Having problems with your Cars & Trucks ?

For a 1989 Porsche 928 S4, I am looking for a vaccum diagram or graph to show me where all the vaccum lines go to. I appreciate it. I mainly need the vaccum lines that connect to the intake manufold.

\015 I need the diagram for all the vaccum lines for the particular porsche described above. I appreciate it. Thanks! Apparently the client didn't know what he was doing and detached all the vaccum lines and I dont have the books to figure where they all go. I appreciate if anyone has the diagrams or scans to see where they all go. Thanks for your time and help!\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

For a 1989 Porsche 928 S4, I am looking for a vaccum diagram or graph to show me where all the vaccum lines go to. I appreciate it. I mainly need the vaccum lines that connect to the intake manufold.

... Cars & Trucks

I have 98" Sentra 1.6L GA16I TBI, SOHC. All I lack is getting all the VACCUME hoses attached to and around the intake manifold in the right places. Some lines have a hose & some don't ? ? Can you please send or show pics. On the account I'm evidentally not bright enough to just do it without a picture. I truley appreciate Ya'lls help. [email protected]

... Cars & Trucks

I have vaccum lines and I am not sure where they go to, I need a diagram showing me where all the vaccum lines go

I don't have the diagram for vacuum lines for the 1988 model year, but I have one for the 1989 model year 2.5L engine VIN E Throttle Body Injection:\015\012\015\012 ... 1988 Chevrolet S-10

I have a 5.7 1989 chevy blazer, i have a vaccum line sitting on the intake manifold not connected. it has vaccum, it starts from on top of the intake (passenger side) and curves aound back of distributor and sits there on driver side sucking air

IT GOES ON TO THE DISTRIBUTOR as its for the vacuum advance so when you put the throttle down for power the plate inside is turned around 1/4'"there for advancing the spark ,so it dosent backfire through the aircleaner,\015\012So on the side of ... 1989 Chevrolet S-10 Blazer

Need a vacuum diagram for a 2001 kia sportage....i just bought the car and there are several vacuum ports which are open...one of which i need to know about is located on the passenger side on the top of the intake...IT IS THE SMALLER LINE UNDER THE LARGER VACCUME LINE...IF ANYONE COULD HELP IT WOULD BE GREAT

... 2001 Kia Sportage

I have solved the roblem, i need a part number for the vaccum hoses i need to replace, there are three in front of the transverse engine coupled together make a T shape just below where the plugs are situed, on a ford fiesta 1997 1.25 zetec lx and they are all kinked to shape with a little plastic T bar shape to connect them all in the middle of them all! any help will be very much appreciated as its the wifes car, and she needs it for work as she is a home carer, thanks to all. p.s. please igno

Instead of buying preformed lines from the dealer, just measure the total length of all the hoses you need to replace and go down to your local auto parts store and buy it by the foot for less than $1 a foot. You can also get connectors. Chances are ... 1997 Ford Escort

My rear brake return line (I am assuming its a return line it comes out of the top of the splitter block on top of the rear axle) is diconnected on the opposite end and is causing me to have brake problems, I need to know where it connects to so I can replace or repair it. Any advice will be appreciated.

There is no return line. The line should be filled with fluid that applies the brakes when pressurized. Some systems have a vent hose on the rear axle that is only connected on one end, but the hydraulic line will be solid and unopened. There is a ... Dodge Dakota

Need a diagram for vaccum lines on the intake and intake manifold for a 1998 ford ranger. 2.5 four cylinder

I think this is a vacuum diagram you need. ... Ford Ranger

Need schematic for vacuum line on 1998 Ford Contour to see where vacuum line from booster connects to intake

... Ford Contour

2006 Avalon Limited with 40,500 miles. Like new. Seatbelt was closed in the driver side door and batter was drained. I charged the battery and everything seemed ok. The following fault codes are now displayed: P0441, 0445 and 0456. Dealership says the charcoal canister needs to be replaced. Is it normal for the VSC light to show when the check engine light is on? I understand that the fuel line leak can be as simple as a loose cap or the canister may need to be replaced. My main concern

Yea VSC lite will come on when ever a check engine lite is On, the codes you mentioned are certainly a EVAP codes, make sure your gas cap is a factory and inspect seal surface and contac surface on filler neck for rust clean if any,also check all hos ... 2007 Toyota Avalon

I need to know the routing of the brake lines at the EHCU. Specifically which brake line connects to which port on the EHCU. There are 3 brake lines in the truck, 1-front right brake, 2-front left brake, 3 the rear brakes. There are 5 brake line ports on the EHCU, 2 of the ports connect to the master cylinder, and the other 3 ports go to a specific wheels brakes for the antilock to work properly. I only need the 3 brake line ports, which brake connects to which port.

... 1999 Ford F150 Regular Cab

I want to add he factory sirius module to my truck. I bought the module on a on line auction. I can use the after market antenna. But, where does the module go? I assume somewhere in the dash. I can't figure it out. Also do I need to but the wiring harness to connect the radio to the module or did ford leave one in the truck? Any help would be appreciated.

If the module is the one I think you have, you will need to remove radio and connect to the back of the radio. ... 2007 Ford F-250 Super Duty Lariat

1992 Ford Bronco 4.9L Automatic 4x4 - The PCV has two vacuum connections. One goes to the intake, anybody know where the other one goes? Also need to know which vacuum line goes to the transmission?

... Cars & Trucks

Need to find an intake vaccum line on Vortec 6000 V8

I do not beleve they have any the reason those engines are called vortecs is because the vaccum is self contained inside of the intake plenum that is also where your fuel injectors, pressure regulator and the entire fuel spyder is located . . . dont ... 2005 Hummer H2

Ok I have a holley four barrel 650 and i have it on the truck but it will run for a few minutes and then cut out. i think is a vaccum leak somewhere on thed carb but i need a schimatic to show me the which lines to plug up.

You are not going to find a vacuum diagram for a holley. the line on rt side of carb is ported vacuum for distibutor advance. and the lower bigger port is for pcv valve. ... 1985 Chevrolet S-10

I have A 1987 cadillac -4100 engine I replaced the crank and need torque specs on the mains and connecting rod bolts. Any help would be appreciated.

... Cars & Trucks

I need a diagram showing where the vacuum lines connect to on a 1997 olds silhouette

Hello Robert.There are two diagrams available. One showing emission system and the other for the heat/ defrost controls.The first is emission. ... Oldsmobile Silhouette

I have a 1970 ford f-150 with a holly four barrel carb im missing all the vacuum lines but one i was needed a diagram map to show where they run an connect

Go to the library, the auto manual section and look it up. If not successful, try going on-line and browse google. Type-in Ford F-150 repair manual. Good Luck ... Ford F-150

Need to know if vacuum line connects to fuel pressure regulator on 93 ford explorer. have replaced fuel pumps transmission pan gasket and vaccum module on the tranny. vehicle is now to rich when running and very poor on mpgs.

Yes there is a vacccum line that is on the fuel regulator ... 1993 Ford Explorer Limited

Cant find I have a 1993 xj6 and had the fuel pump changed and come to find out the connector that connects to the fuel pump was burnt. I need to find this part i went to the jaguar dealership and they couldnt identify it. I showed them the part and the id number on it and they still could not find. Its a intank fuel pump which sits inside my trunk. Any help would be most appreciated.

Yes order the harness, they were just playing dumb, parts tech's can do that, I will bet my pay check they knew u needed the whole harness, they love to play games like this. I m a dealer tech of 35 years, so seen it many times. ... 1993 Jaguar XJ6

1992 Honda Accord we are trying to fix for son. Been sitting 6 years. Tries to start but won't turn over. Have replaced main relay. Will run a few seconds if we spray starting fluid in intake. Also changed fuel filter. Gas gauge not showing any fuel even though we put in 5 gal. fresh gas.After trying to crank we loosened fuel line and does not seem to be any fuel going to injecters. Can't hear fuel pump, but wondering if there is a fuse or separate relay for fuel pump etc. before we tackle fuel

Hi\015\012\015\012There are quite a few potential causes of this in a car that has been sitting up for 6 years. These can range from a problem with the cars ignition switch to a bad coil (faulty coil will cause fuel pump not to operate on ... Honda Accord

During a diagnostic test I was told cylinders 2 and 4 had pressure of 110 and 115. The others were at 140(6 cyl)I was told I needed a head gasket to solve the problem.My 2003 ranger seems to be running fine,though. I noticed a vaccum line missing after I got my truck back and dont know where it connected. The service engine light stays on now.I was looking for a diagram for vac routing before a major repair


The water pipe that connects to the radiator's main hose line cracked/broke apart. How do I fix it? Do I need to replace the complete radiator?

Yes. ebay has cheap radiators.\015\012\015\012more help\015\012http://autos.groups.yahoo.com/group/villagerquest/files/ ... 1996 Nissan Quest

I need many specs for a 1994 Chevy cavalier motor. To name all the things i need: bore size, Stroke length, ignition firing order,connecting rod bearing clearance, main bearing clearance,crankshaft run out, connecting rod journal diameter and maximum allowable taper/out of round for it. Main bearing journal diameter and Maximum allowable taper/out of round for it. Piston size, skirt clearance, ring groove clearance, ring end gap. Connecting rod bore out of round. Maximum allowable Cylinder taper

If your going to do do that much work , I would invest in a Chilton's or Haynes manual ... 1994 Chevrolet Cavalier

I have a broken brake line above my gas tank and I can not find a diagram to show me if the line runs straight across the tank or if there are other connecting lines above the gas tank that I can not see. I have a 99 dodge grand caravan. Do you know if there are any other connecting lines that met above the tank of is it just a connecting line for the back tires only? Or where I might be able to find a diagram of this vehicle?

... 1999 Dodge Caravan
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6595 seconds