Having problems with your Cars & Trucks ?

I need a diagram of the wiring in an '89 YJ jeep wrangler stearing colum. Wind shield wipers do not work still after I have replaced the old one with a new one.

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need a diagram of the wiring in an '89 YJ jeep wrangler stearing colum. Wind shield wipers do not work still after I have replaced the old one with a new one.


... Cars & Trucks

Hi i have a '06 dodge ram pick-up truck n there seems to be a problem with the high beams. well first of all i had to replace the head lamp on the drivers side n still when i put on the high beams the driver side does not work. I'm a firm believer in when one side does'nt work to replace both n that's what i did in doing so neither light bulb seamed to work. trying the two new ones n the old ( in which was still good) n the out come was the driverside high beam does not come on whereas the low b


I had the same prob. ended up being a bad connection between the bulb and harness... but then shortly after every time i try to go from dim to bright the wipers come on..... the dealer has finally admitted they have a prob with the multifuntion sw ... 2006 Dodge Ram 1500

1989 Buick park Ave....I have replaced the fuel pump, which didn't make a noise when it stalled, so i assumed it was the pump,...i checked the old one and it works,...so i have the new pump connected,...and it still doesn't work,...tested that one also before i put it in and it works,...i have replaced the fuel filter also,...i have checked or replaced the fuses associated (2),..and the fuel pump relay behind the glove box,...is there another rlay in the engine compartment?....i have also looked


... 1989 Buick Park Avenue

My ford telstar gd model f8 engine. i have replaced in new slave sylinder after the old one was damaged.i bought new one and fitted it on but can not have pressor on my clutch its still on the floor. no matter how much i have tried to bleed it but still can not work. can some one give me help


... 1986 Ford F 250

I have a 2003 buick rendezvous. thought it had a bad starter. I cant get the car to crank even after replacing the starter. has new starter strong battery and have gone over the fuses under the hood and in the cab. Test light endicates power to the starter. Does this car have a sucurity feature that wont let me start it? I had a new key made a couple months ago, then found the old one and now can't find the new one. should the old key still work?


Does the engine turn over good? If so you may want to have the crank shaft position sensor checked out. Also check for fuel making it to the engine. You should have a fuel rail which is chrome looking that runs on top of the engine. Look along the ra ... 2002 Buick Rendezvous

Car starts sometimes & sometimes it don't. Battery good, rotor button new, distributor cap new, battery cables new, fuel injection good when checked. Still won't start half the time! Wipers work, only one out of four power windows work. Dome light works, clock don't work. Speed odometer just recently stopped working after having a gear indicator cable replaced. Coil h as plenty power when high voltage checker used. when you turn on the ignition it cranks but don't seem to be geeting t he fire to


Check fuel pump presure ... 1986 Ford LTD

Im working on a 1999 Honda passport v6 4wd. The rear wiper motor doesnt work, I replaced the wiper motor with a new one. Still doesnt work. I inspected the wiring and found no physical damage. The rear washer fluid switch works but the wiper motor doesnt work or move. Can you send me some troubleshooting info or a schematic for this vehicle. Thank you.


Richard, I am actually going through some troubleshooting with the rear wiper on my 98 Passport. Mine runs . . . it just doesn't stop where and when it should anymore. There are some Rodeo/Passport enthusiast sites that have some threads on this. ... Honda Passport

My mechanic is working on my car right now as we speak, I wanna know what steps should he take? My hasn't been working, I have gotten another radiator that was used put on because my old one wasn't getting hot, and also I got the radiator flushed before it got put on,. The heater core has been replaced with a new one,a new thermostat, and its still over heating. He said something to me about the vacuum lines, and he said that the antifreeze isnt circulating. Should he check the water pump? Does


If the antifreeze is not circulating than yes you need a new water pump. You might also have him look at the thermostat. It can be stuck in the close position.\015\012\015\012The vacuum lines have nothing to do with the car o ... Cadillac DeVille

I have a problem with my reverse lights i found that the switch had been cut. so i went out a bought a brand new 1. i have now revmoved and installed the new part and the reverse lights still aint working can you plz help all the fuses are still fine i even bought new fuses and replace with the old one and still no go i don't no what to do and i need it fixed asap.


It sounds like you did everything correctly, the only 2 things I can think of is:\015\012\015\012Check contacts in reverse lamp housings and they're grounded\015\012\015\012And how about new bulbs? ... 1989 Honda CRX

I have power to rear wiper motor replace old one with new one 1995 jeep grande cherokee but still wiper wont operate


Make sure its grounded properly ... 1995 Jeep Grand Cherokee

95 ford ranger windshield wipers dont work, I replaced the multi function switch and wiper motor with new one but still will not work. Also checked the fuses and relays, they were all good. Please help. Thanks


... 1995 Ford Ranger Supercab

I replaced the fuel pump in my corsica because it wasnt cycling. when i took the old one out i tested both sending units and both worked fine. i still replaced it with the new one and it started the car about 3 times but it wouldnt run right like it was not getting fuel. i tested spark and everything was fine. eventually the car wouldnt even start. is there a sensor or relay to check or could this just be a bad wire running to the fuel pump?


The first thing i would check is the fuel pressure. This is a simple procedure and you can probably do this yourself, although you will need some specialty tools. For a full color pictorial on checking fuel pressure, ... 1990 Chevrolet Corsica

Solo44 4 minutes ago My 1999 Chrysler LHS has a serious problem the starter does not spin but it whins when I turn the key. I replaced the starter with a new one and still have the same problem,I replaced the starter relay and I just installed a brand new battery 1 week before I had the starter problems. The old starter was tested at the auto parts store and it worked fine. The flywheel has no missing gears or chipped or worn down All fuses have been checked. The car has a electrial issue in the


Hi,\012\012Looks like an ECU problem,\012\012You should go to your nearest dealer and check/scan and analyze your computer/ecu, some of the sensors might not be working already and need to be replace.\012\012In the issue o ... 1999 Chrysler LHS

My brake lights aren't working so I bought new light bulbs to replace the old ones, but when I put the new ones on the lights still don't turn on. Could there be another problem with the brake ligths?


Hi yes have a look at the switch under the dashboard where the brake peddle is, look at the top of that and there should be a switch with 2 wires on it, check ( dependent on type as there are 2 types) to see if either the plunger ( if that type) is s ... 1995 Buick Regal

I have a 2007 Cadillac SRX with the Bose system. I noticed the front driver door speaker wasn't working so I replaced it (with factory bose speaker). It still doesn't work. Of course I suspect the wiring but also think maybe the amp has some problem. All other speakers work fine and the radio head control seems ok too. When I turn the balance to the left, the tweeter in the pillar works fine. I did test the old speaker with ohm meter and it looks to be bad, and the new one, fine.


Use an ohmmeter and test the wiring to the amp and then from amp to speaker to find out where the fault is. ... 2008 Cadillac Srx

I replaced my break switch on my 2002 dodge dakota because it wasn't going out of park, now my break lights won't come on. I tried 2 new Switches in case 1 was bad but still no luck. I noticed not all the wires were connected on the old one and maybe that is the problem, but I don't know what color wire goes into each terminal. I know 1 and 2 work lights 3 and 4 work abs and 5 and 6 work speed control (which has never worked, maybe because it wasn't hooked up) But I need to know what color wire


... 2002 Dodge Dakota Club Cab

My dash lights wont come on. when you try to turn on dome switch, the four ways and hight beam indicator lights come on and the seat belt light. I tried replaceing the dome and head light switch, but every time I plug in the new one or old one I get different light problems and still no dash lights. All external lights work fine. also when lights are on and I turn on turn singal my fuel gage goes up and down. all fuse are fine. can any one help? 1988 chevy s-10 pickup


Bad ground , check ground at headlight switch, or behind dash ... Chevrolet S 10

Headlights not working - Removed the Circuit Breaker to take it in to get a new one and my fog lamps quit working but only until I shut the car off and turned it back on. Replaced the Circuit Breaker (with the same one that I took out) and dash lights started working but still no head lights? I was going to replace the Circuit Breaker with a new one but when the fog lights quit working, I thought it might be an electrical problem. What are your thoughts???


... 2000 Pontiac Grand Prix

I have a 2001 olds aurora. The windshield washer pump is not working, I replaced it with a new one and is still not working. Can't find a fuse for the pump. Is there a fuse or relay that I can change? If so, where is it?


... 2001 Oldsmobile Aurora

Took our 2001 Caravan SE to local mechanic because rear wiper quit working. They diagosed proble as faulty PCM. Thought they were doing us a favour by putting in a used one from a 2002 that they thought was correctly coded. Everthing ran fine for a couple of minutes until they went to drive it and then everything quit. Tried putting the old PCM back on and van still wouldn't run. Ordered new PCM from Chrysler but still can't make the van run. Now it has been towed to Chrysler shop and th


I dont see why they would diag the pcm for the rear wiper, power from fuse to switch to wiper!! no pcm in between this operation. I would have had this fixed in a hour. Have mechanic pay for the bill to get it running. It was running fine when you to ... 2001 Dodge Caravan

I have a 2001 Chevy Impala. The drivers side window wouldn't roll down so I ordered a new switch. While waiting for it to come in the mail I noticed the back drivers side switch didn't work either. I replaced the drivers side master switch and front and back drivers side still won't roll up or down but it will work on the passenger side front and back as did the old one. What else could be the problem? Thanks, Teresa johnston


... 2001 Chevrolet Impala

I have a 1989 chevy van and i am wating to fix my brake lights i had replace the old lights with new ones, but the problem is all the lights work on the van when i turn them on but when i hit the brake paddle the no lights come on in the back so i replace the stoplight switch and check the fuses and still no luck what can i do?


Did you adjust the stop light switch? If not do so by pushing it inward some more in the round bracket it slides into. The plunger must be depressed into the switch to activate the lights. If that was done correctly check the brake light switch wire ... Chevrolet G20

I ALSO HAVE A FUEL ISSUE WITH MY JAG XJ6.I CAN STILL HEAR THE FUEL PUMP WORK, BUT I'M NOT GETTING GAS TO THE BAR ABOVE THE INJECTORS. SO I REPLACED THE FILTER THAT IS BACK BY THE DRIVERS LEFT WHEEL. WHEN I TOOK THE OLD ONE OFF THERE WAS PRESSURE IN THE LINE. BUT EVEN WITH THE NEW FILTER (THE CORRECT ONE) I AM NOT GETTING FUEL TO THE INJECTORS. THE CAR STARTS RIGHT UP WITH STARTING FULID, SO IT HAS TO BE NO GAS. IS THERE A 2nd FILTER? OR SOMEWHERE ELSE I CAN CHECK?


There's no 2nd filter for JAG XJ6. You mentioned that the car starts right up, but did it die after a second or two? If yes, then: You need to check the "Block diode relay" and a "Inhibitor relay". But you need to consult a mechanic to ch ... Jaguar XJ6

I have the same code PO446. The vehical is a 2007 Chev. Silverado LT. I have replaced the Canister which has a solinoid vavle on it (Located at the back corner of the tank). Also note it was hard to fill the tank at this time.When I tested the old one it was bad as it was stuck, and I was able to make the new one work when I tested it, prior to instalation. I installed it and removed the battery cable to reset the code, but the light was still on. I also tried putting gas in it again, and it was


... 2007 Chevrolet Silverado 1500 2WD

I own a 1992Mercedes 400se. All the door and trunk locks do not work. Usually, when press down on the drivers door lock, all the other door locks will also go down. Now ever the trunk and gas flaps do not work either. I thought it might be the vacuum pump,under the rear seat, passenger side, the old motor smelled burned, so I replaced it with a new one. I even had to adopt a replacement kit to make the bosch pump work in place of the old Hella pump. Guess what, nothing works: the new


Your problem is more than likely a broken wire in \015\012the wiring loom that goes to the driver's side door. Check the loom at the door \015\012hinge.Also, try checking the pin switch (door \015\012switch) that is either out o ... 1992 Mercedes-Benz Mercedes Benz S Class
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.8808 seconds