Having problems with your Cars & Trucks ?

Egr valve whistle noise coming out of it its in a 2005 model triton 2.8 diesel

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Egr valve whistle noise coming out of it its in a 2005 model triton 2.8 diesel


... Cars & Trucks

C 270 cdi 2003 model. 1.It makes a whistilling noise when you are accelarating hard is like a turbo noise. 2. On two occassions it lost power and I could not accelarate. After stopping for about 2 hours it was behaving normally but the whistling noise remains. 3.When in heavy traffic there is a vibtrating noise from the front when the fan comes on. the whole bornet vibrates. 4.When you switch on the aircon it makes a vibrating noise as well. 5. The CD is not playing. When you put a CD it jus


My c class Blue Efficienay has a vibration noise from the driver side ... 2002 Mercedes-Benz C-Class

Hi, can someone pls help ?? KIA Lantra 2000 SW 2.0Lt (Please note: This is Australian model) Recently had all belts replaced inc Internal timing belt. Now 2 weeks after this the engine is making ticking noise, I suspect that the noise is coming from the valves. Could this relate to the belts replacement ?? loose or too tight belt, or even misaligned belts?? Thanks in advance, Salih


First of all it can be misaligned,or have miss one teeth of the belt if so the engine will never start,you are right the ticking noise came mainly from the valve,how long have you have adjusted the valve clearance ?I think you must check the valve ad ... 2000 Kia Amanti

Model is 2ltd turbo diesel Whistling noise from engine compartment, which gets higher tone with revs. worst when cold.


It could be a loose pipe on the turbo. the noise would get louder with higher revs as with higher revs higher boost is produced. check for loose pipes and give them a tighten then try a test drive. hope it helps you ... 2006 Mazda 6

1992 sunbird 3.1L, 185,456 miles. 5 sp manual trans at 184,598 miles replaced the lifters due to #3 intake failing. Haven't had any problems since. Yesterday noticed noise coming from engine again that sounds like knocking. Starts about 1200 rpm up to 3000 rpm floating rpm. No noise under accel or decel, just under coast. Appears to be coming from under intake area. Removed both valve covers and inspected valve train. All appears normal. Any ideas that I may have missed as to noise? Don


I ended up removing the oil pan and found #3 rod bearing spun. Have emery clothed the rough spots off on the crank with super fine emery and replaced with updated rod bearing from the OEM dealer. Cleaned out oil pan and replaced oil pump as a preca ... 1990 Pontiac Sunbird

I have a rexton 290 turbo diesel. year 2005, automatic transmission. It has had a noise coming from the left side front wheel. The noise sounds like a metal to metal scratching noise. Light noise like a spring subbing against the rim when the wheel turns. However the noise is intermittent. It comes on at random. Nothing to do with pressing the brake petal or with accellerating. It seems independent of these. however it seems to come on when the steering is turned to the right. It is a very inter


... 2000 Chevrolet Malibu

HI MY NAME IS MUKHTAR.I HAVE A 2004 C220 CDI W203 SERIES.THE VEHICLE COMES UP WITH A DIAGNOSTIC CODE (2634) RAIL PRESSURE MONITORING VIA VOLUME CONTROL VALVE RAIL PRESSURE DEVIATION DUE TO AIR FOAMING IN THE SYSTEM WHEN TANK IS RUN EMPTY.THE TANK IS FULL BUT STILL COMES UP AS A FAULT.THE pRESSURE PUMP IN THE TANK HAS BEEN REPLACED,THE VOLUME CONTROL VALVE HAS BEEN REPLACED,DIESEL FILTER BEEN REPLACED,QUANTITY CONTROL VALVE BEEN REPLACED & STILL COMES UP WITH THE SAME FAULT PLEASE HELP THANK YOU


May I know the full chassis no : like WD_203xxxxxxxxxxx. ... 2004 Mercedes-Benz C-Class

Whistling noise in 2006 Diesel Holden Rodeo


... Isuzu Rodeo

Hyundai Elantra diesel P0403 code comes up saying problem with EGR engine management light light comes on, I have changed the EGR VALVE AND THE Electronic valve,What can be the reason for the light to


... Cars & Trucks

There is a humming noise coming from air filter side of my toyota corola 1.4 vvti engine. The noise is gone when i disconnect the idle speed control valve and comes back on after 15-20 seconds after r


... Toyota Corolla

95 mustang valve train noise.. coming from top of valve covers.. dont think its the lifters.. could it be rockers.. loose or damaged.. whats the process of removing valve cover.. do i have to take off upper intake.. and is it hard to replace or adjust the rockers.. thanks for your help.. noise i like a ticking but sounds a little different than lifters. 302 95 5.0 mustang.. thanks for your help.


Not hard and no dont need to remove intake will have to remove some things depends on which side your working on like air intake hose a wire or two might have to unbolt a/c/ if u have- could be rocker also check for dry push rod ,weak valve springs ... 1995 Ford Mustang

2006 Ford F150 5.4Liter 3 valve 70,000 miles. Started running rough and whistling noise during acceleration or engine lugging, Missing and no power at shift points, engine would pop, NO CHECK ENGINE LIGHT. AutoZone scan showed bank one rich cylinder # 2 and #3 miss fire. Changed plugs (Thats Another Stroy) seems to be worse. Replaced #2 and #3 coil no change.Whistling noise or air pump noise form paasenger side exhaust sounds like cylinder #3. I'm lost. NO CHECK ENGINE LIGHT. PVC valve?? Hea


... Cars & Trucks

Whistling noise coming from the engine compartment on a 2006 Ford Escape. The noise usually comes and goes. Mostly when the truck is idling or when I accelerate. I've been told it's a vacuum leak. Firestone told me it was my brakes power booster, Just brakes said "no way" it's coming from somewhere else.


A whistling noise will be a vacuum leak from some point. The Escapes are known for having vacuum issues in the rear of the engine due heat caused from the motor. The lines dry and crack out. ... 2006 Ford Escape

Is valve adjustments needed on 2000 camry V6 I am hearing noises that seems like coming from under valve cover, you can hear the noise from inside car,but not from outside of car. I was told this engine does not need valve adj.,unless you have removed camshaft, which I have not.Thank you for help


The valve adjustment usually isnt done unless there is valve noise. If you think its valve noise, have the dealer check it or a shop that does a LOT of Toyota work. Special tools and shims are needed to adjust the valves. Its a LOT of work and will n ... 2000 Toyota Camry

2001 saturn with a 2.2 has oil coming from breather on top of valve cover causing it to puddle in air intake.Also have noticed odd noises coming from valve cover area.I had the engine running and removed the oil cap and it seemed to have a lot of air pressure coming out.


Hi\015\012\015\012Change the PCV valve, that will stop the oil going into the intake and relieve some of the pressure in the valve chamber.. Check your oil level. If it's time for a tune up, don't wait.\015\012\015\012Good L ... Saturn SL

Hi i recently baught a nh pajero 4d56 2.5 turbo diesel to days prior of replacing the head gasket it started sounding like a truck noise came from the intake and airbox i fixed the head gasket reset the rockers that operate the valves to .25mm hot the noise went now it is back again so i checked the rocker arm out and found one tappet was pretty loose and was barely touching the valve why and what would cause it to wear like that and could that be the noise for sure


... Cars & Trucks

There is a clattering/scraping noise coming from the engine on my S10 pickup, so we removed the accessory drive belt, but the noise continued. Next we removed the rocker covers (4.3L V-6) thinking it was a valve traing issue. All the rockers seemed to be working normally with the engine idleing but the noise seemed to coinside with the valve train frequency. Next, off came the intake thinking one of the roller lifters may be bad. But after inspecting them all, nothing appeared to be wrong with t


I have hd this problem and did exactly what u did ad itnd up being the dip stick tube got turned although mounted and was slpping the crank shaft ... 1997 Chevrolet S-10 Pickup

I have a 2000 ford contour with a 2.0 vct engine.i was wondering when i took off the cap where you put oil into the valve cover noise comes out it sounds like exhaust i was wondering if thats normal that noise comes out of their


Hi!!\015\012\015\012This happens when the piston rings/valves are worn and the compression is reversed. This means the engine is messed up and pretty soon it will give up. You will be faced with two choices, to pay for an overhaul or to ... 2001 Ford Escort ZX2

My first problem is that when you start the truck, it doesn't run smoothly at the start.It seems to run rough and not have full power for about 5 mins. Second problem is that at about 1100 revs it starts making a vibrating noise that comes from the engine, almost like a rattle. The noise comes and goes. My truck is a diesel 2006 6 liter.


You have replaced the fuel filter? This is a ford right? ... Ford F-250

Have a1997 2.5 jeep wrangler. when u start the engine it runs and sounds fine but after a few seconds it starts a consistant knocking noise. removed valve cover and all the valves seem to be working right. at rapid speed you can't hear the noise until it goes back to idle then it comes back.


If a knocking sound occurs at idle, a bearing for the camshaft or the crankshaft may be bad. ... Jeep Wrangler

6.5 DIESEL HAS GRINDIN SOUND I THINK IS COMING FROM TURBO HOW CAN I DETERMINE IF THIS IS WHERE NOISE IS COMING FROM IF YOU ACCELERATE NOISE CEases


You can make a simple listening device using a long handled screwdriver. place the metal blade of the screwdriver on the turbo or any other device you want to test and then place your ear on the plastic end of the screwdriver handle, watch out for ... 1995 Chevrolet K1500

There was a loud whistling noise coming from the engine compartment and the car die, my question is do coil packs make whistling noises when they malfunction?


Usually a whistling sound is from a vacuum leak ... Honda Civic

I HAVE A 07 TAURUS. 49000. MILES . IT FEELS LIKE A MISS-FIRE AT A STEADY RPM SPEED. WHEN IDLING, YOU CAN SEE THE RPM NEEDLE BOUNCE 600RPMS TO 450RPMS . When the engine drops rpms on idle. you can here a slight thumping noise coming from the air box. so i remove the air box and the thumping noise was coming through the throttle body. I have replace plugs, plug wires, coil, fuel filter, with gas treatment , air filter, and clean the throttle body and mafs and air control valve. with all this done.


Hello. You may have one clogged fuel injector. Go to an autoparts store and get a bottle of a fuel additive called seafoam. Pour it into the fuel tank and then drive for 5 miles. This should clear the problem. Joe\015\012\015\0124 th ... 2006 Ford Taurus

2002 Buick Rondevoux 3.4 V6. Makes a noise from the engine like a buzzing sound. Sounds seems to come from power steering pump. I had it changed twice and still have the sound. Car is quit for twenty minutes and then sound appears.It sounds like it could be coming from the transmission, but when you put the car in park and rev. the engine you still have the sound. Was told that on the 2002 Rondevoux the problem could be the fuel pressure valve (release valve) Can you give me an answer


If the noise is different in park, rev or drive , its in the trans. if no difference, take the belt off and see if its still there, its just a process of elimination. the fuel pressure regulator should have a vacuum hose on it, see if it changes when ... 2002 Buick Rendezvous

Loud noise! 0 Jeep Grand Cherokee after about 5 min starts a very loud high pitch whinning.It used to eventually go away but now it is always whinning and even louder!Seems like it's coming from drivers side engine compartment near the intake manifold. I thought it was a belt because when you step on the gas the rpms go up and the noise quits until you slow down or come to a stop then it starts again!! Is it a vacuum leak? A bearing seizing somewhere? Belt tensioner?


I would say a bad pulley also. Try to open the hood at idle and see if you can hear where it's coming from. Possibly a bad idle pulley or even the fan belf if yours is a mechanical fan. ... 2000 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.7633 seconds