Having problems with your Cars & Trucks ?

Replaced the battery on the keyfob, still wont work, is there a reset step?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replaced the battery on the keyfob, still wont work, is there a reset step?


... Cars & Trucks

Something in my fuel pump is draining my battery and the van wont start. Meaning this I charge up the battery to start the van and the van will turn over but not fire (start) I replaced the fuel pump and still no luck starting the engine. I notice that when I step on the fuel pedal it seems to put a drain on the battery. The other symptom that it had making me believe it was the fuel pump is that before the van quit working as I stepped on the gas to accelerate the van slowed down until it


Could be a bad ( tps ) sensor it registers the amount of pedal you give it so it knows how much fuel to give the engine if the starting volts are not where they should be it won't start. ... 2002 Kia Sedona

Wiper interval governor ticking, wipers wont work. Tail/brake lights and turn signals wont come on. Replaced interval governor, placed hot wire from battery and wipers still inoperative. Replaced brake light switch and all bulbs and still nothing works


... 1990 Ford F150

99 sable won't start, replaced battery,starter,alternator, but still wont even crank. code reader also said map sensor so it was reset worked for alittle but now nothing


If the car does not have a security system, I would check for voltage at the starter from the battery and from the key switch.The power from the key switch goes thru the neutral safety switch before getting to the starter. ... 1999 Mercury Sable

My 91 nissan sentra would not start, I checked the fuel pump, it was not working, so i replaced it, the fuel pump is now working , but it still wont start. the sprack plugs were replaced, the igniition works, the battery is fine, it starts to turn , all most makes it,but then it dosnt turn all the way,,, why wont it start??


Maybe you have a plugged fuel return line.You have a fuel supply line and a fuel return.If its plugged you can not get the air out of the lines.Remove the the line and blow through it If you cant its clogged.Also you can prime the line line by turni ... Nissan Sentra

Hi since my battery went flat my car wont start due to the immobilizer not working my key still works to open the car but wont start it, i have tryed to reset the immobilized but it didnt work and i d


Try unlocking your doors manualy one at a time then try if it dont work them cheapest way is to call a lock smith some of them have the programer and there only arround $ 150 bucks ok hope this helps ... Cars & Trucks

1994 NISSAN PATHFINDER WONT START I LIKE TO FIND OUT HOW CANT I BY PASS THE MANUFACTURE SECURIETY SYSTEM . BUT I HAVE INSTALLED A AFTER MARKET ALARM AND I HAVE A BRAND NEW STARTER, ALTERNATOR , BATTERY AND STILL WONT START WHAT CANT I DO TO GET IT WORKING. THANK YOU FOR ALL THE HELP.MY NISSAN PATHFINDER I REPLACE THE IGNISION WIRE AND STILL WONT ALL THE PARTS I INSTALED IN MY PATHFINDER AND STILL WONT RUN WHAT ELSE CANT I DO


First thing you should have done was check and test.NOT REPLACE PARTS.Did you test the battery to determine it needed to go? Had the starter failed to turn the engine over? The Alt supplies current to run the vehicle ,and keep the battery at the prop ... 1994 Nissan Pathfinder

Just bought a new battery for my remote key on chrysler,STILL MY AUTOMATIC LOCKS WONT WORK! MY neighbor said he culd try and reset my batterie but still nothing. Culd it be a Fuse. My car starts fine. When I put my key in the door and turn right twice, Normally all the locks wuld open Now Dead Nothing Can Anyone Help With a Solution. Working Mom


Sounds like a fuse , check the owners manual for fuse diagram. Also , if you have 2 sets of keys , try the other remote. Yours might be dead. ... Chrysler 300C

My key fob stopped working, I replaced the batteries and it still wont work. Do I need to reprogram it since I replaced the batteries? Or do I need to go to the dealership and get a new key fob?


Check to see if you put the battery in right. ... 1999 Jeep Grand Cherokee

Hi there have had a new fob key and now the immobiliser still wont work, Had a new battery and now it works to central lock but car still wont start. is there sut a thing as a reset button its R reg?


... 1996 Ford Explorer

How do I replace the starter in a 2003 Corolla? Over the past few days, my car was taking a little longer to start than usual. At first I thought it was the battery going on me. Yesterday my car wouldn't start at all, no noise, no clicking, nothing. I bought a new battery and still nothing. The interior lights, wipers, windows and radio work fine, but the exterior lights don't work and it still wont start. Does anyone think this could be the starter?


Hmmm. Don't be too hasty replacing the starter. With no exterior lights working it suggests an open circuit in the system that could relate to your starting problem. Start with your fuses that are related to lighting and starting. Check connections f ... 2003 Toyota Corolla

I have not been able to get my 92 GMC Sierra radio to work although it appears to have power and will turn on and off. The radio station will appear but volume and tuning controls wont respond. Recently, I had to replace the battery in the truck and although the time and station changed when the battery was reconnected, it showed a different time (1:00) and the station that was programmed to the second button. However, it still wont work. I dont believe its a fuse since there is power to the uni


GOTTA GET A NEW(OR USED RADIO FROM JUNK YARD)THE ONE YOU HAVE IS HALF WAY OUT!!! ... 1993 GMC Sierra

My key remote stop working and i replace the battery. After replacing the the battery it still does not work. i would like to know how to reset the remote without going to the dealer.


Place your key into your car's ignition and turn it from "Off" to "On" \015\012eight times in quick succession, ending in the "On" position (one click \015\012short of turning the car on).Press any button on your keyless-entry remote to reprogram it. ... 1995 Chevrolet Camaro

My dash lights all come on, the gages stop working, air conditioner stops, windows wont roll down. One day it works fine, next nothing works. One day it would not start- but only one day. They cleaned a battery wire for the starting problem. Body control module was replaced and still not working. Any help???? 1999 jeep grand cherokee Ltd. Yes, I know that it is an electrical problem! Battery can be disconnected over night and things work good for about 6-8 hours. Turning switch to "on" without s


Try the alternator ... 1999 Jeep Grand Cherokee

1999 ford ranger wont start. no attempt to start no clicking etc. Replaced battery and still no attempt to start. Lights work etc. Battery was charged and tested at parts store and I was told the original battery was bad. The new battery is installed correctly but still no luck. The connections to the battery do not have a lot of buildup on them either.


Starter may be bad, or connection to the starter could be corroded or broken. There also may be a fuse, I'm not sure. Locate the starter and try running a jumper wire to it. Mini jumper cables will work. Hook those up to the battery and then run it ... 1999 Ford Ranger SuperCab

Odyssey alternator Battery light stays on. Thought it was old battery issue. Replaced it and light still stays on. Measured the new battery when van is running, it was around 12v. Obviously, charging system is not working. Before replacing the alternator, please advise steps to eliminate other possible issues that could cause battery not being charged. As you know alternator is expensive. I want to be sure it is the problem before I spend big money. Thanks.


... 2006 Honda Odyssey

Ok, so my girlfriend has a 1987 mazda B2200 that absolutely refuses to work. They've had the spark plugs replaced, the battery replaced, several licensed mechanics have looked at it, tried replacing or fixing something or another, and it still wont work. The engine will turn over but it won't actually fire. The fuel pump has also been replaced. I know it's a long shot, but any ideas would be appreciated.


Push pull or drag trade that puppy in and get something up-to-date man that's almost as old as me. ... 1987 Mazda B-Series

Alarm system has stopped working on my x reg 4.0 cherokee jeep.Both key fobs have new batterys, was ok, up and till brakes where replaced recently.Jeeps battery showing charged.Alarm still wont work having to manualy lock doors. Local garage has no idea why it has failed to work what has gone wrong.


Please explain what year a X registration vehicle is ,as i have no idea ,last one i remember was a T 1978 .Now i think that this alarm fob might need re-programming into the vehicle where you swing on the aerial whilst holding the key fob in teeth an ... 2000 Jeep Grand Cherokee

I recently had body work done on my car. Now my keyfob doesn't work and my tire pressure monitor doesn't work. I have already replaced the battery and attempted a reset of the keyfob. No luck. I do not have a manual to check out my tire pressure monitor info. 2008 Chevy Malibu. Tia


... Cars & Trucks

Car wont start, battery is fine, starter clicks, wont turn over, key icon flashes on dash board, has gas, disconnected the battery last night in an attempt to reset the computer and it still wont work.


Take it to local parts store and get a free electrical test for your battery, starter, and alternater. That should indicate your problem. ... 2007 Honda Accord Sedan

I replaced ignition switch and i fogot to disconnect the battery,and smoke came out of my battery. my car wont turn on my dash board dont work my windows wont go up,i allready change the battery, new fuses and relays and i still have that problem


Check\015\012all of the battery terminals and cables and check the wires on the\015\012starter/selonoid, start from the battery and follow the cable out and check all\015\012conections , clean and tighten them and if it still does it the\015\01 ... 1990 Ford Mustang

My brake pads have been replaced, however the dash brake warning light still appears. In addition, the cruise control is not working. This has reset a few times and the light has gonen out adn the cruise resumed working. I want the light out/cruise working consistentley! Have also tried disconnecting the battery in hopes it would reset. Just disconnected for a minute or 2... Mountaineer V-8, 85K mi


Look at your brake master cylinder, open the top to it, and check your brake fluid. If low, that is why the brake light is on. Or check to see if your emergency brake is pushed in. Check your fuses for the cruise control. Hope this helps, James Booth ... 2004 Mercury Mountaineer

Homelink wont work. did rolling code programming replaced batteries still wont work.


... Nissan Altima

We replaced the fuel pump and filter but the van still wont crank. we disconected the battery for five minutes to reset pumo but it still wont crank


Check the fuel pump relay ... 1994 Chevrolet Astro

Car wont start. tested battery and it is good. replaced battery terminals, but still wont start. headlights and all other lights work. assuming it could be the starter. need to know where the starter is located and difficulty of changing the starter in the car


This job is easy to do, dissconnect battery terminal wait 3 min, before continuing, next remove cooler line clamp off starter, then remove the cable wire and the small wire from the starter, next remove the two bolts holding the starter and starter i ... 2001 Acura 3.2CL
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.6886 seconds