Having problems with your Cars & Trucks ?

Rd532i heating controls

\015 How do you set heating on this boiler there is no manual\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Rd532i heating controls


... Cars & Trucks

2005 GMC Yukon Denali XL - Climate Control issue- Rear heat blows cold, Front heat working fine. Rear Climate Control worked fine in summer in a/c mode. Problem noticed when turning rear temperature from cold to hot â?? outside temperature 24 degrees. No difference between using driver overhead controls or rear passenger center console controls - checked fuses. Blower fan controls working fine, and floor versus roof air flow directional controls working fine. Tried removing 10 amp hvac/ea


Are you aware of any codes that may stored in the body control module and do you hear a clicking or ticking noise in the rear? ... 2005 GMC Yukon Xl Denali

No Heat Passenger Side. I have a 1999 Cadillac Deville. The problem is I can't get heat on the passenger side. Air blows but it is cold. I do have heat on the driver?s side. My car has the spate control for the passenger on the door. I have turned both controls set of controls on and off (Driver and Passenger). Also the air coming out of the passenger side comes out at a higher velocity.


Hello: You have a failed temperature control actuator for the passenger air mix door. Remove the glove box and the close out panel under the dash on the passenger side. You will see two silver rods going from the actuators (mounted o ... 1999 Cadillac DeVille

In my 1998 Mazda B2500 extended cab, the heater sends out only hot heat on heater settings (as well as on A/C). I have no control on the temperature - it is always high heat. Also, the high heat comes out on A/C. Also, when I set the heater to Max A/C, only the very coldest air comes out, also with no control of the temperature. The directional control works fine.


This truck has an electric air blend door motor that fails but sometimes the shaft though the heater box splits where the blend motor fits it's square peg that turns withthe motor and the plastic shaft with a square hole in the shaft splits open. Un ... 1998 Ford Ranger SuperCab

I have a 99 mercury mountaineer with no heat.....got hot water in and out of the heater core but no heat fan works all controls work on the control panel that i can tell the heat control is going from 60 to 90 but no change to the temperature


There is a blend door motor that control the hot to cold,and it sounds to be stuck open or close. ... Mercury Mountaineer

2003 S10 heater controls dont work / work with most heat comong through front vents replaced vac cannister, vac lines from transfer case to heater control switch on transfer case and one actuating motor under the dash the whole system is right a 16 pounds right where it is supposed to be heat works but i have to close the front vents for to get def and even then there is heavy heat coming through the front vents and even bought a heater control from yhe bnre yard with no change any ideas


Your Blend / mode door inside the heater ac blower box. is stuck or not moving completly into place. ... 2003 Chevrolet S-10

Put new radiator,heating cord,heating control valve,thermostat and still not getting heat also new heating temperature control on the dash from red to blue still no heat. What should have done or did not do.


Are the water pipes leading to the heatrer rad getting hot ?? ... Ford E-150

No heat blows cold car has been running but cannot get heat to blow out just blows cold The rear blower will only blow to the floor weather calling for heating or cooling It will also only blow cold. Is there a fuse that controls the heat control only


Most likely either the vacuum line to the round ball is disconnected allowing the vacuum pressure from moving the inner levers to the heating unit of ....check your radiator fluid levels to ensure they are to specifications level ...or you may need a ... 1998 Ford Windstar

Low heat output, blower works, new thermostat, temp running 195 at gage. new water temp sensor installed. Once in awhile get sensor bad messsage on the info display. If you turn the temp control quickly from cool to heat, you get short surge of heat then lukewarm. What is the operation of this unit. Is there a valve on the heater fluid circut and or a door to control the heat? Can you get at the works anyway, including cutting aux hole, to avoid removing the dash?


Small rad in heater unit possibly airlocked if you had the water drained recently one hose in one out normally inlet from top of engine ... 1996 Jeep Grand Cherokee

AIR CONDITIONER STAYS FULL COOL EVEN AT HEAT POSITION OF CONTROL, ALSO HEATER DOES NOT HEAT AT FULL HEAT POSITION OF CONTROL.


Does it have knobs for control or is this Automatic temp control? ... 1998 Ford Taurus

Climate control always blows extremely hot air no matter what setting is on digital control. When this first started in the summer, the air conditioning would work great then it would change to hot heat. Now, it blows hot heat all the time. No cool or warm air, only heat as if the setting is on 90 degrees. What are some areas I need to look at in order to solve this.


First thing. does the air compressor kick on ? ... 1994 Ford Thunderbird

My 2003 buick century has dual control air conditioning and heating controls for driver and passenger. Moving the slider for the passenger temperature control does not change the temperature of the heat coming out of the passenger side.


... 2003 Buick Century

I have a 1996 Dodge Ram 1500 with very little heat. The lines get hot going to the heater core, but I do not get enough heat out to keep the cab warm. I contacted heatertreater, but my hot cold control is a cable which does move the white plastice controls on the top of the plenum? or heat box right next to the heater core. I am at loss on what could actually be the problem.


I had the same exact problem and basically replaced the water pump, thermostat, radiator and all hoses, had the system flushed three differnt times with in 6 months and still barely any heat from the blowing air. I finally replaced the heater core a ... 2000 Dodge Ram 1500 Truck

2002 silverado ext cab 4.8l motor ! heater control randomly will not control heat [too much heat]. installed new blower door control , worked fine for 2 months . now acting up again randomly !


Ok,and what have you tried since it started happening again? These are very common problems for this vehicle. have you replaced the \015\012Blower Motor Control Processor yet?That may be the problem as well. Also what do you mean by won't ... Chevrolet Silverado 1500

I have replaced the internal tempature control, a/c and air volume, about a year ago. The a/c worked fine, but when you turned to heat it did not switch over. Once I replaced the part (from a juck yard) everything worked perfect. Until, yesterday, same problem, however now there is a click sound inside the car only when the heat is turned all the up from the control knob, but no heat comes out, if you turn the knob to the opsite direction to cool, everything works just fine. Do i need to


The ac control controls a door actuator motor that moves the temperature vent door,this actuator motor has gone out,or the vent door is stuck.It`s location is on top of the blower box.Open the glove box,and make it fold down,where it hangs down out o ... Ford Explorer

How to change heater control motor in mitsubishi galant 2002. The temperature control stopped working for the heat the a/c works fine but no heat. Need to know how to get to this heater control motor and change it out with new.


Http://fixmymitsu.wordpress.com/ ... 2003 Mitsubishi Galant

97 Buick Regal dual HVAC Controls. Compressor runs when turn to heat controls. Unpluged compressor. Need to get heat working. Good on fluids and thermostat. Hear switch control change to defrost or floor but still cold air!. Heater hoses both hot. Fuses OK. Should I pull dash? If thermostat for HVAC is stuck how do I fix? What should I check next? Thanks in advance for your help. This is my wifes car and she is cold. Bert and Gail


... 1997 Buick.5 Regal

Hello, My 2001 mazda 626lx will not blow out heat, only cool air. Changed the thermostat and mechanic says it is the heat control. If it is, what part is it do I need to buy? Cannot find "heat control" at auto stores on line, unless I am asking for the wrong part.


Climet control ... 2001 Mazda 626

My heat just stopped blowing out of the vents, when you move the heat control unit to turn on or off heat, you get nothing at all, not even noise..so i replaced the blower motor,and checked fuses, and still nothing.whats next, replace the control unit....i cant afford a brand new unit, there over $500. , what year dakotas can i take one from..... thanks my truck is a dodge dakota , v6 magnum, ext cab....with AC..


Change the blower motor resistor. somewhere behind the glovebox area. they are around 20 bucks. common failure. ... 1996 Dodge Dakota

My heat started blowing out warm air. I reversed and forward flushed the system several times, still the same. I bought a Heat Control Valve and replaced the vacuum hose, still the same. I bought a Climate control Head, still the same. I took it to a mechanic and put a new radiator, cap, thermostat and heater core, still the same. He said that the Climate Control Cable could be stretched and not allowing the door to work properly. I took the cable off the Head & held the case while pulling on th


Hello, my name is Ben. Since you stated it got a little hotter when you manually pulled on the cable, it is possible that the plastic where the cable ends hook could be worn excessively. Have you tried to manipulate the door by hand, totally eliminat ... 1995 Plymouth Grand Voyager

Heat works on the front and the back only works when I use the front controls to turn on heater.The back Heater control panel wont turn the heat on for thr back.but still blos hot air when turned on only by the front panel.is there a fuse for the back heat panel ? if yes where is it located ?


Here's what the system looks like. left rear panel\015\012please rate as fixya if this solves your issue\015\012\015\012\015\012\015\012 ... 1997 Ford Expedition

Car barely idles. No exceleration. Prior to this, lost all interior heat. Looked on line and saw a heat control valve. Is there a idle control valve, and is it controlled by a relay? I have no legend for my fuse block.


Check your anti freeze and oil. If your oil is milky or antifreeze is gone you might wanna get it checked for a blown headgasket. ... 2007 Ford Fusion I4 SEL Sedan

How to change heater control motor in mitsubishi galant 2003. The temperature control stopped working for the heat the A/C works fine but no heat. Need to know how to get to this heater control motor and change it out with new.


... 2003 Mitsubishi Galant

I have a 2002 voyager that the heat control started changing from a/c to heat by its self but now you can't get it to change to heat checked connection on back of control panel


Have the blend air door checked ... 2002 Chrysler Voyager

PASSENGER SIDE HEAT NOT WORKING. Dual heat control for driver and passenger. Driver side heat works but the passenger side is blowing cold air no matter where you have the thermostat control.


The passenger blend door is broken on its shaft into the air cooling assembly.\015\012The disgnostic is very easy, the part itself is very cheap. The bad new is that the dash has to be removed to reach the HCAV assembly where the blending doors ... 2000 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1439 seconds