Having problems with your Cars & Trucks ?

Where is crank sensor locate on motor of 2003 kia rio 1.6

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is crank sensor locate on motor of 2003 kia rio 1.6


... Cars & Trucks

Crank sensor for a 2005 kia rio locate - 2005 Kia Rio


... 2005 Kia Rio

2004 kia rio... was driving on highway and then sudden loss of power... now starts but as soon as you touch gas pedal engine dies... recently changed motor and clutch and crank sensor


Had the same thing with my chevy..turned out to be a lousy $20 mapsensor ... 2004 Kia Rio

Where is the crank position sensor located on my 2003 kia sedona lx .do i need to open up the front of the motor.


Hi, the crankshaft position sensor for this car is located/mounted on top of transmission housing close to engine block. ... Kia Sedona

Knock sensor replacement ....2003 kia rio....emissions ...obd II....failure...need to pass inspection...failure code P0325 (Knock sensor 1 circuit malfunction)....where vis the knock sensor located on a 2003 Kia Rio and is it hard to get to?


Turn ignition off. Disconnect knock sensor 3-pin harness connector. Locate knock sensor, on cylinder block. On Optima 2.7L engine, sensors are located on both sides of cylinder block. . Remove knock sensor from cy ... 2003 Kia Rio

Have a '02 Kia Sportage, my crank sensor is bad, bad, bad.... How do I replace the css? And where is it located, and is there a picture showing it?


... Dodge Ram

Just rebuilt 01 kia rio 1.5 engine. runs great but when u first crank or let set for a while it runs ruff u can cut car off and crank rite back and it runs fine.scanned computer said cam sensor replaced sensor still does same thing customer brought back today scanned again says cylinder misfire on 2 and 4 speed sensor and an 1100 dealar code for power train.also when runs ruff u sto the car it will die always cranks rite back


There may be an intermittent misfire caused by bad plug wires or a cracked plug.\015\012If this codes show then cylinder misfire error is possible.\015\012P0302 Cylinder 2-Misfire detected. P0303 Cylinder ... 2002 Kia Sedona

Need to locate iat sensor on 2001 kia rio - 2001 Kia Rio


At the back of the intake maifold ... 2001 Kia Rio

Iat sensor locate 2003 kia rio - 2003 Kia Rio


Wiki.answers.com/.../Where_is_the_Intake_Air_Temperature_sensor_on_2000_Kia_Rio - ... 2003 Kia Rio

Kia Rio Diagram sensors location - 2001 Kia Rio


... 2001 Kia Rio

Location speed sensor kia rio 1.3 rs PO501 - 2004 Kia Rio


... 2004 Kia Rio

Location temp sensor 2002 kia rio cinco - 2002 Kia Rio


... 2002 Kia Rio

2004 kia rio wont start changed cam and crank position sensor


... 2002 GMC Yukon Denali

Whare is the Cam position sensor located? 1998 Buick Lesaber with 3.8L Issue is Car will turnover but not crank on hot days only. In the morning the car will start every time but later during the day it wont start. I have replaced the fuel filter, battery, battery bolts, coils, mounting plate coils mount onto, and a MAP sensor on top of the motor. I am running out of ideas. I am going to clean the mass air flow sensor and plan to replace the cam position sensor, but after that I don't know.


Car starts up stays on for 2 min cuts off & doesn't start back up\015\015 ... 1998 Buick LeSabre

Need to know where knock sensor is located on a 2001 kia rio.


At center rear of engine compartment, by intake manifold support bracket. ... 2001 Kia Rio

Locating crank position sensor on ford expidition 5.4 motor


... 1997 Ford Expedition

I have 02 pontiac grand am and it wont start, it cranks over and getting spark and getting fuel, I replaced crank sensor, however i pulled spark plugs and didnt smell gas in the cylinders when someone else was cranking it with the key. not sure if fuel rail is bad or if the computer isnt letting the fuel into cylinders. the fuel rail is getting fuel cause i checked the release pressure valve like on a tire which is located on front side of motor. what is my problem?


Attempt to start the car by turning the key to the Start/Run Position. Observe that the vehicle fails to start and that the security light is illuminated. leave the key in the 'ON/Accessory' Position. (DO NOT turn key to the 'off' position.) ... 2002 Pontiac Grand Am

I have a 2002 Kia Rio. It started trying to stall when going into slow traffic or at stop signs. Now it is hard to start when it is cold. I have had the fuel filters changed, the crank sensor replaced, the computer changed, and the o2 sensor replaced. The fuel pump has been checked also the idle sensor. Can anyone help me? My car has been in the garage for 2 weeks.


This is likely going to be the Pre cat that is connected to the exhaust just off of the exhaust manifold attatched to the cylinder head. These were a little problematic for plugging and causing exactly what you are describing. Find a trusted exhaust ... 2002 Kia Rio

Crank sensor location on 2006 kia optima


In the tank ... 2006 Kia Optima

Can u tell me were the crank sensor os on my 2004 kia optima with a 4 cylinder is located


The sensor is most always located infront of the timng cover behind the crank pully or harmonic balancer on the crank shaft ... 2004 Kia Optima

Location of Knock Sensor KIA RIO and steps to replacement


I can honestly say i have never seen one on a europeon model for this age vehicle ,only later years are they on any make of car .If anywhere it will be on the back of the engine level with the pistons in the block but never had a problem with them,pe ... 1997 Nissan Maxima

I have a 2004 kia rio manual trans. it will crank but wont start. the cam shaft pos. sensor code was read off the car. erased, then came back on after i tried to start the car again. we already replaced the sensor before the we tried to start the car again.


Sounds like most of Kia problems...timing belt !\015\012BEWARE that this is an "Interference Engine", meaning the valves and pistons "interfere" with each other and more than likely serious damage has already occurred.\015\012If this is i ... 2004 Kia Rio

Maf sensore location on 2003 kia - 2004 Kia Rio


... 2004 Kia Rio

2004 Kia Rio Cinco 1.6L. Stalled while driving. Car cranks but won't turn over. Have power to the fuel pump, good relay, and fuse. Fuel pump does not prime/operate. Does not have spark. Had the head redone a month ago and replaced all the goodies during the process. Have seen a couple of the same problems posted on forums and dealer/garage mechanics are stumped. They have replaced fuel pumps, crank and cam position sensors, still no luck. Have not seen any solution posted. Apparently, it is a sm


... 2004 Kia Rio

Wheres the trans. Temp sensor located on a 2004 kia rio 4cyl. Auto. Sensor bad and need to change...thxs...


... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.5527 seconds