 41 on 1992 corvette... - Cars & Trucks


... Cars & Trucks

Cylinder 1 misfire code p0301 - Taurus Ford Cars & Trucks


Kenracer yes our codes p0301 and p0306 is the #1 and #6 misfire ... Ford Taurus

Jeep wrangler cd player error code 1 - Cars & Trucks


... Cars & Trucks

Squib code 1 interpret please - Cars & Trucks


... Cars & Trucks

How do you run the codes for a obd 1 - Suburban 1500 Chevrolet Cars & Trucks


First thing you want to do is ground the test terminal which is the top right hand terminal, just make a jumper wire and attach the other end to the terminal to its left. When you look at the OBD plug under the steering column, the two top right hand ... Chevrolet Suburban 1500
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4156 seconds